Vito R. Gervasi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Vito R. Gervasi has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- David B. Comber
Department of Mechanical Engineering, Vanderbilt University, Nashville, Tenne-ssee
1 shared publication - Eric John Barth
Vanderbilt University
1 shared publication - Jonathon E. Slightam
Department of Mechanical Engineering, Marquette University, Milwaukee, WI 53233
1 shared publication Joseph S. Neimat
Department of Neurological Surgery, Vanderbilt University Medical Center, Nashville, TN, USA
1 shared publication
Latest Publications
- 19 January 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Robotics
- Vol. 32 (1) , 138-149
Design, Additive Manufacture, and Control of a Pneumatic MR-Compatible Needle Driver
This paper reports the design, modeling, and control of an MR-compatible actuation unit comprising pneumatic stepper mechanisms. One helix-shaped bellows and one toroid-shaped bellows were designed to actuate in pure rotation and pure translation, respectively. The actuation unit is a 2-degree-of-freedom (DOF) needle driver that translates and rotates the base of one tube of a steerable needle like a concentric tube robot. For safety, mechanical stops limit needle motion to maximum unplanned step sizes of 0.5 mm and 0.5°. Additively manufactured by selective laser sintering, the flexible fluidic actuating (FFA) mechanism achieves 2-DOF motion as a monolithic, compact, and hermetically sealed device. A second novel contribution is substep control for precise translations and rotations less than full-step increments; steady-state errors of 0.013 mm and 0.018° were achieved. The linear FFA produced peak forces of 33 and -26.5 N for needle insertion and retraction, respectively. The rotary FFA produced bidirectional peak torques of 68 N·mm. With the FFAs in full motion in a 3-T scanner, no loss in signal-to-noise ratio of MR images observed.
- 19 January 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Robotics
- Vol. 32 (1) , 138-149
Design, Additive Manufacture, and Control of a Pneumatic MR-Compatible Needle Driver
This paper reports the design, modeling, and control of an MR-compatible actuation unit comprising pneumatic stepper mechanisms. One helix-shaped bellows and one toroid-shaped bellows were designed to actuate in pure rotation and pure translation, respectively. The actuation unit is a 2-degree-of-freedom (DOF) needle driver that translates and rotates the base of one tube of a steerable needle like a concentric tube robot. For safety, mechanical stops limit needle motion to maximum unplanned step sizes of 0.5 mm and 0.5°. Additively manufactured by selective laser sintering, the flexible fluidic actuating (FFA) mechanism achieves 2-DOF motion as a monolithic, compact, and hermetically sealed device. A second novel contribution is substep control for precise translations and rotations less than full-step increments; steady-state errors of 0.013 mm and 0.018° were achieved. The linear FFA produced peak forces of 33 and -26.5 N for needle insertion and retraction, respectively. The rotary FFA produced bidirectional peak torques of 68 N·mm. With the FFAs in full motion in a 3-T scanner, no loss in signal-to-noise ratio of MR images observed.