Toh-Ming Lu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Toh-Ming Lu has a total of 48 co-authors. Here are the top co-authors by number of shared publications:
- Gwo-Ching Wang
Rensselaer Polytechnic Institute
6 shared publications - Joel. L. Plawsky
Rensselaer Polytech Inst, Howard P Isermann Dept Chem & Biol Engn, Troy, NY 12180 USA
5 shared publications Juan Pablo Borja
General Electric Global Research Center
5 shared publications- Xixing Wen
College of Electronic and Optical Engineering & College of Flexible Electronics (Future Technology) State Key Laboratory of Flexible Electronics Nanjing University of Posts and Telecommunications Nanjing China
3 shared publications - Zonghuan Lu
Center for Materials, Devices, and Integrated Systems (CMDIS), Rensselaer Polytechnic Institute 2 , Troy, New York 12180
3 shared publications - Jian Shi
Department of Materials Science and Engineering Rensselaer Polytechnic Institute Troy New York USA
2 shared publications
Latest Publications
- 31 July 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 44 (5)
Surface morphology and oxide phases of Cu pads in vias under thermal annealing in air
Thermal annealing of Cu, including oxidation and grain growth, plays a crucial role in the reliability performance of microelectronic devices. We present an experimental analysis of Cu oxide growth in dielectric-confined Cu pads in vias, essential for the development of a reliable Cu/oxide hybrid bonding process. Thermal oxidation of Cu pads grown by electroplating and processed by dual damascene was performed at a fixed annealing temperature (Ta) from 200 to 350 °C for 30 min under ambient air. As the temperature increases, the Cu pad expands and bulges above the dielectric surface. The surface morphology and roughness of Cu pad were examined by atomic force microscopy. The evolution of Cu oxide phases versus Ta was examined by Raman spectroscopy. At low Ta, the Cu2O phase dominates. As Ta increases, the CuO phase appears at 250 °C and coexists with the Cu2O phase. The energy dispersive x-ray spectroscopy shows that Cu oxide phases exist in the bulged-out Cu pad and can be detached from the unoxidized part of the Cu pad beneath the dielectric surface. The focused ion beam cross sections of Cu pads show a boundary region with gaps and void between oxidized Cu and unoxidized Cu pads. This understanding is relevant for the reliability of hybrid bonding in microelectronic Cu interconnects.
- 31 July 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 44 (5)
Surface morphology and oxide phases of Cu pads in vias under thermal annealing in air
Thermal annealing of Cu, including oxidation and grain growth, plays a crucial role in the reliability performance of microelectronic devices. We present an experimental analysis of Cu oxide growth in dielectric-confined Cu pads in vias, essential for the development of a reliable Cu/oxide hybrid bonding process. Thermal oxidation of Cu pads grown by electroplating and processed by dual damascene was performed at a fixed annealing temperature (Ta) from 200 to 350 °C for 30 min under ambient air. As the temperature increases, the Cu pad expands and bulges above the dielectric surface. The surface morphology and roughness of Cu pad were examined by atomic force microscopy. The evolution of Cu oxide phases versus Ta was examined by Raman spectroscopy. At low Ta, the Cu2O phase dominates. As Ta increases, the CuO phase appears at 250 °C and coexists with the Cu2O phase. The energy dispersive x-ray spectroscopy shows that Cu oxide phases exist in the bulged-out Cu pad and can be detached from the unoxidized part of the Cu pad beneath the dielectric surface. The focused ion beam cross sections of Cu pads show a boundary region with gaps and void between oxidized Cu and unoxidized Cu pads. This understanding is relevant for the reliability of hybrid bonding in microelectronic Cu interconnects.
- 1 December 2025
- Published by American Physical Society (APS) in Physical Review B
- Vol. 112 (22)
Enhanced magnetic phase contrast at step edges of Cr Te 2 flakes
- 1 December 2025
- Published by American Physical Society (APS) in Physical Review B
- Vol. 112 (22)
Enhanced magnetic phase contrast at step edges of Cr Te 2 flakes
- Open Access
- 1 January 2022
- Published by Elsevier in SSRN Electronic Journal
Free-Standing [001]-Oriented One-Dimensional Crystal-Structural Antimony Selenide Films for Self-Powered Flexible Near-Infrared Photodetectors
Flexible optoelectronic is one of the key components for acquiring biological signals in wearable devices and implantable systems. Recently, antimony selenide (Sb2Se3) has shown an exciting potential for flexible optoelectronic applications due to its unique one-dimensional (1D) ribbon-typed crystal structure, low-cost constituents, and superior optoelectronic properties. However, the growth of [001]-oriented Sb2Se3 film, which can efficiently enhance the carrier transport, is still challenging, particularly for its application in flexible electronics. Herein, we propose to grow the free-standing [001]-oriented Sb2Se3 film for self-powered flexible photodiode through selenizing the van der Waals (vdW) epitaxial Sb film on mica substrate. The epitaxial Sb film possesses a single (0001) out-of-plane orientation. The theoretical calculation reveals that Sb(0001) plane provides a high adsorption energy for Se atoms, which promotes the [001]-oriented growth of Sb2Se3 film. The weak vdW interaction between Sb2Se3 film and mica substrate enables the film separation, and results in a free-standing Sb2Se3 film. Benefiting from the enhanced carrier transport in [001]-oriented Sb2Se3 film, the flexible photodiode exhibits a high responsivity up to 0.74 A W-1, a specific detectivity of 5.1 × 1013 Jones, a linear dynamic range of 102 dB, rise/fall time of 0.16/0.15 ms for near-infrared light detection without any external bias, and excellent folding endurance after 1000 bending cycles. It has been also successfully employed as a wearable photodetector to detect a person’s heart rate. This work demonstrates a strategy for the orientation control of low-dimensional crystal-structural materials and a great potential of free-standing films in flexible electronics applications.
- 1 January 2022
- Published by Elsevier in SSRN Electronic Journal
Open AccessFree-Standing [001]-Oriented One-Dimensional Crystal-Structural Antimony Selenide Films for Self-Powered Flexible Near-Infrared Photodetectors
Flexible optoelectronic is one of the key components for acquiring biological signals in wearable devices and implantable systems. Recently, antimony selenide (Sb2Se3) has shown an exciting potential for flexible optoelectronic applications due to its unique one-dimensional (1D) ribbon-typed crystal structure, low-cost constituents, and superior optoelectronic properties. However, the growth of [001]-oriented Sb2Se3 film, which can efficiently enhance the carrier transport, is still challenging, particularly for its application in flexible electronics. Herein, we propose to grow the free-standing [001]-oriented Sb2Se3 film for self-powered flexible photodiode through selenizing the van der Waals (vdW) epitaxial Sb film on mica substrate. The epitaxial Sb film possesses a single (0001) out-of-plane orientation. The theoretical calculation reveals that Sb(0001) plane provides a high adsorption energy for Se atoms, which promotes the [001]-oriented growth of Sb2Se3 film. The weak vdW interaction between Sb2Se3 film and mica substrate enables the film separation, and results in a free-standing Sb2Se3 film. Benefiting from the enhanced carrier transport in [001]-oriented Sb2Se3 film, the flexible photodiode exhibits a high responsivity up to 0.74 A W-1, a specific detectivity of 5.1 × 1013 Jones, a linear dynamic range of 102 dB, rise/fall time of 0.16/0.15 ms for near-infrared light detection without any external bias, and excellent folding endurance after 1000 bending cycles. It has been also successfully employed as a wearable photodetector to detect a person’s heart rate. This work demonstrates a strategy for the orientation control of low-dimensional crystal-structural materials and a great potential of free-standing films in flexible electronics applications.
- 10 August 2021
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 130 (6) , 065301
Domain boundaries in incommensurate epitaxial layers on weakly interacting substrates
There has been increasing interest in the fabrication of thin film materials with mixed dimensions, in particular, 2D to 3D and 3D to 2D heterostructures. Often, if the interface interaction is weak, the lattice matching criterion between the substrate and overlayer can be lifted. If the overlayer lattice is completely relaxed, it can form an incommensurate film on the mismatched substrate. In this work, we show that domain boundaries are inherent in the incommensurate epitaxial films due to random nucleation sites of domains in an overlayer. The nature and origin of the incommensurate domain boundaries are different from the conventional dislocation boundaries that come from the relaxation of strain due to film–substrate lattice mismatch. We propose that the formation of such domain boundaries can be studied through Voronoi tessellation. Using a case study of monolayer WS2 on sapphire (2D on 3D), we show the formation of domain boundaries that compared well with a recent experiment reported in the literature. In the Voronoi tessellation, we also show quantitatively that the average domain size depends on the density of nucleation sites. The conclusion of this case study may be generalized to any incommensurate epitaxial films when the interface interaction is weak.
- 10 August 2021
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 130 (6) , 065301
Domain boundaries in incommensurate epitaxial layers on weakly interacting substrates
There has been increasing interest in the fabrication of thin film materials with mixed dimensions, in particular, 2D to 3D and 3D to 2D heterostructures. Often, if the interface interaction is weak, the lattice matching criterion between the substrate and overlayer can be lifted. If the overlayer lattice is completely relaxed, it can form an incommensurate film on the mismatched substrate. In this work, we show that domain boundaries are inherent in the incommensurate epitaxial films due to random nucleation sites of domains in an overlayer. The nature and origin of the incommensurate domain boundaries are different from the conventional dislocation boundaries that come from the relaxation of strain due to film–substrate lattice mismatch. We propose that the formation of such domain boundaries can be studied through Voronoi tessellation. Using a case study of monolayer WS2 on sapphire (2D on 3D), we show the formation of domain boundaries that compared well with a recent experiment reported in the literature. In the Voronoi tessellation, we also show quantitatively that the average domain size depends on the density of nucleation sites. The conclusion of this case study may be generalized to any incommensurate epitaxial films when the interface interaction is weak.
- 1 January 2021
- Published by Elsevier in Applied Surface Science
- Vol. 536, 147886
Water-assisted exfoliation of epitaxial CdTe film from mica analyzed with azimuthal RHEED
- 1 January 2021
- Published by Elsevier in Applied Surface Science
- Vol. 536, 147886
Water-assisted exfoliation of epitaxial CdTe film from mica analyzed with azimuthal RHEED
- Open Access
- 23 July 2020
- Published by Springer Nature in Scientific Reports
- Vol. 10 (1) , 1-7
Growth front smoothing effects in extremely high pressure vapor deposition
Recent experimental chemical vapor depositions of silicon at extreme pressures of ~ 50 MPa (~ 500 atm) have been observed to generate remarkably smooth surfaces not predicted by low-pressure deposition models. In this paper, we propose an anti-shadowing mechanism where the collision of particles within the valleys of the surface growth front leads to smoothening. We conduct Monte Carlo simulations to simulate the evolution of film roughness at pressures between 1 and 50 MPa. We observe that surface roughness approaches an asymptotic invariant value that follows power law behavior as a function of pressure. The film thickness at which invariance begins is shown to have a similar power law behavior with respect to pressure. Our simulated results compare favorably with recent experimental observations and provide insight into the fundamental mechanisms underlying film evolution at pressures between one and hundreds of atmospheres.
- 23 July 2020
- Published by Springer Nature in Scientific Reports
- Vol. 10 (1) , 1-7
Open AccessGrowth front smoothing effects in extremely high pressure vapor deposition
Recent experimental chemical vapor depositions of silicon at extreme pressures of ~ 50 MPa (~ 500 atm) have been observed to generate remarkably smooth surfaces not predicted by low-pressure deposition models. In this paper, we propose an anti-shadowing mechanism where the collision of particles within the valleys of the surface growth front leads to smoothening. We conduct Monte Carlo simulations to simulate the evolution of film roughness at pressures between 1 and 50 MPa. We observe that surface roughness approaches an asymptotic invariant value that follows power law behavior as a function of pressure. The film thickness at which invariance begins is shown to have a similar power law behavior with respect to pressure. Our simulated results compare favorably with recent experimental observations and provide insight into the fundamental mechanisms underlying film evolution at pressures between one and hundreds of atmospheres.
- 17 September 2016
- Published by Springer Nature
- p. 59-75
Kinetics of Charge Carrier Confinement in Thin Dielectrics
- 17 September 2016
- Published by Springer Nature
- p. 59-75
Kinetics of Charge Carrier Confinement in Thin Dielectrics
- 17 September 2016
- Published by Springer Nature
- p. 21-26
Measurement Tools and Test Structures
- 17 September 2016
- Published by Springer Nature
- p. 93-98
Dielectric Breakdown in Copper Interconnects
- 17 September 2016
- Published by Springer Nature
- p. 99-105
Reconsidering Conventional Field Acceleration Models
- 17 September 2016
- Published by Springer Nature
- p. 99-105
Reconsidering Conventional Field Acceleration Models