Jiye Zhao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jiye Zhao has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Jinji Sun
4 shared publications- Jinji Sun
Beihang University
2 shared publications - Lu Zhang
National Institute of Extremely-Weak Magnetic Field Infrastructure, Hangzhou 310000, People’s Republic of China
2 shared publications Di Zhang
1 shared publicationHaifeng Zhang
1 shared publication- Haoting Wu
School of Instrumentation and Optoelectronic Engineering, Beihang University 1 , Beijing 100191
1 shared publication
Latest Publications
- Open Access
- 19 November 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (19)
A dual-stage magnetic field compensation method inside a lightweight magnetic shielding room based on combined external and internal coils
Atomic magnetometers are magnetic field sensors that measure extremely weak magnetic field signals, and their measurement process typically requires a magnetic environment with high uniformity and low residual magnetic field. This paper proposes a dual-stage magnetic field compensation method for a lightweight magnetic shielding room (LMSR) based on a combination of external and internal coils. The first stage uses external coils to compensate for the residual magnetic distribution inside the LMSR, achieving a near-zero magnetic field level in the target area. Building on this initial compensation, the second stage employs internal coils designed with a particle swarm optimization algorithm that incorporates the distribution of the residual magnetic field to enhance the spatial magnetic field uniformity and compensate for magnetic field noise. Experimental results demonstrate that the dual-stage magnetic field compensation method designed for the LMSR effectively improves the uniformity of the target area with the central magnetic field close to 0 nT. After compensation with the external coils, the maximum values of the residual magnetic field components in three axes are decreased by factors of 2.5, 4.04, and 8.1, respectively. Following compensation by the internal coils, there is a significant improvement in the measurement performance of atomic magnetometers, with the maximum magnetic field fluctuation reduced by a factor of 12.6.
- 19 November 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (19)
Open AccessA dual-stage magnetic field compensation method inside a lightweight magnetic shielding room based on combined external and internal coils
Atomic magnetometers are magnetic field sensors that measure extremely weak magnetic field signals, and their measurement process typically requires a magnetic environment with high uniformity and low residual magnetic field. This paper proposes a dual-stage magnetic field compensation method for a lightweight magnetic shielding room (LMSR) based on a combination of external and internal coils. The first stage uses external coils to compensate for the residual magnetic distribution inside the LMSR, achieving a near-zero magnetic field level in the target area. Building on this initial compensation, the second stage employs internal coils designed with a particle swarm optimization algorithm that incorporates the distribution of the residual magnetic field to enhance the spatial magnetic field uniformity and compensate for magnetic field noise. Experimental results demonstrate that the dual-stage magnetic field compensation method designed for the LMSR effectively improves the uniformity of the target area with the central magnetic field close to 0 nT. After compensation with the external coils, the maximum values of the residual magnetic field components in three axes are decreased by factors of 2.5, 4.04, and 8.1, respectively. Following compensation by the internal coils, there is a significant improvement in the measurement performance of atomic magnetometers, with the maximum magnetic field fluctuation reduced by a factor of 12.6.
- 3 March 2025
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 387
Dynamic field nulling method for magnetically shielded room based on Smith predictor assisted GADRC
- 3 March 2025
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 387
Dynamic field nulling method for magnetically shielded room based on Smith predictor assisted GADRC
- 16 October 2024
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 58 (2) , 025001
Non-uniform dynamic magnetic field compensation for a lightweight magnetically shielded room based on distributed differential coils
Due to the influence of material characteristics and engineering imperfections, the residual magnetic fields including static and dynamic field in a lightweight magnetically shielded room (MSR) present non-uniform distribution characteristic. To effectively reduce the residual static field, a non-uniform field compensation method based on distributed coils has been proposed. This method takes the L2-norm of the magnetic field at the target array points as the objective function, to optimize the compensation current in each of the designed distributed coils, achieving non-uniform field compensation. To further achieve compensation for non-uniform residual dynamic field, a closed-loop control system containing a voltage divider and multi-channel amplifiers is designed in this paper. Additionally, the coil constant of the distributed differential coils and the initial magnetic field distribution vector for dynamic compensation are redefined. In conjunction with a PI controller, dynamic compensation is achieved using a single optically pumped magnetometer as the feedback component. The experimental results indicate that the average dynamic field decreased from 376.75 pT to 27.80 pT over the central volume of (300 mm)3 in MSR, achieving a near-zero magnetic environment. This method has universal applicability for compensating non-uniform residual field under different working conditions.
- 16 October 2024
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 58 (2) , 025001
Non-uniform dynamic magnetic field compensation for a lightweight magnetically shielded room based on distributed differential coils
Due to the influence of material characteristics and engineering imperfections, the residual magnetic fields including static and dynamic field in a lightweight magnetically shielded room (MSR) present non-uniform distribution characteristic. To effectively reduce the residual static field, a non-uniform field compensation method based on distributed coils has been proposed. This method takes the L2-norm of the magnetic field at the target array points as the objective function, to optimize the compensation current in each of the designed distributed coils, achieving non-uniform field compensation. To further achieve compensation for non-uniform residual dynamic field, a closed-loop control system containing a voltage divider and multi-channel amplifiers is designed in this paper. Additionally, the coil constant of the distributed differential coils and the initial magnetic field distribution vector for dynamic compensation are redefined. In conjunction with a PI controller, dynamic compensation is achieved using a single optically pumped magnetometer as the feedback component. The experimental results indicate that the average dynamic field decreased from 376.75 pT to 27.80 pT over the central volume of (300 mm)3 in MSR, achieving a near-zero magnetic environment. This method has universal applicability for compensating non-uniform residual field under different working conditions.
- Open Access
- 10 August 2024
- Published by MDPI AG in Electronics
- Vol. 13 (16) , 3163
Dynamic Field Nulling Method for Magnetically Shielded Room Based on Padé Approximation and Generalized Active Disturbance Rejection Control
Magnetically shielded rooms (MSRs) provide a near-zero field environment for magnetoencephalography (MEG) research. Due to the high cost of high-permeability materials and the weak shielding capability against low-frequency magnetic disturbance, it is necessary to further design active compensation coils combined with a closed-loop control system to achieve dynamic nulling of environmental magnetic disturbance. To enhance the performance of the dynamic nulling system, this paper proposes a novel controller design method based on Padé approximation and generalized active disturbance rejection control (GADRC). First, a precise closed-loop model of the dynamic nulling system is established. On this basis, the delay element of the optically pumped magnetometer (OPM) is approximated using the Padé approximation method, and the controller is designed within the GADRC framework. The system’s stability and disturbance suppression capability are analyzed using frequency-domain methods. To validate the effectiveness of the proposed method, simulations and experiments are conducted, achieving a shielding factor greater than 40 dB at 0.1 Hz. After filtering out power frequency interference, the peak-to-peak field fluctuation is reduced from 320.3 pT to 1.8 pT.
- 10 August 2024
- Published by MDPI AG in Electronics
- Vol. 13 (16) , 3163
Open AccessDynamic Field Nulling Method for Magnetically Shielded Room Based on Padé Approximation and Generalized Active Disturbance Rejection Control
Magnetically shielded rooms (MSRs) provide a near-zero field environment for magnetoencephalography (MEG) research. Due to the high cost of high-permeability materials and the weak shielding capability against low-frequency magnetic disturbance, it is necessary to further design active compensation coils combined with a closed-loop control system to achieve dynamic nulling of environmental magnetic disturbance. To enhance the performance of the dynamic nulling system, this paper proposes a novel controller design method based on Padé approximation and generalized active disturbance rejection control (GADRC). First, a precise closed-loop model of the dynamic nulling system is established. On this basis, the delay element of the optically pumped magnetometer (OPM) is approximated using the Padé approximation method, and the controller is designed within the GADRC framework. The system’s stability and disturbance suppression capability are analyzed using frequency-domain methods. To validate the effectiveness of the proposed method, simulations and experiments are conducted, achieving a shielding factor greater than 40 dB at 0.1 Hz. After filtering out power frequency interference, the peak-to-peak field fluctuation is reduced from 320.3 pT to 1.8 pT.
- Open Access
State Space Representation of Jiles–Atherton Hysteresis Model and Application for Closed-Loop Control
Hysteresis is a fundamental characteristic of magnetic materials. The Jiles–Atherton (J-A) hysteresis model, which is known for its few parameters and clear physical interpretations, has been widely employed in simulating hysteresis characteristics. To better analyze and compute hysteresis behavior, this study established a state space representation based on the primitive J-A model. First, based on the five fundamental equations of the J-A model, a state space representation was established through variable substitution and simplification. Furthermore, to address the singularity problem at zero crossings, local linearization was obtained through an approximation method based on the actual physical properties. Based on these, the state space model was implemented using the S-function. To validate the effectiveness of the state space model, the hysteresis loops were obtained through COMSOL finite element software and tested on a permalloy toroidal sample. The particle swarm optimization (PSO) method was used for parameter identification of the state space model, and the identification results show excellent agreement with the simulation and test results. Finally, a closed-loop control system was constructed based on the state space model, and trajectory tracking experiments were conducted. The results verify the feasibility of the state space representation of the J-A model, which holds significant practical implications in the development of magnetically shielded rooms, the suppression of magnetic interference in cold atom clocks, and various other applications.
Open AccessState Space Representation of Jiles–Atherton Hysteresis Model and Application for Closed-Loop Control
Hysteresis is a fundamental characteristic of magnetic materials. The Jiles–Atherton (J-A) hysteresis model, which is known for its few parameters and clear physical interpretations, has been widely employed in simulating hysteresis characteristics. To better analyze and compute hysteresis behavior, this study established a state space representation based on the primitive J-A model. First, based on the five fundamental equations of the J-A model, a state space representation was established through variable substitution and simplification. Furthermore, to address the singularity problem at zero crossings, local linearization was obtained through an approximation method based on the actual physical properties. Based on these, the state space model was implemented using the S-function. To validate the effectiveness of the state space model, the hysteresis loops were obtained through COMSOL finite element software and tested on a permalloy toroidal sample. The particle swarm optimization (PSO) method was used for parameter identification of the state space model, and the identification results show excellent agreement with the simulation and test results. Finally, a closed-loop control system was constructed based on the state space model, and trajectory tracking experiments were conducted. The results verify the feasibility of the state space representation of the J-A model, which holds significant practical implications in the development of magnetically shielded rooms, the suppression of magnetic interference in cold atom clocks, and various other applications.
- Open Access
- 10 July 2022
- Published by Institution of Engineering and Technology (IET) in IET Electric Power Applications
- Vol. 16 (11) , 1317-1329
Low power control for magnetically suspended control moment gyro based on current adaptive adjustment‐gimbal angular velocity feedforward method
Magnetically suspended control moment gyro (MSCMG) outputs gyro moment by changing the direction of the rotor angular momentum to adjust the spacecraft attitude. In the process of outputting moment, due to the moving‐gimbal effect, the power consumption of magnetic bearing occupies a large proportion in MSCMG. The existing low power control methods have problems that adjustment time is long and the effect of reducing energy consumption depends on the model accuracy. To solve these problems, the method of current adaptive adjustment‐gimbal angular velocity feedforward (CAA‐GAVF) is proposed. The CAA‐GAVF method controls rotor deflect actively so that the permanent magnet can generate moment to offset the coupling moment of moving‐gimbal effect, thus reducing the power consumption of control current. In CAA‐GAVF, the deflection angle of rotor is quickly adjusted by the feedforward of gimbal angular velocity. The current integral value is used to adjust the feedforward matrix adaptively and precisely. The experimental results show that the power consumption of CAA‐GAVF method is reduced to 43.3% of the traditional control method.
- 10 July 2022
- Published by Institution of Engineering and Technology (IET) in IET Electric Power Applications
- Vol. 16 (11) , 1317-1329
Open AccessLow power control for magnetically suspended control moment gyro based on current adaptive adjustment‐gimbal angular velocity feedforward method
Magnetically suspended control moment gyro (MSCMG) outputs gyro moment by changing the direction of the rotor angular momentum to adjust the spacecraft attitude. In the process of outputting moment, due to the moving‐gimbal effect, the power consumption of magnetic bearing occupies a large proportion in MSCMG. The existing low power control methods have problems that adjustment time is long and the effect of reducing energy consumption depends on the model accuracy. To solve these problems, the method of current adaptive adjustment‐gimbal angular velocity feedforward (CAA‐GAVF) is proposed. The CAA‐GAVF method controls rotor deflect actively so that the permanent magnet can generate moment to offset the coupling moment of moving‐gimbal effect, thus reducing the power consumption of control current. In CAA‐GAVF, the deflection angle of rotor is quickly adjusted by the feedforward of gimbal angular velocity. The current integral value is used to adjust the feedforward matrix adaptively and precisely. The experimental results show that the power consumption of CAA‐GAVF method is reduced to 43.3% of the traditional control method.
- 6 April 2022
- Published by Elsevier in Mechatronics
- Vol. 84
Gimbal Angular Velocity Feedforward Method for Magnetically Suspended Control Moment Gyro with Hybrid Magnetic Bearing#
- 6 April 2022
- Published by Elsevier in Mechatronics
- Vol. 84
Gimbal Angular Velocity Feedforward Method for Magnetically Suspended Control Moment Gyro with Hybrid Magnetic Bearing#