LCLinfeng Chen

Linfeng Chen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Linfeng Chen has a total of 30 co-authors. Here are the top co-authors by number of shared publications:

  • Fuchang Zhou

    Wuhan Second Ship Design and Research Institute, Wuhan, China

    2 shared publications
  • Peng Dou

    School of Naval Architecture and Ocean Engineering, Jiangsu University of Science and Technology, Zhenjiang 212100, China

    2 shared publications
  • Renwei Ji

    School of Naval Architecture and Ocean Engineering, Jiangsu University of Science and Technology, Zhenjiang 212100, China

    2 shared publications
  • Xianglu Jia

    Ocean Institute, Northwestern Polytechnical University, Xi’an, China

    2 shared publications
  • Yuhong Dong

    Shanghai Key Laboratory of Mechanics in Energy Engineering, Shanghai Institute of Applied Mathematics and Mechanics, School of Mechanics and Engineering Science, Shanghai University, Shanghai, China

    2 shared publications
  • Yuhong Dong

    Shanghai Institute of Applied Mathematics and Mechanics, School of Mechanics and Engineering Science, and Shanghai Key Laboratory of Mechanics in Energy Engineering, Shanghai University 1 , Shanghai 200072

    2 shared publications

Latest Publications

  • High-order large eddy simulation of incompressible turbulent flow by variational multiscale method

    by Linfeng Chen, Xianglu Jia, Peng Xu, Yuhong Dong, Jiafeng Wu, Chen Niu, Jie Zhu, Fuchang Zhou

  • Open Access

    Theoretical Analysis and Optimal Design of Underwater Towed Body Dynamic Stability

    by Junhao Chen, Linfeng Chen

    This study presents the analysis of towed stability and the optimization design method for an underwater towed body, aiming to design a towing system with high stability, good hydrodynamic performance and a high degree of safety and reliability. By proposing analytical models for both the static and dynamic behavior of the towing system, the influence of the structural characteristics on the motion of the towed body were determined. The Computational Fluid Dynamics (CFD) method was employed to conduct hydrodynamic numerical simulations of the towed body, obtaining precise hydrodynamic coefficients. The optimization design of the towed body’s center of gravity and cable connecting point position was carried out. The simulation results systematically revealed the influence of towing speed and cable length on the dynamic behavior of the towed body. With the speed increasing from 4 kN to 20 kN the depth of the towed body reduces from 277.0 m to 90.6 m, the tension of the cable inreases from 11.5 kN to 171.85 kN. At a towing speed of 20 kN, the optimized towed body stay at an averaged pitch angle of 6.82° with very small roll angles. This research provides theoretical and numerical analyzing approach for the design of high-performance underwater towed bodies.

  • Top Cited Papers
    Open Access

    A Comprehensive Review of Numerical Simulations on Vortex-Induced Vibration Response Characteristics of Deep-Sea Risers

    by Xiangquan Li, Renwei Ji, Ho-Seong Yang, Yuquan Zhang, Ratthakrit Reabroy, Peng Dou, Linfeng Chen, Lixin Xu

    As core structural components for deep-sea oil and gas exploitation, deep-sea risers are continuously subjected to wind, wave, and current loads, which readily induce vortex-induced vibration (VIV) and further trigger structural fatigue damage. Furthermore, the progressive exploitation of deepwater and ultra-deepwater oil and gas resources has exacerbated the complexity and risk of riser VIV, rendering it a critical engineering problem that urgently requires effective solutions. This paper presents a comprehensive review of numerical studies on deep-sea riser VIV, systematically elaborating the fundamental principles, research advances, and application scenarios of three mainstream numerical approaches: semi-empirical models, computational fluid dynamics (CFD) models, and computational structural dynamics (CSD) models. The respective accuracy advantages and inherent limitations of each numerical method are thoroughly analyzed. Additionally, this review focuses on key research hotspots and challenging issues, including VIV responses of flexible risers, dynamic fluid–structure boundary coupling, internal–external flow coupling effects, wake interference of multi-riser systems, efficient VIV prediction, and vibration suppression optimization. The current technical bottlenecks in existing research are clarified. This study aims to provide a systematic theoretical framework and methodological reference for subsequent numerical investigations and engineering applications of riser VIV, and offer technical support for the optimal structural design and safety risk prevention of deep-sea riser systems.


  • Top Cited Papers
    Open Access

    Energy-Harvesting Performance of Twin-Rotor Vertical-Axis Wind Turbines with Phase Interference Under Different Solidities

    by Miankui Wu, Renwei Ji, Peng Dou, Chenghang Gao, Yuquan Zhang, Jianhua Zhang, Linfeng Chen, Emmanuel Fernandez-Rodriguez

    This paper aims to investigate the aerodynamic variation patterns of twin-rotor vertical-axis wind turbines (TR-VAWTs) considering phase interference under different solidities, and to reveal the interactive mechanism between solidity, phase interference, and aerodynamic loads of TR-VAWTs. This paper first establishes a phase interference aerodynamic analysis model for TR-VAWTs based on two-dimensional computational fluid dynamics (CFD) methods. Secondly, experimental results are used to verify the accuracy of the numerical model. Finally, the variation patterns of aerodynamic forces and wake characteristics of TR-VAWTs under different parameters (solidity, initial phase angle) are explored. The results show that: (1) Each turbine of the side-by-side TR-VAWTs exhibits an increase in the energy utilization coefficient (CP) in comparison with a single rotor. (2) The phase angle exhibits similar influence patterns on the efficiency of TR-VAWTs with different solidities. As the phase angle varies within the range of 30° to 60°, the efficiencies of rotor 1 and rotor 2 under medium-to-high tip speed ratios are both improved, while within the range of 60° to 90°, the efficiencies of each rotor generally decrease. (3) When TR-VAWTs with different solidities are at intermediate phase angles (90° for two blades, 60° for three blades, and 45° for four blades), the efficiencies of each rotor are basically consistent, which is conducive to power transmission. (4) If the intermediate phase angle is adopted as the reference configuration, the pressure influence on the turbines is minimized, which can not only make the power output more balanced but also improve the wake characteristics to a certain extent.


  • Hydroacoustic reduction mechanism for the bionic hydrofoil

    by Linfeng Chen, Xianglu Jia, Peng Xu, Dongyang Chen, Kunde Yang, Jialu Wang, Yuhong Dong, Jiafeng Wu, Fuchang Zhou

    A bionic hydrofoil with the features of trailing-edge serrations, leading-edge wavy protuberances, and wavy surface was proposed for the radiation noise reduction. Large eddy simulations were conducted for the near-field unsteady turbulent flows at Reynolds number (Re) 1.0×105 and zero angle of attack to obtain the radiation noise sources. A Ffowcs Williams and Hawkings acoustic analogy was applied to the far-field sound calculations for two sets of bionic hydrofoils with different amplitudes and wavelengths of the wavy edge. The results show that the bionic hydrofoil effectively reduces its drag, the maximum drag reduction reaches 18.15% and the smallest mean drag exists at the medium amplitude or wavelength. The bionic hydrofoil also effectively reduces the turbulent radiation noise; the maximum overall sound pressure level reduction reaches 20 dB in the considered cases. It is found that, as the wavy edge amplitude increases to 2 mm, the line spectra disappear in the sound pressure level (SPL) profile. The SPL reduces by a value more than 25 dB. The wavy surface of the bionic hydrofoil triggers streamwise vortices, which break the long spanwise vortex structures into the small-scale vortices and make the flow separation shift forward. As the amplitude of the wavy edge increases, the vorticity of the streamwise vortices increases. This makes the flow separation shift more forward and more violently breaks the downstream vortices. It turns out that the velocity fluctuation in the wake is attenuated, leading to the radiation noise reduction.

  • Open Access

    Modulation of wake evolution, separation, and radiated noise by a cylinder with porous media cladding

    by Huanhuan Feng, Linfeng Chen, Yuhong Dong

    In this paper, the effects of porous media parameters on circular cylinder wake flow and radiation noise are investigated using large eddy simulations and Ffowcs Williams–Hawkings acoustic analogy. We performed three-dimensional numerical simulations for flow around the cylinder coated with a porous layer of different pores per inch in a subcritical flow regime (ReD=4.7×104) to explore the control mechanism of porous media on wake and radiation noise. The results show that the application of porous media significantly alters the separation pattern behind the cylinder and stabilizes the shear layer detached from the cylinder. The existence of porous layers leads to the transformation of chaotic and irregular vortex structures into more orderly vortices. Moreover, this study also reveals that the cylinder coated with high pore density can provide the desired noise reduction. The analysis of vortex sound theory indicates that porous media reduces the interaction area and magnitude of the positive and negative Lamb vector divergences, which is beneficial for drag reduction and noise attenuation. In addition, the comparison of sound pressure contours shows that the application of porous media does not change the radiation mode of noise, but the porous media with high pore density helps to decrease the generation of noise and intensity of the sound source.


  • Open Access

    Numerical Investigations of Blade Shape Effects on the Flow Characteristics in a Stirred Dead-End Membrane Bioreactor

    by Xu-Qu Hu, Xing-Yi Wang, Xiu-Cheng Lei, Xiang Qiu, Lin-Feng Chen

    Numerical simulations of turbulent flows in a stirred dead-end membrane bioreactor are performed by the RNG k-ε model based on finite volume method using Fluent codes. Comparisons of numerical and experimental results confirm the reliability and feasibility of the constructed model. Flow structures such as wake flows and circulation loops in stirred flows were well simulated. An increase of stirring speed is proposed to use to minimize the low velocity region. The single vane stirrer is found to be beneficial for biological separations. Results reveal that the increase of vane number can enhance the mixing effect in flow domains. However, a circular disk stirrer goes against the formation of vertical circulations. The six-vane stirrer is found to be able to provide a uniform distribution of high shear stress.