Gwo-Ching Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Gwo-Ching Wang has a total of 187 co-authors. Here are the top co-authors by number of shared publications:
T.-M. Lu
Department of Physics, Applied Physics and Astronomy, Rensselaer Polytechnic Institute , 110, 8th Street, Troy, New York 12180, USA
21 shared publicationsToh-Ming Lu
18 shared publications- Yiping Zhao
The University of Georgia
13 shared publications - Jian Shi
Department of Materials Science and Engineering Rensselaer Polytechnic Institute Troy New York USA
6 shared publications - Toh-Ming Lu
Rensselaer Polytechnic Institute
6 shared publications H.-N. Yang
Department of Physics, Applied Physics, and Astronomy, and Center for Integrated Electronics and Electronics Manufacturing, Rensselaer Polytechnic Institute, Troy, New York 12180-3590
5 shared publications
Latest Publications
- 31 July 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 44 (5)
Surface morphology and oxide phases of Cu pads in vias under thermal annealing in air
Thermal annealing of Cu, including oxidation and grain growth, plays a crucial role in the reliability performance of microelectronic devices. We present an experimental analysis of Cu oxide growth in dielectric-confined Cu pads in vias, essential for the development of a reliable Cu/oxide hybrid bonding process. Thermal oxidation of Cu pads grown by electroplating and processed by dual damascene was performed at a fixed annealing temperature (Ta) from 200 to 350 °C for 30 min under ambient air. As the temperature increases, the Cu pad expands and bulges above the dielectric surface. The surface morphology and roughness of Cu pad were examined by atomic force microscopy. The evolution of Cu oxide phases versus Ta was examined by Raman spectroscopy. At low Ta, the Cu2O phase dominates. As Ta increases, the CuO phase appears at 250 °C and coexists with the Cu2O phase. The energy dispersive x-ray spectroscopy shows that Cu oxide phases exist in the bulged-out Cu pad and can be detached from the unoxidized part of the Cu pad beneath the dielectric surface. The focused ion beam cross sections of Cu pads show a boundary region with gaps and void between oxidized Cu and unoxidized Cu pads. This understanding is relevant for the reliability of hybrid bonding in microelectronic Cu interconnects.
- 31 July 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 44 (5)
Surface morphology and oxide phases of Cu pads in vias under thermal annealing in air
Thermal annealing of Cu, including oxidation and grain growth, plays a crucial role in the reliability performance of microelectronic devices. We present an experimental analysis of Cu oxide growth in dielectric-confined Cu pads in vias, essential for the development of a reliable Cu/oxide hybrid bonding process. Thermal oxidation of Cu pads grown by electroplating and processed by dual damascene was performed at a fixed annealing temperature (Ta) from 200 to 350 °C for 30 min under ambient air. As the temperature increases, the Cu pad expands and bulges above the dielectric surface. The surface morphology and roughness of Cu pad were examined by atomic force microscopy. The evolution of Cu oxide phases versus Ta was examined by Raman spectroscopy. At low Ta, the Cu2O phase dominates. As Ta increases, the CuO phase appears at 250 °C and coexists with the Cu2O phase. The energy dispersive x-ray spectroscopy shows that Cu oxide phases exist in the bulged-out Cu pad and can be detached from the unoxidized part of the Cu pad beneath the dielectric surface. The focused ion beam cross sections of Cu pads show a boundary region with gaps and void between oxidized Cu and unoxidized Cu pads. This understanding is relevant for the reliability of hybrid bonding in microelectronic Cu interconnects.
- 14 January 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 44 (2)
Van der Waals epitaxy of millimeter-domain Bi2Se3
The unique electronic structure of Bi2Se3 makes it appealing not only for studying fundamental topological physics but also for pursuing technological applications that include future electronics, spintronics, and quantum computing. This work uses a chemical vapor deposition approach to synthesize submillimeter domain continuous epitaxial thin films as well as continuous films with preferred orientation and domain sizes ranging up to a millimeter. Atomic force microscopy imaging reveals a terraced pyramid structure with step sizes down to one quintuple layer. We observe that large amounts of deposition on the tube walls from previous growths negatively affect the quality of epitaxy but positively affect grain size due to revaporization of previous growth. Transport measurements and Hikami–Larkin–Nagaoka fits of conductivity versus magnetic field indicate a bulk conducting nature to the film. This work pushes forward the domain size Bi2Se3 films by an order of magnitude, while maintaining the regularly reported doping problems of topological insulators.
- 14 January 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 44 (2)
Van der Waals epitaxy of millimeter-domain Bi2Se3
The unique electronic structure of Bi2Se3 makes it appealing not only for studying fundamental topological physics but also for pursuing technological applications that include future electronics, spintronics, and quantum computing. This work uses a chemical vapor deposition approach to synthesize submillimeter domain continuous epitaxial thin films as well as continuous films with preferred orientation and domain sizes ranging up to a millimeter. Atomic force microscopy imaging reveals a terraced pyramid structure with step sizes down to one quintuple layer. We observe that large amounts of deposition on the tube walls from previous growths negatively affect the quality of epitaxy but positively affect grain size due to revaporization of previous growth. Transport measurements and Hikami–Larkin–Nagaoka fits of conductivity versus magnetic field indicate a bulk conducting nature to the film. This work pushes forward the domain size Bi2Se3 films by an order of magnitude, while maintaining the regularly reported doping problems of topological insulators.
- 1 December 2025
- Published by American Physical Society (APS) in Physical Review B
- Vol. 112 (22)
Enhanced magnetic phase contrast at step edges of Cr Te 2 flakes
- 1 December 2025
- Published by American Physical Society (APS) in Physical Review B
- Vol. 112 (22)
Enhanced magnetic phase contrast at step edges of Cr Te 2 flakes
- 27 November 2025
- Published by Elsevier in Next Research
- Vol. 3
Revealing ripples in wafer-scale bi-layer graphene through azimuthal reflection high energy electron diffraction
- 27 November 2025
- Published by Elsevier in Next Research
- Vol. 3
Revealing ripples in wafer-scale bi-layer graphene through azimuthal reflection high energy electron diffraction
- 1 October 2025
- Published by Springer Nature in Nature
- Vol. 646 (8085) , 584-591
Long-distance remote epitaxy
Remote epitaxy, in which an epitaxial relation is established between a film and a substrate through remote interactions, enables the development of high-quality single crystalline epilayers and their transfer to and integration with other technologically crucial substates1,2. It is commonly believed that in remote epitaxy, the distance within which the remote interaction can play a leading part in the epitaxial process is less than 1 nm, as the atomically resolved fluctuating electric potential decays very rapidly to a negligible value after a few atomic distances3. Here we show that it is possible to achieve remote epitaxy when the epilayer–substrate distance is as large as 2–7 nm. We experimentally demonstrate long-distance remote epitaxy of CsPbBr3 film on an NaCl substrate, KCl film on a KCl substrate and ZnO microrods on GaN, and show that a dislocation in the GaN substrate exists immediately below every remotely epitaxial ZnO microrod. These findings indicate that remote epitaxy could be designed and engineered by means of harnessing defect-mediated long-distance remote interactions.
- 1 October 2025
- Published by Springer Nature in Nature
- Vol. 646 (8085) , 584-591
Long-distance remote epitaxy
Remote epitaxy, in which an epitaxial relation is established between a film and a substrate through remote interactions, enables the development of high-quality single crystalline epilayers and their transfer to and integration with other technologically crucial substates1,2. It is commonly believed that in remote epitaxy, the distance within which the remote interaction can play a leading part in the epitaxial process is less than 1 nm, as the atomically resolved fluctuating electric potential decays very rapidly to a negligible value after a few atomic distances3. Here we show that it is possible to achieve remote epitaxy when the epilayer–substrate distance is as large as 2–7 nm. We experimentally demonstrate long-distance remote epitaxy of CsPbBr3 film on an NaCl substrate, KCl film on a KCl substrate and ZnO microrods on GaN, and show that a dislocation in the GaN substrate exists immediately below every remotely epitaxial ZnO microrod. These findings indicate that remote epitaxy could be designed and engineered by means of harnessing defect-mediated long-distance remote interactions.
- 17 March 2023
- Published by Elsevier in Thin Solid Films
- Vol. 772
2D reciprocal space map of etched metalorganic chemical vapor deposited CdTe(001) film surface on miscut GaAs(001)
- 17 March 2023
- Published by Elsevier in Thin Solid Films
- Vol. 772
2D reciprocal space map of etched metalorganic chemical vapor deposited CdTe(001) film surface on miscut GaAs(001)
- 19 January 2023
- Published by Springer Nature in Journal of Materials Research
- Vol. 38 (5) , 1224-1238
Near surface structure of ultrathin epitaxial Ru films on graphene/amorphous SiO2 revealed by azimuthal RHEED
- 19 January 2023
- Published by Springer Nature in Journal of Materials Research
- Vol. 38 (5) , 1224-1238
Near surface structure of ultrathin epitaxial Ru films on graphene/amorphous SiO2 revealed by azimuthal RHEED
- 10 August 2021
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 130 (6) , 065301
Domain boundaries in incommensurate epitaxial layers on weakly interacting substrates
There has been increasing interest in the fabrication of thin film materials with mixed dimensions, in particular, 2D to 3D and 3D to 2D heterostructures. Often, if the interface interaction is weak, the lattice matching criterion between the substrate and overlayer can be lifted. If the overlayer lattice is completely relaxed, it can form an incommensurate film on the mismatched substrate. In this work, we show that domain boundaries are inherent in the incommensurate epitaxial films due to random nucleation sites of domains in an overlayer. The nature and origin of the incommensurate domain boundaries are different from the conventional dislocation boundaries that come from the relaxation of strain due to film–substrate lattice mismatch. We propose that the formation of such domain boundaries can be studied through Voronoi tessellation. Using a case study of monolayer WS2 on sapphire (2D on 3D), we show the formation of domain boundaries that compared well with a recent experiment reported in the literature. In the Voronoi tessellation, we also show quantitatively that the average domain size depends on the density of nucleation sites. The conclusion of this case study may be generalized to any incommensurate epitaxial films when the interface interaction is weak.
- 10 August 2021
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 130 (6) , 065301
Domain boundaries in incommensurate epitaxial layers on weakly interacting substrates
There has been increasing interest in the fabrication of thin film materials with mixed dimensions, in particular, 2D to 3D and 3D to 2D heterostructures. Often, if the interface interaction is weak, the lattice matching criterion between the substrate and overlayer can be lifted. If the overlayer lattice is completely relaxed, it can form an incommensurate film on the mismatched substrate. In this work, we show that domain boundaries are inherent in the incommensurate epitaxial films due to random nucleation sites of domains in an overlayer. The nature and origin of the incommensurate domain boundaries are different from the conventional dislocation boundaries that come from the relaxation of strain due to film–substrate lattice mismatch. We propose that the formation of such domain boundaries can be studied through Voronoi tessellation. Using a case study of monolayer WS2 on sapphire (2D on 3D), we show the formation of domain boundaries that compared well with a recent experiment reported in the literature. In the Voronoi tessellation, we also show quantitatively that the average domain size depends on the density of nucleation sites. The conclusion of this case study may be generalized to any incommensurate epitaxial films when the interface interaction is weak.