Yongtae Ahn
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yongtae Ahn has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Byong-Hun Jeon
Department of Earth Resources and Environmental Engineering Hanyang University Seoul Republic of Korea
1 shared publication - Byongsueng Jeon
Department of Chemical Engineering, Hanyang University, 222, Wangsimni-ro, Seongdong-gu, Seoul 04763, Korea
1 shared publication - Byoung-In Sang
Department of Chemical Engineering, Hanyang University, Seoul 04763, Republic of Korea
1 shared publication - Dong-Wan Cho
Geo-Environment Division, Korea Institute of Geoscience and Mineral Resources, Daejeon, Korea
1 shared publication - Doorae Lee
Chemical and Environmental Engineering Department, University of Arizona, Tucson, Arizona, 85721, USA
1 shared publication - Gi-Hyeon Kim
Department of Environmental Engineering, University of Seoul, 163 Seoulsiripdaero, Dongdaemun-gu, Seoul 02504, Korea
1 shared publication
Latest Publications
- Open Access
- 10 January 2019
- Published by MDPI AG in Applied Sciences
- Vol. 9 (2) , 229
Comparison between OCl−-Injection and In Situ Electrochlorination in the Formation of Chlorate and Perchlorate in Seawater
To prevent biofouling from occurring in the cooling systems of coastal power plants, chlorine is often added to the cooling water. In this study, we have evaluated the fate of the total residual oxidants and the formation of inorganic chlorination byproducts including ClO3− and ClO4− during in situ electrochlorination with seawater. Then, the results were compared with those during direct OCl−-injection to seawater. The in situ electrochlorination method based on Ti/RuO2 electrodes produced much less ClO3−, while a similar level of total residual oxidants could be achieved with a reaction time of 5 min. Moreover, no ClO4− was observed, while the direct OCl−-injection system could still result in the production of ClO4−. The less or no production of ClO3− or ClO4− by the electrochlorination of seawater was mainly attributed to two reasons. First, during the electrolysis, the less amount of OCl− is available for ClO3− formation. Secondly, the formation of ClO3− or ClO4− is affected by the electrode material. In other words, if the electrode material is carefully chosen, the production of harmful reaction byproducts can be prevented or minimized. In short, based on the results from our study, electrochlorination technology proves to be a marine environmentally friendly method for controlling biofouling in the pipes of the cooling system in a coastal power plant.
- 10 January 2019
- Published by MDPI AG in Applied Sciences
- Vol. 9 (2) , 229
Open AccessComparison between OCl−-Injection and In Situ Electrochlorination in the Formation of Chlorate and Perchlorate in Seawater
To prevent biofouling from occurring in the cooling systems of coastal power plants, chlorine is often added to the cooling water. In this study, we have evaluated the fate of the total residual oxidants and the formation of inorganic chlorination byproducts including ClO3− and ClO4− during in situ electrochlorination with seawater. Then, the results were compared with those during direct OCl−-injection to seawater. The in situ electrochlorination method based on Ti/RuO2 electrodes produced much less ClO3−, while a similar level of total residual oxidants could be achieved with a reaction time of 5 min. Moreover, no ClO4− was observed, while the direct OCl−-injection system could still result in the production of ClO4−. The less or no production of ClO3− or ClO4− by the electrochlorination of seawater was mainly attributed to two reasons. First, during the electrolysis, the less amount of OCl− is available for ClO3− formation. Secondly, the formation of ClO3− or ClO4− is affected by the electrode material. In other words, if the electrode material is carefully chosen, the production of harmful reaction byproducts can be prevented or minimized. In short, based on the results from our study, electrochlorination technology proves to be a marine environmentally friendly method for controlling biofouling in the pipes of the cooling system in a coastal power plant.
- Open Access
- 1 September 2018
- Published by MDPI AG in Applied Sciences
- Vol. 8 (9) , 1502
Removal of Algae, and Taste and Odor Compounds by a Combination of Plant-Mineral Composite (PMC) Coagulant with UV-AOPs: Laboratory and Pilot Scale Studies
The seasonal occurrence of algae blooms in surface waters remains a common problem, such as taste and odor (T&Os), the risk of disinfection by-products (DBPs), and disturbance to water treatment systems. The coagulation efficiency of plant-mineral composite (PMC) coagulant followed by UV-based advanced oxidation processes (UV-AOPs; UV/H2O2 and UV/Cl2) was evaluated for removal of algae, turbidity, dissolved organic matters, and taste and odor compounds in lab-scale and pilot-scale tests. In the lab-scale test, coagulation process with 20 mg/L of PMC shows high removal efficiency of turbidity (94%) and algae (99%) and moderate removal efficiency of UV254 (51%) and geosmin (46%). The pilot test results also show good removal efficiency of turbidity (64%), chlorophyll-a (96%). After PMC coagulation process, the major water factors, which affected the performance of UV-AOPs (i.e., UV transmittance (85–94%), and scavenging factor (64,998–28,516 s−1)), were notably improved, and further degradation of geosmin and 2-methylisoborneol (2-MIB) was achieved in both lab-and pilot-scale tests of the UV-AOPs. The UV/H2O2 process shows higher removal efficiency of geosmin and 2-MIB than the UV/Cl2 process because of the pH effect. The results confirmed that the PMC-based coagulation followed by UV/H2O2 process could be an effective process for the removal of algae, geosmin, and 2-MIB.
- 1 September 2018
- Published by MDPI AG in Applied Sciences
- Vol. 8 (9) , 1502
Open AccessRemoval of Algae, and Taste and Odor Compounds by a Combination of Plant-Mineral Composite (PMC) Coagulant with UV-AOPs: Laboratory and Pilot Scale Studies
The seasonal occurrence of algae blooms in surface waters remains a common problem, such as taste and odor (T&Os), the risk of disinfection by-products (DBPs), and disturbance to water treatment systems. The coagulation efficiency of plant-mineral composite (PMC) coagulant followed by UV-based advanced oxidation processes (UV-AOPs; UV/H2O2 and UV/Cl2) was evaluated for removal of algae, turbidity, dissolved organic matters, and taste and odor compounds in lab-scale and pilot-scale tests. In the lab-scale test, coagulation process with 20 mg/L of PMC shows high removal efficiency of turbidity (94%) and algae (99%) and moderate removal efficiency of UV254 (51%) and geosmin (46%). The pilot test results also show good removal efficiency of turbidity (64%), chlorophyll-a (96%). After PMC coagulation process, the major water factors, which affected the performance of UV-AOPs (i.e., UV transmittance (85–94%), and scavenging factor (64,998–28,516 s−1)), were notably improved, and further degradation of geosmin and 2-methylisoborneol (2-MIB) was achieved in both lab-and pilot-scale tests of the UV-AOPs. The UV/H2O2 process shows higher removal efficiency of geosmin and 2-MIB than the UV/Cl2 process because of the pH effect. The results confirmed that the PMC-based coagulation followed by UV/H2O2 process could be an effective process for the removal of algae, geosmin, and 2-MIB.
- 1 March 2012
- Published by Taylor & Francis in Geosystem Engineering
- Vol. 15 (1) , 60-65
Removal of nitrate from groundwater using ZVI treatment system combined with continuous CO2gas bubbling
A zero-valent iron (ZVI) treatment system combined with pH adjustment, aeration, sedimentation and microfiltration processes was developed for the robust removal of nitrate from groundwater. Powdered ZVI dosed at 10 g L− 1 removed nitrate by 166 mg L− 1, of which 80% were converted to ammonium ion for a given contact time of 125 h. By diffusing gaseous carbon dioxide (CO2) into the ZVI reactor, pH was desirably controlled in the range of 5.5–6.5, and concurrently < 0.5 mg L− 1 dissolved oxygen was consistently maintained during the longer-term of dissolved oxygen ZVI treatment system. The combination of ZVI treatment and CO2 gas bubbling reached up to 35% removal of nitrate and passivation on the surface of ZVI was prevented by diffusing CO2 gas. Soluble Fe (II) concentration of mixed liquor in the ZVI reactor ranged between 0.2 and 7.8 mg L− 1 and Fe (II) dissolved in the ZVI-treated water was almost completely removed by subsequent aeration. The overall result shows that the novel ZVI treatment system is significantly promising to remove nitrate in groundwater and therefore to meet the regulatory limit for drinking water.
- 1 March 2012
- Published by Taylor & Francis in Geosystem Engineering
- Vol. 15 (1) , 60-65
Removal of nitrate from groundwater using ZVI treatment system combined with continuous CO2gas bubbling
A zero-valent iron (ZVI) treatment system combined with pH adjustment, aeration, sedimentation and microfiltration processes was developed for the robust removal of nitrate from groundwater. Powdered ZVI dosed at 10 g L− 1 removed nitrate by 166 mg L− 1, of which 80% were converted to ammonium ion for a given contact time of 125 h. By diffusing gaseous carbon dioxide (CO2) into the ZVI reactor, pH was desirably controlled in the range of 5.5–6.5, and concurrently < 0.5 mg L− 1 dissolved oxygen was consistently maintained during the longer-term of dissolved oxygen ZVI treatment system. The combination of ZVI treatment and CO2 gas bubbling reached up to 35% removal of nitrate and passivation on the surface of ZVI was prevented by diffusing CO2 gas. Soluble Fe (II) concentration of mixed liquor in the ZVI reactor ranged between 0.2 and 7.8 mg L− 1 and Fe (II) dissolved in the ZVI-treated water was almost completely removed by subsequent aeration. The overall result shows that the novel ZVI treatment system is significantly promising to remove nitrate in groundwater and therefore to meet the regulatory limit for drinking water.