Dongil Kang
Research Subjects
Dongil Kang has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
S. Scott Goldsborough
Center for Transportation Research, Energy Systems Division Argonne National Laboratory Argonne Illinois USA
4 shared publications- Andre Louis Boehman
Department of Mechanical Engineering, University of Michigan, Ann Arbor, MI, USA
2 shared publications - Angela Violi
Electrical Engineering and Computer Science, University of Michigan, Ann Arbor, USA
2 shared publications Doohyun Kim
2 shared publications- Scott W. Wagnon
Lawrence Livermore National Laboratory
2 shared publications - William J. Pitz
Mat Sci Div, Lawrence Livermore Natl Lab, Livermore, CA 94551 USA
2 shared publications
Latest Publications
- 3 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 456-460
Charge Pump System for Energy Harvesting in Low Voltage and Low Frequency Applications
In this paper, we proposed charge pump system designed specifically for energy harvesting at low voltage and low frequency, focusing on the twistron, a carbon nanotube yarn-based harvester. The whole system is composed of a transformer, a voltage doubler, and the charge pump system. Through simulations, we demonstrate that the charge pump system is capable of generating output voltage from 3.97 V to 4.47 V for the load resistance with 10 kΩ 1 MΩ when the input voltage of the charge pump system is set to 1.03 V. The measured power conversion efficiency (PCE) reaches up to 79%.
- 3 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 456-460
Charge Pump System for Energy Harvesting in Low Voltage and Low Frequency Applications
In this paper, we proposed charge pump system designed specifically for energy harvesting at low voltage and low frequency, focusing on the twistron, a carbon nanotube yarn-based harvester. The whole system is composed of a transformer, a voltage doubler, and the charge pump system. Through simulations, we demonstrate that the charge pump system is capable of generating output voltage from 3.97 V to 4.47 V for the load resistance with 10 kΩ 1 MΩ when the input voltage of the charge pump system is set to 1.03 V. The measured power conversion efficiency (PCE) reaches up to 79%.
- 17 May 2021
- Published by Wiley in International Journal of Chemical Kinetics
- Vol. 53 (8) , 915-938
Oxidation and pyrolysis of methyl propyl ether
The ignition, oxidation, and pyrolysis chemistry of methyl propyl ether (MPE) was probed experimentally at several different conditions, and a comprehensive chemical kinetic model was constructed to help understand the observations, with many of the key parameters computed using quantum chemistry and transition state theory. Experiments were carried out in a shock tube measuring time variation of CO concentrations, in a flow tube measuring product concentrations, and in a rapid compression machine (RCM) measuring ignition delay times. The detailed reaction mechanism was constructed using the Reaction Mechanism Generator software. Sensitivity and flux analyses were used to identify key rate and thermochemical parameters, which were then computed using quantum chemistry to improve the mechanism. Validation of the final model against the 1–20 bar 600–1500 K experimental data is presented with a discussion of the kinetics. The model is in excellent agreement with most of the shock tube and RCM data. Strong non‐monotonic variation in conversion and product distribution is observed in the flow‐tube experiments as the temperature is increased, and unusually strong pressure dependence and significant heat release during the compression stroke is observed in the RCM experiments. These observations are largely explained by a close competition between radical decomposition and addition to at different sites in MPE; this causes small shifts in conditions to lead to big shifts in the dominant reaction pathways. The validated mechanism was used to study the chemistry occurring during ignition in a diesel engine, simulated using Ignition Quality Test (IQT) conditions. At the IQT conditions, where the MPE concentration is higher, bimolecular reactions of peroxy radicals are much more important than in the RCM.
- 17 May 2021
- Published by Wiley in International Journal of Chemical Kinetics
- Vol. 53 (8) , 915-938
Oxidation and pyrolysis of methyl propyl ether
The ignition, oxidation, and pyrolysis chemistry of methyl propyl ether (MPE) was probed experimentally at several different conditions, and a comprehensive chemical kinetic model was constructed to help understand the observations, with many of the key parameters computed using quantum chemistry and transition state theory. Experiments were carried out in a shock tube measuring time variation of CO concentrations, in a flow tube measuring product concentrations, and in a rapid compression machine (RCM) measuring ignition delay times. The detailed reaction mechanism was constructed using the Reaction Mechanism Generator software. Sensitivity and flux analyses were used to identify key rate and thermochemical parameters, which were then computed using quantum chemistry to improve the mechanism. Validation of the final model against the 1–20 bar 600–1500 K experimental data is presented with a discussion of the kinetics. The model is in excellent agreement with most of the shock tube and RCM data. Strong non‐monotonic variation in conversion and product distribution is observed in the flow‐tube experiments as the temperature is increased, and unusually strong pressure dependence and significant heat release during the compression stroke is observed in the RCM experiments. These observations are largely explained by a close competition between radical decomposition and addition to at different sites in MPE; this causes small shifts in conditions to lead to big shifts in the dominant reaction pathways. The validated mechanism was used to study the chemistry occurring during ignition in a diesel engine, simulated using Ignition Quality Test (IQT) conditions. At the IQT conditions, where the MPE concentration is higher, bimolecular reactions of peroxy radicals are much more important than in the RCM.
- 1 January 2021
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 38 (1) , 415-423
An improved detailed chemical kinetic model for C3-C4 linear and iso-alcohols and their blends with gasoline at engine-relevant conditions
- 1 January 2021
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 38 (1) , 415-423
An improved detailed chemical kinetic model for C3-C4 linear and iso-alcohols and their blends with gasoline at engine-relevant conditions
- 1 January 2019
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 37 (4) , 4699-4707
Auto-ignition study of FACE gasoline and its surrogates at advanced IC engine conditions
- 1 January 2019
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 37 (4) , 4699-4707
Auto-ignition study of FACE gasoline and its surrogates at advanced IC engine conditions
- 1 January 2019
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 37 (1) , 603-611
Heat release analysis for rapid compression machines: Challenges and opportunities
- 1 January 2019
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 37 (1) , 603-611
Heat release analysis for rapid compression machines: Challenges and opportunities
- 1 January 2019
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 37 (4) , 4681-4689
The effect of molecular structures of alkylbenzenes on ignition characteristics of binary n-heptane blends
- 1 January 2019
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 37 (4) , 4681-4689
The effect of molecular structures of alkylbenzenes on ignition characteristics of binary n-heptane blends