Electronic Calibration for Submillimeter-Wave On-Wafer Scattering Parameter Measurements Using Schottky Diodes
- 2 July 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Terahertz Science and Technology
- Vol. 10 (6) , 583-592
Abstract
A proof-of-concept demonstration of on-wafer electronic calibration in the submillimeter-wave band (325—500 GHz) is presented. A GaAs Schottky diode shunting a coplanar transmission line is employed as an electronic standard that is tuned by bias applied through wafer probes. Error-corrected scattering parameter measurements, based on a Thru-Reflect-Line (TRL) calibration are used to characterize the on-wafer diode and establish it as a standard for electronic calibration. Subsequently, ensembles of measurements from a multiline TRL calibration and the diode calibration standard are performed and compared to assess the uncertainty associated with the two approaches. It is found that the error coefficients estimated using the electronic standard are in good agreement with those found from the multiline TRL calibration. Moreover, the electronic standard exhibits a significant reduction in uncertainty compared with the TRL standards, consistent with previous work showing that error in probe placement between measurements was a principle source of uncertainty for TRL-based calibration.Keywords
Funding Information
- National Ground Intelligence Center (W911W5-16-C-0007)
- Air Force Office of Scientific Research (FA864920P0943)
- National Science Foundation (ECCS-1609411)
- IEEE Instrumentation and Measurement Society Graduate Fellowship Award
This publication has 27 references indexed in Scilit:
- An Epitaxy Transfer Process for Heterogeneous Integration of Submillimeter-Wave GaAs Schottky Diodes on Silicon Using SU-8IEEE Electron Device Letters, 2017
- Design and Characterization of Integrated Submillimeter-Wave Quasi-Vertical Schottky DiodesIEEE Transactions on Terahertz Science and Technology, 2014
- 160 GHz Balanced Frequency Quadruplers Based on Quasi-Vertical Schottky Varactors Integrated on Micromachined SiliconIEEE Transactions on Terahertz Science and Technology, 2014
- Improved Micromachined Terahertz On-Wafer Probe Using Integrated Strain SensorIEEE Transactions on Microwave Theory and Techniques, 2013
- Repeatability and Mismatch of Waveguide Flanges in the 500–750 GHz BandIEEE Transactions on Terahertz Science and Technology, 2013
- An Experimental Technique for Calibration Uncertainty AnalysisIEEE Transactions on Microwave Theory and Techniques, 2012
- Handbook of Microwave Component Measurements2012
- Terahertz Micromachined On-Wafer Probes: Repeatability and ReliabilityIEEE Transactions on Microwave Theory and Techniques, 2012
- Micromachined Probes for Submillimeter-Wave On-Wafer Measurements—Part II: RF Design and CharacterizationIEEE Transactions on Terahertz Science and Technology, 2011
- Micromachined Probes for Submillimeter-Wave On-Wafer Measurements—Part I: Mechanical Design and CharacterizationIEEE Transactions on Terahertz Science and Technology, 2011