Alexander Gribenyukov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Alexander Gribenyukov has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Sergey Podzyvalov
Scientific Educational Center “Optical and Photonic Technologies”, National Research Tomsk State University, 634050 Tomsk, Russia
8 shared publications - Elena Slyunko
Scientific Educational Center “Optical and Photonic Technologies”, National Research Tomsk State University, 634050 Tomsk, Russia
6 shared publications - Nikolai Nikolayevich Yudin
Scientific Educational Center “Optical and Photonic Technologies”, National Research Tomsk State University, 634050 Tomsk, Russia
6 shared publications - Victor Dyomin
Laboratory for Radiophysical and Optical Methods of Environmental Research, National Research Tomsk State University, 36 Lenin Avenue, 634050 Tomsk, Russia
6 shared publications - Mikhail Zinoviev
Scientific Educational Center “Optical and Photonic Technologies”, National Research Tomsk State University, 634050 Tomsk, Russia
5 shared publications - Oleg Leonidovich Antipov
Russian Academy of Sciences
5 shared publications
Latest Publications
- Open Access
- 28 May 2026
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 27 (11) , 4890
Minimization of Intrinsic Impurity Concentration in ZnGeP2 Single Crystals via Directional Recrystallization
Zinc germanium phosphide (ZnGeP2) is an important nonlinear crystal for mid-infrared conversion, but its performance is limited by residual absorption and intrinsic impurity phases. In this study, polycrystalline ZnGeP2 was synthesized by a modified two-temperature method, purified by inclined directional recrystallization for up to three cycles, and then grown into single crystals by the vertical Bridgman method. The resulting material was examined by shadow-projection imaging, transmission spectroscopy in the 650–2500 nm range, absorption measurements at 2.097 µm, laser-induced damage threshold (LIDT) testing, and powder X-ray diffraction. Repeated purification improved optical homogeneity and near-infrared transparency, while the absorption coefficient at 2.097 µm decreased from 0.45 to 0.30 cm−1 after three purification cycles. Semi-quantitative PXRD analysis showed progressive suppression of intrinsic impurity phosphides, with phase purity increasing from 86.31% after the first cycle to 95.995% after the second and reaching 100% after the third within the detection limit of the method. However, the LIDT decreased with increasing purification number, indicating a trade-off between lower optical losses and damage resistance. These results demonstrate that inclined directional recrystallization is an effective pre-growth purification route for ZnGeP2 and that the optimal number of purification cycles should be selected according to the intended application.
- 28 May 2026
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 27 (11) , 4890
Open AccessMinimization of Intrinsic Impurity Concentration in ZnGeP2 Single Crystals via Directional Recrystallization
Zinc germanium phosphide (ZnGeP2) is an important nonlinear crystal for mid-infrared conversion, but its performance is limited by residual absorption and intrinsic impurity phases. In this study, polycrystalline ZnGeP2 was synthesized by a modified two-temperature method, purified by inclined directional recrystallization for up to three cycles, and then grown into single crystals by the vertical Bridgman method. The resulting material was examined by shadow-projection imaging, transmission spectroscopy in the 650–2500 nm range, absorption measurements at 2.097 µm, laser-induced damage threshold (LIDT) testing, and powder X-ray diffraction. Repeated purification improved optical homogeneity and near-infrared transparency, while the absorption coefficient at 2.097 µm decreased from 0.45 to 0.30 cm−1 after three purification cycles. Semi-quantitative PXRD analysis showed progressive suppression of intrinsic impurity phosphides, with phase purity increasing from 86.31% after the first cycle to 95.995% after the second and reaching 100% after the third within the detection limit of the method. However, the LIDT decreased with increasing purification number, indicating a trade-off between lower optical losses and damage resistance. These results demonstrate that inclined directional recrystallization is an effective pre-growth purification route for ZnGeP2 and that the optimal number of purification cycles should be selected according to the intended application.
- Open Access
Physical and Technological Aspects of Laser-Induced Damage of ZGP Single Crystals under Periodically Pulsed Laser Irradiation at 2.1 μm
The nonlinear properties of zinc germanium diphosphide (ZGP) crystals enable their applications in powerful mid-IR optical parametric oscillators and second-harmonic generators. This paper summarizes the mechanisms of the laser-induced damage (LID) of high-purity ZGP crystals under periodically pulsed nanosecond irradiation by a Ho3+:YAG laser at 2.1 μm. The ZGP samples were manufactured by “LOC” Ent., Tomsk, Russia, or the Harbin Institute of Technology, China. The impact of processing techniques and the post-growing methods for polishing and anti-reflective coatings on the LID threshold are discussed. The importance of the defect structure of the crystal lattice and the parameters of transparent coatings for increasing the LID threshold are also discussed. The impact of the test laser parameters on the LID threshold and the transient area near the LID threshold obtained using digital holography are analyzed. The influence of the pre-damage processes on the optical parametric oscillations is reported. Lastly, the prospects for improving ZGP crystals to further increase the LID threshold are discussed.
Open AccessPhysical and Technological Aspects of Laser-Induced Damage of ZGP Single Crystals under Periodically Pulsed Laser Irradiation at 2.1 μm
The nonlinear properties of zinc germanium diphosphide (ZGP) crystals enable their applications in powerful mid-IR optical parametric oscillators and second-harmonic generators. This paper summarizes the mechanisms of the laser-induced damage (LID) of high-purity ZGP crystals under periodically pulsed nanosecond irradiation by a Ho3+:YAG laser at 2.1 μm. The ZGP samples were manufactured by “LOC” Ent., Tomsk, Russia, or the Harbin Institute of Technology, China. The impact of processing techniques and the post-growing methods for polishing and anti-reflective coatings on the LID threshold are discussed. The importance of the defect structure of the crystal lattice and the parameters of transparent coatings for increasing the LID threshold are also discussed. The impact of the test laser parameters on the LID threshold and the transient area near the LID threshold obtained using digital holography are analyzed. The influence of the pre-damage processes on the optical parametric oscillations is reported. Lastly, the prospects for improving ZGP crystals to further increase the LID threshold are discussed.
- Open Access
- 23 November 2023
- Published by MDPI AG in Preprints.org
Physical and Technological Aspects of Laser Induced Damage of ZGP Single Crystals under Periodically-Pulsed Laser Irradiation at 2.1 μm
Nonlinear properties of zinc germanium diphosphide (ZGP) crystals enable their ap-plications in powerful mid-IR optical parametric oscillators and second-harmonic generators. This paper summarizes mechanisms of the laser induced damage (LID) in high-purity ZGP crystals under periodically pulsed nanosecond irradiation by a Ho3+:YAG laser at 2.1 μm. The ZGP samples were manufactured by “LOC” Ent., Tomsk, Russia, or Harbin Institute of Technology, China. The impact of processing techniques and the post-growing methods for polishing and anti-reflection coating on the LID threshold are discussed. The importance of the defect structure of the crystal lattice and the parameters of transparent coatings for increasing the LID threshold is discussed. The impact of the test laser parameters on the LID threshold is analyzed. The transient area near the LID threshold obtained using digital holography is ana-lyzed. Influence of the pre-damage processes on the optical parametric oscillations is reported. Prospects for improving ZGP crystals to further increase the LID threshold are discussed.
- 23 November 2023
- Published by MDPI AG in Preprints.org
Open AccessPhysical and Technological Aspects of Laser Induced Damage of ZGP Single Crystals under Periodically-Pulsed Laser Irradiation at 2.1 μm
Nonlinear properties of zinc germanium diphosphide (ZGP) crystals enable their ap-plications in powerful mid-IR optical parametric oscillators and second-harmonic generators. This paper summarizes mechanisms of the laser induced damage (LID) in high-purity ZGP crystals under periodically pulsed nanosecond irradiation by a Ho3+:YAG laser at 2.1 μm. The ZGP samples were manufactured by “LOC” Ent., Tomsk, Russia, or Harbin Institute of Technology, China. The impact of processing techniques and the post-growing methods for polishing and anti-reflection coating on the LID threshold are discussed. The importance of the defect structure of the crystal lattice and the parameters of transparent coatings for increasing the LID threshold is discussed. The impact of the test laser parameters on the LID threshold is analyzed. The transient area near the LID threshold obtained using digital holography is ana-lyzed. Influence of the pre-damage processes on the optical parametric oscillations is reported. Prospects for improving ZGP crystals to further increase the LID threshold are discussed.
- 24 March 2023
- Published by Springer Nature in Russian Physics Journal
- Vol. 65 (12) , 2130-2136
Visualization and Characterization of Pre-breakdown Processes in the Volume of a ZnGeP2 Single Crystal During Parametric Generation of Radiation in the Wavelength Range of 3.5–5 μm when Pumped by Ho:YAG Laser Radiation
- 24 March 2023
- Published by Springer Nature in Russian Physics Journal
- Vol. 65 (12) , 2130-2136
Visualization and Characterization of Pre-breakdown Processes in the Volume of a ZnGeP2 Single Crystal During Parametric Generation of Radiation in the Wavelength Range of 3.5–5 μm when Pumped by Ho:YAG Laser Radiation
- 2 February 2023
- Published by Elsevier in Optical Materials
- Vol. 137
Combined use of optical technologies for complex diagnostics of opaque nonlinear optical materials
- 2 February 2023
- Published by Elsevier in Optical Materials
- Vol. 137
Combined use of optical technologies for complex diagnostics of opaque nonlinear optical materials
- Open Access
Laser-Induced Damage Threshold of Single Crystal ZnGeP2 at 2.1 µm: The Effect of Crystal Lattice Quality at Various Pulse Widths and Repetition Rates
The ZnGeP2 crystal is a material of choice for powerful mid-IR optical parametric oscillators and amplifiers. In this paper, we present the experimental analysis of the optical damage threshold of ZnGeP2 nonlinear crystals induced by a repetitively-pulsed Ho3+:YAG laser at 2091 nm. Two types of ZnGeP2 crystals grown under different conditions were examined using the laser and holographic techniques. The laser-induced damage threshold (LIDT) determined by the pulse fluence or peak intensity was studied as a function of the pulse repetition rate (PRR) and laser exposure duration. The main crystal structure factor for a higher LIDT was found to be a reduced dislocation density of crystal lattice. The ZnGeP2 nonlinear crystals characterized by the high structural perfection with low density of dislocations and free from twinning and stacking faults were measured to have a 3.5 J/cm2 pulse fluence damage threshold and 10.5 MW/cm2 peak intensity damage threshold at 12 kHz PRR; at 40 kHz PRR the pulse fluence damage threshold increased to over 6 J/cm2, but the peak intensity damage threshold dropped to 5.5 MW/cm2.
Open AccessLaser-Induced Damage Threshold of Single Crystal ZnGeP2 at 2.1 µm: The Effect of Crystal Lattice Quality at Various Pulse Widths and Repetition Rates
The ZnGeP2 crystal is a material of choice for powerful mid-IR optical parametric oscillators and amplifiers. In this paper, we present the experimental analysis of the optical damage threshold of ZnGeP2 nonlinear crystals induced by a repetitively-pulsed Ho3+:YAG laser at 2091 nm. Two types of ZnGeP2 crystals grown under different conditions were examined using the laser and holographic techniques. The laser-induced damage threshold (LIDT) determined by the pulse fluence or peak intensity was studied as a function of the pulse repetition rate (PRR) and laser exposure duration. The main crystal structure factor for a higher LIDT was found to be a reduced dislocation density of crystal lattice. The ZnGeP2 nonlinear crystals characterized by the high structural perfection with low density of dislocations and free from twinning and stacking faults were measured to have a 3.5 J/cm2 pulse fluence damage threshold and 10.5 MW/cm2 peak intensity damage threshold at 12 kHz PRR; at 40 kHz PRR the pulse fluence damage threshold increased to over 6 J/cm2, but the peak intensity damage threshold dropped to 5.5 MW/cm2.
- 24 March 2022
- Published by Springer Nature in Russian Physics Journal
- Vol. 64 (11) , 2096-2101
Influence of Postgrowth Processing Technology on the Laser Induced Damage Threshold of ZnGeP2 Single Crystal
- 24 March 2022
- Published by Springer Nature in Russian Physics Journal
- Vol. 64 (11) , 2096-2101
Influence of Postgrowth Processing Technology on the Laser Induced Damage Threshold of ZnGeP2 Single Crystal
- 28 March 2019
- Published by Springer Nature in Russian Physics Journal
- Vol. 61 (11) , 2042-2052
Investigation of the Process of Optical Damage of ZnGeP2 Crystals Using Digital Holography
- 28 March 2019
- Published by Springer Nature in Russian Physics Journal
- Vol. 61 (11) , 2042-2052
Investigation of the Process of Optical Damage of ZnGeP2 Crystals Using Digital Holography