EIEugene N. Ivanov

Eugene N. Ivanov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Eugene N. Ivanov has a total of 52 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    The study of thermal fluctuations in microwave and mechanical resonators

    by Michael T. Hatzon, Eugene N. Ivanov, Aaron Quiskamp, Michael E. Tobar

    We report high-resolution measurements of thermal fluctuations in microwave and mechanical resonators using a dual-channel readout system. The latter comprises a low-noise amplifier, an I/Q-mixer, and a cross-correlator. We discovered that, under certain conditions, the intrinsic fluctuations of the low-noise amplifier, which are common to both channels of the readout system, are averaged out when computing the voltage noise cross-spectrum between the mixer's outputs. The suppression of the amplifier's technical fluctuations significantly improves the contrast of the thermal noise peaks exhibited by the resonators. Thus, for the room-temperature-stabilized 9 GHz sapphire-loaded cavity resonator, we observed more than 16 dB improvement in the thermal noise peak contrast relative to the single-channel measurements. The ability of the dual-channel readout system to discriminate between the broad- and narrow-band fluctuations may benefit the search for dark matter, which relies on the use of cryogenic microwave resonators.

  • Microwave Oscillator Based on Two Optimally Tuned YIG Filters

    by Robert C. Crew, Eugene N. Ivanov, Graeme Flower, Michael E. Tobar, Maxim Goryachev

    We report a novel X-band loop oscillator, whose resonator is formed from two optimally tuned commercial yttrium iron garnet (YIG) filters. We call this a $\Lambda $ -resonator, owing to the characteristic $\Lambda $ -shape of its amplitude transfer function (ATF). At offset frequencies greater than 70 Hz, oscillator phase noise is limited by the contribution from the amplifier, as described by Leeson’s model. The effective Q-factor of the $\Lambda $ -resonator (2.6×103) is determined by the slope of its phase transfer function on resonance, which is directly proportional to the group delay of the filters. With off-the-shelf components, we achieve single-sideband (SSB) phase noise of −151 dBc/Hz at 1 MHz offset for an oscillation frequency of 9.2 GHz. This work points to the potential for improvements with custom built filters optimized for high group delay. The high selectivity of the $\Lambda $ -resonator (made of two seventh-order YIG-filters) allowed a strong suppression of both phase and amplitude fluctuations of the transmitted signal at Fourier frequencies outside the resonator’s bandwidth. We also investigated relevant oscillator noise sources, including power-to-frequency conversion as a function of Fourier frequency, and use a novel, highly sensitive technique to characterize the noise.

  • Open Access

    Near-quantum-limited axion dark matter search with the ORGAN experiment around 26  μeV

    by Aaron P. Quiskamp, Graeme R. Flower, Steven Samuels, Ben T. McAllister, Paul Altin, Eugene N. Ivanov, Maxim Goryachev, Michael E. Tobar

    The latest result from the ORGAN experiment, an axion haloscope, is presented. This iteration of the experiment operated at millikelvin temperatures using a flux-driven Josephson parametric amplifier for reduced noise, along with various other improvements over previous iterations. Covering the 25.45 − 26.27 μ eV (6.15–6.35 GHz) mass (frequency) range, this near-quantum-limited phase of ORGAN employs a conducting rod resonator and a 7-T solenoidal magnet to place the most sensitive exclusion limits on axion-photon coupling in the range to date, with | g a γ γ | ≳ 2.8 × 10 − 13 at a 95% confidence level.


  • Microwave Armstrong Amplitude Modulator

    by Eugene N. Ivanov

    We describe a microwave amplitude modulator capable of operating at high modulation rates (limited by mixer IF port bandwidth) with minimal residual phase modulation. The modulator is based on Armstrong’s idea to produce any modulated signal by varying the phase shift between the carrier and modulation sidebands. We conducted our experiments at 11 GHz. The frequency of the modulation signal was below 1 MHz to measure the residual phase modulation with the digital phase detector (DPD). We showed that the phase noise of the microwave pilot signal was the main factor limiting the minimal detectable level of the residual phase modulation.


  • Open Access

    Upconversion of phonon modes into microwave photons in a lithium niobate bulk acoustic wave resonator coupled to a microwave cavity

    by S. Parashar, W. M. Campbell, J. Bourhill, E. Ivanov, M. Goryachev, M. E. Tobar

    The coupling between acoustic vibrations in a lithium niobate bulk acoustic wave resonator and microwave photons of a re-entrant microwave cavity was investigated at a temperature close to 4 K. Coupling was achieved by placing the acoustic resonator in the location of the re-entrant cavity electric field maxima in a symmetric “split-post” configuration with a large overlap between the microwave field and the acoustic mode, allowing acoustic modulations of the microwave frequency. We show that the acoustic modes in this setup retain large inherent quality factors of greater than 106. A maximum optomechanical coupling rate was determined to be g0 = 0.014 mHz, four orders of magnitude larger than previous results obtained using a quartz BAW at 4 K in a similar experimental setup but using a single post-re-entrant cavity resonator.


  • Microwave-cavity-mode optimization by background antiresonance tuning

    by Michael T. Hatzon, Eugene N. Ivanov, Jeremy F. Bourhill, Maxim Goryachev, Michael E. Tobar

    To derive the best oscillator phase noise when implementing a high-Q resonator, the resonant spectral line shape must have high contrast and symmetry. Ideally, this line shape is second order and Lorentzian; however, in a high-mode-density spectral region, low-Q background spurious modes interact and distort the resonance. For a sapphire-loaded cavity resonator operating with whispering-gallery modes confined within the sapphire crystal, we show that this high contrast and symmetry can be achieved by meticulously changing the dimensions of the surrounding metallic cavity shield to tune the background low-Q structures into antiresonance. This works because the high-Q resonances are primarily defined by the sapphire, while the background modes are defined by the cavity shield. Alternatively, it has been shown that a similar result can be achieved by exciting the high-Q resonator with a balanced microwave dipole probe in a Mach-Zehnder interferometric configuration. The probe has been constructed from two separate coaxial electric field probes symmetrically inserted into a cylindrical-cavity resonator, from opposite sides with a small gap between them, so they can behave like an active wire-dipole antenna. The power into the two separate probes may be matched with an external variable attenuator in one of the arms of the interferometer. Conversely, the phase between the two electric field probes may be changed with an external variable phase shifter, which changes the nature of the field components to which the probe couples. The probe couples to the high-Q resonant modes as well as low-Q background modes, which can be made resonant or antiresonant with respect to the high-Q modes by changing this external phase. When the background modes are in antiresonance, the line shape of the high-Q mode can be made symmetric and with higher contrast. This technique has been applied to both whispering-gallery sapphire modes, as well as hollow-cavity resonators, without changing the dimensions of the cavity.


  • Open Access

    Power-to-Frequency Conversion in Cryogenic Sapphire Resonators

    by Eugene Ivanov, Michael Tobar

    We studied how the cryogenic sapphire resonator responds to fast variations of the dissipated microwave power. The experiments were carried out with sapphire resonators cooled to 6 K at frequencies around 11 GHz. We found that the power-to-frequency conversion of the resonator depends on Fourier frequency as the transfer function of the 1st-order low-pass filter with corner frequency close to the resonator loaded half-bandwidth. Having measured the power-to-frequency conversion of the cryogenic sapphire resonator, we predicted the phase noise of the microwave oscillator based on such resonator.

  • Open Access

    Noise Suppression with Cryogenic Resonators

    by Eugene N. Ivanov, Michael E. Tobar

    We show that fast technical fluctuations of microwave signals can be strongly suppressed by cryogenic resonators. The experiments were carried out with sapphire resonators cooled to approximately 6 K at frequencies around 11 GHz. Each sapphire crystal was shaped like a spindle with the rotational and crystal axes aligned within a degree. Noise suppression factors in excess of 50 dB were measured at 10 kHz offset from the carrier. This was achieved by rotating the sapphire spindle and moving the coupling probes relative to its surface. Microwave signals with reduced fast technical fluctuations allow the high-precision tests of fundamental physics, as well as the development of better radars.

  • Open Access

    Frequency Stable Microwave Sapphire Oscillators

    by Eugene N. Ivanov, Michael E. Tobar

    We show that state-of-the-art phase noise and high frequency stability could be simultaneously achieved in a microwave oscillator based on the sapphire-loaded cavity resonator. The 9 GHz sapphire oscillator was constructed with the SSB phase noise close to -170 dBc/Hz at an offset frequency of 10 kHz and fractional frequency instability less than 2 10$^{-13}$ for integration times from 5 to 50 s. In this work, we focus on the technique for phase-referencing the microwave sapphire oscillator to a stable radio-frequency source. We also discuss the suppression of the fast phase fluctuations of the microwave signal due to its transmission through the high-Q resonator.

  • Frequency Stable Microwave Sapphire Oscillators

    by Eugene N. Ivanov, Michael E. Tobar

    We show that state-of-the-art phase noise and high frequency stability could be simultaneously achieved in a microwave oscillator based on the sapphire-loaded cavity resonator. Two 9 GHz sapphire oscillators were constructed with the single-sideband (SSB) phase noise close to $-$ 170 dBc/Hz at an offset frequency of 10 kHz and fractional frequency instability less than 2 10 $^{-13}$ for integration times from 5 to 50 s. This work describes the technique for phase-referencing the microwave sapphire oscillator to a stable radio frequency source. We also discuss the suppression of the fast phase fluctuations of the microwave signal due to its transmission through the high- $Q$ resonator.