Shizhuo Hu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Shizhuo Hu has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Rui Qiu
School of Electrical Engineering and Automation Wuhan University Wuhan China
4 shared publications - Wenjun Zhou
School of Electrical Engineering and Automation, Wuhan University, Wuhan, China
3 shared publications - Han Li
State Key Laboratory of Power Grid Environmental Protection, Wuhan, China
2 shared publications Jianhui Yu
School of Electrical Engineering and Automation Wuhan University Wuhan China
2 shared publications- Yu Zheng
School of Electrical Engineering and Automation Wuhan University Wuhan China
2 shared publications - Baoshan Wang
College of Chemistry and Molecular Sciences Wuhan University Wuhan China
1 shared publication
Latest Publications
- 16 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 40 (5) , 2811-2819
Feasibility Study of Using C4F7N/Helium in Eco-Friendly Gas-Insulated Transformer: Dielectric Strength and Heat Dissipation Performance
This contribution proposes an eco-friendly insulation gas mixture of perfluoroisobutyronitrile (C4F7N)/helium with good heat transfer performance for gas-insulated transformers (GITs). The dielectric strength of C4F7N/helium was assessed by AC breakdown test and voltage withstand test. The heat dissipation performance of the mixture was evaluated by test of temperature rise due to short-circuit on a self-cooling GIT. The test results demonstrated that the dielectric strength of C4F7N/helium exhibited a synergistic effect in various proportions. Especially for 40% C4F7N /60% helium, its dielectric strength could exceed that of SF6 used in existing GITs. After filling it into the eco-friendly GIT, the dielectric strength remains stable and the average temperature rise of the winding could be reduced by over 20% . In addition, based on the convection heat dissipation model, a calculation method for the average temperature rise of the eco-friendly GIT was adjusted. The errors of the model were found to be within a margin of ±3°C for C4F7N/helium under different pressures and proportions. The dielectric strength and heat dissipation performance of the mixture indicated that 40% C4F7N /60% helium could directly replace SF6 without adjusting voltage levels or insulation gaps in larger capacity and eco-friendly GITs.
- 16 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 40 (5) , 2811-2819
Feasibility Study of Using C4F7N/Helium in Eco-Friendly Gas-Insulated Transformer: Dielectric Strength and Heat Dissipation Performance
This contribution proposes an eco-friendly insulation gas mixture of perfluoroisobutyronitrile (C4F7N)/helium with good heat transfer performance for gas-insulated transformers (GITs). The dielectric strength of C4F7N/helium was assessed by AC breakdown test and voltage withstand test. The heat dissipation performance of the mixture was evaluated by test of temperature rise due to short-circuit on a self-cooling GIT. The test results demonstrated that the dielectric strength of C4F7N/helium exhibited a synergistic effect in various proportions. Especially for 40% C4F7N /60% helium, its dielectric strength could exceed that of SF6 used in existing GITs. After filling it into the eco-friendly GIT, the dielectric strength remains stable and the average temperature rise of the winding could be reduced by over 20% . In addition, based on the convection heat dissipation model, a calculation method for the average temperature rise of the eco-friendly GIT was adjusted. The errors of the model were found to be within a margin of ±3°C for C4F7N/helium under different pressures and proportions. The dielectric strength and heat dissipation performance of the mixture indicated that 40% C4F7N /60% helium could directly replace SF6 without adjusting voltage levels or insulation gaps in larger capacity and eco-friendly GITs.
- 18 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 31 (2) , 793-800
Dielectric Properties and Synergistic Effect Evaluation Method of C4F7N Mixtures
In order to accelerate the screening and design of new eco-friendly insulating mixtures, AC breakdown tests were performed on 9 binary C 4 F 7 N mixtures, specifically C 4 F 7 N mixed with rare gases (He, Ne, Ar), conventional gases (CO 2 , N 2 ), and fluorocarbon gases (CF 4 , C 2 F 6 , C 3 F 6 , and C 3 F 8 ), under slightly non-uniform electric fields. The effects of pressure, buffer gas, and mixing ratio on the AC breakdown characteristics were analyzed. It is found that the AC breakdown voltages of the 9 C 4 F 7 N mixtures increase linearly with increasing pressure. As the mixing ratio of C 4 F 7 N increases, the impact of the buffer gas on the AC breakdown voltages decreases. All C 4 F 7 N mixtures show synergistic effects with segmented characteristics that transition from nonlinear to linear. And the synergistic effect of C 4 F 7 N/CO 2 mixture is the most significant. A new method for evaluating the degree of synergistic effects is proposed. Based on the synergistic effect evaluation coefficient N and the dielectric strength of gas components, the dielectric strengths of binary mixtures can be calculated and predicted.
- 18 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 31 (2) , 793-800
Dielectric Properties and Synergistic Effect Evaluation Method of C4F7N Mixtures
In order to accelerate the screening and design of new eco-friendly insulating mixtures, AC breakdown tests were performed on 9 binary C 4 F 7 N mixtures, specifically C 4 F 7 N mixed with rare gases (He, Ne, Ar), conventional gases (CO 2 , N 2 ), and fluorocarbon gases (CF 4 , C 2 F 6 , C 3 F 6 , and C 3 F 8 ), under slightly non-uniform electric fields. The effects of pressure, buffer gas, and mixing ratio on the AC breakdown characteristics were analyzed. It is found that the AC breakdown voltages of the 9 C 4 F 7 N mixtures increase linearly with increasing pressure. As the mixing ratio of C 4 F 7 N increases, the impact of the buffer gas on the AC breakdown voltages decreases. All C 4 F 7 N mixtures show synergistic effects with segmented characteristics that transition from nonlinear to linear. And the synergistic effect of C 4 F 7 N/CO 2 mixture is the most significant. A new method for evaluating the degree of synergistic effects is proposed. Based on the synergistic effect evaluation coefficient N and the dielectric strength of gas components, the dielectric strengths of binary mixtures can be calculated and predicted.
- Open Access
- 9 July 2021
- Published by Institution of Engineering and Technology (IET) in High Voltage
- Vol. 7 (1) , 41-51
Methods for alleviation of impacts of axial diffusion on decomposition products monitoring in gas‐insulated transmission lines
Considering the long length of gas‐insulated transmission lines (GILs), novel methods are required to alleviate the impacts of axial diffusion on decomposition products' monitoring. The diffusion process of two typical decomposition products, SO 2 and SO 2 F 2 , was studied. During the diffusion experiments, SO 2 and SO 2 F 2 were generated by partial discharges. Based on Fick’s law, an axial diffusion model of SO 2 and SO 2 F 2 was proposed. By combining the experiment and simulation results, it was found that the diffusion coefficient of SO 2 was greater than that of SO 2 F 2 . In addition, the concentration variation at different positions would experience some delay and decay in axial direction. The delay and decay were inversely related to the diffusion coefficient and increased with prolongation of the distance. Based on the diffusion characteristics determined, methods for optimising the monitoring positions, correcting concentration, and using the concentration ratio and generation rate were proposed to alleviate the impacts of diffusion. The methods could allow the decomposition products to be monitored in 1 month and reduce the monitoring error to 10% or less. The diffusion model and the methods could be useful for monitoring decomposition products in GILs.
- 9 July 2021
- Published by Institution of Engineering and Technology (IET) in High Voltage
- Vol. 7 (1) , 41-51
Open AccessMethods for alleviation of impacts of axial diffusion on decomposition products monitoring in gas‐insulated transmission lines
Considering the long length of gas‐insulated transmission lines (GILs), novel methods are required to alleviate the impacts of axial diffusion on decomposition products' monitoring. The diffusion process of two typical decomposition products, SO 2 and SO 2 F 2 , was studied. During the diffusion experiments, SO 2 and SO 2 F 2 were generated by partial discharges. Based on Fick’s law, an axial diffusion model of SO 2 and SO 2 F 2 was proposed. By combining the experiment and simulation results, it was found that the diffusion coefficient of SO 2 was greater than that of SO 2 F 2 . In addition, the concentration variation at different positions would experience some delay and decay in axial direction. The delay and decay were inversely related to the diffusion coefficient and increased with prolongation of the distance. Based on the diffusion characteristics determined, methods for optimising the monitoring positions, correcting concentration, and using the concentration ratio and generation rate were proposed to alleviate the impacts of diffusion. The methods could allow the decomposition products to be monitored in 1 month and reduce the monitoring error to 10% or less. The diffusion model and the methods could be useful for monitoring decomposition products in GILs.
- 10 August 2020
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 59 (35) , 15796-15804
Dielectric Properties of CF3SO2F/N2 and CF3SO2F/CO2 Mixtures as a Substitute to SF6
- 10 August 2020
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 59 (35) , 15796-15804
Dielectric Properties of CF3SO2F/N2 and CF3SO2F/CO2 Mixtures as a Substitute to SF6
- Open Access
- 12 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 50159-50167
Synergistic Effect of i-C3F7CN/CO2and i-C3F7CN/N2Mixtures
In order to study the synergistic effect of i-C 3 F 7 CN mixtures, were carried out the power frequency breakdown experiments on 5%–20% i-C 3 F 7 CN/CO 2 and i-C 3 F 7 CN/N 2 mixtures in uniform electric fields with pressures ranging from 0.1 to 0.7 MPa. Based on density functional theory (DFT), the configurations of single molecular and bimolecular complexes were established and optimized using the M06-2X-D3/6-311G(d, p) method. Also, the total energy, interaction energy, and bond energy of the molecules or complexes were obtained using M06-2X-D3/6-311+G(d, p) method. The experimental and computational results show that the power frequency breakdown fields of i-C 3 F 7 CN/CO 2 and i-C 3 F 7 CN/N 2 mixtures increase linearly with pressure. In the range of 0.1–0.2 MPa, the synergistic effect of the i-C 3 F 7 CN mixtures enhances as the i-C 3 F 7 CN proportion increases, and the synergistic effect of i-C 3 F 7 CN/CO 2 mixture is more significant than that of i-C 3 F 7 CN/N 2 mixture. The interaction energy between the complexes of i-C 3 F 7 CN$\ldots $ CO 2 is −7.36 kJ/mol, which is stronger than −3.09 kJ/mol of the complexes of i-C 3 F 7 CN$\ldots$ N 2 . The results show that there is a correlation between the synergistic effect of i-C 3 F 7 CN mixtures and the intermolecular interaction of i-C 3 F 7 CN bimolecular complexes. The synergistic effect of i-C 3 F 7 CN mixtures can be analyzed by calculating the interaction between i-C 3 F 7 CN and the molecular structure of buffer gases.- 12 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 50159-50167
Open AccessSynergistic Effect of i-C3F7CN/CO2and i-C3F7CN/N2Mixtures
In order to study the synergistic effect of i-C 3 F 7 CN mixtures, were carried out the power frequency breakdown experiments on 5%–20% i-C 3 F 7 CN/CO 2 and i-C 3 F 7 CN/N 2 mixtures in uniform electric fields with pressures ranging from 0.1 to 0.7 MPa. Based on density functional theory (DFT), the configurations of single molecular and bimolecular complexes were established and optimized using the M06-2X-D3/6-311G(d, p) method. Also, the total energy, interaction energy, and bond energy of the molecules or complexes were obtained using M06-2X-D3/6-311+G(d, p) method. The experimental and computational results show that the power frequency breakdown fields of i-C 3 F 7 CN/CO 2 and i-C 3 F 7 CN/N 2 mixtures increase linearly with pressure. In the range of 0.1–0.2 MPa, the synergistic effect of the i-C 3 F 7 CN mixtures enhances as the i-C 3 F 7 CN proportion increases, and the synergistic effect of i-C 3 F 7 CN/CO 2 mixture is more significant than that of i-C 3 F 7 CN/N 2 mixture. The interaction energy between the complexes of i-C 3 F 7 CN$\ldots $ CO 2 is −7.36 kJ/mol, which is stronger than −3.09 kJ/mol of the complexes of i-C 3 F 7 CN$\ldots$ N 2 . The results show that there is a correlation between the synergistic effect of i-C 3 F 7 CN mixtures and the intermolecular interaction of i-C 3 F 7 CN bimolecular complexes. The synergistic effect of i-C 3 F 7 CN mixtures can be analyzed by calculating the interaction between i-C 3 F 7 CN and the molecular structure of buffer gases.