Yasutaka Nagai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yasutaka Nagai has a total of 72 co-authors. Here are the top co-authors by number of shared publications:
- Akihiko Kato
Toyota Central Research and Development Laboratories (Japan)
5 shared publications - Satoru Kato
Toyota Central Research and Development Laboratories (Japan)
4 shared publications - Daigo Setoyama
Toyota Central R&D Labs., Inc
3 shared publications Hirofumi Shinjoh
TOYOTA Central R&D Labs., Inc. Nagakute, Aichi 480-1192 (Japan), Fax: (+81) 561-63-6150
3 shared publicationsKazuhiko Dohmae
Toyota Central R&D Labs., Inc., Aichi 480-1192, Nagakute, Japan
3 shared publicationsNobuyuki Takagi
Higashi-Fuji Technical Center, TOYOTA Motor Corporation, Shizuoka (Japan)
3 shared publications
Latest Publications
- Open Access
- 19 February 2024
- Published by Springer Nature in Communications Engineering
- Vol. 3 (1) , 1-7
Experimental visualization of water/ice phase distribution at cold start for practical-sized polymer electrolyte fuel cells
The automotive industry aims to ensure the cold-start capability of polymer electrolyte fuel cells (PEFCs) for developing fuel cell electric vehicles that can be driven in cold climates. Water and ice behavior is a key factor in maintaining this capability. Previously reported methods for visualizing water and/or ice are limited to small-sized PEFCs ( < 50 cm2), while fuel cell electric vehicles are equipped with larger PEFCs. Here, we developed a system using a pulsed spallation neutron beam to visualize water distribution and identify water/ice phases in practical-sized PEFCs at a cold start. The results show direct evidence of a stepwise freezing behavior inside the PEFC. The produced water initially accumulated at the center of the PEFC and then froze, followed by PEFC shutdown as freezing progressed. This study can serve as a reference to guide the development of cold-start protocols, cell design, and materials for next-generation fuel cell electric vehicles.
- 19 February 2024
- Published by Springer Nature in Communications Engineering
- Vol. 3 (1) , 1-7
Open AccessExperimental visualization of water/ice phase distribution at cold start for practical-sized polymer electrolyte fuel cells
The automotive industry aims to ensure the cold-start capability of polymer electrolyte fuel cells (PEFCs) for developing fuel cell electric vehicles that can be driven in cold climates. Water and ice behavior is a key factor in maintaining this capability. Previously reported methods for visualizing water and/or ice are limited to small-sized PEFCs ( < 50 cm2), while fuel cell electric vehicles are equipped with larger PEFCs. Here, we developed a system using a pulsed spallation neutron beam to visualize water distribution and identify water/ice phases in practical-sized PEFCs at a cold start. The results show direct evidence of a stepwise freezing behavior inside the PEFC. The produced water initially accumulated at the center of the PEFC and then froze, followed by PEFC shutdown as freezing progressed. This study can serve as a reference to guide the development of cold-start protocols, cell design, and materials for next-generation fuel cell electric vehicles.
- 12 July 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 50 (B) , 1218-1227
Dependence of vapor and liquid water removal on cross-flow in polymer electrolyte fuel cell investigated by operando synchrotron X-ray radiography
- 12 July 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 50 (B) , 1218-1227
Dependence of vapor and liquid water removal on cross-flow in polymer electrolyte fuel cell investigated by operando synchrotron X-ray radiography
- Open Access
- 17 August 2022
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 29 (5) , 1258-1264
Observation of water droplets in microporous layers for polymer electrolyte fuel cells by X-ray computed nano-tomography
An X-ray computed nano-tomography (nano-CT) system has been established at the BL33XU beamline of SPring-8. The optical system consists of pseudo-Köhler illumination with a sector condenser zone plate, an apodization Fresnel zone plate as the objective lens, and a Zernike phase plate. The imaging detector is a fiber-coupling type X-ray camera. The performance of the X-ray nano-CT system was confirmed by imaging an X-ray test chart. The system was subsequently applied to the observation of a microporous layer for polymer electrolyte fuel cells and a simulated microporous layer including liquid water. The nano-CT system, which can perform a computed tomography measurement in less than 4 min, allowed visualization of a spherical water droplet produced in the microporous layer. In the present study, the shape of water droplets in a nanoscale porous structure is investigated.
- 17 August 2022
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 29 (5) , 1258-1264
Open AccessObservation of water droplets in microporous layers for polymer electrolyte fuel cells by X-ray computed nano-tomography
An X-ray computed nano-tomography (nano-CT) system has been established at the BL33XU beamline of SPring-8. The optical system consists of pseudo-Köhler illumination with a sector condenser zone plate, an apodization Fresnel zone plate as the objective lens, and a Zernike phase plate. The imaging detector is a fiber-coupling type X-ray camera. The performance of the X-ray nano-CT system was confirmed by imaging an X-ray test chart. The system was subsequently applied to the observation of a microporous layer for polymer electrolyte fuel cells and a simulated microporous layer including liquid water. The nano-CT system, which can perform a computed tomography measurement in less than 4 min, allowed visualization of a spherical water droplet produced in the microporous layer. In the present study, the shape of water droplets in a nanoscale porous structure is investigated.
- 20 March 2021
- Published by Society of Chemical Engineers, Japan in KAGAKU KOGAKU RONBUNSHU
- Vol. 47 (2) , 44-50
Spatiotemporal Analysis of Plug Flow Reactor for NOX Storage and Reduction Catalyst by Operando X-ray Absorption Spectroscopy
NOX吸蔵還元型触媒において,触媒床温度とNOX吸蔵量がNOX浄化率に与える影響を検討した.反応中のRh/Ba/Al2O3中のRh酸化状態の変化を,時間・空間分解能を併せ持つX線吸収分光法で測定すると同時に,触媒出ガスの分析を行い,吸蔵NOXの還元過程を解析した.その結果,NOX浄化率を低下させる要因として①NOX吸蔵サイトの空き不足,②低温での貴金属の還元反応速度の低下,③高温での吸蔵NOXの分解速度の上昇,以上3種が明らかになった.これらの結果から,NOX浄化率を向上させる指針として,(1)貴金属の還元反応速度が十分高く,吸蔵NOXの分解が比較的抑制される温度域で使用すること,(2)下流側のNOX吸蔵サイトの空きを確保するためにNOX吸蔵量を抑制することを提案した.
- 20 March 2021
- Published by Society of Chemical Engineers, Japan in KAGAKU KOGAKU RONBUNSHU
- Vol. 47 (2) , 44-50
Spatiotemporal Analysis of Plug Flow Reactor for NOX Storage and Reduction Catalyst by Operando X-ray Absorption Spectroscopy
NOX吸蔵還元型触媒において,触媒床温度とNOX吸蔵量がNOX浄化率に与える影響を検討した.反応中のRh/Ba/Al2O3中のRh酸化状態の変化を,時間・空間分解能を併せ持つX線吸収分光法で測定すると同時に,触媒出ガスの分析を行い,吸蔵NOXの還元過程を解析した.その結果,NOX浄化率を低下させる要因として①NOX吸蔵サイトの空き不足,②低温での貴金属の還元反応速度の低下,③高温での吸蔵NOXの分解速度の上昇,以上3種が明らかになった.これらの結果から,NOX浄化率を向上させる指針として,(1)貴金属の還元反応速度が十分高く,吸蔵NOXの分解が比較的抑制される温度域で使用すること,(2)下流側のNOX吸蔵サイトの空きを確保するためにNOX吸蔵量を抑制することを提案した.
- 10 December 2020
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 23 (2) , 1062-1071
Pulsed neutron imaging for differentiation of ice and liquid water towards fuel cell vehicle applications
This study is the first report on liquid water and ice imaging conducted at a pulsed spallation neutron source facility. Neutron imaging can be utilised to visualise the water distribution inside polymer electrolyte fuel cells (PEFCs). Particularly, energy-resolved neutron imaging is a methodology capable of distinguishing between liquid water and ice, and is effective for investigating ice formation in PEFCs operating in a subfreezing environment. The distinction principle is based on the fact that the cross sections of liquid water and ice differ from each other at low neutron energies. In order to quantitatively observe transient freezing and thawing phenomena in a multiphase mixture (gas/liquid/solid) within real PEFCs with high spatial resolution, a pulsed neutron beam with both high intensity and wide energy range is most appropriate. In the validation study of the present work, we used water sealed in narrow capillary tubes to simulate the flow channels of a PEFC, and a pulsed neutron beam was applied to distinguish ice, liquid water and super-cooled water, and to clarify freezing and thawing phenomena of the water within the capillary tubes. Moreover, we have enabled the observation of liquid water/ice distributions in a large field of view (300 mm × 300 mm) by manufacturing a sub-zero environment chamber that can be cooled down to −30 °C, as a step towards in situ visualisation of full-size fuel cells.
- 10 December 2020
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 23 (2) , 1062-1071
Pulsed neutron imaging for differentiation of ice and liquid water towards fuel cell vehicle applications
This study is the first report on liquid water and ice imaging conducted at a pulsed spallation neutron source facility. Neutron imaging can be utilised to visualise the water distribution inside polymer electrolyte fuel cells (PEFCs). Particularly, energy-resolved neutron imaging is a methodology capable of distinguishing between liquid water and ice, and is effective for investigating ice formation in PEFCs operating in a subfreezing environment. The distinction principle is based on the fact that the cross sections of liquid water and ice differ from each other at low neutron energies. In order to quantitatively observe transient freezing and thawing phenomena in a multiphase mixture (gas/liquid/solid) within real PEFCs with high spatial resolution, a pulsed neutron beam with both high intensity and wide energy range is most appropriate. In the validation study of the present work, we used water sealed in narrow capillary tubes to simulate the flow channels of a PEFC, and a pulsed neutron beam was applied to distinguish ice, liquid water and super-cooled water, and to clarify freezing and thawing phenomena of the water within the capillary tubes. Moreover, we have enabled the observation of liquid water/ice distributions in a large field of view (300 mm × 300 mm) by manufacturing a sub-zero environment chamber that can be cooled down to −30 °C, as a step towards in situ visualisation of full-size fuel cells.
- 1 September 2019
- Published by Elsevier in Journal of Power Sources
- Vol. 435
Improving water management in fuel cells through microporous layer modifications: Fast operando tomographic imaging of liquid water
- 1 September 2019
- Published by Elsevier in Journal of Power Sources
- Vol. 435
Improving water management in fuel cells through microporous layer modifications: Fast operando tomographic imaging of liquid water
- Open Access
- 14 February 2019
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 9 (5) , 1103-1107
Mechanistic insights into a NOx storage-reduction (NSR) catalyst by spatiotemporal operando X-ray absorption spectroscopy
Spatially resolved monitoring of the catalytically active state and online catalytic activity measurements were applied to track the fast transient phenomena occurring along the axial direction of a NSR catalyst bed. This methodology clarified the distribution of stored NOx as well as the cause of NOx spike emission.
- 14 February 2019
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 9 (5) , 1103-1107
Open AccessMechanistic insights into a NOx storage-reduction (NSR) catalyst by spatiotemporal operando X-ray absorption spectroscopy
Spatially resolved monitoring of the catalytically active state and online catalytic activity measurements were applied to track the fast transient phenomena occurring along the axial direction of a NSR catalyst bed. This methodology clarified the distribution of stored NOx as well as the cause of NOx spike emission.
- 29 January 2015
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 119 (8) , 4224-4234
In Situ Characterization of Highly Dispersed, Ceria-Supported Fe Sites for NO Reduction by CO
- 29 January 2015
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 119 (8) , 4224-4234
In Situ Characterization of Highly Dispersed, Ceria-Supported Fe Sites for NO Reduction by CO
- 17 January 2013
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 15 (22) , 8461-8465
Operando XAFS study of catalytic NO reduction over Cu/CeO2: the effect of copper–ceria interaction under periodic operation
Using an operando time-resolved XAFS technique at the Cu and Ce K-edges, we have discovered that the synchronization of Cu and Ce valence change in Cu/CeO2 under periodic (rich–lean cycling) operation can improve the catalytic activity for NO reduction at low temperature.
- 17 January 2013
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 15 (22) , 8461-8465
Operando XAFS study of catalytic NO reduction over Cu/CeO2: the effect of copper–ceria interaction under periodic operation
Using an operando time-resolved XAFS technique at the Cu and Ce K-edges, we have discovered that the synchronization of Cu and Ce valence change in Cu/CeO2 under periodic (rich–lean cycling) operation can improve the catalytic activity for NO reduction at low temperature.