Kostiantyn Kovtun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Kostiantyn Kovtun has a total of 63 co-authors. Here are the top co-authors by number of shared publications:
- P. I. Stoev
Institute of Solid State Physics, Materials Science and Technologies, National Academy of Sciences of Ukraine, Kharkiv, Ukraine
3 shared publications A. A. Vasil’ev
National Science Centre “Kharkov Institute of Physics and Technology
2 shared publicationsO. V. Trembach
National Science Center “Kharkov Institute of Physics and Technology
2 shared publications- Ruslan Smolianets
B. Verkin Institute for Low Temperature Physics and Engineering of the National Academy of Sciences of Ukraine , Kharkiv 61103
2 shared publications - V. S. Trush
Lviv Polytechnic National University, Lviv, Ukraine
2 shared publications - Viktor Fedirko
Karpenko Physico-Mechanical Institute of the National Academy of Sciences of Ukraine
2 shared publications
Latest Publications
- 14 April 2026
- Published by Problems of Atomic Science and Technology in Problems of Atomic Science and Technology
Hf COMPTON NEUTRON DETECTOR IN THE CORE OF WWER-1000
Hafnium-based Compton self-powered detectors were investigated through MCNPX simulations of four fuel cycles in a WWER-1000 reactor core with fuel by “Westinghouse”. Seven detectors positioned at standard Rh detector locations were modeled to obtain: nuclide composition evolution, (n, γ)-reaction rates, neutron absorption rates, neutron and γ-ray flux distributions, and emissive current characteristics.
- 14 April 2026
- Published by Problems of Atomic Science and Technology in Problems of Atomic Science and Technology
Hf COMPTON NEUTRON DETECTOR IN THE CORE OF WWER-1000
Hafnium-based Compton self-powered detectors were investigated through MCNPX simulations of four fuel cycles in a WWER-1000 reactor core with fuel by “Westinghouse”. Seven detectors positioned at standard Rh detector locations were modeled to obtain: nuclide composition evolution, (n, γ)-reaction rates, neutron absorption rates, neutron and γ-ray flux distributions, and emissive current characteristics.
- Open Access
- 1 November 2024
- Published by AIP Publishing in Low Temperature Physics
- Vol. 50 (11) , 1043-1051
Mechanisms of plastic deformation of cryorolled hafnium in the temperature range 1.7–430 K
The stress-strain curves of coarse-grained and nanocrystalline hafnium were found under quasi-static uniaxial compression in the temperature range 1.7–430 K. The temperature dependences of the yield strength, rate sensitivity of the deforming stress, and activation volume of the plastic deformation process were determined. The nanoscale grain size was obtained by rolling at liquid nitrogen temperature. When discussing the physical nature of the features observed below 25 K, such as the transition from smooth at room and moderately low temperatures to jump-like plastic flow, as well as the athermicity of the temperature dependences of the yield stress and its rate sensitivity, theoretical hypotheses related to the manifestation of the inertial properties of dislocations were used. Experimental results for the temperature range above 25 K were discussed using the method of thermal activation analysis within the framework of the model of dislocations overcoming local barriers, and dislocation mechanisms that control the rate of plastic deformation were established.
- 1 November 2024
- Published by AIP Publishing in Low Temperature Physics
- Vol. 50 (11) , 1043-1051
Open AccessMechanisms of plastic deformation of cryorolled hafnium in the temperature range 1.7–430 K
The stress-strain curves of coarse-grained and nanocrystalline hafnium were found under quasi-static uniaxial compression in the temperature range 1.7–430 K. The temperature dependences of the yield strength, rate sensitivity of the deforming stress, and activation volume of the plastic deformation process were determined. The nanoscale grain size was obtained by rolling at liquid nitrogen temperature. When discussing the physical nature of the features observed below 25 K, such as the transition from smooth at room and moderately low temperatures to jump-like plastic flow, as well as the athermicity of the temperature dependences of the yield stress and its rate sensitivity, theoretical hypotheses related to the manifestation of the inertial properties of dislocations were used. Experimental results for the temperature range above 25 K were discussed using the method of thermal activation analysis within the framework of the model of dislocations overcoming local barriers, and dislocation mechanisms that control the rate of plastic deformation were established.
- Open Access
- 12 October 2023
- Published by Problems of Atomic Science and Technology in Problems of Atomic Science and Technology
- No. 5,p. 146-151
PROPORTIONAL DETECTORS OF GAMMA-RADIATION BASED ON HIGH PURITY XENON GAS FOR RADIATION MONITORING
This article is dedicated to a detailed investigation of properties of a proportional counter based on the Xe+2%CH4 mixture. A setup for filling the detectors with high purity Xe gas and Xe-based gas mixtures was designed and made. An optimized design of the proportional counters was developed and investigated. The design parameters, such as the material and diameter of the anode, the number and material of the gas mixture inlets, composition and pressure of the gas were improved. The operating regimes of the proportional counters, as well as their thermal stability, were investigated.
- 12 October 2023
- Published by Problems of Atomic Science and Technology in Problems of Atomic Science and Technology
- No. 5,p. 146-151
Open AccessPROPORTIONAL DETECTORS OF GAMMA-RADIATION BASED ON HIGH PURITY XENON GAS FOR RADIATION MONITORING
This article is dedicated to a detailed investigation of properties of a proportional counter based on the Xe+2%CH4 mixture. A setup for filling the detectors with high purity Xe gas and Xe-based gas mixtures was designed and made. An optimized design of the proportional counters was developed and investigated. The design parameters, such as the material and diameter of the anode, the number and material of the gas mixture inlets, composition and pressure of the gas were improved. The operating regimes of the proportional counters, as well as their thermal stability, were investigated.
- 1 January 2019
- Published by Lviv Polytechnic National University in Ukrainian journal of mechanical engineering and materials science
- Vol. 5 (3-4) , 39-43
Differences of the effect of thermal treatment in an oxygen-containing gas medium on properties of the surface layer Ti, Zr, Hf
The paper presents the characteristics of the surface layer of d-elements of the IV group (titanium, zirconium and hafnium) after thermal diffusion saturation from a controlled oxygen-containing gas medium. Saturation was carried out at T = 750 °C for = 5 hours at different pressures (P = 1.33∙10–1 Pa, P = 1.33∙10–2 Pa, P = 1.33∙10–3 Pa). Experimentally revealed differences in the characteristics of the surface layer of titanium, zirconium and hafnium. It was shown that a hardened diffuse layer is formed with a higher hardness relative to the metal core in the reverse order of their affinity for oxygen. On titanium, zirconium and hafnium, only a diffuse layer is formed without a phase film. The appearance of the surface of the samples before and after processing is given. According to the results of the study, chemical-thermal treatment in an oxygen-containing gas medium leads to changes in the surface layer of sheet material from titanium, zirconium and hafnium. The state of the surface layers directly affects the characteristics of finished products, in particular, fatigue life. Therefore, this treatment is a good tool for controlling the state of the surface layers of the aforementioned metals, and then their properties.
- 1 January 2019
- Published by Lviv Polytechnic National University in Ukrainian journal of mechanical engineering and materials science
- Vol. 5 (3-4) , 39-43
Differences of the effect of thermal treatment in an oxygen-containing gas medium on properties of the surface layer Ti, Zr, Hf
The paper presents the characteristics of the surface layer of d-elements of the IV group (titanium, zirconium and hafnium) after thermal diffusion saturation from a controlled oxygen-containing gas medium. Saturation was carried out at T = 750 °C for = 5 hours at different pressures (P = 1.33∙10–1 Pa, P = 1.33∙10–2 Pa, P = 1.33∙10–3 Pa). Experimentally revealed differences in the characteristics of the surface layer of titanium, zirconium and hafnium. It was shown that a hardened diffuse layer is formed with a higher hardness relative to the metal core in the reverse order of their affinity for oxygen. On titanium, zirconium and hafnium, only a diffuse layer is formed without a phase film. The appearance of the surface of the samples before and after processing is given. According to the results of the study, chemical-thermal treatment in an oxygen-containing gas medium leads to changes in the surface layer of sheet material from titanium, zirconium and hafnium. The state of the surface layers directly affects the characteristics of finished products, in particular, fatigue life. Therefore, this treatment is a good tool for controlling the state of the surface layers of the aforementioned metals, and then their properties.
- 1 September 2017
- Published by Springer Nature in Materials Science
- Vol. 53 (2) , 194-199
Optimization of the Medium of Thermal Treatment of GFE-1 Hafnium Alloy
- 1 September 2017
- Published by Springer Nature in Materials Science
- Vol. 53 (2) , 194-199
Optimization of the Medium of Thermal Treatment of GFE-1 Hafnium Alloy
- 19 April 2016
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) in Metallofizika i Noveishie Tekhnologii
- Vol. 38 (2) , 189-203
High Frequency Vibrations Impact on Mechanical Properties of Nanocrystalline Titanium
- 19 April 2016
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) in Metallofizika i Noveishie Tekhnologii
- Vol. 38 (2) , 189-203
High Frequency Vibrations Impact on Mechanical Properties of Nanocrystalline Titanium
- 7 July 2015
- Published by Pleiades Publishing Ltd in Physics of the Solid State
- Vol. 57 (7) , 1289-1292
Internal friction in the bulk metallic glass Zr41.2Ti13.8Cu12.5Ni10Be22.5 in amorphous and crystalline states
The low-frequency temperature dependences of the internal friction and the Young’s modulus of the Vitreloy-1 alloy (Zr41.2Ti13.8Cu12.5Ni10Be22.5) have been studied in amorphous and crystalline states. The increase and maxima of the Young’s modulus due to structural transformations are observed during the crystallization of the Vitreloy-1 alloy from the amorphous phase in the range from the glass transition temperature (325°C) to the temperature of the secondary crystallization (460°C). At 200°C, the internal friction in a partially crystallized Vitreloy-1 alloy exhibits a peak of presumably an interface nature.
- 7 July 2015
- Published by Pleiades Publishing Ltd in Physics of the Solid State
- Vol. 57 (7) , 1289-1292
Internal friction in the bulk metallic glass Zr41.2Ti13.8Cu12.5Ni10Be22.5 in amorphous and crystalline states
The low-frequency temperature dependences of the internal friction and the Young’s modulus of the Vitreloy-1 alloy (Zr41.2Ti13.8Cu12.5Ni10Be22.5) have been studied in amorphous and crystalline states. The increase and maxima of the Young’s modulus due to structural transformations are observed during the crystallization of the Vitreloy-1 alloy from the amorphous phase in the range from the glass transition temperature (325°C) to the temperature of the secondary crystallization (460°C). At 200°C, the internal friction in a partially crystallized Vitreloy-1 alloy exhibits a peak of presumably an interface nature.
- 1 March 2011
- Published by Springer Nature in Strength of Materials
- Vol. 43 (2) , 230-235
Acoustic emission in hafnium under tensile deformation
- 1 March 2011
- Published by Springer Nature in Strength of Materials
- Vol. 43 (2) , 230-235
Acoustic emission in hafnium under tensile deformation
- 1 January 2010
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 207
Ion-bombardment modification of the surface of mirrors fabricated of ZrTiCuNiBe amorphous alloys
- 1 January 2010
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 207
Ion-bombardment modification of the surface of mirrors fabricated of ZrTiCuNiBe amorphous alloys