LDLulu Du

Lulu Du

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Lulu Du has a total of 21 co-authors. Here are the top co-authors by number of shared publications:

  • Aimin Song

    Institute of Nanoscience and Applications, Southern University of Science and Technology, Shenzhen, China

    6 shared publications
  • Qian Xin

    School of Integrated Circuits, Shandong University, Jinan, China

    6 shared publications
  • Mingsheng Xu

    School of Integrated Circuits, Shandong Key Laboratory of Next-Generation Semiconductor Technology and Systems, Shandong University 1 , Jinan 250100

    4 shared publications
  • Qingpu Wang

    State Key Laboratory of Crystal Materials, Shandong Technology Center of Nanodevices and Integration, Institute of Novel Semiconductors, Shandong University, Jinan, China

    4 shared publications
  • Yaxuan Liu

    Center of Nanoelectronics, and School of Microelectronics, Shandong University, Jinan 250100, P. R. China and State Key Laboratory of Crystal Materials, Shandong University, Jinan 250100, P. R. China

    3 shared publications
  • Yunpeng Li

    State Grid Information Telecommunication Group Co., Ltd,Beijing,China

    3 shared publications

Latest Publications

  • High-Performance Ga2O3 Diode Based on Tin Oxide Schottky Contact

    by Lulu Du, Qian Xin, Mingsheng Xu, Yaxuan Liu, Wenxiang Mu, Shiqi Yan, Xinyu Wang, Gongming Xin, Zhitai Jia, Xu-Tang Tao, et al.

    A high-performance Schottky diode based on a 600-μm-thick Cr-doped β-Ga2O3 single crystal has been fabricated using SnOx as the Schottky contact. The SnOx film was deposited in argon/oxygen mixture gas to ensure an oxygen-rich stoichiometry in Ga2O3 near the Schottky interface, thus reducing oxygen deficiency related interface state density. The SnOx film included three components: Sn, SnO, and SnO2, as revealed by X-ray photoelectron spectroscopy characterization. The high quality Ga2O3 single crystal grown by an edge-defined film-fed method has a carrier concentration of 1.0 × 1018 cm-3 and an electron mobility of ~90 cm2/Vs. Current density-voltage characteristics of the Schottky diode demonstrated high performance with a large barrier height of 1.19 eV, a close-to-unity ideality factor of 1.02, and a high rectification ratio beyond 1010. Frequency-dependent capacitance and conductance analysis revealed that the maximum active interface state density is 2.46 × 1012 eV-1cm-2 at a frequency of 500 kHz.


  • All-Oxide-Semiconductor-Based Thin-Film Complementary Static Random Access Memory

    by Jin Yang, Yuzhuo Yuan, Yunpeng Li, Lulu Du, Yiming Wang, Zhenjia Hu, Qingpu Wang, Li Zhou, Qian Xin, Aimin Song

    Static random access memory (SRAM) is essential for cache memory. Although oxide semiconductors are ideal candidate materials for next generation flexible electronics, complementary SRAM based on oxide semiconductors has not yet been demonstrated. Here, we reported an SRAM with a traditional 6-transistor structure based on n-type indium gallium zinc oxide and p-type tin monoxide. A cell area of only 130 × 160 μm2 has been achieved, and is the smallest among the reported values of SRAMs based on flexible semiconductors. Both traditional static voltage characteristic and N-curve methods are applied to analyse the noise margin level of the cell. The former method demonstrates a high noise margin of 1.43 V in read at VDD of 8 V, and the latter demonstrates static current and voltage noise margins of 13 μA and 2.05 V, respectively. In addition, the SRAM cell shows rather short writing time of 121 and 82 μs for high and low writing states, respectively. This high performance complementary SRAM based on all oxide semiconductors indicates its high application potential in large-scale flexible electronics for data storage and processing.


  • Ga2O3 Field-Effect-Transistor-Based Solar-Blind Photodetector With Fast Response and High Photo-to-Dark Current Ratio

    by Yaxuan Liu, Lulu Du, Guangda Liang, Wenxiang Mu, Zhitai Jia, Mingsheng Xu, Qian Xin, Xutang Tao, Aimin Song

    A high-performance solar-blind photodetector based on Cr-doped gallium oxide (Ga 2 O 3 ) has been fabricated. A 140-nm-thick Ga 2 O 3 layer was mechanically exfoliated from bulk crystal. The photodetector was based on a field-effect transistor structure, which showed a very high photo-to-dark current ratio larger than 10 6 and excellent current saturation. When the photodetector was tested with a 254-nm ultra-violet light, the ratio of drain current with and without the UV light reached nearly six orders of magnitude. The dark current was as low as 5 pA. Furthermore, the current rise time and decay time were both about 25 ms. High responsivity of ${4.79} \times {10}^{{5}}$ A/W and external quantum efficiency of ${2.34} \times {10}^{{6}}$ also have been achieved at the same time.


  • Oxide-Based Complementary Inverters With High Gain and Nanowatt Power Consumption

    by Yuzhuo Yuan, Jin Yang, Zhenjia Hu, Yunpeng Li, Lulu Du, Yiming Wang, Li Zhou, Qingpu Wang, Aimin Song, Qian Xin

    Oxide semiconductors are ideal candidates for flexible and transparent electronics. Here, we report complementary inverters based on p-type tin monoxide and n-type indium-gallium-zinc-oxide thin-film transistors. The inverters have a gain of 63 at a supply voltage, V DD , of 1.5 V with a maximum static power consumption of 15.6 nW, and a gain of 226 at V DD of 3.0 V with a maximum power consumption of 241.2 nW. A five-stage ring oscillator (RO) based on the complementary inverters is able to operate at 1.04 kHz with full amplitude oscillations at V DD of 1.5 V. All the inverters and RO are fabricated on silicon wafers but at a maximum processing temperature of 225 °C, so that the results are relevant to possible flexible applications. The extremely low power consumption of nanowatt, high gain, kHz operation, and possible flexibility of the fabricated complementary components is well suited to meet the requirements of wearable electronics, Internet of Things technology, and so on.


  • High-Performance Flexible Schottky Diodes Based on Sputtered InGaZnO

    by Lulu Du, Jiawei Zhang, Yunpeng Li, Mingsheng Xu, Qingpu Wang, Aimin Song, Qian Xin

    High-performance flexible InGaZnO-based Schottky diodes are fabricated on polyethylene terephthalate (PET) and polyimide (PI) substrates at room temperature without any thermal treatment. The diode performance improves significantly by either oxygen plasma or UV-ozone treatment on Pd anode. X-ray photoelectron spectroscopy indicates that both treatments lead to Pd surface oxidation. The oxygen plasma treatment results in more complete oxidation, and thus ensures better oxygen stoichiometry at the Schottky interface and a higher anode work function. This leads to high performance with on/off ratios of 7.3 × 10 6 and 2.6 × 10 4 , barrier heights of 0.79 and 0.76 eV, and ideality factors of 1.22 and 1.19 on PET and PI, respectively. Interestingly, these flexible diodes show improved performance after storing in ambient air for two years, and fittings on the reverse currents indicate an improved barrier uniformity. The flexible diode on PET after a two-year storage achieves a high on/off ratio of 2 107, a large barrier height of 0.80 eV, a close to unity ideality factor of 1.09, a high breakdown voltage of -7.5 V, and robust performance upon outward or inward bending, which is, to the best of our knowledge, the highest performance in reported flexible diodes to date.


  • Low-Voltage, Flexible IGZO Transistors Gated by PSSNa Electrolyte

    by Lulu Du, Dandan He, Yaxuan Liu, Mingsheng Xu, Qingpu Wang, Qian Xin, Aimin Song

    A carving, cutting, and flip-chip bonding process is proposed for the fabrication of flexible electric double layer transistors (EDLTs) with low cost. Solution processed poly(styrenesulfonic acid sodium salt) is used as a gate dielectric. The large EDL-specific capacitance ( $4.5~\mu \text{F}$ /cm 2 at 20 Hz) can induce very high charge carrier density in the InGaZnO (IGZO) channel layer, enabling the EDLTs to operate at a single-battery-drivable low voltage of 1.0 V with a high on-current of 10 −4 A. The effect of IGZO layer thickness on the performance of EDLTs was investigated. The flexible EDLT with optimized IGZO thickness of 100 nm has achieved a high on/off ratio of $1.4 \times 10^{7}$ , a low threshold voltage of 0.51 V, a saturated field-effect mobility of 1.14 cm 2 /Vs, and high positive gate bias stress stability. Furthermore, the achieved subthreshold swing, 76 mV/dec, is very close to the theoretical ideal minimum value.