Ali Mohsenatabar Firozjaii
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ali Mohsenatabar Firozjaii has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Ghassem Zargar
Department of Petroleum Engineering, Petroleum University of Technology, Abadan, Iran
2 shared publicationsAli Jalali
Department of Petroleum Engineering, Petroleum University of Technology, Abadan, Iran
1 shared publicationAmin Derakhshan
Department of Petroleum Engineering, Petroleum University of Technology (PUT), Abadan, Iran
1 shared publicationEzatallah Kazemzadeh
Research Institute of Petroleum Industry
1 shared publication- Majid Akbari
Petroleum University of Technology (PUT)
1 shared publication Omid Mosalman Haghighi
Department of Petroleum Engineering, Petroleum University of Technology, Abadan, Iran
1 shared publication
Latest Publications
- 1 October 2019
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 45 (2) , 4282-4292
Experimental investigation on new derived natural surfactant: wettability alteration, IFT reduction, and core flooding in oil wet carbonate reservoir
It is necessary to enhance oil production from reservoir due to increase of the fossil fuel consumption that results of industrial life development. Surfactant flooding is a popular method to enhance oil recovery by IFT reduction and wettability alteration. In this study, a new natural surfactant that extracted from Cordia myxa leaf is used for surfactant flooding. The effect of this natural surfactant on IFT and wettability is investigated experimentally. Then, surfactant flooding is applied in a carbonate core sample. The results show the IFT of solution was reduced from 33/28mN/M at 0 wt% to 16.24 mN/M at 6 wt% by increasing natural surfactant concentration. More than, contact angle was decreased from 137.05° at 0 wt. % to 130.65° at 5.5 wt. %. The core flooding results show C. myxa flooding increased 27% more oil recovery compared to water flooding and reduced residual oil saturation in porous media. The results show C. myxa can be applicable as a green surfactant for enhancing oil recovery.
- 1 October 2019
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 45 (2) , 4282-4292
Experimental investigation on new derived natural surfactant: wettability alteration, IFT reduction, and core flooding in oil wet carbonate reservoir
It is necessary to enhance oil production from reservoir due to increase of the fossil fuel consumption that results of industrial life development. Surfactant flooding is a popular method to enhance oil recovery by IFT reduction and wettability alteration. In this study, a new natural surfactant that extracted from Cordia myxa leaf is used for surfactant flooding. The effect of this natural surfactant on IFT and wettability is investigated experimentally. Then, surfactant flooding is applied in a carbonate core sample. The results show the IFT of solution was reduced from 33/28mN/M at 0 wt% to 16.24 mN/M at 6 wt% by increasing natural surfactant concentration. More than, contact angle was decreased from 137.05° at 0 wt. % to 130.65° at 5.5 wt. %. The core flooding results show C. myxa flooding increased 27% more oil recovery compared to water flooding and reduced residual oil saturation in porous media. The results show C. myxa can be applicable as a green surfactant for enhancing oil recovery.
- Open Access
- 23 July 2019
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 10 (3) , 893-901
An experimental investigation into enhancing oil recovery using combination of new green surfactant with smart water in oil-wet carbonate reservoir
Enhancing oil recovery from oil-wet carbonate oil reservoir is an important challenge in the world, especially in Middle East oil field. Surfactant and smart water can change the interfacial tension and wettability condition of this type of rock to water wet from oil wet. The present study follows the experimental work of the combination of new green surfactant with smart water to enhance oil recovery from a carbonate oil-wet rock. Wettability alternation and IFT reduction by surfactant, smart water and combination of surfactant with smart water were investigated experimentally. The results show that making surfactant solution using smart water can reduce oil saturation by reducing IFT and alter wettability conditions. The oil recovery factor at the end of water, surfactant and surfactant–smart water flooding was 36, 52 and 66%, respectively. It shows that combination of surfactant with smart water can help surfactant to be powerful.
- 23 July 2019
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 10 (3) , 893-901
Open AccessAn experimental investigation into enhancing oil recovery using combination of new green surfactant with smart water in oil-wet carbonate reservoir
Enhancing oil recovery from oil-wet carbonate oil reservoir is an important challenge in the world, especially in Middle East oil field. Surfactant and smart water can change the interfacial tension and wettability condition of this type of rock to water wet from oil wet. The present study follows the experimental work of the combination of new green surfactant with smart water to enhance oil recovery from a carbonate oil-wet rock. Wettability alternation and IFT reduction by surfactant, smart water and combination of surfactant with smart water were investigated experimentally. The results show that making surfactant solution using smart water can reduce oil saturation by reducing IFT and alter wettability conditions. The oil recovery factor at the end of water, surfactant and surfactant–smart water flooding was 36, 52 and 66%, respectively. It shows that combination of surfactant with smart water can help surfactant to be powerful.
- 28 November 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 41 (15) , 1847-1861
Sensitivity analysis and optimization on effective parameters during chemical enhanced oil recovery (CEOR) using experimental design and numerical simulation
Several factors effect on choosing the best enhanced oil recovery process in a hydrocarbon reservoir. In the present study, effective factors on chemical enhanced oil recovery involved in polymer flooding, surfactant flooding, surfactant–polymer flooding, and alkaline–surfactant–polymer flooding are discussed in numerical simulation. The numbers of the simulation runs are estimated based on the number of factors and their maximum and minimum values using experimental design software. Oil recovery factor from reservoir simulation is considered as comparison factor in all of the run cases. The results from one parameter and two interaction factors during each flooding case were analyzed by Tornado and Parto plot. The oil recovery factor also was estimated using statistical analysis using Minitab. The results show that there is a strong correlation between simulation and statistical analysis. Furthermore, the results show that each selected factor has a different effect on oil recovery in each case of chemical flooding. The case study results on two Iranian oil fields at the end of the present study clarified that results of this study can be useful for selecting the best chemical process for oil reservoir based on reservoir properties.
- 28 November 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 41 (15) , 1847-1861
Sensitivity analysis and optimization on effective parameters during chemical enhanced oil recovery (CEOR) using experimental design and numerical simulation
Several factors effect on choosing the best enhanced oil recovery process in a hydrocarbon reservoir. In the present study, effective factors on chemical enhanced oil recovery involved in polymer flooding, surfactant flooding, surfactant–polymer flooding, and alkaline–surfactant–polymer flooding are discussed in numerical simulation. The numbers of the simulation runs are estimated based on the number of factors and their maximum and minimum values using experimental design software. Oil recovery factor from reservoir simulation is considered as comparison factor in all of the run cases. The results from one parameter and two interaction factors during each flooding case were analyzed by Tornado and Parto plot. The oil recovery factor also was estimated using statistical analysis using Minitab. The results show that there is a strong correlation between simulation and statistical analysis. Furthermore, the results show that each selected factor has a different effect on oil recovery in each case of chemical flooding. The case study results on two Iranian oil fields at the end of the present study clarified that results of this study can be useful for selecting the best chemical process for oil reservoir based on reservoir properties.
- Open Access
- 12 October 2018
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 9 (2) , 1485-1494
An investigation into polymer flooding in high temperature and high salinity oil reservoir using acrylamide based cationic co-polymer: experimental and numerical simulation
- 12 October 2018
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 9 (2) , 1485-1494
Open AccessAn investigation into polymer flooding in high temperature and high salinity oil reservoir using acrylamide based cationic co-polymer: experimental and numerical simulation
- 27 August 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 40 (24) , 2974-2985
An investigation into surfactant flooding and alkaline-surfactant-polymer flooding for enhancing oil recovery from carbonate reservoirs: Experimental study and simulation
The main aim of the present work was to study history matching of surfactant flooding using CMG-STARS simulator and experimental results. In the experimental case, the critical micellar concentration of dodecyltrimethylammonium bromide solution is obtained, and the changes in the contact angle are investigated from 1 to 10% weight. Then, after water flooding, surfactant flooding is applied on the critical micellar concentration of dodecyltrimethylammonium bromide. In the simulation case, after history matching of production data, the performance of alkaline-surfactant-polymer flooding using sodium hydroxide, hydrolyzed polyacrylamide, and that surfactant was a prediction. The numerical simulation alkaline-surfactant-polymer flooding increased the oil recovery factor 26% more than surfactant flooding.
- 27 August 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 40 (24) , 2974-2985
An investigation into surfactant flooding and alkaline-surfactant-polymer flooding for enhancing oil recovery from carbonate reservoirs: Experimental study and simulation
The main aim of the present work was to study history matching of surfactant flooding using CMG-STARS simulator and experimental results. In the experimental case, the critical micellar concentration of dodecyltrimethylammonium bromide solution is obtained, and the changes in the contact angle are investigated from 1 to 10% weight. Then, after water flooding, surfactant flooding is applied on the critical micellar concentration of dodecyltrimethylammonium bromide. In the simulation case, after history matching of production data, the performance of alkaline-surfactant-polymer flooding using sodium hydroxide, hydrolyzed polyacrylamide, and that surfactant was a prediction. The numerical simulation alkaline-surfactant-polymer flooding increased the oil recovery factor 26% more than surfactant flooding.