Weiyue Zhou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Weiyue Zhou has a total of 97 co-authors. Here are the top co-authors by number of shared publications:
- Michael Philip Short
Department of Nuclear Science and Engineering, Massachusetts Institute of Technology, Cambridge, USA
19 shared publications - Kevin Benjamin Woller
Massachusetts Institute of Technology
14 shared publications - Guiqiu Zheng
Nuclear Reactor Laboratory, Massachusetts Institute of Technology, Cambridge, MA, USA
5 shared publications - Minyi Zhang
Department of Materials University of Oxford Parks Road OX1 3PH Oxford United Kingdom
5 shared publications - Rémi Delaporte-Mathurin
Plasma Science and Fusion Center Massachusetts Institute of Technology 02139 Cambridge MA USA
4 shared publications - Andrew M. Minor
University of California Berkeley
3 shared publications
Latest Publications
- 7 October 2026
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 634
Proton irradiation–induced morphological evolution of corrosion in molten fluoride salts
- 7 October 2026
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 634
Proton irradiation–induced morphological evolution of corrosion in molten fluoride salts
- Open Access
- 1 August 2026
- Published by Elsevier in SSRN Electronic Journal
Oxygen Transport Pathways and Oxidation-Induced Microstructural Degradation of T91 Steel in Lead–Bismuth Eutectic
This study investigates the corrosion behaviour of T91 steel in static lead–bismuth eutectic (LBE) at 700 °C for 245 h under controlled oxidising conditions, with emphasis on nanoscale microstructural evolution and oxygen transport mechanisms. A combination of transmission Kikuchi diffraction (TKD), scanning/transmission electron microscopy (STEM/TEM), and atom probe tomography (APT) was employed to elucidate the corrosion mechanisms. The results show that corrosion is dominated by preferential grain boundary (GB) oxidation rather than dissolution-controlled processes typical of reducing environments. The oxidised grain boundaries (GBs) are decorated with Cr-rich oxides, which induce significant local Cr depletion and thus facilitate a ferrite phase transformation in the adjacent matrix. A Si-rich oxide layer is further observed at the outer edge of the oxidised GBs. A distinct multi-layered microstructural evolution was identified, comprising a fine recrystallised near-surface region, an intermediate coarsened recrystallised zone, and a transition region retaining lath martensite features. Intragranular oxidation, together with Cr- and Si-enriched oxide particles, indicates that oxygen penetrates beyond GBs. VN precipitates and dislocation structures were also found to act as additional fast diffusion pathways, facilitating local oxidation. Combined, these observations show that oxidation in T91 is governed by a hierarchical network of diffusion paths that accelerates oxygen ingress, microstructural degradation, and recrystallisation. GB oxidation propagates into the grain interior, causing Cr depletion and microstructural degradation, which may facilitate the continued advance of the LBE corrosion front.
- 1 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessOxygen Transport Pathways and Oxidation-Induced Microstructural Degradation of T91 Steel in Lead–Bismuth Eutectic
This study investigates the corrosion behaviour of T91 steel in static lead–bismuth eutectic (LBE) at 700 °C for 245 h under controlled oxidising conditions, with emphasis on nanoscale microstructural evolution and oxygen transport mechanisms. A combination of transmission Kikuchi diffraction (TKD), scanning/transmission electron microscopy (STEM/TEM), and atom probe tomography (APT) was employed to elucidate the corrosion mechanisms. The results show that corrosion is dominated by preferential grain boundary (GB) oxidation rather than dissolution-controlled processes typical of reducing environments. The oxidised grain boundaries (GBs) are decorated with Cr-rich oxides, which induce significant local Cr depletion and thus facilitate a ferrite phase transformation in the adjacent matrix. A Si-rich oxide layer is further observed at the outer edge of the oxidised GBs. A distinct multi-layered microstructural evolution was identified, comprising a fine recrystallised near-surface region, an intermediate coarsened recrystallised zone, and a transition region retaining lath martensite features. Intragranular oxidation, together with Cr- and Si-enriched oxide particles, indicates that oxygen penetrates beyond GBs. VN precipitates and dislocation structures were also found to act as additional fast diffusion pathways, facilitating local oxidation. Combined, these observations show that oxidation in T91 is governed by a hierarchical network of diffusion paths that accelerates oxygen ingress, microstructural degradation, and recrystallisation. GB oxidation propagates into the grain interior, causing Cr depletion and microstructural degradation, which may facilitate the continued advance of the LBE corrosion front.
- 18 July 2026
- Published by Elsevier in Acta Materialia
- Vol. 318
Controlling the dealloying morphology of Fe-36Ni alloy exposed to liquid Pb using temperature and in situ proton irradiation
- 18 July 2026
- Published by Elsevier in Acta Materialia
- Vol. 318
Controlling the dealloying morphology of Fe-36Ni alloy exposed to liquid Pb using temperature and in situ proton irradiation
- Open Access
- 28 May 2026
- Published by Elsevier in SSRN Electronic Journal
Quantifying Multidimensional Transport Effects on Permeability Inference in FLiBe Systems Using a Validation-Informed Modeling Framework
Hydrogen isotope permeability in molten salts is commonly inferred from permeation experiments using one-dimensional interpretations, which may not capture the coupled transport pathways in realistic systems. In this work, a multidimensional, multi-material transport modeling framework implemented in FESTIM is applied to permeation measurements from the HYPERION experiment over 773K to 973K. The model resolves hydrogen isotope transport across molten salt, nickel structures, and external boundaries, with two limiting boundary conditions (ideal coating and uncoated conditions) bracketing the possible hydrogen exchange with the environment. A validation-informed inverse framework is used to infer the FLiBe permeability by matching simulated and measured steady-state permeation fluxes. The model reproduces the measured fluxes under both boundary-condition limits while revealing significant lateral transport and sidewall leakage pathways absent from one-dimensional interpretations. The inferred FLiBe permeability follows Arrhenius behavior but spans more than an order of magnitude across boundary-condition limits, demonstrating that one-dimensional formulations cannot reliably extract permeability from coupled-system permeation experiments. These results provide a physically grounded basis for interpreting permeation measurements and highlight the importance of multidimensional transport modeling for property inference in fusion-relevant molten-salt systems.
- 28 May 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessQuantifying Multidimensional Transport Effects on Permeability Inference in FLiBe Systems Using a Validation-Informed Modeling Framework
Hydrogen isotope permeability in molten salts is commonly inferred from permeation experiments using one-dimensional interpretations, which may not capture the coupled transport pathways in realistic systems. In this work, a multidimensional, multi-material transport modeling framework implemented in FESTIM is applied to permeation measurements from the HYPERION experiment over 773K to 973K. The model resolves hydrogen isotope transport across molten salt, nickel structures, and external boundaries, with two limiting boundary conditions (ideal coating and uncoated conditions) bracketing the possible hydrogen exchange with the environment. A validation-informed inverse framework is used to infer the FLiBe permeability by matching simulated and measured steady-state permeation fluxes. The model reproduces the measured fluxes under both boundary-condition limits while revealing significant lateral transport and sidewall leakage pathways absent from one-dimensional interpretations. The inferred FLiBe permeability follows Arrhenius behavior but spans more than an order of magnitude across boundary-condition limits, demonstrating that one-dimensional formulations cannot reliably extract permeability from coupled-system permeation experiments. These results provide a physically grounded basis for interpreting permeation measurements and highlight the importance of multidimensional transport modeling for property inference in fusion-relevant molten-salt systems.
- Open Access
- 18 May 2026
- Published by IOP Publishing in Nuclear Fusion
- Vol. 66 (7)
BABY 1L: First tritium breeding campaign results
Achieving tritium self-sufficiency is a critical challenge for future fusion power plants. The BABY 1L experiment, part of the LIBRA project at MIT, aims to benchmark tritium breeding and release in molten salt breeder systems under deuterium-tritium (DT) neutron irradiation. Building on the initial \SI{100}{mL} campaign, BABY 1L introduces a tenfold increase in breeder volume, improved thermal and gas handling systems, and enhanced neutron diagnostics, including a proton recoil telescope. We report on results from four irradiation experiments using sealed-tube DT neutron generators, with tritium collected by water bubblers measured via liquid scintillation counting. Experimentally determined Tritium Breeding Ratios (TBRs) were compared to OpenMC neutronics simulations, showing very good agreement. The measured TBR values demonstrate a six-fold improvement over the \SI{100}{mL} experiments, largely attributed to the increased solid angle and improved measurement fidelity. We also investigate tritium release dynamics and identify diffusion-limited transport as the dominant regime in the salt volume in the temperature range 630-750 \si{\celsius}. Additionally, we observe that the introduction of hydrogen in the helium carrier gas significantly accelerates tritium release, consistent with an isotopic exchange mechanism. All analysis is conducted through the open-source \texttt{libra-toolbox} \cite{libra-toolbox}, which streamlines simulation, data processing, and validation across experimental campaigns. These results provide critical insights into the design and operation of future liquid breeder systems and demonstrate the maturity of the BABY platform as a testbed for tritium breeding studies.
- 18 May 2026
- Published by IOP Publishing in Nuclear Fusion
- Vol. 66 (7)
Open AccessBABY 1L: First tritium breeding campaign results
Achieving tritium self-sufficiency is a critical challenge for future fusion power plants. The BABY 1L experiment, part of the LIBRA project at MIT, aims to benchmark tritium breeding and release in molten salt breeder systems under deuterium-tritium (DT) neutron irradiation. Building on the initial \SI{100}{mL} campaign, BABY 1L introduces a tenfold increase in breeder volume, improved thermal and gas handling systems, and enhanced neutron diagnostics, including a proton recoil telescope. We report on results from four irradiation experiments using sealed-tube DT neutron generators, with tritium collected by water bubblers measured via liquid scintillation counting. Experimentally determined Tritium Breeding Ratios (TBRs) were compared to OpenMC neutronics simulations, showing very good agreement. The measured TBR values demonstrate a six-fold improvement over the \SI{100}{mL} experiments, largely attributed to the increased solid angle and improved measurement fidelity. We also investigate tritium release dynamics and identify diffusion-limited transport as the dominant regime in the salt volume in the temperature range 630-750 \si{\celsius}. Additionally, we observe that the introduction of hydrogen in the helium carrier gas significantly accelerates tritium release, consistent with an isotopic exchange mechanism. All analysis is conducted through the open-source \texttt{libra-toolbox} \cite{libra-toolbox}, which streamlines simulation, data processing, and validation across experimental campaigns. These results provide critical insights into the design and operation of future liquid breeder systems and demonstrate the maturity of the BABY platform as a testbed for tritium breeding studies.
- Open Access
- 30 March 2026
- Published by Elsevier in SSRN Electronic Journal
Corrosion Evolution of T91 Steel in Static Lead-Bismuth Eutectic Under an Oxidising Environment
Understanding corrosion in liquid metal-cooled nuclear systems is essential in order be able to control it. While much literature exists detailing corrosion rates and mechanisms of structural materials in liquid metals, much still remains to be discovered in new regimes of temperature, chemistry, and impurity content. We focus on a less-studied set of conditions, specifically to investigate how liquid lead-bismuth eutectic (LBE) corrodes ferritic/martensitic steels under high-temperature oxidizing conditions. We find that corrosion follows grain boundaries, transitioning from intergranular attack to broader area corrosion as it progresses. Both chromium and oxygen diffusion play vital roles in this process. Mechanistically speaking, the ingress of LBE induces regions of martensite decomposition to ferrite via localized chromium depletion, somewhat slowing corrosion. A stable, coherent oxide scale appears to be the deciding factor that controls whether intergranular LBE attack occurs or not. Most surprisingly, a layer of iron enriched body-centred cubic phase forms on the surface of LBE-corroded T91 at these conditions, contradicting previous studies, which reported only oxide-based surface layers.
- 30 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessCorrosion Evolution of T91 Steel in Static Lead-Bismuth Eutectic Under an Oxidising Environment
Understanding corrosion in liquid metal-cooled nuclear systems is essential in order be able to control it. While much literature exists detailing corrosion rates and mechanisms of structural materials in liquid metals, much still remains to be discovered in new regimes of temperature, chemistry, and impurity content. We focus on a less-studied set of conditions, specifically to investigate how liquid lead-bismuth eutectic (LBE) corrodes ferritic/martensitic steels under high-temperature oxidizing conditions. We find that corrosion follows grain boundaries, transitioning from intergranular attack to broader area corrosion as it progresses. Both chromium and oxygen diffusion play vital roles in this process. Mechanistically speaking, the ingress of LBE induces regions of martensite decomposition to ferrite via localized chromium depletion, somewhat slowing corrosion. A stable, coherent oxide scale appears to be the deciding factor that controls whether intergranular LBE attack occurs or not. Most surprisingly, a layer of iron enriched body-centred cubic phase forms on the surface of LBE-corroded T91 at these conditions, contradicting previous studies, which reported only oxide-based surface layers.
- 27 March 2026
- Published by Elsevier in Corrosion Science
- Vol. 266
Cationic impurity deposition-decelerated corrosion of NiCr alloys in molten fluoride salts
- 27 March 2026
- Published by Elsevier in Corrosion Science
- Vol. 266
Cationic impurity deposition-decelerated corrosion of NiCr alloys in molten fluoride salts
- 20 February 2026
- Published by Elsevier in Corrosion Science
- Vol. 263
In situ proton irradiation-induced delocalization of corrosion in Fe-based alloys exposed to liquid Pb-4Bi at 675 °C
- 20 February 2026
- Published by Elsevier in Corrosion Science
- Vol. 263
In situ proton irradiation-induced delocalization of corrosion in Fe-based alloys exposed to liquid Pb-4Bi at 675 °C
- Open Access
- 1 December 2025
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 45
Improving accuracy in fluoride salt composition analysis: A focus on sample preparation for ICP-MS
- 1 December 2025
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 45
Open AccessImproving accuracy in fluoride salt composition analysis: A focus on sample preparation for ICP-MS