Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jiao Zhao has a total of 55 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Regional Variations in Physicochemical Properties and Oil–Solid Interaction Mechanisms of Oily Sludge from Three Chinese Oilfields

    by Yuwei Bao, Jiao Zhao, Yang Liu, Yimin Zhu

    Oily sludge is one of the most challenging solid wastes generated during petroleum production and wastewater treatment, posing long-term environmental risks and demanding effective resource-recovery strategies. This study systematically investigated the physicochemical characteristics, compositional differences, and oil–solid interaction mechanisms of oily sludge (OS) from three representative Chinese oilfields, Panjin, Daqing and Xinjiang, through integrated analyses of elemental composition, oil composition, X-ray diffractometer (XRD), Fourier-transform infrared (FT-IR), Gas chromatograph (GC), and Confocal laser scanning microscope (CLSM). The results revealed pronounced regional variations in oxidation degree, hydrocarbon composition, and mineralogy that critically influenced oil occurrence and removal behavior. The Panjin OS sample (PJ-OS) exhibited a high oxidation degree, enriched resins and asphaltenes, and compact film-like oil–solid structures, resulting in the lowest oil mobility and recovery potential. The Daqing OS (DQ-OS) was dominated by light saturates and showed the weakest oil–solid bonding, while the Xinjiang OS (XJ-OS) displayed moderate oxidation and intermediate properties. A novel room-temperature high-speed stirring cleaning method was applied to evaluate oil removal performance under ambient conditions. The residual oil contents after treatment were 4.43% (PJ-OS), 1.65% (DQ-OS), and 1.22% (XJ-OS), corresponding to removal efficiencies of 80.86%, 86.74%, and 90.33%, respectively. The cleaning efficiency was strongly governed by the sludge composition and oxidation state: higher O/C ratios and enrichment of polar heavy fractions enhanced oil–solid adhesion and hindered oil detachment, whereas higher saturate contents and lower oxidation degrees facilitated rapid oil separation. Overall, the findings demonstrate that the treatability of oily sludge is controlled by its intrinsic physicochemical properties. The proposed high-speed stirring technique provides a promising, energy-efficient, and environmentally sustainable approach for oily sludge remediation and resource recovery, offering valuable insights for optimizing treatment parameters and scaling up green petroleum waste management technologies.


  • Open Access

    Fabrication of CuO/BiVO 4 composites for enhanced visible-light-driven photocatalytic antibacterial activity

    by Jiao Zhao, He Yang, Chen Chen, Tong You, Xingyi Yu, Yan Zhang, Hongyan Liu, Yimin Zhu

    CuO/BiVO 4 composites were constructed for enhanced photocatalytic antibacterial activity mainly via ROS oxidative damage.


  • Open Access

    Equal volume impregnation–air calcination synthesis of lithium-doped MgO nanoplates for enhanced antibacterial performance

    by Xiaoyi Li, Junmei Pu, Yanqun Zu, Yongmei He, Fangdong Zhan, Xi Li, Jiao Zhao

    Magnesium oxide nanomaterials (nano-MgO) have many advantages, such as environmentally benign, high thermal stability, no need of illumination, broad-spectrum antibacterial activity and more. However, its low activity has restricted the application in environmental purification and antibacterial disinfection. Herein, the equal volume impregnation–air calcination method was first used in the synthesis of nano-MgO and a series of nano-MgO with varying amounts of Li doping were prepared to enhance their antibacterial properties. Li doping leads to the distortion of MgO lattice structure and the presence of oxygen vacancies, enhancing oxygen absorption and alkalinity. This enhancement effectively promotes the formation of reactive oxygen species (ROS) and maintains its high chemical reactivity. The Li doped nano-MgO at 100 μg mL−1 showed a significant improvement in antibacterial activity, achieving the antibacterial ratio of 99.6% against Escherichia coli (E. coli). Moreover, the contribution of alkalinity, ROS, physical morphology effect, and dissolved ions (Mg2+ and Li+) to the antibacterial ability was further discussed. Especially, the results of dialysis tube test indirectly indicated that ROS played the crucial role in enhancing the antibacterial performance of nano-MgO. This study lays an essential foundation for further investigation into the antibacterial performance and mechanism of nano-MgO.


  • Open Access

    Variations in Oil Occurrence State and Properties during High-Speed Stirring Treatment of Oily Sludge

    by Yuwei Bao, Yimin Zhu, Yang Liu, Jiao Zhao, Xiaojia Tang, Tie Li, Yin Wang, Xianmeng Liu, Hao Zhang

    Oily sludge (OS) has long been regarded as a hazardous waste, and improper disposal may lead to serious environmental concerns and human health risks. Despite various methods having been proposed and applied to the treatment of OS, the oil occurrence states and properties in sludge are rarely characterized, which may directly link to the selection and effectiveness of treatment methods. Here, confocal laser scanning microscopy (CLSM), X-ray diffraction (XRD), gas chromatography (GC), and four components (SARA) analysis were utilized to characterize the changes in the oil occurrence states and compositions in OS samples before and after high-speed stirring (HSS) treatment. Our results show a substantial reduction in the oil concentration of OS after HSS treatment (from 32.98% to 1.65%), while SARA analysis reveals a similar oil composition before and after treatment, suggesting the broad applicability of HSS in removing oil and its insignificant selectivity towards various hydrocarbon components. This is further supported by the total petroleum hydrocarbon (TPH) analysis results, which show that the separated oil phase has a hydrocarbon composition similar to that of the original OS sample. The CLSM and fluorescence analysis suggest a homogeneous distribution of oil in the sludge, with relatively light components more concentrated in the pore systems between coarse mineral particles, whereas relatively heavy components tend to coexist with clay minerals. After HSS cleaning, both light and heavy components are removed to varying degrees, but light components are preferentially removed while heavy components tend to be retained in the sludge due to adsorption by clay minerals. This is consistent with TPH analysis, where a significant decrease in n-alkanes with lower carbon numbers (n-C14 to n-C20) was observed in the residual sample. Our findings demonstrate the dynamic response of oil occurrence states and compositions to the OS treatment process and highlight the importance of characterizing these fundamental properties prior to the selection of OS treatment methods.


  • Enhanced antibacterial effect with MgO nanoplates: Role of oxygen vacancy and alkalinity

    by Xiaoyi Li, Hongyan Liu, Yongmei He, Zuran Li, Fangdong Zhan, Yuan Li, Jiao Zhao


  • Open Access

    Simulation Study on the Process of Cleaning Oily Sludge with High-speed Stirring Rotor

    by Yin Wang, Keqing Li, Jiao Zhao, Xiaojia Tang, Tie Li, Xianmeng Liu, Hao Zhang, Yimin Zhu

    In this paper, COMSOL Multiphysics software was used to simulate and analyze the process of cleaning oily sludge by high-speed stirring rotor. The physical phenomena such as velocity field, pressure field, heat dissipation and cavitation generated by the rotor during the process of the oily sludge cleaning were analyzed. The results showed that in the process of cleaning the oily sludge by high-speed stirring rotor, the shear force, heat dissipation and pressure increased with the enhance in the rotor speed. Cavitation occurs in the impeller area of the rotor because of the change of pressure, so the cavitation bubbles were formed. Shear force, heat dissipation and cavitation contributed to the separation of oil phase in oily sludge. Meanwhile, the simulation results were verified by experiments.

  • Open Access

    Highly Efficient Treatment of Oily Sludge by a Novel High-Speed Stirring Method at Room Temperature

    by Yimin Zhu, Keqing Li, Yin Wang, Jiao Zhao, Xiaojia Tang, Tie Li, Chenming Zhang

    Oily sludge is one of the main hazardous wastes which seriously endangers the ecological environment and human health. In this paper, in order to effectively treat oily sludge, a novel high-speed stirring (HSS) method was proposed to clean oily sludge, and the main parameters affecting the residual oil rate of oily sludge were studied experimentally. Firstly, the cleaning time and stirring speed were optimized in the one-stage HSS cleaning, and then the optimal cleaning time of two-stage HSS cleaning was determined by the response surface method. The results suggested that the oil can be efficiently separated by high-speed stirring at room temperature, and that the two-stage cleaning with a circular-hole outlet (Rotor-C) followed by a vertical hole-outlet (Rotor-V) presented the best effect. The optimal stirring speed was 6000 r/min, and the optimal cleaning times of the two-stage cleaning were 7 min and 8 min, respectively. After cleaning, the residual oil rate of the treated oily sludge was 1.65%, and the removal rate of the petroleum hydrocarbons was 84.3%.


  • Oxygen‐Vacancy‐Mediated ROS Generation Mechanism of MgO Nanoparticles against Escherichia coli

    by Xiaoyi Li, Jiao Zhao, Wei Fan, Yin Wang, Xiaojia Tang, Yimin Zhu

    The antibacterial property of MgO nanomaterials was strongly dependent on the surface defect‐mediated reactive oxygen species (ROS, such as . O 2 − , . OH and H 2 O 2 ) generation, which makes the construction of surface defects become very significant. This work demonstrated that the anti‐ Escherichia coli (E. coli) activity of MgO nanoparticles was obviously enhanced via N 2 calcination processes, with the antibacterial ratio of 95.7 % for MgO nanoparticles calcined in N 2 at 650 °C. The electron spin resonance (ESR) and X‐ray photoelectron spectroscopy (XPS) results indicated that rich oxygen vacancies on the surface of designed MgO nanoparticles could increase adsorbed oxygen content and further promote the activation of O 2 and generation of ROS. The fluorescence probe results also verified that high‐level ROS could accumulate in E. coli exposed to MgO nanomaterials. Besides, . O 2 − played a dominant role in the antibacterial property of MgO nanoparticles compared with . OH and H 2 O 2 . The above findings illustrated the correlation between oxygen vacancy‐mediated ROS generation and enhanced antibacterial activity in MgO nanoparticles calcined under N 2 atmosphere.