Tatsuya Mori
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tatsuya Mori has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Yoko Akiyama
Graduate School of Engineering, The University of Osaka
5 shared publications - Hidehiko Okada
National Institute for Materials Science, Tsukuba, Japan
4 shared publications - Fumihito Mishima
Department of Applied Nuclear Technology, Faculty of Engineering, Fukui University of Technology, Fukui, Japan
2 shared publications - Fumihito Mishima
FUT, 215108 Fukui, Japan
2 shared publications Hideki Matsuura
Shikoku Research Institute Inc., Takamatsu, Japan
2 shared publications- Hideki Matsuura
Shikoku Research Institute Inc., Japan
2 shared publications
Latest Publications
- 25 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 32 (6) , 1-5
Removal of Iron Oxide Scale From Boiler Feed-Water in Thermal Power Plant by Magnetic Separation-Scale Removal at High-Temperature
The removal of scale by high gradient magnetic separation (HGMS) has been investigated utilizing the magnetic properties of the scale. This study focuses on a thermal power plant with oxygen treatment (OT), which has been applied in many new power plants with large generation capacity in recent years. At high-temperature conditions where the HGMS system is expected to be installed, the viscosity of the fluid will be lower than that of at room temperature, which makes the separation ratio higher. In this study, the scale capture rate at room temperature (25°C) and 80°C was investigated by particle trajectory calculation and experiment, in order to design magnetic separation conditions suitable for the high-temperature environment of the chemical cleaning line of the thermal power plant adopting OT.
- 25 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 32 (6) , 1-5
Removal of Iron Oxide Scale From Boiler Feed-Water in Thermal Power Plant by Magnetic Separation-Scale Removal at High-Temperature
The removal of scale by high gradient magnetic separation (HGMS) has been investigated utilizing the magnetic properties of the scale. This study focuses on a thermal power plant with oxygen treatment (OT), which has been applied in many new power plants with large generation capacity in recent years. At high-temperature conditions where the HGMS system is expected to be installed, the viscosity of the fluid will be lower than that of at room temperature, which makes the separation ratio higher. In this study, the scale capture rate at room temperature (25°C) and 80°C was investigated by particle trajectory calculation and experiment, in order to design magnetic separation conditions suitable for the high-temperature environment of the chemical cleaning line of the thermal power plant adopting OT.
- 22 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 31 (5) , 1-4
Removal of Iron Oxide Scale From Boiler Feed-Water in Thermal Power Plant by Magnetic Separation-Separation Conditions of Oxygenated Treatment Scale
We have been developing the scale removal system utilizing superconducting magnet that can remove iron scale from boiler feed-water in a thermal power plant. The scale removal prevents the plants from the reduction in power generation efficiency. Iron oxide scale consists of the ferromagnetic and the paramagnetic particles, and the optimal separation conditions largely differ de-pending on the magnetic properties of the particles. So, single separation condition may cause the filter blockage by over capture or inadequate capture. We proposed the two-stage magnetic separation according to the magnetic properties of the aggregates, where the ferromagnetic particles are captured in the 1st stage in low magnetic field and field gradient, and then the paramagnetic ones are captured in the 2nd stage in high magnetic field and field gradient. It was shown that two-stage magnetic separation system for the mixture of ferromagnetic and paramagnetic particles is possible by utilizing one superconducting solenoidal magnet.
- 22 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 31 (5) , 1-4
Removal of Iron Oxide Scale From Boiler Feed-Water in Thermal Power Plant by Magnetic Separation-Separation Conditions of Oxygenated Treatment Scale
We have been developing the scale removal system utilizing superconducting magnet that can remove iron scale from boiler feed-water in a thermal power plant. The scale removal prevents the plants from the reduction in power generation efficiency. Iron oxide scale consists of the ferromagnetic and the paramagnetic particles, and the optimal separation conditions largely differ de-pending on the magnetic properties of the particles. So, single separation condition may cause the filter blockage by over capture or inadequate capture. We proposed the two-stage magnetic separation according to the magnetic properties of the aggregates, where the ferromagnetic particles are captured in the 1st stage in low magnetic field and field gradient, and then the paramagnetic ones are captured in the 2nd stage in high magnetic field and field gradient. It was shown that two-stage magnetic separation system for the mixture of ferromagnetic and paramagnetic particles is possible by utilizing one superconducting solenoidal magnet.
- 13 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 56 (12) , 1-8
Removal of Iron Oxide Scale From Feed-Water in Thermal Power Plant by High-Gradient Magnetic Separation: Scale-Up Effect
In the boiler feed-water system of thermal power plants, iron oxide scale is generated due to the corrosion of piping, which decreases the effectiveness of the heat exchanger in the boiler and contributes to reduced power generation efficiency. Scale removal can prevent this phenomenon, which consequently results in decreased carbon dioxide emission. In a previous study, an iron scale removal system was developed using superconducting magnets, and high-gradient magnetic separation (HGMS) experiments were conducted using the height difference between the inflow and outflow tanks. As a result, particles were intensively captured by the filters at the inflow side. We succeeded in eliminating this capture by properly controlling the applied magnetic field. However, because the suspension also flowed due to the height difference in this experiment, the problems of partial blockage of the filter and the resulting decrease in the flow rate were not resolved even under the controlled magnetic field. In this study, HGMS experiments were conducted under a constant flow rate with a large pump in a large-scale system having a filter diameter of 300 mm to simulate a boiler feed-water system or chemical cleaning line. Furthermore, we investigated the feasibility of the large-scale HGMS system and elucidated the scale-up effect on the amount captured and the spatial distribution of the captured particles on the filters. Based on these results, a plant-scale HGMS system (800 mm filter diameter) was designed.
- 13 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 56 (12) , 1-8
Removal of Iron Oxide Scale From Feed-Water in Thermal Power Plant by High-Gradient Magnetic Separation: Scale-Up Effect
In the boiler feed-water system of thermal power plants, iron oxide scale is generated due to the corrosion of piping, which decreases the effectiveness of the heat exchanger in the boiler and contributes to reduced power generation efficiency. Scale removal can prevent this phenomenon, which consequently results in decreased carbon dioxide emission. In a previous study, an iron scale removal system was developed using superconducting magnets, and high-gradient magnetic separation (HGMS) experiments were conducted using the height difference between the inflow and outflow tanks. As a result, particles were intensively captured by the filters at the inflow side. We succeeded in eliminating this capture by properly controlling the applied magnetic field. However, because the suspension also flowed due to the height difference in this experiment, the problems of partial blockage of the filter and the resulting decrease in the flow rate were not resolved even under the controlled magnetic field. In this study, HGMS experiments were conducted under a constant flow rate with a large pump in a large-scale system having a filter diameter of 300 mm to simulate a boiler feed-water system or chemical cleaning line. Furthermore, we investigated the feasibility of the large-scale HGMS system and elucidated the scale-up effect on the amount captured and the spatial distribution of the captured particles on the filters. Based on these results, a plant-scale HGMS system (800 mm filter diameter) was designed.
- 27 February 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 29 (5) , 1-5
Removal of Iron Scale from Boiler Feed-Water in Thermal Power Plant by Magnetic Separation: Large-Scale Experiment
We have been developing a scale removal system utilizing a superconducting magnet that can remove the iron oxide scale from the boiler feed-water in the thermal power plants. Scale removal can prevent a decrease in the power generation efficiency and contribute to reduce the carbon dioxide emissions. In our previous study, we conducted the large-scale experiments for practical use, but model particles were intensively captured by the inflow side filter. In this research, we succeeded to homogenize the distribution of captured particles in the filter stacks by controlling the applied magnetic field strength. In addition, magnetic field strength dependency of filter blockage was examined in the lab-scale experiments to clarify a detailed mechanism of blockage.
- 27 February 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 29 (5) , 1-5
Removal of Iron Scale from Boiler Feed-Water in Thermal Power Plant by Magnetic Separation: Large-Scale Experiment
We have been developing a scale removal system utilizing a superconducting magnet that can remove the iron oxide scale from the boiler feed-water in the thermal power plants. Scale removal can prevent a decrease in the power generation efficiency and contribute to reduce the carbon dioxide emissions. In our previous study, we conducted the large-scale experiments for practical use, but model particles were intensively captured by the inflow side filter. In this research, we succeeded to homogenize the distribution of captured particles in the filter stacks by controlling the applied magnetic field strength. In addition, magnetic field strength dependency of filter blockage was examined in the lab-scale experiments to clarify a detailed mechanism of blockage.
- Open Access
- 1 January 2017
- Published by Cryogenic Association of Japan in Teion Kogaku (Journal of Cryogenics and Superconductivity Society of Japan)
- Vol. 52 (2) , 98-104
Fundamental Study for Magnetic Drug Delivery System with a Rotating Magnetic Field using Superconducting Magnets
For the medical application of superconducting magnets, we investigated a new magnetic drug delivery system that utilizes a rotating magnetic field. To improve the efficiency of drug treatment, a technique that can accumulate the drug in a targeted area is needed. Recently, utilizing a magnetic field by combining ferromagnetic particles and the drugs (ferromagnetic drugs) and applying the magnetic field has been investigated (i.e., Magnetic Drug Delivery System: MDDS). In conventional MDDS, however, the drug can be accumulated only near the body surface because the magnetic field is applied from outside of the body. This indicates that it is difficult to accumulate the drug to a deep target inside the body. We aim to resolve this problem by means of MDDS utilizing a Rotating Magnetic Field (RMF) with superconducting magnets. With this technique it is possible to accumulate a drug selectively in a targeted area, preventing drug accumulation outside of the target by rotating the magnetic field around the central axis of the targeted area. As a fundamental study, we used multiple electromagnets in order to rotate a magnetic field inside the body by controlling the electric current. As a result, we established a fundamental technique to accumulate ferromagnetic particles (a model ferromagnetic drug) at the central axis of the RMF. The feasibility of the technique to accumulate ferromagnetic drugs selectively deep inside the body using the strong magnetic field of superconducting magnets was proven.
- 1 January 2017
- Published by Cryogenic Association of Japan in Teion Kogaku (Journal of Cryogenics and Superconductivity Society of Japan)
- Vol. 52 (2) , 98-104
Open AccessFundamental Study for Magnetic Drug Delivery System with a Rotating Magnetic Field using Superconducting Magnets
For the medical application of superconducting magnets, we investigated a new magnetic drug delivery system that utilizes a rotating magnetic field. To improve the efficiency of drug treatment, a technique that can accumulate the drug in a targeted area is needed. Recently, utilizing a magnetic field by combining ferromagnetic particles and the drugs (ferromagnetic drugs) and applying the magnetic field has been investigated (i.e., Magnetic Drug Delivery System: MDDS). In conventional MDDS, however, the drug can be accumulated only near the body surface because the magnetic field is applied from outside of the body. This indicates that it is difficult to accumulate the drug to a deep target inside the body. We aim to resolve this problem by means of MDDS utilizing a Rotating Magnetic Field (RMF) with superconducting magnets. With this technique it is possible to accumulate a drug selectively in a targeted area, preventing drug accumulation outside of the target by rotating the magnetic field around the central axis of the targeted area. As a fundamental study, we used multiple electromagnets in order to rotate a magnetic field inside the body by controlling the electric current. As a result, we established a fundamental technique to accumulate ferromagnetic particles (a model ferromagnetic drug) at the central axis of the RMF. The feasibility of the technique to accumulate ferromagnetic drugs selectively deep inside the body using the strong magnetic field of superconducting magnets was proven.