DKDongsung Kim

Dongsung Kim

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Dongsung Kim has a total of 63 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    First results from a high-frame-rate, multi-GHz ionizing particle detection system geared toward accelerator diagnostic applications

    by Mohammadreza Mohseni Ferezghi, Carl Grace, Mark Gulley, Bryce Jacobson, Dongsung Kim, Forest Martinez-McKinney, James McDaniel, Sean McHale, Tyler Morris, Samuel Mudford, et al.

    An integrated detection system, consists of a thin diamond sensor incorporated into a compact signal loop, coupled in turn to an application-specific integrated circuit readout chip, has been tested for the first time, using ps-duration electron pulses from the Next Linear Collider Test Accelerator at the SLAC National Accelerator Laboratory. For readout frame rates as high as 120 kHz, the detection system is shown to achieve a linear dynamic range of 10 3 and a bandwidth of 4–5 GHz, with no ringing seen on the tail of the output pulse. These results represent the best-performing multi-GHz ionizing particle detection system achieved to date.

  • Toward an integrated multi-gigahertz ionizing particle diagnostic

    by J. Bohon, C. Grace, M. Gulley, B. Jacobson, S. Kachiguine, D. Kim, F. Martinez-Mckinney, N. Nagel, M. Nizam, R. Padilla, et al.

    Needs arising at both current and future accelerator facilities call for the development of radiation-hardened position-sensing diagnostics that can operate with multi-GHz repetition rates. Such instruments are likely to also have applications in the diagnosis of rapid plasma behavior. Building on the recent work of our Advanced Accelerator Diagnostics Collaboration, we are exploring the development of integrated multi-GHz ionizing particle detection systems based on chemical-vapor deposition diamond sensors, with the initial goal of producing a quadrant detector that can determine the intensity and centroid position of a particle beam at a repetition rate between 5 and 10 GHz. Results from our initial high-speed characterization work are presented, including those from a single-channel sensor with a GHz response. Approaches to achieving multi-GHz (5–10 GHz) rate capability, including the design of a dedicated Application Specific Integrated Circuit and the use of 3D RF-solver computer aided design software, are presented and discussed in more detail. 3D RF simulations suggest clean pulses of duration less than 250 ps (FWHM less than 125 ps) can be achieved with the approaches developed by this work.


  • Open Access

    Ultrafast laser triggered electron emission from ultrananocrystalline diamond pyramid tip cathode

    by A. Kachwala, O. Chubenko, D. Kim, E. I. Simakov, S. Karkare

    Nitrogen-incorporated ultrananocrystalline diamond [(N)UNCD] pyramid tip cathode has been considered as a next-generation high peak current electron source for dielectric laser accelerators as well as other high peak current particle accelerator applications. In this work, we study non-linear photoemission from an (N)UNCD pyramid tip cathode using an ultrafast laser with the pulse length of 150 fs with the central wavelength of 800 nm in the peak intensity range of 109–1010W/cm2. We demonstrated that as the incident laser intensity increases, the current emitted from the nano-tip first increases as a power function with an exponent of about 5 and then starts to roll over to an exponent of 3. This roll over is attributed to the Coulomb interaction between electrons emitted from the tip also known as the space charge. We also measured the photoemission electron energy spectra that show electrons with energies as high as ∼10 eV. Based on the shape of the electron energy spectra, we conclude that the high-energy electrons are thermally emitted electrons due to ultrafast laser heating at the tip of the (N)UNCD pyramid tip cathode.


  • Open Access

    Diagnostics for PSR Upgrade

    by Haoran Xu, Dongsung Kim, Charles Edward Taylor, Janardan Upadhyay

    The U.S. Department of Energy's Office of Scientific and Technical Information


  • Open Access

    Effect of material composition of diamond field emission array cathodes on quality of transversely shaped beams

    by Mitchell E. Schneider, Heather Andrews, Sergey V. Baryshev, Emily Jevarjian, Dongsung Kim, Kimberley Nichols, Taha Y. Posos, Michael Pettes, John Power, Jiahang Shao, et al.

    Diamond field emitter array field emission cathodes (DFEA FECs) are attractive for the next generation of injectors due to their ability to produce transversely shaped beams without the need for complex masking or laser schemes. However, reliability of this cathode technology remains a challenging issue as principal mechanisms guiding and allowing for output beam shaping remained poorly understood. This paper reports the results of testing two DFEA FECs with the same pattern and emitter tip geometry. Although both cathodes were able to sustain gradients of 44 MV/m and produce maximum output integral charge of 0.5 nC per radio frequency pulse, their emission patterns were different. One cathode did not produce a shaped beam, while the other one did. This difference was explained by the extent of the local variations of the diamond material across the arrays as discovered by spatially resolved Raman spectroscopy. The main practical takeaways were (i) tip sharpness was not a prerequisite for producing a shaped beam and instead (ii) material characteristics resulting in different cathode ballast resistance affected emission spatial uniformity across the array and hence the beam shaping.


  • Quantum efficiency, photoemission energy spectra, and mean transverse energy of ultrananocrystalline diamond photocathode

    by A. Kachwala, O. Chubenko, D. Kim, E. I. Simakov, S. Karkare

    The quantum efficiency and mean transverse energy of electrons emitted from a cathode determine the quality of beams generated from photoinjectors. The nitrogen-incorporated ultrananocrystalline diamond, (N)UNCD, is a new class of robust semiconductor photocathodes, which has been considered in photoinjectors for high peak current extraction. In this work, we measure the spectral response in quantum efficiency, photoemission energy spectra, and mean transverse energy of the (N)UNCD photocathode using a photoemission electron microscope. The observed quantum efficiency was comparable to that of copper photocathodes. Photoemission spectra showed the evidence of scattering of electrons before emission. This relaxation of electrons due to scattering is also observed in the spectral response of the mean transverse energy. The mean transverse energy is limited to ∼70 meV at the threshold. We attribute this to the physical and chemical roughness of the (N)UNCD photocathode and, hence, smoother films will be required to further reduce the mean transverse energy obtained from the (N)UNCD photocathode.


  • Evaluation of Synthetic Diamond Detectors for Fast Neutron and X-ray Detection [Slides]

    by Dongsung Kim, John Morgan Smedley, Jennifer Michelle Bohon

    The U.S. Department of Energy's Office of Scientific and Technical Information

  • Demonstration of transport of a patterned electron beam produced by diamond pyramid cathode in an rf gun

    by K. E. Nichols, H. L. Andrews, D. Kim, E. I. Simakov, M. Conde, D. S. Doran, G. Ha, W. Liu, J. F. Power, J. Shao, et al.

    We have demonstrated generation and transport of a patterned electron beam from a Diamond Field-Emitter Array (DFEA) cathode in a radio frequency (rf) gun. DFEAs are arrays of micrometer-scale pyramids with nanometer-scale tips. They can be fabricated with base widths ranging from 3 μm to 25 μm and pitches as small as 5 μm. They have an inherent 1:0.7 base to height ratio. DFEAs operate as field-emitter cathodes and potentially produce intrinsically shaped electron beams, which are of interest for a number of accelerator applications. We report on the results of a recent experiment in which a beam, consisting of several beamlets, was produced from a DFEA cathode in an rf gun and transported 2.54 m along a beam line. A macrobunch charge of 60 pC was measured at a cathode field gradient of 15.1 MV/m.


  • Open Access

    Modeling of diamond field emitter arrays for a compact source of high brightness electron beams

    by C.-K. Huang, H. L. Andrews, R. C. Baker, R. L. Fleming, D. Kim, T. J. T. Kwan, A. Piryatinski, V. Pavlenko, E. I. Simakov

    Many applications, such as compact accelerators and electron microscopy, demand high brightness electron beams with small source size and ultralow emittance. Diamond emitters manufactured with semiconductor processes can be employed in such compact beam sources. The micrometer-scale pyramid structure of the emitter allows enhancement of the external field compared to that at the substrate, leading to electron emission with small beam size. We investigate the dependence of the field enhancement on the shape of the emitter and the resulting emission characteristics. The beam formation and dynamics are simulated with the LSP [D. Welch, D. Rose, R. Clark, T. Genoni, and T. Hughes, Comput. Phys. Commun. 164, 183 (2004)] particle-in-cell code to obtain the macroscopic observables. To account for the semiconductor charge transport in the bulk material and the tunneling through the surface, a first-principle semiclassical Monte Carlo emission model is developed and applied to the diamond pyramid. Using this Monte Carlo emission model and the result from the geometric field enhancement calculation, we construct a simple model to qualitatively explain the measured emission characteristics. A comparison between our model and experiments indicates that the beam current is mostly emitted at the apex of the emitter.