Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Tomás Calheiros-Cabral has a total of 22 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Reducing Wave Overtopping on Rubble Mound Breakwaters Using Floating Kelp Farms

    by Filipe Miranda, Tomás Calheiros-Cabral, Diogo Mendes, Paulo Rosa-Santos, Francisco Taveira-Pinto, Tiago Fazeres-Ferradosa

    Near-surface floating kelp farms constitute a Nature-Based Solution (NBS) capable of damping incident wind-generated waves, which might be beneficial to reduce wave overtopping on maritime structures. As the global mean sea level rises, the mean wave overtopping discharge is expected to increase. The incorporation of this NBS, as a green–grey solution, might be beneficial to mitigate this effect. Physical modelling experiments with random waves have been conducted to assess the ability of this NBS to reduce the mean wave overtopping discharge on a rubble mound breakwater. Results show that while the mean wave overtopping discharge was reduced by 47% with a kelp farm length of 50 m (prototype scale), a kelp farm of 200 m achieved a reduction of 93% for the tested conditions. This reduction is mainly a function of the ratio between floating kelp farm length and incident wavelength. An idealized case study at the Port of Leixões breakwater suggests that, under storm wave conditions with return period of 2 and 5 years, floating kelp farms could maintain mean wave overtopping discharges below present levels until 2070. Thus, this study highlights the relevance of incorporating NBS with existing coastal and port defence structures as an adaptation measure to mitigate climate change effects.


  • Open Access

    On the Development of a Near-Shore Pivoting Wave Energy Converter

    by Gianmaria Giannini, Esmaeil Zavvar, Victor Ramos, Tomás Calheiros-Cabral, Isabel Iglesias, Francisco Taveira-Pinto, Paulo Rosa-Santos

    Numerous offshore wave energy converter (WEC) designs have been invented; however, none has achieved full commercialization so far. The primary obstacle impeding WEC commercialization is the elevated levelized cost of energy (LCOE). Consequently, there exists a pressing need to innovate and swiftly diminish the LCOE. A critical challenge faced by WECs is their susceptibility to extreme wave loads during storms. Promising concepts must demonstrate robust design features to ensure resilience in adverse conditions, while maintaining efficiency in harnessing power under normal sea states. It is anticipated that the initial commercial endeavors will concentrate on near-shore WEC technologies due to the cost advantages associated with proximity to the coastline, facilitating more affordable power transmission and maintenance. In response, this manuscript proposes a pioneering near-shore WEC concept designed with a survivability mode that is engineered to mitigate wave loads during severe sea conditions. Moreover, prior investigations have highlighted favorable resonance properties of this novel concept, enhancing wave power extraction during recurrent energetic sea states. This study employs numerical and physical modelling techniques to evaluate wave loads on the proposed WEC. The results indicate a remarkable 65% reduction in wave loads on the moving floater of the WEC during a range of sea states under the implemented survivability mode.


  • Open Access

    Blue Seaports: The Smart, Sustainable and Electrified Ports of the Future

    by Daniel Clemente, Tomás Calheiros-Cabral, Paulo Rosa-Santos, Francisco Taveira-Pinto

    Seaports are at the forefront of global trade networks, serving as hubs for maritime logistics and the transportation of goods and people. To meet the requirements of such networks, seaport authorities are investing in advanced technologies to enhance the efficiency and reliability of port infrastructures. This can be achieved through the digitalization and automation of core systems, aimed at optimizing the management and handling of both goods and people. Furthermore, a significant effort is being made towards a green energy transition at seaports, which can be supported through marine renewable sources. This promotes energy-mix diversification and autonomy, whilst reducing the noteworthy environmental footprint of seaport activities. By analyzing these pertinent topics under the scope of a review of container-terminal case studies, and these ports’ respective contexts, this paper seeks to identify pioneering smart seaports in the fields of automation, real-time management, connectivity and accessibility control. To foster the sustainable development of seaports, from an energy perspective, the potential integration with marine renewable-energy systems is considered, as well as their capabilities for meeting, even if only partially, the energy demands of seaports. By combining these fields, we attempt to construct a holistic proposal for a “model port” representing the expected evolution towards the seaports of the future.


  • Open Access

    Development and Assessment of a Hybrid Breakwater-Integrated Wave Energy Converter

    by Tomás Calheiros-Cabral, Ajab Gul Majidi, Victor Ramos, Gianmaria Giannini, Paulo Rosa-Santos, Francisco Taveira-Pinto

    Harnessing and using marine renewable energy at seaports is a promising solution to put these energy-intensive infrastructures on the right track to energy self-sufficiency and environmental sustainability, reducing their carbon footprint. This paper presents a summary of the main conclusions and achievements of a recently concluded R&D project that encompassed the experimental study of an innovative hybrid wave energy converter integrated into a case-study rubble-mound breakwater in the Port of Leixões, Portugal. It also describes the prospective studies planned in two ongoing projects, PORTOS – Ports Towards Energy Self-Sufficiency and WEC4Ports – A hybrid Wave Energy Converter for Ports, intended to further develop and assess this promising technology. It has been demonstrated that its wave-to-wire efficiency and annual energy production are 27.3% and 35.0 MWh/m per year, respectively, for the case-study location. Hence, a 240 m long device could provide more than half of the port’s electricity consumption, which vows for the device’s potential. Moreover, the impact of its integration into the case-study breakwater showed that it leads to a 50% reduction of overtopping discharges over the structure, and no significant effects on the structure’s wave reflection, although the stability of the toe berm blocks was negatively impacted. Overall, the conclusions obtained are favourable to the integration of this technology into rubble-mound breakwaters. Notwithstanding, further research is still needed, namely in terms of wave forces acting upon the structure, important for the assessment of the functional performance and lifecycle readiness of the technology, and the use of PTO control strategies. This is being addressed in PORTOS and WEC4Ports projects.


  • Open Access

    An Integrated Approach to Assessing the Wave Potential for the Energy Supply of Ports: A Case Study

    by Victor Ramos, Gianmaria Giannini, Tomás Calheiros-Cabral, Paulo Rosa-Santos, Francisco Taveira-Pinto

    In recent years, seaports have faced increasing pressure to transition towards a low-carbon and more sustainable energy model. In this context, the exploitation of the local wave energy resource may appear as a promising alternative. Therefore, the objective of this work is to present a methodology to select the best WEC-site combination to supply the energy demands of ports. To illustrate this methodology, the Port of Leixões (Portugal) is used as a case study. For the selection of wave energy sites in port areas, the methodology proposes a detailed spatial characterisation of both the wave resource and marine uses. For the area of study, having considered the main marine uses (sediment disposal, biodiversity, aquaculture, recreational and navigation), two exploitable wave energy sites (Areas I and II) with average annual energy resources of 24 and 17 kWm−1, respectively, were found. Next, the methodology proposes a techno-economic optimisation of WECs, based on the local wave conditions of Areas I and II, to minimise their associated Levelised Cost of Energy (LCoE). The results obtained confirm the effectiveness of the methodology, with the novel oCECO device, appearing as the most feasible option (with an LCoE of EUR 387.6/MWh) to exploit the wave potential in the surrounding areas of the port.


  • Open Access

    Hydrokinetic Power Resource Assessment in a Combined Estuarine and River Region

    by Gianmaria Giannini, Victor Ramos, Paulo Rosa-Santos, Tomás Calheiros-Cabral, Francisco Taveira-Pinto

    The worldwide river and tidal hydrokinetic power potential is considerable. Harnessing such potential could allow the generation of a significant amount of sustainable electricity for local uses. To the present, most studies on hydrokinetic power have focused on large-scale commercial technology development, large tidal farms planning, and high-intensity resources assessment. Reduced attention was oriented towards investigating possibilities for small to medium-size hydrokinetic plants. However, given the characteristics of rivers and estuaries, in most cases, relevant hydrokinetic power exploitation possibilities exist regardless of the dimensions of the region considered. The planning of small to medium-size hydrokinetic plants for various aspects differs from larger developments. In the present work, a method for assessing the hydrokinetic resource is proposed and applied to the case study of the Douro waterway, which is characterized by moderate flow speeds and limited water depths. A high-resolution shallow-water numerical model is set up using ocean and river inflow boundary conditions. The flow velocities are estimated for the neap-spring period for different freshwater discharges. The spots presenting the highest annual hydrokinetic power average were identified, maximum flow speeds of about 1 m/s were found, and an annual mean power of 0.4 kW/m2 was estimated, indicating that prospects for hydrokinetic energy harvesting exist.


  • Open Access

    Assessing the Effectiveness of a Novel WEC Concept as a Co-Located Solution for Offshore Wind Farms

    by Victor Ramos, Gianmaria Giannini, Tomás Calheiros-Cabral, Mario López, Paulo Rosa-Santos, Francisco Taveira-Pinto

    The combined exploitation of wave and offshore wind energy resources is expected to improve the cost competitiveness of the wave energy industry as a result of shared capital and operational costs. In this context, the objective of this work is to explore the potential benefits of co-locating CECO, an innovative wave energy converter, with the commercial WindFloat Atlantic wind farm, located on the northern coast of Portugal. For this purpose, the performance of the combined farm was assessed in terms of energy production, power smoothing and levelised cost of energy (LCoE). Overall, the co-located farm would increase the annual energy production by approximately 19% in comparison with the stand-alone wind farm. However, the benefits in terms of power output smoothing would be negligible due to the strong seasonal behaviour of the wave resource in the area of study. Finally, the LCoE of the co-located farm would be drastically reduced in comparison with the stand-alone wave farm, presenting a value of 0.115 per USD/kWh, which is similar to the levels of the offshore wind industry as of five years ago. Consequently, it becomes apparent that CECO could progress more rapidly towards commercialisation when combined with offshore wind farms.


  • Open Access

    Hydraulic and Structural Assessment of a Rubble-Mound Breakwater with a Hybrid Wave Energy Converter

    by Daniel Clemente, Tomás Calheiros-Cabral, Paulo Rosa-Santos, Francisco Taveira-Pinto

    Seaports’ breakwaters serve as important infrastructures capable of sheltering ships, facilities, and harbour personnel from severe wave climate. Given their exposure to ocean waves and port authorities’ increasing awareness towards sustainability, it is important to develop and assess wave energy conversion technologies suitable of being integrated into seaport breakwaters. To fulfil this goal whilst ensuring adequate sheltering conditions, this paper describes the performance and stability analysis of the armour layer and toe berm of a 1/50 geometric scale model of the north breakwater extension project, intended for the Port of Leixões, with an integrated hybrid wave energy converter. This novel hybrid concept combines an oscillating water column and an overtopping device. The breakwater was also studied without the hybrid wave energy device as to enable a thorough comparison between both solutions regarding structural stability, safety, and overtopping performance. The results point towards a considerable reduction in the overtopping volumes through the integration of the hybrid technology by an average value of 50%, while the stability analysis suggests that the toe berm of the breakwater is not significantly affected by the hybrid device, leading to acceptable safety levels. Even so, some block displacements were observed, and the attained stability numbers were slightly above the recommended thresholds from the literature. It is also shown that traditional damage assessment parameters should be applied with care when non-conventional structures are analysed, such as rubble-mound breakwaters with integrated wave energy converters.


  • Top Cited Papers

    Legal framework of marine renewable energy: A review for the Atlantic region of Europe

    by V. Ramos, G. Giannini, T. Calheiros-Cabral, P. Rosa-Santos, F. Taveira-Pinto