Asif Raza
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Asif Raza has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
In Wook Nah
2 shared publicationsSang-Min Lee
Korea Electrotechnology Research Institute
2 shared publicationsCheolhee Han
Department of Energy Science and Engineering, Daegu Gyeongbuk Institute of Science and Technology (DGIST), Daegu, 42988, Republic of Korea
1 shared publication- Chil-Hoon Doh
Korea Electro-Technology Research Institute (KERI)
1 shared publication Daeseung Kyung
1 shared publication- Doohun Kim
Battery Research Division, Korea Electrotechnology Research Institute (KERI), 12, Jeongiui-gil, Seongsan-gu, Changwon-si, Gyeongsangnam-do, 51543, Republic of Korea
1 shared publication
Latest Publications
- 27 July 2022
- Published by Wiley in International Journal of Energy Research
- Vol. 46 (13) , 18269-18277
Crystallinity‐controlled SiO x anode material prepared through a salt‐assisted magnesiothermic reduction for lithium‐ion batteries
- 27 July 2022
- Published by Wiley in International Journal of Energy Research
- Vol. 46 (13) , 18269-18277
Crystallinity‐controlled SiO x anode material prepared through a salt‐assisted magnesiothermic reduction for lithium‐ion batteries
- 19 October 2021
- Published by The Electrochemical Society in ECS Meeting Abstracts
- Vol. MA2021-02 (5) , 1929
Inert Salt Assisted Magnesiothermic Reduction Process for the Synthesis of Crystallinity Controlled High-Performance SiOx Anode Material for Lithium-Ion Batteries
Silicon sub oxides (SiOx) materials are considered as potential anode materials for next-generation high-energy lithium-ion batteries (LIBs) because of their high specific capacity and improved cyclic performance with the advantage of low operating voltage. Many parameters influence the performance anode material in lithium ion batteries, such as nano-size material, high surface area and crystalline structure. Especially crystallinity of Si is a significant factor for obtaining better performance because it directly affect the structural stability of Si anode during the electrochemical reactions. Crystallinity is directly controlled by the reaction temperature. Here we compared the effect of heat absorbent inner salt KCl and NaCl on the Si crystallinity. Crystallinity controlled D-SiOx anode material has been prepared by partial magnesiothermic reduction process using heat regulating inert salts KCl and NaCl for enhanced electrochemical properties. Anode prepared using KCl assisted shows low crystallinity of Si with remarkably improved reversible capacity and excellent cyclic stability as compared with NaCl assisted high crystalline Si. KCl assisted D-SiOx exhibited initial discharge and charge capacities of 2243 and 1862 mA h g-1, respectively, with an ICE of 83%. Moreover, it showed a stable cycle performance, maintaining a high capacity retention of up to 90% even after 200 cycles at 0.5C. Figure 1
- 19 October 2021
- Published by The Electrochemical Society in ECS Meeting Abstracts
- Vol. MA2021-02 (5) , 1929
Inert Salt Assisted Magnesiothermic Reduction Process for the Synthesis of Crystallinity Controlled High-Performance SiOx Anode Material for Lithium-Ion Batteries
Silicon sub oxides (SiOx) materials are considered as potential anode materials for next-generation high-energy lithium-ion batteries (LIBs) because of their high specific capacity and improved cyclic performance with the advantage of low operating voltage. Many parameters influence the performance anode material in lithium ion batteries, such as nano-size material, high surface area and crystalline structure. Especially crystallinity of Si is a significant factor for obtaining better performance because it directly affect the structural stability of Si anode during the electrochemical reactions. Crystallinity is directly controlled by the reaction temperature. Here we compared the effect of heat absorbent inner salt KCl and NaCl on the Si crystallinity. Crystallinity controlled D-SiOx anode material has been prepared by partial magnesiothermic reduction process using heat regulating inert salts KCl and NaCl for enhanced electrochemical properties. Anode prepared using KCl assisted shows low crystallinity of Si with remarkably improved reversible capacity and excellent cyclic stability as compared with NaCl assisted high crystalline Si. KCl assisted D-SiOx exhibited initial discharge and charge capacities of 2243 and 1862 mA h g-1, respectively, with an ICE of 83%. Moreover, it showed a stable cycle performance, maintaining a high capacity retention of up to 90% even after 200 cycles at 0.5C. Figure 1
- 1 February 2021
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 314
Eco-friendly prepared mesoporous carbon encapsulated SnO2 nanoparticles for high-reversible lithium-ion battery anodes
- 1 February 2021
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 314
Eco-friendly prepared mesoporous carbon encapsulated SnO2 nanoparticles for high-reversible lithium-ion battery anodes
- 23 November 2020
- Published by The Electrochemical Society in ECS Meeting Abstracts
- Vol. MA2020-02 (2) , 433
Improved Initial Coulombic Efficiency of Optimized SiOx Via Simple Magnesiothermic Reduction As High-Performance Anode Material for Lithium-Ion Battery
With the increasing demands of portable electronics and electric vehicles, rechargeable lithium-ion batteries are strongly considered from the utility standpoint due to their high energy density. Lithium-ion batteries have become a leading technology [1]. Silicon-based materials have gained tremendous attention due to their great importance in various techniques such as electronic devices, solar energy conversion and high capacity anode for LIBs [2]. Low cost, high energy density, SiO considered one of the most promising anode material for lithium-ion batteries. However low initial Coulombic efficiency is a serious limitation for the practical application of SiO. The intrinsic low Coulombic efficiency (ICE) caused by the side reactions between Li-ions and Si as well as the formation of Solid Electrolyte interphase (SEI) [3]. Many methods have been approached to solve this challenge, pre-lithiation, metal reduction, graphene coating, Nano-sizing, nanotubes, and fabrication of silicon and carbon composite. Among these methods, the metallothermic reduction has gained significant attention. The reducing metal should be inexpensive, convenient to handle and easily removable by-product, therefore Mg has been widely used metal to reduce Si oxides [4]. Herein, we report an affordable low temperature and low-cost synthesis method to synthesize SiOx by partial reduction of SiO via Magnesiothermic reduction. To find out the optimum amount of Mg to reduce SiO, various amount of Mg has been investigated. The ICE was gradually increased with the amount of Mg increased. The electrochemical performance was tested by cyclic voltammetry (CV) and discharge-charge measurement. The results show the sample prepared at 85% (mole) of Mg exhibited the larger storage capacity of 1656.47 mAh g-1 and outstanding high initial Coulombic efficiency of 83.09%, and better cyclic property as compare to Bare SiO. [1] M. Armand and J.-M. Tarascon, “Building better batteries,” Nature, vol. 451, p. 652, Feb. 2008. [2] N. Lin et al., “A low temperature molten salt process for aluminothermic reduction of silicon oxides to crystalline Si for Li-ion batteries,” Energy Environ. Sci., vol. 8, no. 11, pp. 3187–3191, 2015. [3] Y. Zhang et al., “An affordable manufacturing method to boost the initial Coulombic efficiency of disproportionated SiO lithium-ion battery anodes,” J. Power Sources, vol. 426, pp. 116–123, 2019. [4] Y. Lai, J. R. Thompson, and M. Dasog, “Metallothermic Reduction of Silica Nanoparticles to Porous Silicon for Drug Delivery Using New and Existing Reductants,” Chem. Eur. J., vol. 24, no. 31, pp. 7913–7920, 2018.
- 23 November 2020
- Published by The Electrochemical Society in ECS Meeting Abstracts
- Vol. MA2020-02 (2) , 433
Improved Initial Coulombic Efficiency of Optimized SiOx Via Simple Magnesiothermic Reduction As High-Performance Anode Material for Lithium-Ion Battery
With the increasing demands of portable electronics and electric vehicles, rechargeable lithium-ion batteries are strongly considered from the utility standpoint due to their high energy density. Lithium-ion batteries have become a leading technology [1]. Silicon-based materials have gained tremendous attention due to their great importance in various techniques such as electronic devices, solar energy conversion and high capacity anode for LIBs [2]. Low cost, high energy density, SiO considered one of the most promising anode material for lithium-ion batteries. However low initial Coulombic efficiency is a serious limitation for the practical application of SiO. The intrinsic low Coulombic efficiency (ICE) caused by the side reactions between Li-ions and Si as well as the formation of Solid Electrolyte interphase (SEI) [3]. Many methods have been approached to solve this challenge, pre-lithiation, metal reduction, graphene coating, Nano-sizing, nanotubes, and fabrication of silicon and carbon composite. Among these methods, the metallothermic reduction has gained significant attention. The reducing metal should be inexpensive, convenient to handle and easily removable by-product, therefore Mg has been widely used metal to reduce Si oxides [4]. Herein, we report an affordable low temperature and low-cost synthesis method to synthesize SiOx by partial reduction of SiO via Magnesiothermic reduction. To find out the optimum amount of Mg to reduce SiO, various amount of Mg has been investigated. The ICE was gradually increased with the amount of Mg increased. The electrochemical performance was tested by cyclic voltammetry (CV) and discharge-charge measurement. The results show the sample prepared at 85% (mole) of Mg exhibited the larger storage capacity of 1656.47 mAh g-1 and outstanding high initial Coulombic efficiency of 83.09%, and better cyclic property as compare to Bare SiO. [1] M. Armand and J.-M. Tarascon, “Building better batteries,” Nature, vol. 451, p. 652, Feb. 2008. [2] N. Lin et al., “A low temperature molten salt process for aluminothermic reduction of silicon oxides to crystalline Si for Li-ion batteries,” Energy Environ. Sci., vol. 8, no. 11, pp. 3187–3191, 2015. [3] Y. Zhang et al., “An affordable manufacturing method to boost the initial Coulombic efficiency of disproportionated SiO lithium-ion battery anodes,” J. Power Sources, vol. 426, pp. 116–123, 2019. [4] Y. Lai, J. R. Thompson, and M. Dasog, “Metallothermic Reduction of Silica Nanoparticles to Porous Silicon for Drug Delivery Using New and Existing Reductants,” Chem. Eur. J., vol. 24, no. 31, pp. 7913–7920, 2018.
- 1 December 2019
- Published by Elsevier in Applied Surface Science
- Vol. 497
Optimization of synthesis conditions of high–tap density FeVO4 hollow microspheres via spray pyrolysis for lithium–ion batteries
- 1 December 2019
- Published by Elsevier in Applied Surface Science
- Vol. 497
Optimization of synthesis conditions of high–tap density FeVO4 hollow microspheres via spray pyrolysis for lithium–ion batteries