Souheil Nadri
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Souheil Nadri has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Linli Xie
Department of Electrical and Computer Engineering, University of Virginia, Charlottesville, VA, USA
5 shared publications - Robert M. Weikle
Department of Electrical and Computer Engineering, University of Virginia, Charlottesville, VA, USA
5 shared publications - Michael E. Cyberey
Department of Electrical Engineering, The University of Virginia, Charlottesville, USA
2 shared publications - Nicholas Scott Barker
University of Virginia, Charlottesville, VA, USA
2 shared publications - Alexander Arsenovic
Eight Ten Labs LLC
1 shared publication - Alexander Arsenovic
810 Labs LLC, Stanardsville, Virginia United States
1 shared publication
Latest Publications
- 2 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Terahertz Science and Technology
- Vol. 10 (6) , 583-592
Electronic Calibration for Submillimeter-Wave On-Wafer Scattering Parameter Measurements Using Schottky Diodes
A proof-of-concept demonstration of on-wafer electronic calibration in the submillimeter-wave band (325—500 GHz) is presented. A GaAs Schottky diode shunting a coplanar transmission line is employed as an electronic standard that is tuned by bias applied through wafer probes. Error-corrected scattering parameter measurements, based on a Thru-Reflect-Line (TRL) calibration are used to characterize the on-wafer diode and establish it as a standard for electronic calibration. Subsequently, ensembles of measurements from a multiline TRL calibration and the diode calibration standard are performed and compared to assess the uncertainty associated with the two approaches. It is found that the error coefficients estimated using the electronic standard are in good agreement with those found from the multiline TRL calibration. Moreover, the electronic standard exhibits a significant reduction in uncertainty compared with the TRL standards, consistent with previous work showing that error in probe placement between measurements was a principle source of uncertainty for TRL-based calibration.
- 2 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Terahertz Science and Technology
- Vol. 10 (6) , 583-592
Electronic Calibration for Submillimeter-Wave On-Wafer Scattering Parameter Measurements Using Schottky Diodes
A proof-of-concept demonstration of on-wafer electronic calibration in the submillimeter-wave band (325—500 GHz) is presented. A GaAs Schottky diode shunting a coplanar transmission line is employed as an electronic standard that is tuned by bias applied through wafer probes. Error-corrected scattering parameter measurements, based on a Thru-Reflect-Line (TRL) calibration are used to characterize the on-wafer diode and establish it as a standard for electronic calibration. Subsequently, ensembles of measurements from a multiline TRL calibration and the diode calibration standard are performed and compared to assess the uncertainty associated with the two approaches. It is found that the error coefficients estimated using the electronic standard are in good agreement with those found from the multiline TRL calibration. Moreover, the electronic standard exhibits a significant reduction in uncertainty compared with the TRL standards, consistent with previous work showing that error in probe placement between measurements was a principle source of uncertainty for TRL-based calibration.
- 7 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 29 (7) , 474-476
Measurement and Extraction of Parasitic Parameters of Quasi-Vertical Schottky Diodes at Submillimeter Wavelengths
This letter reports on a method for extracting parasitic equivalent-circuit model parameters at submillimeter-wave frequencies. The devices investigated are quasi-vertical gallium arsenide Schottky diodes integrated on silicon. The technique utilizes measurements of coplanar waveguide-fed passive structures in the WR-2.2 band (325-500 GHz), which are fabricated on the same wafer as the diodes. These structures consist of short- and open-circuited terminations that allow direct measurement of the parasitic circuit elements associated with the device. The values of the parasitic elements obtained using this method are in agreement with the values reported in the literature for diodes of comparable geometry.
- 7 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 29 (7) , 474-476
Measurement and Extraction of Parasitic Parameters of Quasi-Vertical Schottky Diodes at Submillimeter Wavelengths
This letter reports on a method for extracting parasitic equivalent-circuit model parameters at submillimeter-wave frequencies. The devices investigated are quasi-vertical gallium arsenide Schottky diodes integrated on silicon. The technique utilizes measurements of coplanar waveguide-fed passive structures in the WR-2.2 band (325-500 GHz), which are fabricated on the same wafer as the diodes. These structures consist of short- and open-circuited terminations that allow direct measurement of the parasitic circuit elements associated with the device. The values of the parasitic elements obtained using this method are in agreement with the values reported in the literature for diodes of comparable geometry.
- 28 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (1) , 349-356
Thermal Characterization of Quasi-Vertical GaAs Schottky Diodes Integrated on Silicon
- 28 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (1) , 349-356
Thermal Characterization of Quasi-Vertical GaAs Schottky Diodes Integrated on Silicon
- 1 January 2018
- Published by Optica Publishing Group
- p. SM2I.1
High-performance InGaAs/InP photodiodes on silicon using low-temperature wafer-bonding
We demonstrate back-illuminated III-V modified uni-traveling carrier photodiodes on silicon using SU-8 as the bonding layer. Responsivity at 1620nm, bandwidth, output RF power and OIP3 are 0.8A/W, 18GHz, 4dBm and 22.5dBm at 9GHz, respectively.
- 1 January 2018
- Published by Optica Publishing Group
- p. SM2I.1
High-performance InGaAs/InP photodiodes on silicon using low-temperature wafer-bonding
We demonstrate back-illuminated III-V modified uni-traveling carrier photodiodes on silicon using SU-8 as the bonding layer. Responsivity at 1620nm, bandwidth, output RF power and OIP3 are 0.8A/W, 18GHz, 4dBm and 22.5dBm at 9GHz, respectively.
- 11 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
An Integrated 100-element schottky varactor diode array for sideband generation at 1.6 THz
This work describes the development and implementation of a Schottky varactor diode array for sideband generation at 1.6 THz. The array integrates 100 planar diodes into an array of bowtie antennas to act as a tunable phase-shifter for reflected submillimeter-wave radiation. Measurements performed to characterize the array indicate that 20° of phase shift is achieved as the diode bias voltage is swept between 0.3 and -4 Volts, yielding an estimated sideband conversion loss of 26 dB.
- 11 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
An Integrated 100-element schottky varactor diode array for sideband generation at 1.6 THz
This work describes the development and implementation of a Schottky varactor diode array for sideband generation at 1.6 THz. The array integrates 100 planar diodes into an array of bowtie antennas to act as a tunable phase-shifter for reflected submillimeter-wave radiation. Measurements performed to characterize the array indicate that 20° of phase shift is achieved as the diode bias voltage is swept between 0.3 and -4 Volts, yielding an estimated sideband conversion loss of 26 dB.