ANAkinori Nagano

Akinori Nagano

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Akinori Nagano has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Peak hip and knee joint moments during a sit-to-stand movement are invariant to the change of seat height within the range of low to normal seat height

    by Shinsuke Yoshioka, Akinori Nagano, Dean C Hay, Senshi Fukashiro

    Previous studies have consistently reported that decreasing seat height increases the peak hip and knee joint moments; however, these findings may not apply to biomechanical changes at very low seat heights. The purpose of this study, therefore, was to examine the effect of a large range of seat heights on peak joint moments of the lower limb during a sit-to-stand (STS) movement. Eight healthy young subjects participated in this experiment. Each subject was instructed to stand up from six seat heights (10, 20, 30, 40, 50 and 60 cm). Joint moments were calculated with an inverse dynamics method. The sum of the hip and knee joint moments was used as the index to indicate the mechanical load of the STS movement. The effect of seat height on the mechanical load was examined with both analytical and experimental approaches. Through the analytical approach, it was revealed that the mechanical load of STS movements from low and normal seat heights (10 to 40 cm) always reaches its peak at or near the posture in which the thigh is horizontally positioned. This finding indicates that the peak value is invariant between the low and normal seat heights. Similar results were also found in the experimental approach. There were few significant differences in the peak mechanical load and the peak hip and knee joint moments between the low and normal seat heights, while they differed significantly between the low and high seat heights. This study concluded that, while the peak mechanical load and the peak hip and knee joint moments increase inversely to seat height within the range of high to normal seat height (60 to 40 cm), they are invariant to the change of seat height within the range of low to normal seat height (10 to 40 cm). These findings are useful for the design of chair, the improvement in the evaluation standard of minimum sit-to-stand height tests and the development of new muscular strength test.


  • Open Access

    Prevention of Running Injuries through Real-time Visual Feedback

    by Kazutaka Iwao, Akinori Nagano, Zhiwei Luo

  • Open Access

    A virtual shopping test for realistic assessment of cognitive function

    by Sayaka Okahashi, Keiko Seki, Akinori Nagano, Zhiwei Luo, Maki Kojima, Toshiko Futaki

    Cognitive dysfunction caused by brain injury often prevents a patient from achieving a healthy and high quality of life. By now, each cognitive function is assessed precisely by neuropsychological tests. However, it is also important to provide an overall assessment of the patients’ ability in their everyday life. We have developed a Virtual Shopping Test (VST) using virtual reality technology. The objective of this study was to clarify 1) the significance of VST by comparing VST with other conventional tests, 2) the applicability of VST to brain-damaged patients, and 3) the performance of VST in relation to age differences. The participants included 10 patients with brain damage, 10 age-matched healthy subjects for controls, 10 old healthy subjects, and 10 young healthy subjects. VST and neuropsychological tests/questionnaires about attention, memory and executive function were conducted on the patients, while VST and the Mini-Mental State Examination (MMSE) were conducted on the controls and healthy subjects. Within the VST, the participants were asked to buy four items in the virtual shopping mall quickly in a rational way. The score for evaluation included the number of items bought correctly, the number of times to refer to hints, the number of movements between shops, and the total time spent to complete the shopping. Some variables on VST correlated with the scores of conventional assessment about attention and everyday memory. The mean number of times referring to hints and the mean number of movements were significantly larger for the patients with brain damage, and the mean total time was significantly longer for the patients than for the controls. In addition, the mean total time was significantly longer for the old than for the young. The results suggest that VST is able to evaluate the ability of attention and everyday memory in patients with brain damage. The time of VST is increased by age.


  • Open Access

    Biomechanical analysis of the relation between movement time and joint moment development during a sit-to-stand task

    by Shinsuke Yoshioka, Akinori Nagano, Dean C Hay, Senshi Fukashiro

    Slowness of movement is a factor that may cause a decrease of quality of daily life. Mobility in the elderly and people with movement impairments may be improved by increasing the quickness of fundamental locomotor tasks. Because it has not been revealed how much muscle strength is required to improve quickness, the purpose of this study was to reveal the relation between movement time and the required muscle strength in a sit to stand (STS) task. Previous research found that the sum of the peak hip and knee joint moments was relatively invariant throughout a range of movement patterns (Yoshioka et al., 2007, Biomedical Engineering Online 6:26). The sum of the peak hip and knee joint moment is an appropriate index to evaluate the muscle strength required for an STS task, since the effect of the movement pattern variation can be reduced, that is, the results can be evaluated purely from the viewpoint of the movement times. Therefore, the sum of the peak hip and knee joint moment was used as the index to indicate the required muscle strength. Experimental kinematics data were collected from 11 subjects. The time at which the vertical position of the right shoulder fell outside three standard deviations of the vertical positions during the static initial posture was regarded as the start time. The time at which the vertical position fell within three standard deviations of the vertical positions during static upright standing posture was regarded as the finish time. Each movement time of the experimental movements was linearly lengthened and shortened through post-processing. Combining the experimental procedure and the post-processing, movements having various movement patterns and a wide range of movement times were obtained. The joint moment and the static and inertial components of the joint moment were calculated with an inverse dynamics method. The static component reflects the gravitational and/or external forces, while the inertial component reflects the acceleration of the body. The quantitative relation between the movement time and the sum of the peak hip and knee joint moments were obtained. As the STS movement time increased, the joint moments decreased exponentially and converged to the static component (1.51 ~ 1.54 N.m/kg). When the movement time was the longest (movement time: 7.0 seconds), the joint moments (1.57 N.m/kg) closely corresponded to the minimum of 1.53 N.m/kg as reported by Yoshioka et al.. The key findings of this study are as follows. (1) The minimum required joint moment for an STS task is essentially equivalent to the static component of the joint moment. (2) For fast and moderate speed movements (less than 2.5 seconds), joint moments increased exponentially as the movement speed increased. (3) For slow movements greater than 2.5 seconds, the joint moments were relatively constant. The results of this STS research has practical applications, especially in rehabilitations and exercise prescription where improved movement time is an intended target, since the required muscle strength can be quantitatively estimated.