GKGyunha Kim

Gyunha Kim

*This is an algorithmically generated author record based on publicly available information.

Gyunha Kim has a total of 3 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Quantitative Analysis of Ringing in a Controller Area Network With Flexible Data Rate for Reliable Physical Layer Designs

    by Hansang Lim, Gyunha Kim, Seungsu Kim, Dongok Kim

    Signal distortion, called ringing, in a controller area network with flexible data rate (CAN-FD) causes asymmetry of propagation delay throughout a network, which is dependent on its physical bus design and becomes a critical issue in limiting the data rate. Thus, the bus structure of a CAN-FD is investigated and a transfer function of ringing is modeled by considering the physical bus configuration and features of a controller area network transceiver. The effects of the main parameters of the physical bus, such as the stub line length and number of stub lines connected to a joint connector, are then quantitatively analyzed using the presented model. When a practical bus structure is considered, additional signal distortion owing to a neighboring connector in a physical bus is modeled and analyzed. These analytical results are confirmed experimentally. Their comparison shows that the presented model-based analysis can closely approximate the size and time response of ringing and the extent of bit time distortion. The presented model-based analysis facilitates reliable communication performance by estimating the ringing and resulting asymmetry of the propagation delay for a given physical bus design and, if necessary, adjusting the design.


  • Ringing Suppression in a Controller Area Network With Flexible Data Rate Using Impedance Switching and a Limiter

    by Gyunha Kim, Hansang Lim

    The ringing and the resulting asymmetry in the propagation delay are the main causes of bandwidth degradation and communication errors in a controller area network (CAN) with flexible data rate. Therefore, in this paper, the mechanism of ringing is analyzed, and the ringing suppression circuit is proposed based on the analysis. The proposed circuit includes an impedance matching resistor and a forward-biased diode for terminating the repetition of reflections and limiting the magnitude of the ringing. These components are temporarily connected by operating a switch that is controlled by the TxD signal of a CAN controller so that the ringing suppression circuit only engages when necessary and at the correct time. The performance of the ringing suppression circuit is verified by experiments. The experimental results show that the proposed circuit keeps the ringing adequately suppressed and the good symmetry in the propagation delay across the physical bus is possessed.