Minimization of Intrinsic Impurity Concentration in ZnGeP2 Single Crystals via Directional Recrystallization
Authors:
- Alexander GribenyukovAGAlexander Gribenyukov
- Alexey LysenkoALAlexey Lysenko
- Nikolay YudinNikolay Yudin
- Elena SlyunkoESElena Slyunko
- Sergey PodzyvalovSPSergey Podzyvalov
- Mikhail ZinovevMZMikhail Zinovev
- Vladimir KuznetsovVKVladimir Kuznetsov
- Andrey KalsinAKAndrey Kalsin
- Andrei KhudoleyAKAndrei Khudoley
- Houssain BaalbakiHBHoussain Baalbaki
- Maxim KuleshMKMaxim Kulesh
- Alexey OlshukovAOAlexey Olshukov
Open Access
- 28 May 2026
- journal article
- research article
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 27 (11) , 4890
Abstract
Zinc germanium phosphide (ZnGeP2) is an important nonlinear crystal for mid-infrared conversion, but its performance is limited by residual absorption and intrinsic impurity phases. In this study, polycrystalline ZnGeP2 was synthesized by a modified two-temperature method, purified by inclined directional recrystallization for up to three cycles, and then grown into single crystals by the vertical Bridgman method. The resulting material was examined by shadow-projection imaging, transmission spectroscopy in the 650–2500 nm range, absorption measurements at 2.097 µm, laser-induced damage threshold (LIDT) testing, and powder X-ray diffraction. Repeated purification improved optical homogeneity and near-infrared transparency, while the absorption coefficient at 2.097 µm decreased from 0.45 to 0.30 cm−1 after three purification cycles. Semi-quantitative PXRD analysis showed progressive suppression of intrinsic impurity phosphides, with phase purity increasing from 86.31% after the first cycle to 95.995% after the second and reaching 100% after the third within the detection limit of the method. However, the LIDT decreased with increasing purification number, indicating a trade-off between lower optical losses and damage resistance. These results demonstrate that inclined directional recrystallization is an effective pre-growth purification route for ZnGeP2 and that the optimal number of purification cycles should be selected according to the intended application.Keywords
Funding Information
- Russian Science Foundation (No. 25-42-10017)
- Belarusian Republican Foundation for Fundamental Research (No. T26RNF-037)
This publication has 15 references indexed in Scilit:
- Latest Research Progress in High-Purity Material Purification TechnologyACS Omega, 2025
- Thermodynamic Analysis of Zone MeltingJournal of Engineering Physics and Thermophysics, 2022
- Structural defects in ZnGeP2single crystals revealed by X-ray topographyJournal of Applied Crystallography, 2018
- Two-temperature synthesis of ZnGeP2Inorganic Materials, 2007
- Characterization of defect-related optical absorption in ZnGeP2Journal of Applied Physics, 1999
- Properties of Dopants in ZnGeP2, CdGeAs2, AgGaS2 and AgGaSe2MRS Bulletin, 1998
- Ultralow Gradient HGF-Grown ZnGeP2 and CdGeAs2 and Their Optical PropertiesMRS Bulletin, 1998
- ZnGeP2 synthesis and growth from meltMaterials Science and Engineering: B, 1997
- Impurity striations in crystalsProgress in Crystal Growth and Characterization of Materials, 1996
- Concerning growth of single crystal of the II-IV-V diamond-like compounds ZnSiP2, CdSiP2, ZnGeP2, and CdSnP2 and standard enthalpies of formation for ZnSiP2 and CdSiP2Journal of Crystal Growth, 1971