Ahyeon Ma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ahyeon Ma has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Ki Min Nam
Pusan National University
3 shared publications Ha Young Kim
Department of Chemistry, Chemistry Institute for Functional Materials, Pusan National University, Busan 46241, Republic of Korea
2 shared publicationsJoon Yong Park
Department of Chemistry, Chemistry Institute for Functional Materials, Pusan National University, Busan 46241, Republic of Korea
2 shared publications- Sung Ki Cho
Center for Hydrogen and Fuel Cells Clean Hydrogen Institute Korea Institute of Science and Technology (KIST) Seongbuk‐gu Seoul Republic of Korea
2 shared publications Dongho Seo
Department of Chemistry, Chemistry Institute for Functional Materials, Pusan National University, Busan 46241, Republic of Korea
1 shared publication- Dongho Seo
Department of Chemistry and Chemistry Institute for Functional Materials, Pusan National University, Geumjeong-gu, Busan, 46241, Republic of Korea
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Wiley in International Journal of Energy Research
- Vol. 2026 (1) , 6003539
A Comprehensive and Systematic Analysis of Performance‐Limiting Factors as a Function of IrO 2 Loading Amount in Proton Exchange Membrane Water Electrolysis: IrO 2 Ultra‐Low‐Loading Strategy
Proton exchange membrane water electrolysis (PEMWE) enables efficient hydrogen production under high current density operation but requires iridium‐based catalysts to sustain anodic oxygen evolution in acidic environments. Reducing Ir usage without sacrificing cell performance therefore represents a key requirement for practical system implementation. Many studies have shown that increasing Ir loading generally improves electrolyzer performance, but how performance limitations evolve across catalyst loading regimes has not been systematically resolved. In this work, the performance of a PEMWE cell was evaluated over a wide IrO 2 loading range of 0.01–4.0 mg cm −2 . Combined polarization analysis and electrochemical impedance spectroscopy (EIS) were employed to distinguish kinetic, ohmic, and mass‐transport contributions governing cell performance. Increasing catalyst loading substantially improved low‐current‐density operation through mitigation of charge‐transfer limitations, accompanied by a reduction in charge‐transfer resistance ( R ct ) from 5.08 to 0.41 Ω between 0.01 and 0.03 mg cm −2 . At higher loadings, performance improvement became progressively limited and approached current saturation at cell voltages above 1.8 V. The IrO 2 mass activity exhibited a maximum at intermediate loading (0.03 mg cm −2 ) and decreased with further loading increase, indicating incomplete utilization of catalyst layers at large thicknesses. The apparent electrochemically active surface area (ECSA)‐normalized charge‐transfer response remained within the same order of magnitude in the ultra‐low‐loading transition region, indicating that the sharp decrease in R ct primarily reflected an increase in electrochemically connected surface area. At the ultra‐low‐loading end of the range, electrodes prepared at ultra‐low loading showed elevated ohmic resistance associated with insufficient electrical connectivity and reduced interfacial contact with the porous transport layer (PTL). Enhancing PTL–electrode contact significantly improved performance under ultra‐low loading conditions. The results establish loading‐dependent performance regimes governed by distinct limiting processes and provide practical guidance for minimizing iridium usage while maintaining high PEMWE performance.
- 1 January 2026
- Published by Wiley in International Journal of Energy Research
- Vol. 2026 (1) , 6003539
Open AccessA Comprehensive and Systematic Analysis of Performance‐Limiting Factors as a Function of IrO 2 Loading Amount in Proton Exchange Membrane Water Electrolysis: IrO 2 Ultra‐Low‐Loading Strategy
Proton exchange membrane water electrolysis (PEMWE) enables efficient hydrogen production under high current density operation but requires iridium‐based catalysts to sustain anodic oxygen evolution in acidic environments. Reducing Ir usage without sacrificing cell performance therefore represents a key requirement for practical system implementation. Many studies have shown that increasing Ir loading generally improves electrolyzer performance, but how performance limitations evolve across catalyst loading regimes has not been systematically resolved. In this work, the performance of a PEMWE cell was evaluated over a wide IrO 2 loading range of 0.01–4.0 mg cm −2 . Combined polarization analysis and electrochemical impedance spectroscopy (EIS) were employed to distinguish kinetic, ohmic, and mass‐transport contributions governing cell performance. Increasing catalyst loading substantially improved low‐current‐density operation through mitigation of charge‐transfer limitations, accompanied by a reduction in charge‐transfer resistance ( R ct ) from 5.08 to 0.41 Ω between 0.01 and 0.03 mg cm −2 . At higher loadings, performance improvement became progressively limited and approached current saturation at cell voltages above 1.8 V. The IrO 2 mass activity exhibited a maximum at intermediate loading (0.03 mg cm −2 ) and decreased with further loading increase, indicating incomplete utilization of catalyst layers at large thicknesses. The apparent electrochemically active surface area (ECSA)‐normalized charge‐transfer response remained within the same order of magnitude in the ultra‐low‐loading transition region, indicating that the sharp decrease in R ct primarily reflected an increase in electrochemically connected surface area. At the ultra‐low‐loading end of the range, electrodes prepared at ultra‐low loading showed elevated ohmic resistance associated with insufficient electrical connectivity and reduced interfacial contact with the porous transport layer (PTL). Enhancing PTL–electrode contact significantly improved performance under ultra‐low loading conditions. The results establish loading‐dependent performance regimes governed by distinct limiting processes and provide practical guidance for minimizing iridium usage while maintaining high PEMWE performance.
- 28 December 2023
- Published by Royal Society of Chemistry (RSC) in Inorganic Chemistry Frontiers
- Vol. 11 (4) , 998-1018
Tailoring co-catalysts on Si photocathodes for efficient photoelectrochemical CO2 reduction: recent progress and prospects of deposition methods
This review examines recent advancements in co-catalyst design and loading strategies for photoelectrochemical CO2 reduction, emphasizing deposition methods such as physical vapor deposition, drop-casting, and photo/electrodeposition.
- 28 December 2023
- Published by Royal Society of Chemistry (RSC) in Inorganic Chemistry Frontiers
- Vol. 11 (4) , 998-1018
Tailoring co-catalysts on Si photocathodes for efficient photoelectrochemical CO2 reduction: recent progress and prospects of deposition methods
This review examines recent advancements in co-catalyst design and loading strategies for photoelectrochemical CO2 reduction, emphasizing deposition methods such as physical vapor deposition, drop-casting, and photo/electrodeposition.
- 6 May 2022
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 10 (22) , 12047-12054
Chemical and electrochemical synthesis of cobalt hydroxides: selective phase transformation and application to distinct electrocatalytic reactions
Electrochemical and chemical phase transformations of α-Co(OH)2 into various other cobalt hydroxides were performed, and their structures were characterized to discern the correlation between electrocatalytic activity and crystal structure.
- 6 May 2022
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 10 (22) , 12047-12054
Chemical and electrochemical synthesis of cobalt hydroxides: selective phase transformation and application to distinct electrocatalytic reactions
Electrochemical and chemical phase transformations of α-Co(OH)2 into various other cobalt hydroxides were performed, and their structures were characterized to discern the correlation between electrocatalytic activity and crystal structure.
- 4 July 2019
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 43 (30) , 11893-11902
Understanding and improving photoelectrochemical performance of Bi2O3/Bi2S3 composite
The simple and fast ultrasonic-assisted synthesis of high-performance, low-interfacial-resistance Bi2O3/Bi2S3 composite semiconductors is demonstrated.
- 4 July 2019
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 43 (30) , 11893-11902
Understanding and improving photoelectrochemical performance of Bi2O3/Bi2S3 composite
The simple and fast ultrasonic-assisted synthesis of high-performance, low-interfacial-resistance Bi2O3/Bi2S3 composite semiconductors is demonstrated.