Khashayar Nasrifar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Khashayar Nasrifar has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Ali Rasoolzadeh
Department of Chemical Engineering, Faculty of Engineering
2 shared publications - Amir Hossein Mohammadi
Department of Mathematics, University of California, Berkeley, CA 94720, USA
2 shared publications Foroozan Keshavarzi
Department of Chemical, Petroleum and Gas Engineering, Shiraz University of Technology, Shiraz 71557-13876, Iran
2 shared publicationsGhulam Murshid
2 shared publications- Jafar Javanmardi
Department of Chemical, Petroleum and Gas Engineering, Shiraz University of Technology, Shiraz, Iran
2 shared publications A. Zarei
Shiraz Univ Technol, Dept Chem Petr & Gas Engn, Shiraz, Iran
1 shared publication
Latest Publications
- 13 February 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (8) , 3780-3796
A Precise Thermodynamic Approach for Calculating Activity of Water in the Presence of Aqueous Alcohol + Salt Solutions and its Application to Gas Hydrate Dissociation Modeling
- 13 February 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (8) , 3780-3796
A Precise Thermodynamic Approach for Calculating Activity of Water in the Presence of Aqueous Alcohol + Salt Solutions and its Application to Gas Hydrate Dissociation Modeling
- 6 June 2022
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 67 (9) , 2760-2766
Experimental and Modeling of Methane + Propane Double Hydrates
- 6 June 2022
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 67 (9) , 2760-2766
Experimental and Modeling of Methane + Propane Double Hydrates
- 25 April 2022
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 41 (4) , 425-443
Algorithm for estimating SARA fraction properties and its application in predicting the densities of heavy oils, bitumen and diluted bitumen with solvents
Using aromatic ring index (ARI) and the densities of saturates, aromatics, resins and asphaltenes (SARA) at any temperature, an algorithm was developed to iteratively estimate the molecular weights and specific gravities (60 °F) of the SARA fractions. The algorithm circumvents molecular weight measurements in reporting SARA fractions properties. Then, using the corresponding state principles the critical properties and acentric factor of the fractions were estimated using the correlations available in literature. Further, applying regular solution theory the densities of heavy oils, bitumen, and five diluted Athabasca bitumen with 5 solvents were predicted from Hankinson-Thomson and a compressed liquid density correlation. The average absolute deviation (AAD) in predicting the densities was found to be 1.33% for 1524 points with temperature range from 288 K to 463 K and pressure from 0.1 to 10 MPa. The method exhibits predictive ability and can be used satisfactorily for any heavy oil/bitumen/solvent system. In order to improve the accuracy of the calculated densities, a constant density translation method can also be applied to the bitumen/oil mixtures. When the translation method was used, the AAD of mixtures was improved to 0.69%. The proposed method was found to be better or comparable to other models in predicting densities.
- 25 April 2022
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 41 (4) , 425-443
Algorithm for estimating SARA fraction properties and its application in predicting the densities of heavy oils, bitumen and diluted bitumen with solvents
Using aromatic ring index (ARI) and the densities of saturates, aromatics, resins and asphaltenes (SARA) at any temperature, an algorithm was developed to iteratively estimate the molecular weights and specific gravities (60 °F) of the SARA fractions. The algorithm circumvents molecular weight measurements in reporting SARA fractions properties. Then, using the corresponding state principles the critical properties and acentric factor of the fractions were estimated using the correlations available in literature. Further, applying regular solution theory the densities of heavy oils, bitumen, and five diluted Athabasca bitumen with 5 solvents were predicted from Hankinson-Thomson and a compressed liquid density correlation. The average absolute deviation (AAD) in predicting the densities was found to be 1.33% for 1524 points with temperature range from 288 K to 463 K and pressure from 0.1 to 10 MPa. The method exhibits predictive ability and can be used satisfactorily for any heavy oil/bitumen/solvent system. In order to improve the accuracy of the calculated densities, a constant density translation method can also be applied to the bitumen/oil mixtures. When the translation method was used, the AAD of mixtures was improved to 0.69%. The proposed method was found to be better or comparable to other models in predicting densities.
- 1 October 2021
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 546, 113121
Determination of clathrate hydrates dissociation conditions in aqueous solutions of methanol and salt using the e-NRTL based model
- 1 October 2021
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 546, 113121
Determination of clathrate hydrates dissociation conditions in aqueous solutions of methanol and salt using the e-NRTL based model
- 12 August 2021
- Published by Springer Nature in Journal of Solution Chemistry
- Vol. 50 (9-10) , 1169-1188
High Pressure Solubility of Light Gases (CH4, C2H6, C3H8, H2S, CO2, N2, Xe, Ar and Kr) and Certain Gas Mixtures in Water from Cubic Equations of State
- 12 August 2021
- Published by Springer Nature in Journal of Solution Chemistry
- Vol. 50 (9-10) , 1169-1188
High Pressure Solubility of Light Gases (CH4, C2H6, C3H8, H2S, CO2, N2, Xe, Ar and Kr) and Certain Gas Mixtures in Water from Cubic Equations of State
- 14 July 2021
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 39 (15-16) , 564-581
Experimental and modeling of two heavy oil densities for temperatures from (288 to 358) K
Experimental liquid densities of two Omani heavy oils are provided as a function of temperature. The oils contain over 98% unknown fractions with molecular weights over 600. The unknown fractions were split using gamma function and characterized with methods suited for conventional oils. In addition, a previously developed saturated liquid density correlation was modified to calculate the liquid densities of the two heavy oils. A parameter so-called characteristic volume was developed to substitute critical volume. A method for estimating the characteristic volumes for unknown fractions is devised. A set of mixing rules is also furnished to apply with the modified density correlation. When the correlation with the mixing rules were applied to the heavy oils, the agreement with experimental liquid density data was found satisfactory. Average absolute deviation in calculating densities for both oils for temperatures from 288 K to 358 K was found to be 1.2%.
- 14 July 2021
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 39 (15-16) , 564-581
Experimental and modeling of two heavy oil densities for temperatures from (288 to 358) K
Experimental liquid densities of two Omani heavy oils are provided as a function of temperature. The oils contain over 98% unknown fractions with molecular weights over 600. The unknown fractions were split using gamma function and characterized with methods suited for conventional oils. In addition, a previously developed saturated liquid density correlation was modified to calculate the liquid densities of the two heavy oils. A parameter so-called characteristic volume was developed to substitute critical volume. A method for estimating the characteristic volumes for unknown fractions is devised. A set of mixing rules is also furnished to apply with the modified density correlation. When the correlation with the mixing rules were applied to the heavy oils, the agreement with experimental liquid density data was found satisfactory. Average absolute deviation in calculating densities for both oils for temperatures from 288 K to 358 K was found to be 1.2%.
- 1 May 2019
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 282, 131-141
Generalized correlations for calculating the density of ionic liquids at 0.1 MPa and higher pressures
- 1 May 2019
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 282, 131-141
Generalized correlations for calculating the density of ionic liquids at 0.1 MPa and higher pressures
- Open Access
- 20 March 2018
- Published by EDP Sciences in Oil & Gas Science and Technology – Revue d’IFP Energies nouvelles
- Vol. 73, 7
Equations of State with Group Contribution Binary Interaction Parameters for Calculation of Two-Phase Envelopes for Synthetic and Real Natural Gas Mixtures with Heavy Fractions
Three equations of state with a group contribution model for binary interaction parameters were employed to calculate the vapor-liquid equilibria of synthetic and real natural gas mixtures with heavy fractions. In order to estimate the binary interaction parameters, critical temperatures, critical pressures and acentric factors of binary constituents of the mixture are required. The binary interaction parameter model also accounts for temperature. To perform phase equilibrium calculations, the heavy fractions were first discretized into 12 Single Carbon Numbers (SCN) using generalized molecular weights. Then, using the generalized molecular weights and specific gravities, the SCN were characterized. Afterwards, phase equilibrium calculations were performed employing a set of (nc + 1) equations where nc stands for the number of known components plus 12 SCN. The equations were solved iteratively using Newton's method. Predictions indicate that the use of binary interaction parameters for highly sour natural gas mixtures is quite important and must not be avoided. For sweet natural gas mixtures, the use of binary interaction parameters is less remarkable, however.
- 20 March 2018
- Published by EDP Sciences in Oil & Gas Science and Technology – Revue d’IFP Energies nouvelles
- Vol. 73, 7
Open AccessEquations of State with Group Contribution Binary Interaction Parameters for Calculation of Two-Phase Envelopes for Synthetic and Real Natural Gas Mixtures with Heavy Fractions
Three equations of state with a group contribution model for binary interaction parameters were employed to calculate the vapor-liquid equilibria of synthetic and real natural gas mixtures with heavy fractions. In order to estimate the binary interaction parameters, critical temperatures, critical pressures and acentric factors of binary constituents of the mixture are required. The binary interaction parameter model also accounts for temperature. To perform phase equilibrium calculations, the heavy fractions were first discretized into 12 Single Carbon Numbers (SCN) using generalized molecular weights. Then, using the generalized molecular weights and specific gravities, the SCN were characterized. Afterwards, phase equilibrium calculations were performed employing a set of (nc + 1) equations where nc stands for the number of known components plus 12 SCN. The equations were solved iteratively using Newton's method. Predictions indicate that the use of binary interaction parameters for highly sour natural gas mixtures is quite important and must not be avoided. For sweet natural gas mixtures, the use of binary interaction parameters is less remarkable, however.