Leah C. Frenette
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Leah C. Frenette has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Todd D. Krauss
University of Rochester
5 shared publications Andrew R. Durney
2 shared publicationsElizabeth C. Hodvedt
2 shared publications- Hitomi Mukaibo
Waseda University
2 shared publications - Adam Creamer
Department of Materials, Department of Bioengineering
1 shared publication André Shamsabadi
Department of Materials, Department of Bioengineering
1 shared publication
Latest Publications
- Open Access
- 20 May 2025
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 10 (6) , 4622-4633
Signal Enhancement in Immunoassays via Coupling to Catalytic Nanoparticles
Early diagnosis is vital for effective disease management, selection of appropriate treatment regimes, and surveillance and control of disease transmission. There is a growing need for point-of-need diagnostic platforms, such as lateral flow immunoassays (LFIAs), to reduce healthcare burdens, particularly in low-resource settings. However, LFIAs often suffer from inadequate sensitivity and exhibit limited dynamic ranges, leading to late-stage diagnosis or misdiagnosis. Here, we present a signal enhancement platform for use in both plate- and paper-based immunoassays, based on the formation of a coupled nanoparticle network. We demonstrate the coupling of an antigen-targeting detection probe with a secondary, catalytically active nanoparticle by utilizing secondary antibody interactions. Here, we show that signal enhancement is achieved through two functional mechanisms: network formation, facilitated by the secondary nanoparticle increasing the relative concentration of nanoparticles immobilized at the test zone; and the inclusion of catalytically active nanoparticles, which catalyze the oxidation of a chromogenic substrate at the test zone. Through this approach, we yielded a 40-fold improvement in the limit of detection (LOD) using 40 nm gold nanoparticle detection probes in spiked pooled human saliva. Further, the signal enhancement platform can be utilized alongside a range of detection probes, including gold nanoparticles, commonly employed for use in LFIAs. This work concludes by showcasing that the signal enhancement mechanism is compatible for use with complex sample matrices, such as human saliva.
- 20 May 2025
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 10 (6) , 4622-4633
Open AccessSignal Enhancement in Immunoassays via Coupling to Catalytic Nanoparticles
Early diagnosis is vital for effective disease management, selection of appropriate treatment regimes, and surveillance and control of disease transmission. There is a growing need for point-of-need diagnostic platforms, such as lateral flow immunoassays (LFIAs), to reduce healthcare burdens, particularly in low-resource settings. However, LFIAs often suffer from inadequate sensitivity and exhibit limited dynamic ranges, leading to late-stage diagnosis or misdiagnosis. Here, we present a signal enhancement platform for use in both plate- and paper-based immunoassays, based on the formation of a coupled nanoparticle network. We demonstrate the coupling of an antigen-targeting detection probe with a secondary, catalytically active nanoparticle by utilizing secondary antibody interactions. Here, we show that signal enhancement is achieved through two functional mechanisms: network formation, facilitated by the secondary nanoparticle increasing the relative concentration of nanoparticles immobilized at the test zone; and the inclusion of catalytically active nanoparticles, which catalyze the oxidation of a chromogenic substrate at the test zone. Through this approach, we yielded a 40-fold improvement in the limit of detection (LOD) using 40 nm gold nanoparticle detection probes in spiked pooled human saliva. Further, the signal enhancement platform can be utilized alongside a range of detection probes, including gold nanoparticles, commonly employed for use in LFIAs. This work concludes by showcasing that the signal enhancement mechanism is compatible for use with complex sample matrices, such as human saliva.
- Top Cited PapersOpen Access
- 27 April 2023
- Published by Wiley in Advanced Materials
- Vol. 36 (10) , e2300184
The Nanozyme Revolution: Enhancing the Performance of Medical Biosensing Platforms
Nanozymes represent a class of nanosized materials that exhibit innate catalytic properties similar to biological enzymes. The unique features of these materials have positioned them as promising candidates for applications in clinical sensing devices, specifically those employed at the point‐of‐care. They notably have found use as a means to amplify signals in nanosensor‐based platforms and thereby improve sensor detection limits. Recent developments in the understanding of the fundamental chemistries underpinning these materials have enabled the development of highly effective nanozymes capable of sensing clinically relevant biomarkers at detection limits that compete with “gold‐standard” techniques. However, there remain considerable hurdles that need to be overcome before these nanozyme‐based sensors can be utilized in a platform ready for clinical use. An overview of the current understandings of nanozymes for disease diagnostics and biosensing applications and the unmet challenges that must be considered prior to their translation in clinical diagnostic tests is provided.
- 27 April 2023
- Published by Wiley in Advanced Materials
- Vol. 36 (10) , e2300184
Top Cited PapersOpen AccessThe Nanozyme Revolution: Enhancing the Performance of Medical Biosensing Platforms
Nanozymes represent a class of nanosized materials that exhibit innate catalytic properties similar to biological enzymes. The unique features of these materials have positioned them as promising candidates for applications in clinical sensing devices, specifically those employed at the point‐of‐care. They notably have found use as a means to amplify signals in nanosensor‐based platforms and thereby improve sensor detection limits. Recent developments in the understanding of the fundamental chemistries underpinning these materials have enabled the development of highly effective nanozymes capable of sensing clinically relevant biomarkers at detection limits that compete with “gold‐standard” techniques. However, there remain considerable hurdles that need to be overcome before these nanozyme‐based sensors can be utilized in a platform ready for clinical use. An overview of the current understandings of nanozymes for disease diagnostics and biosensing applications and the unmet challenges that must be considered prior to their translation in clinical diagnostic tests is provided.
- Open Access
- 9 February 2018
- Published by Springer Nature in Nature Communications
- Vol. 9 (1) , 675
Author Correction: Uncovering active precursors in colloidal quantum dot synthesis
In the original version of this Article, Fig. 3 contained several errors in the chemical structures. This has now been corrected in both the PDF and HTML versions of the Article.
- 9 February 2018
- Published by Springer Nature in Nature Communications
- Vol. 9 (1) , 675
Open AccessAuthor Correction: Uncovering active precursors in colloidal quantum dot synthesis
In the original version of this Article, Fig. 3 contained several errors in the chemical structures. This has now been corrected in both the PDF and HTML versions of the Article.
- Open Access
- 12 December 2017
- Published by Springer Nature in Nature Communications
- Vol. 8 (1) , 2082
Uncovering active precursors in colloidal quantum dot synthesis
Studies of the fundamental physics and chemistry of colloidal semiconductor nanocrystal quantum dots (QDs) have been central to the field for over 30 years. Although the photophysics of QDs has been intensely studied, much less is understood about the underlying chemical reaction mechanism leading to monomer formation and subsequent QD growth. Here we investigate the reaction mechanism behind CdSe QD synthesis, the most widely studied QD system. Remarkably, we find that it is not necessary for chemical precursors used in the most common synthetic methods to directly react to form QD monomers, but rather they can generate in situ the same highly reactive Cd and Se precursors that were used in some of the original II-VI QD syntheses decades ago, i.e., hydrogen chalcogenide gas and alkyl cadmium. Appreciating this surprising finding may allow for directed manipulation of these reactive intermediates, leading to more controlled syntheses with improved reproducibility.
- 12 December 2017
- Published by Springer Nature in Nature Communications
- Vol. 8 (1) , 2082
Open AccessUncovering active precursors in colloidal quantum dot synthesis
Studies of the fundamental physics and chemistry of colloidal semiconductor nanocrystal quantum dots (QDs) have been central to the field for over 30 years. Although the photophysics of QDs has been intensely studied, much less is understood about the underlying chemical reaction mechanism leading to monomer formation and subsequent QD growth. Here we investigate the reaction mechanism behind CdSe QD synthesis, the most widely studied QD system. Remarkably, we find that it is not necessary for chemical precursors used in the most common synthetic methods to directly react to form QD monomers, but rather they can generate in situ the same highly reactive Cd and Se precursors that were used in some of the original II-VI QD syntheses decades ago, i.e., hydrogen chalcogenide gas and alkyl cadmium. Appreciating this surprising finding may allow for directed manipulation of these reactive intermediates, leading to more controlled syntheses with improved reproducibility.
- 23 May 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (22) , 19354
Correction to “Fabrication of Tapered Microtube Arrays and Their Application as a Microalgal Injection Platform”
- 23 May 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (22) , 19354
Correction to “Fabrication of Tapered Microtube Arrays and Their Application as a Microalgal Injection Platform”
- Open Access
- 10 March 2017
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 139 (12) , 4250-4253
General and Efficient C–C Bond Forming Photoredox Catalysis with Semiconductor Quantum Dots
Photoredox catalysis has become an essential tool in organic synthesis because it enables new routes to important molecules. However, the best available molecular catalysts suffer from high catalyst loadings and rely on precious metals. Here we show that colloidal nanocrystal quantum dots (QDs) can serve as efficient and robust, precious-metal free, photoassisted redox catalysts. A single-sized CdSe quantum dot (3.0 ± 0.2 nm) can replace several different dye catalysts needed for five different photoredox reactions (β-alkylation, β-aminoalkylation, dehalogenation, amine arylation, and decarboxylative radical formation). Even without optimization of the QDs or the reaction conditions, efficiencies rivaling those of the best available metal dyes were obtained.
- 10 March 2017
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 139 (12) , 4250-4253
Open AccessGeneral and Efficient C–C Bond Forming Photoredox Catalysis with Semiconductor Quantum Dots
Photoredox catalysis has become an essential tool in organic synthesis because it enables new routes to important molecules. However, the best available molecular catalysts suffer from high catalyst loadings and rely on precious metals. Here we show that colloidal nanocrystal quantum dots (QDs) can serve as efficient and robust, precious-metal free, photoassisted redox catalysts. A single-sized CdSe quantum dot (3.0 ± 0.2 nm) can replace several different dye catalysts needed for five different photoredox reactions (β-alkylation, β-aminoalkylation, dehalogenation, amine arylation, and decarboxylative radical formation). Even without optimization of the QDs or the reaction conditions, efficiencies rivaling those of the best available metal dyes were obtained.
- 8 December 2016
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (50) , 34198-34208
Fabrication of Tapered Microtube Arrays and Their Application as a Microalgal Injection Platform
A template-synthesis method that enables fabrication of tapered microtube arrays is reported. Track-etched poly(ethylene terephthalate) membranes are used as the template, with closed-tipped conical pores having length and the base diameter of 6.27 ± 0.28 μm and 1.21 ± 0.05 μm, respectively. A conductive layer of Pt is deposited by atomic layer deposition (ALD) to enable the successive electrodeposition of Ni. By decreasing the Pt precursor pulse duration from 10 s to 1 s during the ALD step, the heights of the microtubes are controlled from the maximal full length (~6 μm) to only a fraction (1-2 μm) of the template pore. Using a pulsed-current electrodeposition (PCD) method, a smooth and uniform Ni deposit is achieved with a thickness that can be controlled as a function of the PCD cycle. The microtubes’ lumen is confirmed to stay open even after 2000 cycles of Ni PCD. A potential application of the prepared array as a microinjection platform is demonstrated via successful injection of 10 nm-sized CdZnS/ZnS core/shell quantum dots into Chlamydomonas reinhardtii microalgae cells with intact cell walls. The direct delivery method demonstrated in this paper offers novel opportunities for extending the growing interest in array-based microinjection platform to microalgal systems.
- 8 December 2016
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (50) , 34198-34208
Fabrication of Tapered Microtube Arrays and Their Application as a Microalgal Injection Platform
A template-synthesis method that enables fabrication of tapered microtube arrays is reported. Track-etched poly(ethylene terephthalate) membranes are used as the template, with closed-tipped conical pores having length and the base diameter of 6.27 ± 0.28 μm and 1.21 ± 0.05 μm, respectively. A conductive layer of Pt is deposited by atomic layer deposition (ALD) to enable the successive electrodeposition of Ni. By decreasing the Pt precursor pulse duration from 10 s to 1 s during the ALD step, the heights of the microtubes are controlled from the maximal full length (~6 μm) to only a fraction (1-2 μm) of the template pore. Using a pulsed-current electrodeposition (PCD) method, a smooth and uniform Ni deposit is achieved with a thickness that can be controlled as a function of the PCD cycle. The microtubes’ lumen is confirmed to stay open even after 2000 cycles of Ni PCD. A potential application of the prepared array as a microinjection platform is demonstrated via successful injection of 10 nm-sized CdZnS/ZnS core/shell quantum dots into Chlamydomonas reinhardtii microalgae cells with intact cell walls. The direct delivery method demonstrated in this paper offers novel opportunities for extending the growing interest in array-based microinjection platform to microalgal systems.