Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Weibin Cai has a total of 53 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A Study of Liposome Structure Changes with Temperature Using Non-Equilibrium Molecular Dynamics Simulations

    by Gary Q. Yang, Weibin Cai, Ying Wan

    Liposomes, spherical bilayer lipid-containing vesicles, are promising nanocarriers used for constructing drug delivery systems (DDS). Various strategies can be employed to loosen or break the liposome and release drugs as the tumor cells-targeting DDS made of liposomes reach the targeted sites. One of the most commonly used strategies is to heat the liposomal DDS by letting the gold nanoparticles or other light-absorbing substances that partition in various portions (inner water core, lipid bilayer or outside) of the liposome absorb light irradiation. Then, which portion can lead to the largest liposome structure change due to the same temperature variation? The answer is essential to aid the design of liposomal DDS; thus, wet lab experiments were carried out. However, even though irradiation-absorbing substances in different portions were irradiated for the same time and with the same irradiation intensity, it was impossible to ensure the three portions have the same temperature increase in the experiments. Furthermore, it is impossible to learn the related micromechanism and molecular-level details of the effects of temperature changes on the liposome structure with experimental methods. The molecular dynamics (MD) method is extensively employed by researchers to obtain in-depth molecular-level insights. Most researchers tend to simulate only a planar lipid bilayer structure, but Amărandi et al. demonstrated that such simplification strategy may give wrong simulation results contrary to the experimental results. Though Jämbeck et al. and Zhu et al. established whole spherical liposome systems with a diameter of about a dozen nanometers and simulated the systems with MD simulations, they did not simulate temperature-relevant properties of the liposome. Therefore, currently there is a lack of research on simulating the structure change in a whole spherical liposome due to temperature variations. So, we established the whole spherical structure of the liposome, simulated how it changes with temperatures and obtained molecular-level research results. It is observed that the temperature increase in the lipid bilayer causes the largest increase in lipid strand sway amplitude, the largest changes in lipid positions, the largest decrease in the distribution density of lipids and water around a lipid and the largest decrease in the interactions between lipids and lipids and between lipids and water, leading to the largest change in the liposome structure. We also studied how the degree of lipid tail unsaturation affects liposome structure changes with temperatures. Due to the C3 kinks in the unsaturated lipid tails, the distribution density of unsaturated lipids is not as high as saturate ones, leading to smaller attraction interactions and consequently larger liposome structure change with temperature. The obtained results are useful for the liposomal DDS design for the purpose of improving DDS performances and delivery outcomes.


  • Open Access

    Extraction of Phenolic Compounds with the Highly Efficient Novel Coextractants Cyclohexanone and Methyl Isobutyl Ketone

    by Gary Q. Yang, Weibin Cai, Tiankun Liu, Yujun Wang, Liangxia Sun

    Extractant selection is the most important aspect for the extraction treatment of phenolic wastewater from the coal chemical industry. Highly efficient extractants are urgently needed. To our knowledge, we identified for the first time one set of coextractants, cyclohexanone and methyl isobutyl ketone (MIBK), after spending plenty of time and energy for the extraction of phenolic compounds, including polyhydroxyphenol, from wastewater. Fourier transform infrared (FTIR) spectroscopy of the solvents before and after extraction shows that intermolecular hydrogen bonding between the molecules of the extractants and phenols is established, contributing to the high performance. The effects of pH, temperature, and salt concentration on the extractant performance were then studied. The extraction favors acidic and neutral pH values. Increasing the temperature has a negative influence on the extraction. The salt effect by putting inorganic salt can obviously enhance the extractant performance. Compared with single extractants such as MIBK and diisopropyl ether (DIPE), coextractants have significantly improved recovery rates of resorcinol and phloroglucinol. To learn if this set of coextractants also has good performance in practical extraction processes for the treatment of industrial wastewater, three-stage countercurrent extraction experiments were carried out with these coextractants for the extraction of phenolic compounds from coal chemical wastewater. Cascade experiments were used to simulate and verify the countercurrent extraction process in actual industry. According to the results, it is observed that this set of coextractants also has good performance in practical extraction processes for the treatment of industrial wastewater.


  • Open Access

    Development of an Industry-Applicable Distillation Process to Prepare High-Purity Furfural

    by Weibin Cai, Zezhong Wang, Gary Q. Yang, Jianbing Qian

    Furfural can be produced by the acidification and hydrolysis of biomass raw materials, which have the advantages of low prices, abundant sources, and short renewable cycles. High-purity furfural is valuable, but currently, the processes in industry can only obtain furfural with a purity as low as 98.5%. Therefore, people urgently need an industry-applicable purification process to produce high-purity furfural. In this study, a new distillation process was proposed to produce a high-purity furfural. To our knowledge, we are the first to develop such a process. The process has the advantages of large capacity, small device size, high operation stabilities, high operability, and high product purities compared to the single-column batch distillation process. Pilot-scale experiments were performed to verify the modeling results and determine if the process is industry-applicable. The experimental results are in agreement with the modeling ones, and the concentration of furfural in the distillate product is higher than 99.5% and meets the requirements of high-purity furfural.


  • Open Access

    The Sandwich-Structured PVA/PA/PVA Tri-Layer Nanofiltration Membrane with High Performance for Desalination and Pollutant Removal

    by Weibin Cai, Yuzhe Wang, Yuannan Li, Hong Ye, Fuyuan Xiao, Lei Wang, Hengjun Gai

    Nanofiltration (NF) has become a widely used technology in water treatment due to its environmental friendliness, energy efficiency, cost-effectiveness, and operational simplicity. However, polyamide (PA) NF membranes still face challenges, including low permeate flux, limited resistance to organic pollutants, and inadequate resilience to residual chlorine. To address these issues, this study developed a thin-film composite (TFC) NF membrane featuring a separation layer of sandwich structure. Initially, a single separation layer of polyvinyl alcohol (PVA) NF membrane was prepared, followed by the fabrication of a PA layer on its surface, and ultimately, a second PVA layer was constructed on the PA layer. The experimental results show that the PVA/PA/PVA sandwich structure TFC exhibits high permeability to pure water and robust resistance to both pollution and residual chlorine. The PVA-0.20/PA/PVA-0.20 TFC, prepared with a 0.20%w/v PVA solution, achieved a pure water flux of up to 22.05 L m−2 h−1 bar−1 (LMH/bar), which was 2.92 times higher than that of the control TFC membrane. Additionally, it demonstrated a salt rejection rate exceeding 96% for Na2SO4 and over 99% for Congo Red (CR) and Victoria Blue B (VB). In comparison with the control TFC membrane, the PVA-0.20/PA/PVA-0.20 membrane exhibited significantly enhanced resistance to pollution. Following immersion in a 1000 ppm NaClO solution for 4 h, the rejection rate of the control TFC membrane decreased markedly and that of the PVA-0.20/PA/PVA-0.20 membrane decreased marginally, indicating excellent resistance to residual chlorine. Due to the robust overall performance of the PVA/PA/PVA membrane, it holds potential advantages for application in treating reclaimed water or slightly polluted water.


  • Open Access

    Separation of Chloride and Sulfate Ions from Desulfurization Wastewater Using Monovalent Anions Selective Electrodialysis

    by Xufeng Tian, Dongbei Yue, Tao Hou, Fuyuan Xiao, Zhiping Wang, Weibin Cai

    The high concentration of chloride ions in desulphurization wastewater is the primary limiting factor for its reusability. Monovalent anion selective electrodialysis (S-ED) enables the selective removal of chloride ions, thereby facilitating the reuse of desulfurization wastewater. In this study, different concentrations of NaCl and Na2SO4 were used to simulate different softened desulfurization wastewater. The effects of current density and NaCl and Na2SO4 concentration on ion flux, permselectivity (PSO42−Cl−) and specific energy consumption were studied. The results show that Selemion ASA membrane exhibits excellent permselectivity for Cl− and SO42−, with a significantly lower flux observed for SO42− compared to Cl−. Current density exerts a significant influence on ion flux; as the current density increases, the flux of SO42− also increases but at a lower rate than that of Cl−, resulting in an increase in permselectivity. When the current density reaches 25 mA/cm2, the permselectivity reaches a maximum of 50.4. The increase in NaCl concentration leads to a decrease in the SO42− flux; however, the permselectivity is reduced due to the elevated Cl−/SO42− ratio. The SO42− flux increases with the increase in Na2SO4 concentration, while the permselectivity increases with the decrease in Cl−/SO42− ratio.


  • Progress in Programmable DNA-Aided Self-Assembly of the Master Frame of a Drug Delivery System

    by Gary Q. Yang, Weibin Cai, Zhiwen Zhang, Yujun Wang

    Every year cancer causes approximately 10 million deaths globally. Researchers have developed numerous targeted drug delivery systems (DDSs) with nanoparticles, polymers, and liposomes, but these synthetic materials have poor degradability and low biocompatibility. Because DNA nanostructures have good degradability and high biocompatibility, extensive studies have been performed to construct DDSs with DNA nanostructures as the molecular-layer master frame (MF) assembled via programmable DNA-aided self-assembly for targeted drug release. To learn the progressing trend of self-assembly techniques and keep pace with their recent rapid advancements, it is crucial to provide an overview of their past and recent progress. In this review article, we first present the techniques to assemble the MF of a DDS with solely DNA strands; to assemble MFs with one or more additional type of construction materials, e.g., polymers (including RNA and protein), inorganic nanoparticle, or metal ions, in addition to DNA strands; and to assemble the more complex DNA nanocomplexes. It is observed that both the techniques used and the MFs constructed have become increasingly complex and that the DDS constructed has an increasing number of advanced functions. From our focused review, we anticipate that DDSs with the MF of multiple building materials and DNA nanocomplexes will attract an increasing number of researchers' interests. On the basis of knowledge about materials and functional components (e.g., targeting aptamers/peptides/antibodies and stimuli for drug release) obtained from previously performed studies, researchers can combine more materials with DNA strands to assemble more powerful MFs and incorporate more components to endow DDSs with improved or additional properties/functions, thereby subsequently contributing to cancer prevention.


  • Open Access

    Study of the Dissolution and Diffusion of Propane, Propylene and Nitrogen in Polydimethylsiloxane Membranes with Molecular Dynamics Simulation and Monte Carlo Simulation

    by Weibin Cai, Mingqian Wang, Gary Q. Yang, Zhijun Zhang, Yujun Wang, Jiding Li

    Volatile organic compounds (VOCs) are important sources of atmospheric pollutants on account of their high recycling value. The membrane of dense silicone rubber polydimethylsiloxane (PDMS) has wide-ranging prospects for the separation and recovery of VOCs. In this study, PDMS membrane body models were established in BIOVIA Materials Studio (MS) to simulate VOCs with C3/N2 gases, and to study the structure of PDMS membranes and the dissolution and diffusion process of gas in the membranes. The free volume fraction (FFV), cohesive energy density (CED), radial distribution function (RDF), diffusion coefficient and solubility coefficient of C3H8, C3H6 and N2 in PDMS membranes were calculated, and the permeability coefficients were calculated according to these values. At the same time, the effects of temperature and mixed gas on the dissolution and diffusion of C3/N2 in PDMS membranes were investigated. The results show that the mass transfer process of C3 in PDMS membranes is mainly controlled by the dissolution process, while that of N2 is mainly controlled by the diffusion process. In a C3/N2 mixed gas system, there is a synergistic relationship between gases in the diffusion process, while there is competitive adsorption in the dissolution process. With an increase in temperature, the diffusion coefficients of the three gases in PDMS gradually increase, the solubility coefficients gradually decrease, and the overall permeability selectivity coefficients of the gases gradually decrease. Therefore, low-temperature conditions are more conducive to the separation of C3/N2 in PDMS membranes. The simulation results of the permeability selectivity coefficients of pure C3 and N2 in PDMS are similar to the experimental results, and the relationship between the micro- and macro-transport properties of PDMS membranes can be better understood through molecular simulation.