Shima Pashangeh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Shima Pashangeh has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
Morteza Alizadeh
5 shared publications- Mahesh Chandra Somani
University of Oulu
4 shared publications - Mohammad Hadi Moradi Ardekani
Electrical Engineering Department, Faculty of Engineering, Yasouj University, Yasouj, Iran
4 shared publications - Morteza Alizadeh
Department of Materials Science and Engineering, Shiraz University of Technology, Shiraz, Iran
4 shared publications Seyyed Sadegh Ghasemi Banadkouki
Department of Mining and Metallurgical Engineering, Yazd University, Yazd, Iran
3 shared publications- Seyyed Sadegh Ghasemi Banadkouki
Mining Technologies Research Center, Department of Mining and Metallurgical Engineering, Yazd University, Yazd, Iran
3 shared publications
Latest Publications
- 10 February 2026
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 35 (20) , 19675-19692
Phase Interaction and Microstructural Progression in DIN 1.5025 Steel with Medium Carbon Content During Cooling: A Color Metallography Approach
- 10 February 2026
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 35 (20) , 19675-19692
Phase Interaction and Microstructural Progression in DIN 1.5025 Steel with Medium Carbon Content During Cooling: A Color Metallography Approach
- Open Access
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 151359-151370
A Wideband Single-Port Differential-Fed Linear Antenna Array With Low Side Lobe Level and Symmetric Radiation Patterns
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 151359-151370
Open AccessA Wideband Single-Port Differential-Fed Linear Antenna Array With Low Side Lobe Level and Symmetric Radiation Patterns
- 18 December 2025
- Published by Elsevier in Ceramics International
- Vol. 52 (4) , 4927-4947
Effect of reinforcement type, size, and content on bonding behavior of aluminum-based composites fabricated by cold roll bonding
- 18 December 2025
- Published by Elsevier in Ceramics International
- Vol. 52 (4) , 4927-4947
Effect of reinforcement type, size, and content on bonding behavior of aluminum-based composites fabricated by cold roll bonding
- 18 November 2025
- Published by Springer Nature in Metals and Materials International
- Vol. 32 (5) , 1729-1746
Fabrication and Characterization of Al/WC/MoS2 Hybrid Composite via Accumulative Roll Bonding: Microstructural Evolution, and Corrosion Behavior
- 18 November 2025
- Published by Springer Nature in Metals and Materials International
- Vol. 32 (5) , 1729-1746
Fabrication and Characterization of Al/WC/MoS2 Hybrid Composite via Accumulative Roll Bonding: Microstructural Evolution, and Corrosion Behavior
- Open Access
- 17 September 2025
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 39, 474-492
Microstructural evolution and kinetics of the bainite transformation in a silicon-alloyed medium-carbon steel via two-step quenching and partitioning treatment
- 17 September 2025
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 39, 474-492
Open AccessMicrostructural evolution and kinetics of the bainite transformation in a silicon-alloyed medium-carbon steel via two-step quenching and partitioning treatment
- Open Access
- 25 August 2025
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 38, 4482-4494
Modeling and investigation of fabrication parameters influencing the electrical conductivity of ARBed Al/MoS2 and Al/MoS2/WC composites
- 25 August 2025
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 38, 4482-4494
Open AccessModeling and investigation of fabrication parameters influencing the electrical conductivity of ARBed Al/MoS2 and Al/MoS2/WC composites
- Open Access
- 21 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 6 (6) , 1787-1798
Integration of Modified Degenerate Second-Order and Dominant Modes to Design a Broadband Single-Fed Circularly Polarized Patch Antenna
This paper presents a novel broadband single-fed circularly polarized (CP) patch antenna that achieves unprecedented bandwidth performance by leveraging the interaction between dominant (TM10, TM01) and second-order (TM20, TM02) modes. Unlike conventional designs, this antenna achieves simultaneous excitation and mode merging by strategically increasing the air gap between a suspended radiator and the ground plane. This alignment transforms the typical dual-beam radiation of second-order modes into a desirable single-beam broadside pattern. To achieve CP, a square slot, corner truncations, and feed displacement are used to excite orthogonal modes with appropriate phase shifts. Further, the integration of a capacitive probe feed and a capacitive shorting pin significantly enhances impedance bandwidth (IBW) and axial ratio bandwidth (ARBW), respectively. Measured results confirm the effectiveness of the proposed design, demonstrating an exceptional 71.8% IBW and 48.1% ARBW—the widest reported for a single-feed CP patch antenna to date. This work introduces a new strategy for mode control and polarization synthesis in compact patch antennas, offering a structurally simple yet high-performance solution for next-generation wireless communication systems.
- 21 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 6 (6) , 1787-1798
Open AccessIntegration of Modified Degenerate Second-Order and Dominant Modes to Design a Broadband Single-Fed Circularly Polarized Patch Antenna
This paper presents a novel broadband single-fed circularly polarized (CP) patch antenna that achieves unprecedented bandwidth performance by leveraging the interaction between dominant (TM10, TM01) and second-order (TM20, TM02) modes. Unlike conventional designs, this antenna achieves simultaneous excitation and mode merging by strategically increasing the air gap between a suspended radiator and the ground plane. This alignment transforms the typical dual-beam radiation of second-order modes into a desirable single-beam broadside pattern. To achieve CP, a square slot, corner truncations, and feed displacement are used to excite orthogonal modes with appropriate phase shifts. Further, the integration of a capacitive probe feed and a capacitive shorting pin significantly enhances impedance bandwidth (IBW) and axial ratio bandwidth (ARBW), respectively. Measured results confirm the effectiveness of the proposed design, demonstrating an exceptional 71.8% IBW and 48.1% ARBW—the widest reported for a single-feed CP patch antenna to date. This work introduces a new strategy for mode control and polarization synthesis in compact patch antennas, offering a structurally simple yet high-performance solution for next-generation wireless communication systems.
- 12 May 2025
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 34 (24) , 29539-29551
Phase Transformation Kinetics of Austenite in DIN 1.5025 Steel under Controlled Slow Cooling Conditions
- 12 May 2025
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 34 (24) , 29539-29551
Phase Transformation Kinetics of Austenite in DIN 1.5025 Steel under Controlled Slow Cooling Conditions
- Open Access
- 11 February 2025
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 35, 4647-4659
Characterization of wear and corrosion behavior of Al/Cu/MoS2/WC hybrid metal matrix composite fabricated via accumulative roll bonding process
- 11 February 2025
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 35, 4647-4659
Open AccessCharacterization of wear and corrosion behavior of Al/Cu/MoS2/WC hybrid metal matrix composite fabricated via accumulative roll bonding process
- Open Access
- 1 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 171916-171925
A Wideband High-Gain Millimeter-Wave Antenna Array With Inverted-Feed Stacked Patch Design and Single-Port Compact Corporate Feed Network
- 1 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 171916-171925
Open AccessA Wideband High-Gain Millimeter-Wave Antenna Array With Inverted-Feed Stacked Patch Design and Single-Port Compact Corporate Feed Network