Krzysztof Dufrene
Research Subjects
Krzysztof Dufrene has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Andreas Gebhard
DMCE, Linz, Austria
2 shared publications - Harald Pretl
Johannes Kepler University, Linz, Austria
2 shared publications - Mario Huemer
Institute of Signal Processing, Johannes Kepler University, Linz, Austria
2 shared publications - Silvester Sadjina
Intel DMCE, Linz, Austria
2 shared publications - Ram Sunil Kanumalli
Intel DMCE, 4040 Linz, Austria
1 shared publication - Robert Weigel
Friedrich-Alexander-Universitt Erlangen-Nrnberg, Erlangen, Germany
1 shared publication
Latest Publications
- Open Access
- 27 August 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (7) , 1229-1233
A Harmonic Rejection Strategy for 25% Duty-Cycle IQ-Mixers Using Digital-to-Time Converters
Due to the use of wide-band analog front-ends in order to cover the many different frequency bands used in Long Term Evolution (LTE), blocker signals received by the antenna may reach the mixer input. As a consequence, squarewave mixer implementations, as e.g. the 25% duty-cycle currentdriven passive mixer, may lead to the down-conversion of these blocker signals by their harmonic response. This contribution describes a harmonic rejection (HR) strategy, which modifies the local oscillator (LO) waveform of a 25% duty-cycle currentdriven passive mixer, to suppress specific harmonics. Two HR control signal waveforms are proposed and their performance is evaluated by circuit simulations using a 28nm CMOS technology. By applying the proposed concept, the down-conversion of a blocker by the mixer’s 3rd order harmonic response can be suppressed by more than 30 dB, and the receiver noise figure (NF) is improved by 21.1 dB for a blocker power of -5dBm at the low-noise amplifier (LNA) input.
- 27 August 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (7) , 1229-1233
Open AccessA Harmonic Rejection Strategy for 25% Duty-Cycle IQ-Mixers Using Digital-to-Time Converters
Due to the use of wide-band analog front-ends in order to cover the many different frequency bands used in Long Term Evolution (LTE), blocker signals received by the antenna may reach the mixer input. As a consequence, squarewave mixer implementations, as e.g. the 25% duty-cycle currentdriven passive mixer, may lead to the down-conversion of these blocker signals by their harmonic response. This contribution describes a harmonic rejection (HR) strategy, which modifies the local oscillator (LO) waveform of a 25% duty-cycle currentdriven passive mixer, to suppress specific harmonics. Two HR control signal waveforms are proposed and their performance is evaluated by circuit simulations using a 28nm CMOS technology. By applying the proposed concept, the down-conversion of a blocker by the mixer’s 3rd order harmonic response can be suppressed by more than 30 dB, and the receiver noise figure (NF) is improved by 21.1 dB for a blocker power of -5dBm at the low-noise amplifier (LNA) input.
- Open Access
- 6 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 65 (11) , 3745-3755
A Mixed-Signal Circuit Technique for Cancellation of Interferers Modulated by LO Phase-Noise in 4G/5G CA Transceivers
In RF transceivers operating in carrier-aggregation, spurs are generated on the transceiver chip which may down-convert any blocker signal located at the spur frequency into the receiver baseband. The blocker signal could either be the transceiver's own transmit signal when operating in frequency-division duplex, or a WiFi-related signal received by the antenna. This so-called modulated spur interference contains the phase-noise (PN) of the involved local oscillator harmonics which created the spur and leads to a degradation of the wanted RX signal. The presented mixed-signal circuit mimics the spur building law including the PN of the harmonics and is, therefore, able to provide a replica of the spur interference including PN modulated components. This replica is then used as a reference signal for the digital cancellation of the main and image modulated spur interference using a widely-linear (WL) cancellation structure. The proposed circuit technique is implemented in 28 nm LP CMOS technology, and measurement results show that the mixed-signal solution outperforms a digital-only WL cancellation with respect to PN cancellation even with high blocker power levels of -15 dBm at the input of the low-noise amplifier.
- 6 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 65 (11) , 3745-3755
Open AccessA Mixed-Signal Circuit Technique for Cancellation of Interferers Modulated by LO Phase-Noise in 4G/5G CA Transceivers
In RF transceivers operating in carrier-aggregation, spurs are generated on the transceiver chip which may down-convert any blocker signal located at the spur frequency into the receiver baseband. The blocker signal could either be the transceiver's own transmit signal when operating in frequency-division duplex, or a WiFi-related signal received by the antenna. This so-called modulated spur interference contains the phase-noise (PN) of the involved local oscillator harmonics which created the spur and leads to a degradation of the wanted RX signal. The presented mixed-signal circuit mimics the spur building law including the PN of the harmonics and is, therefore, able to provide a replica of the spur interference including PN modulated components. This replica is then used as a reference signal for the digital cancellation of the main and image modulated spur interference using a widely-linear (WL) cancellation structure. The proposed circuit technique is implemented in 28 nm LP CMOS technology, and measurement results show that the mixed-signal solution outperforms a digital-only WL cancellation with respect to PN cancellation even with high blocker power levels of -15 dBm at the input of the low-noise amplifier.
- 1 February 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01936530,p. 86-589
A 0.13μm 1.5V CMOS I/Q Downconverter with Digital Adaptive IIP2 Calibration
A low-voltage I/Q downconverter with digital adaptive IIP2 calibration is presented. The system maintains high linearity over time by continuously updating tuning codes in response to varying operating conditions. A prototype is fabricated in a 0.13μm RF CMOS process. At 2GHz LO, it draws 48mA from a 1.5V supply
- 1 February 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01936530,p. 86-589
A 0.13μm 1.5V CMOS I/Q Downconverter with Digital Adaptive IIP2 Calibration
A low-voltage I/Q downconverter with digital adaptive IIP2 calibration is presented. The system maintains high linearity over time by continuously updating tuning codes in response to varying operating conditions. A prototype is fabricated in a 0.13μm RF CMOS process. At 2GHz LO, it draws 48mA from a 1.5V supply