Hidehiko Okada
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hidehiko Okada has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
Hideki Matsuura
Shikoku Research Institute Inc., Takamatsu, Japan
4 shared publicationsNoriyuki Hirota
National Institute for Materials Science, Tsukuba, Japan
4 shared publicationsSeitoku Namba
Shikoku Research Institute Inc., Takamatsu, Japan
4 shared publications- Tatsuya Mori
Osaka University, Osaka, Japan
4 shared publications Tomokazu Sekine
Ebara Industrial Cleaning Company Ltd., Kawa-saki, Japan
4 shared publications- Yoko Akiyama
Graduate School of Engineering, The University of Osaka
4 shared publications
Latest Publications
- 25 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 32 (6) , 1-5
Removal of Iron Oxide Scale From Boiler Feed-Water in Thermal Power Plant by Magnetic Separation-Scale Removal at High-Temperature
The removal of scale by high gradient magnetic separation (HGMS) has been investigated utilizing the magnetic properties of the scale. This study focuses on a thermal power plant with oxygen treatment (OT), which has been applied in many new power plants with large generation capacity in recent years. At high-temperature conditions where the HGMS system is expected to be installed, the viscosity of the fluid will be lower than that of at room temperature, which makes the separation ratio higher. In this study, the scale capture rate at room temperature (25°C) and 80°C was investigated by particle trajectory calculation and experiment, in order to design magnetic separation conditions suitable for the high-temperature environment of the chemical cleaning line of the thermal power plant adopting OT.
- 25 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 32 (6) , 1-5
Removal of Iron Oxide Scale From Boiler Feed-Water in Thermal Power Plant by Magnetic Separation-Scale Removal at High-Temperature
The removal of scale by high gradient magnetic separation (HGMS) has been investigated utilizing the magnetic properties of the scale. This study focuses on a thermal power plant with oxygen treatment (OT), which has been applied in many new power plants with large generation capacity in recent years. At high-temperature conditions where the HGMS system is expected to be installed, the viscosity of the fluid will be lower than that of at room temperature, which makes the separation ratio higher. In this study, the scale capture rate at room temperature (25°C) and 80°C was investigated by particle trajectory calculation and experiment, in order to design magnetic separation conditions suitable for the high-temperature environment of the chemical cleaning line of the thermal power plant adopting OT.
- 22 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 31 (5) , 1-4
Removal of Iron Oxide Scale From Boiler Feed-Water in Thermal Power Plant by Magnetic Separation-Separation Conditions of Oxygenated Treatment Scale
We have been developing the scale removal system utilizing superconducting magnet that can remove iron scale from boiler feed-water in a thermal power plant. The scale removal prevents the plants from the reduction in power generation efficiency. Iron oxide scale consists of the ferromagnetic and the paramagnetic particles, and the optimal separation conditions largely differ de-pending on the magnetic properties of the particles. So, single separation condition may cause the filter blockage by over capture or inadequate capture. We proposed the two-stage magnetic separation according to the magnetic properties of the aggregates, where the ferromagnetic particles are captured in the 1st stage in low magnetic field and field gradient, and then the paramagnetic ones are captured in the 2nd stage in high magnetic field and field gradient. It was shown that two-stage magnetic separation system for the mixture of ferromagnetic and paramagnetic particles is possible by utilizing one superconducting solenoidal magnet.
- 22 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 31 (5) , 1-4
Removal of Iron Oxide Scale From Boiler Feed-Water in Thermal Power Plant by Magnetic Separation-Separation Conditions of Oxygenated Treatment Scale
We have been developing the scale removal system utilizing superconducting magnet that can remove iron scale from boiler feed-water in a thermal power plant. The scale removal prevents the plants from the reduction in power generation efficiency. Iron oxide scale consists of the ferromagnetic and the paramagnetic particles, and the optimal separation conditions largely differ de-pending on the magnetic properties of the particles. So, single separation condition may cause the filter blockage by over capture or inadequate capture. We proposed the two-stage magnetic separation according to the magnetic properties of the aggregates, where the ferromagnetic particles are captured in the 1st stage in low magnetic field and field gradient, and then the paramagnetic ones are captured in the 2nd stage in high magnetic field and field gradient. It was shown that two-stage magnetic separation system for the mixture of ferromagnetic and paramagnetic particles is possible by utilizing one superconducting solenoidal magnet.
- 13 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 56 (12) , 1-8
Removal of Iron Oxide Scale From Feed-Water in Thermal Power Plant by High-Gradient Magnetic Separation: Scale-Up Effect
In the boiler feed-water system of thermal power plants, iron oxide scale is generated due to the corrosion of piping, which decreases the effectiveness of the heat exchanger in the boiler and contributes to reduced power generation efficiency. Scale removal can prevent this phenomenon, which consequently results in decreased carbon dioxide emission. In a previous study, an iron scale removal system was developed using superconducting magnets, and high-gradient magnetic separation (HGMS) experiments were conducted using the height difference between the inflow and outflow tanks. As a result, particles were intensively captured by the filters at the inflow side. We succeeded in eliminating this capture by properly controlling the applied magnetic field. However, because the suspension also flowed due to the height difference in this experiment, the problems of partial blockage of the filter and the resulting decrease in the flow rate were not resolved even under the controlled magnetic field. In this study, HGMS experiments were conducted under a constant flow rate with a large pump in a large-scale system having a filter diameter of 300 mm to simulate a boiler feed-water system or chemical cleaning line. Furthermore, we investigated the feasibility of the large-scale HGMS system and elucidated the scale-up effect on the amount captured and the spatial distribution of the captured particles on the filters. Based on these results, a plant-scale HGMS system (800 mm filter diameter) was designed.
- 13 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 56 (12) , 1-8
Removal of Iron Oxide Scale From Feed-Water in Thermal Power Plant by High-Gradient Magnetic Separation: Scale-Up Effect
In the boiler feed-water system of thermal power plants, iron oxide scale is generated due to the corrosion of piping, which decreases the effectiveness of the heat exchanger in the boiler and contributes to reduced power generation efficiency. Scale removal can prevent this phenomenon, which consequently results in decreased carbon dioxide emission. In a previous study, an iron scale removal system was developed using superconducting magnets, and high-gradient magnetic separation (HGMS) experiments were conducted using the height difference between the inflow and outflow tanks. As a result, particles were intensively captured by the filters at the inflow side. We succeeded in eliminating this capture by properly controlling the applied magnetic field. However, because the suspension also flowed due to the height difference in this experiment, the problems of partial blockage of the filter and the resulting decrease in the flow rate were not resolved even under the controlled magnetic field. In this study, HGMS experiments were conducted under a constant flow rate with a large pump in a large-scale system having a filter diameter of 300 mm to simulate a boiler feed-water system or chemical cleaning line. Furthermore, we investigated the feasibility of the large-scale HGMS system and elucidated the scale-up effect on the amount captured and the spatial distribution of the captured particles on the filters. Based on these results, a plant-scale HGMS system (800 mm filter diameter) was designed.
- Open Access
- 8 September 2020
- Published by Wiley in IEEJ Transactions on Electrical and Electronic Engineering
- Vol. 15 (11) , 1655-1662
Development of magnetic separation system for thermal power plants
- 8 September 2020
- Published by Wiley in IEEJ Transactions on Electrical and Electronic Engineering
- Vol. 15 (11) , 1655-1662
Open AccessDevelopment of magnetic separation system for thermal power plants
- Open Access
- 20 May 2020
- Published by Cryogenic Association of Japan in Teion Kogaku (Journal of Cryogenics and Superconductivity Society of Japan)
- Vol. 55 (3) , 179-184
Development of Magnetic Separation System with Superconducting Magnet for Thermal Power Plants
The development of magnetic separation systems for thermal power plants, including our recent studies, are reviewed. The magnetic separation systems reduce the scale in boiler feed water in thermal power plants and maintain energy conversion efficiency at a high level, reducing the amount of carbon dioxide discharged from thermal power plants.
- 20 May 2020
- Published by Cryogenic Association of Japan in Teion Kogaku (Journal of Cryogenics and Superconductivity Society of Japan)
- Vol. 55 (3) , 179-184
Open AccessDevelopment of Magnetic Separation System with Superconducting Magnet for Thermal Power Plants
The development of magnetic separation systems for thermal power plants, including our recent studies, are reviewed. The magnetic separation systems reduce the scale in boiler feed water in thermal power plants and maintain energy conversion efficiency at a high level, reducing the amount of carbon dioxide discharged from thermal power plants.
- 27 February 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 29 (5) , 1-5
Removal of Iron Scale from Boiler Feed-Water in Thermal Power Plant by Magnetic Separation: Large-Scale Experiment
We have been developing a scale removal system utilizing a superconducting magnet that can remove the iron oxide scale from the boiler feed-water in the thermal power plants. Scale removal can prevent a decrease in the power generation efficiency and contribute to reduce the carbon dioxide emissions. In our previous study, we conducted the large-scale experiments for practical use, but model particles were intensively captured by the inflow side filter. In this research, we succeeded to homogenize the distribution of captured particles in the filter stacks by controlling the applied magnetic field strength. In addition, magnetic field strength dependency of filter blockage was examined in the lab-scale experiments to clarify a detailed mechanism of blockage.
- 27 February 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 29 (5) , 1-5
Removal of Iron Scale from Boiler Feed-Water in Thermal Power Plant by Magnetic Separation: Large-Scale Experiment
We have been developing a scale removal system utilizing a superconducting magnet that can remove the iron oxide scale from the boiler feed-water in the thermal power plants. Scale removal can prevent a decrease in the power generation efficiency and contribute to reduce the carbon dioxide emissions. In our previous study, we conducted the large-scale experiments for practical use, but model particles were intensively captured by the inflow side filter. In this research, we succeeded to homogenize the distribution of captured particles in the filter stacks by controlling the applied magnetic field strength. In addition, magnetic field strength dependency of filter blockage was examined in the lab-scale experiments to clarify a detailed mechanism of blockage.
- 15 August 2011
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 110 (4) , 043903
Simulation of fluid flow during protein crystal growth in magnetic fields
We are developing a superconducting magnet system to grow high-quality protein crystals. The gravity-controlled environment, based on magnetic forces, can suppress thermal convection and may give rise to a variety of additional effects on the protein crystal growth. To design suitable magnetic force conditions for protein crystal growth in protein solutions, we are studying a gravity-controlled environment by magnetic forces in the crystal growth process by computer simulations. In this study, we derived a modified Navier-Stokes equation with gravity and static magnetic force and numerically solved the equation. The obtained results show that the temperature dependence of the magnetization modifies the levitation condition and the magnetic force gives rise to an unexpected change of fluid motion.
- 15 August 2011
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 110 (4) , 043903
Simulation of fluid flow during protein crystal growth in magnetic fields
We are developing a superconducting magnet system to grow high-quality protein crystals. The gravity-controlled environment, based on magnetic forces, can suppress thermal convection and may give rise to a variety of additional effects on the protein crystal growth. To design suitable magnetic force conditions for protein crystal growth in protein solutions, we are studying a gravity-controlled environment by magnetic forces in the crystal growth process by computer simulations. In this study, we derived a modified Navier-Stokes equation with gravity and static magnetic force and numerically solved the equation. The obtained results show that the temperature dependence of the magnetization modifies the levitation condition and the magnetic force gives rise to an unexpected change of fluid motion.
- Open Access
- 1 January 2005
- Published by Cryogenic Association of Japan in Teion Kogaku (Journal of Cryogenics and Superconductivity Society of Japan)
- Vol. 40 (2) , 51-58
Development of a Practical Magnetic Separation System
- 1 January 2005
- Published by Cryogenic Association of Japan in Teion Kogaku (Journal of Cryogenics and Superconductivity Society of Japan)
- Vol. 40 (2) , 51-58
Open AccessDevelopment of a Practical Magnetic Separation System