Subramanian Ramalingam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Subramanian Ramalingam has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Constantine A. Balanis
School of Electrical, Computer and Energy Engineering, Arizona State University, Tempe, AZ, USA
5 shared publications Craig R. Birtcher
School of Electrical, Computer, and Energy Engineering, Arizona State University (ASU), Tempe, AZ 85287 USA
3 shared publications- Hussein N. Shaman
Center of Excellence for Microwave Sensor Technology, King Abdulaziz City for Science and Technology, Riyadh, Saudi Arabia
3 shared publications - Craig R. Birtcher
School of Electrical, Computer and Energy Engineering, Arizona State University, Tempe, Arizona United States
2 shared publications - Anuj Y. Modi
School of Electrical, Computer, and Energy Engineering (Ira A. Fulton Schools of Engineering), Arizona State University, Tempe, AZ 85287 USA
1 shared publication - Meshaal A. Alyahya
School of Electrical, Computer, and Energy Engineering, Arizona State University, Tempe, AZ 85287, USA
1 shared publication
Latest Publications
- Open Access
- 6 August 2020
- Published by MDPI AG in Electronics
- Vol. 9 (8) , 1262
Metasurfaces for Reconfiguration of Multi-Polarization Antennas and Van Atta Reflector Arrays
This paper discusses the application of metasurfaces for three different classes of antennas: reconfiguration of surface-wave antenna arrays, realization of high-gain polarization-reconfigurable leaky-wave antennas (LWAs), and performance enhancement of van Atta retrodirective reflectors. The proposed surface-wave antenna is designed by embedding four square ring elements within a metasurface, which improves matching and enhances the gain when compared to conventional square-ring arrays. The design for linear polarization comprises of a 1 × 4 arrangement of ring elements, with a 0.56 spacing, placed amidst periodic patches. A 2 × 2 arrangement of ring elements is utilized for reconfiguration from linear to circular polarization, where a similar peak gain with better port isolation is realized. A prototype of the 2 × 2 array is fabricated and measured; a good agreement is observed between simulations and measurements. In addition, the concepts of the design of polarization-diverse holographic metasurface LWAs that form a pencil beam in the desired direction with a reconfigurable polarization are discussed. Moreover, recent developments incorporating polarization-reconfigurability in metasurface LWAs are briefly reviewed. In the end, the theory of van Atta arrays is outlined and their monostatic RCS is reviewed. A conventional retrodirective array is designed using aperture-coupled patch antennas with a microstrip-line feeding network, where the scattering from the structure itself degrades the performance of the reflector. This is followed by the integration of judiciously synthesized metasurfaces to reconfigure and improve the performance of retrodirective reflectarrays by removing the above-mentioned undesired scattering from the structure.- 6 August 2020
- Published by MDPI AG in Electronics
- Vol. 9 (8) , 1262
Open AccessMetasurfaces for Reconfiguration of Multi-Polarization Antennas and Van Atta Reflector Arrays
This paper discusses the application of metasurfaces for three different classes of antennas: reconfiguration of surface-wave antenna arrays, realization of high-gain polarization-reconfigurable leaky-wave antennas (LWAs), and performance enhancement of van Atta retrodirective reflectors. The proposed surface-wave antenna is designed by embedding four square ring elements within a metasurface, which improves matching and enhances the gain when compared to conventional square-ring arrays. The design for linear polarization comprises of a 1 × 4 arrangement of ring elements, with a 0.56 spacing, placed amidst periodic patches. A 2 × 2 arrangement of ring elements is utilized for reconfiguration from linear to circular polarization, where a similar peak gain with better port isolation is realized. A prototype of the 2 × 2 array is fabricated and measured; a good agreement is observed between simulations and measurements. In addition, the concepts of the design of polarization-diverse holographic metasurface LWAs that form a pencil beam in the desired direction with a reconfigurable polarization are discussed. Moreover, recent developments incorporating polarization-reconfigurability in metasurface LWAs are briefly reviewed. In the end, the theory of van Atta arrays is outlined and their monostatic RCS is reviewed. A conventional retrodirective array is designed using aperture-coupled patch antennas with a microstrip-line feeding network, where the scattering from the structure itself degrades the performance of the reflector. This is followed by the integration of judiciously synthesized metasurfaces to reconfigure and improve the performance of retrodirective reflectarrays by removing the above-mentioned undesired scattering from the structure. - Open Access
- 18 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 1, 26-40
Analysis and Design of Checkerboard Leaky-Wave Antennas With Low Radar Cross Section
This paper addresses the analysis and design of a new class of metasurface leaky-wave antennas (LWAs) that inherently have low monostatic radar cross section (RCS) for normal incidence parallel polarization. The impedance profile of these antennas is modulated with a square wave to achieve leaky-wave behavior with low RCS. The low RCS performance is justified by the concepts of generalized Snell’s law of reflection and array theory. When the reflection phase difference between consecutive periods is near 180∘, the power reflected in the specular direction is minimal. It is also shown that modulating the surface impedance with a square wave still results in a high-gain fan beam similar to that of a sinusoidal modulation; however, the trade-off for obtaining a low RCS is an increase in the sidelobe level due to radiation from higher-order harmonics. A similar trade-off exists between the gain/beamwidth and RCS reduction. A prototype of an LWA with low RCS was fabricated and measured; an excellent agreement was observed between simulations and measurements.
- 18 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 1, 26-40
Open AccessAnalysis and Design of Checkerboard Leaky-Wave Antennas With Low Radar Cross Section
This paper addresses the analysis and design of a new class of metasurface leaky-wave antennas (LWAs) that inherently have low monostatic radar cross section (RCS) for normal incidence parallel polarization. The impedance profile of these antennas is modulated with a square wave to achieve leaky-wave behavior with low RCS. The low RCS performance is justified by the concepts of generalized Snell’s law of reflection and array theory. When the reflection phase difference between consecutive periods is near 180∘, the power reflected in the specular direction is minimal. It is also shown that modulating the surface impedance with a square wave still results in a high-gain fan beam similar to that of a sinusoidal modulation; however, the trade-off for obtaining a low RCS is an increase in the sidelobe level due to radiation from higher-order harmonics. A similar trade-off exists between the gain/beamwidth and RCS reduction. A prototype of an LWA with low RCS was fabricated and measured; an excellent agreement was observed between simulations and measurements.
- 1 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 623-624
Radiation of Forward and Backward Leaky Waves in Sinusoidally-Modulated Metasurfaces
This paper compares the radiation characteristics of forward and backward leaky waves in one-dimensionally periodic metasurface leaky-wave antennas (LWAs). Two LWAs are designed to form a fan beam along +30° and 30° from broadside at 15 GHz. It is shown that the LWA −employing backward leaky waves has a higher scan-angle range (∆θ = 55° as compared to ∆θ = 34°) and a slightly higher gain within the bandwidth of 13 - 19 GHz.
- 1 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 623-624
Radiation of Forward and Backward Leaky Waves in Sinusoidally-Modulated Metasurfaces
This paper compares the radiation characteristics of forward and backward leaky waves in one-dimensionally periodic metasurface leaky-wave antennas (LWAs). Two LWAs are designed to form a fan beam along +30° and 30° from broadside at 15 GHz. It is shown that the LWA −employing backward leaky waves has a higher scan-angle range (∆θ = 55° as compared to ∆θ = 34°) and a slightly higher gain within the bandwidth of 13 - 19 GHz.
- 20 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 18 (2) , 264-268
Polarization-Diverse Holographic Metasurfaces
- 20 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 18 (2) , 264-268
Polarization-Diverse Holographic Metasurfaces
- 27 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 17 (1) , 130-133
Axially Modulated Cylindrical Metasurface Leaky-Wave Antennas
This letter addresses the design and analysis of cylindrical one-dimensional leaky-wave antennas (LWAs) in which the surface impedance is modulated along the axis of the cylinder. The surface impedance modulation function for these LWAs is obtained using the holographic principle. The effect of the curvature for the radiation characteristics of the antenna are explained by projecting the curved aperture of the antenna onto a planar aperture. An analytical model is developed to predict the radiation characteristics of the antenna. The utilization of these antennas for automotive radar applications is examined in some detail. The effect of painting the antenna surface, and used as a cover, is predicted using a transmission line model.
- 27 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 17 (1) , 130-133
Axially Modulated Cylindrical Metasurface Leaky-Wave Antennas
This letter addresses the design and analysis of cylindrical one-dimensional leaky-wave antennas (LWAs) in which the surface impedance is modulated along the axis of the cylinder. The surface impedance modulation function for these LWAs is obtained using the holographic principle. The effect of the curvature for the radiation characteristics of the antenna are explained by projecting the curved aperture of the antenna onto a planar aperture. An analytical model is developed to predict the radiation characteristics of the antenna. The utilization of these antennas for automotive radar applications is examined in some detail. The effect of painting the antenna surface, and used as a cover, is predicted using a transmission line model.