HRHans Reisinger

Hans Reisinger

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Hans Reisinger has a total of 89 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Gate Switching Instability in Silicon Carbide MOSFETs—Part II: Modeling

    by Tibor Grasser, Maximilian W. Feil, Katja Waschneck, Hans Reisinger, Judith Berens, Dominic Waldhoer, Aleksandr Vasilev, Michael Waltl, Thomas Aichinger, Michel Bockstedte, et al.

    It has recently been observed that bipolar switching between accumulation and inversion can result in an unexpected threshold voltage drift in SiC MOSFETs. This phenomenon has been termed gate switching instability (GSI) and is characterized by power-law time exponents close to unity, significantly larger than what is typically observed for ordinary bias temperature instability (BTI) during static or unipolar switching stress. Since the bias, frequency, and temperature dependence of GSI are the same as what is seen in charge pumping (CP) experiments, we stipulate that recombination events at the interface lead to recombination-enhanced defect reactions (REDRs), which can eventually lead to degradation. Based on these observations, we develop a comprehensive physical model for GSI, discuss its features, derive a closed form analytical solution, and finally validate the model against detailed experimental data.


  • Open Access

    Gate Switching Instability in Silicon Carbide MOSFETs—Part I: Experimental

    by Maximilian W. Feil, Katja Waschneck, Hans Reisinger, Judith Berens, Thomas Aichinger, Sven Prigann, Gregor Pobegen, Paul Salmen, Gerald Rescher, Dominic Waldhoer, et al.

    In the context of renewable energy generation, compact and efficient electric power conversion is becoming increasingly important. Due to their low-loss switching capability at high frequencies, of up to hundreds of kilohertz, silicon carbide (SiC) MOSFETs are currently gaining a lot of attention from industry and are gradually replacing silicon (Si)-based devices in numerous applications. Recently, it has been revealed that SiC MOSFETs show a new type of instability in extensive high-frequency operations when the device is switched in bipolar mode. This gate switching instability has been observed in all commercial devices and occurs concurrently with the well-known bias temperature instability. We summarize the defining experimental characteristics of gate switching instability, including frequency, voltage, temperature, transition time dependencies, and the impact of undershoots in gate voltage. Subsequently, we discuss these observations together with those from other researchers, including recently proposed mechanisms and how they agree or disagree with the available experimental evidence. In the second part of this publication, we will present a detailed physics-based model that fully agrees with all presented experiments.


  • Open Access

    On the Frequency Dependence of the Gate Switching Instability in Silicon Carbide MOSFETs

    by Maximilian Wolfgang Feil, Katja Waschneck, Hans Reisinger, Paul Salmen, Gerald Rescher, Thomas Aichinger, Wolfgang Gustin, Tibor Grasser

    Silicon carbide power metal-oxide semiconductor field-effect transistors (MOSFETs) are suitable for more compact and energy efficient electric power conversion, pushing forward numerous key technologies in emission-free mobility and green power generation. These applications require fast gate switching up to hundreds of kilohertz. Typically, to assure a clear turn-off state of the electron channel, a negative turn-off gate bias is used in conjunction with a positive turn-on gate bias. Recently, several reports have revealed a new and so far unknown degradation mechanism that emerges during such operation conditions in apparently all commercial silicon carbide MOSFETs. As this mechanism arises upon gate switching, the terms gate switching instability (GSI) and gate switching stress (GSS) for the mechanism and the associated stress, respectively, have been introduced.Here, we show that this degradation mechanism does not depend on the used frequency up to at least 2 MHz, but that it is actually related to the cumulative number of switching cycles. For this purpose, we performed measurements at various frequencies comprising ultra-fast in-situ measurements of the threshold voltage and pre- and post-stress characterization by impedance analysis. The results are important both for understanding the underlying physics and for developing a correct methodology for industrial device qualification.


  • Open Access

    Performance Analysis of 4H-SiC Pseudo-D CMOS Inverter Circuits Employing Physical Charge Trapping Models

    by Michael Waltl, Yoanlys Hernandez, Christian Schleich, Katja Waschneck, Bernhard Stampfer, Hans Reisinger, Tibor Grasser

    For the analysis of the characteristics and behavior of circuits prior to fabrication and to improve circuit performance, simulations using Spice tools are typically performed. Such tools rely on static compact models describing the behavior of the individual circuit components such as transistors. In reality, the behavior of the transistors changes over time due to aging, for instance, as a consequence of bias temperature instabilities (BTI). BTI is typically referred to as a drift of the threshold voltage of a transistor due to charge trapping at oxide and interface defects. To explain BTI, power-law-like mathematical expressions are often employed. However, using these simple formulas, the experimental data can only be replicated with limited accuracy. To evaluate the performance of logic inverter circuits made from 4H-SiC CMOS transistors with high precision, we use a physics-based defect model to describe the change of the device behavior from a defect-centric perspective. Our results indicate the limitations of using power-law-like formulas as they lead to an overly pessimistic estimation for circuit parameters.


  • Physical Modeling of Charge Trapping in 4H-SiC DMOSFET Technologies

    by Christian Schleich, Dominic Waldhoer, Katja Waschneck, Maximilian W. Feil, Hans Reisinger, Tibor Grasser, Michael Waltl

    Silicon carbide (SiC) MOSFETs still exhibit higher drifts of the threshold voltage than comparable silicon devices due to charge trapping, especially regarding small time scales. Understanding this behavior and the consequences in application relevant conditions is therefore of high research interest. Since charge trapping at different defects close to the SiC/ SiO 2 interface and in the bulk oxide is strong bias and temperature-dependent, the phenomenon is referred to as bias temperature instability (BTI). It has been shown that drifts caused by BTI vary both in transient shape and magnitude for commercially available devices. These differences arise from defect densities and properties in the respective technologies. A physical model together with defect parameters that explain the charge transfer reactions at the defects is essential to understand all peculiarities of the transient degradation. In this work, we use a novel method to semiautomatically extract defect parameters within a two-state nonradiative multiphonon model framework. Our work reveals properties of defects responsible for shifts of the threshold voltage for both short-term ac and long-term dc stress conditions which are accurately reproduced for three different DMOS technologies. Our calibrated simulation framework is further used to extrapolate device degradation at operation relevant ac bias conditions to typical device lifetimes.


  • Open Access

    The Impact of Interfacial Charge Trapping on the Reproducibility of Measurements of Silicon Carbide MOSFET Device Parameters

    by Maximilian W. Feil, Andreas Huerner, Katja Puschkarsky, Christian Schleich, Thomas Aichinger, Wolfgang Gustin, Hans Reisinger, Tibor Grasser

    Silicon carbide is an emerging material in the field of wide band gap semiconductor devices. Due to its high critical breakdown field and high thermal conductance, silicon carbide MOSFET devices are predestined for high-power applications. The concentration of defects with short capture and emission time constants is higher than in silicon technologies by orders of magnitude which introduces threshold voltage dynamics in the volt regime even on very short time scales. Measurements are heavily affected by timing of readouts and the applied gate voltage before and during the measurement. As a consequence, device parameter determination is not as reproducible as in the case of silicon technologies. Consequent challenges for engineers and researchers to measure device parameters have to be evaluated. In this study, we show how the threshold voltage of planar and trench silicon carbide MOSFET devices of several manufacturers react on short gate pulses of different lengths and voltages and how they influence the outcome of application-relevant pulsed current-voltage characteristics. Measurements are performed via a feedback loop allowing in-situ tracking of the threshold voltage with a measurement delay time of only 1 μs. Device preconditioning, recently suggested to enable reproducible BTI measurements, is investigated in the context of device parameter determination by varying the voltage and the length of the preconditioning pulse.


  • On the Physical Meaning of Single-Value Activation Energies for BTI in Si and SiC MOSFET Devices

    by M. W. Feil, K. Puschkarsky, W. Gustin, H. Reisinger, T. Grasser

    Bias temperature instability (BTI) has been shown to be the collective response of an ensemble of defects to a gate voltage signal. Each defect can be described using first-order reactions for either charge trapping or defect creation with a broad distribution of time constants. Consequently, the temperature dependence of BTI has to be determined by a distribution of activation energies reflecting the variety of available defects. Commonly employed single-value apparent activation energy-based modeling of BTI can therefore be at best a very rough approximation and its apparent activation energy is consequently a model parameter without physical justification. This study investigates the impact of measurement parameters, such as the extraction point in the drift curve and the recovery time, on these apparent activation energies that can be extracted either by threshold voltage shift increase (vertical method) or by stress time acceleration (horizontal method). The framework of activation energy maps enables an analytical mathematical approach to calculate the dependence of extracted apparent activation energies on the measurement parameters. A comparison between Si and SiC MOSFET devices is employed, and nonphysical negative apparent activation energies are explained. Since apparent activation energies have been repeatedly employed to justify physics-based descriptions of BTI, their physical (in)significance is discussed.


  • Open Access

    Mixed Hot-Carrier/Bias Temperature Instability Degradation Regimes in Full {V G, V D} Bias Space: Implications and Peculiarities

    by Markus Jech, Gunnar Rott, Hans Reisinger, Stanislav Tyaginov, Gerhard Rzepa, Alexander Grill, Dominic Jabs, Christoph Jungemann, Michael Waltl, Tibor Grasser

    Characterizing mixed hot-carrier/bias temperature instability (BTI) degradation in full { $\textit {V}_{\text{G}}$ , $\textit {V}_{\text{D}}$ } bias space is a challenging task. Therefore, studies usually focus on individual degradation mechanisms, such as BTI and hot-carrier degradation (HCD). However, a simple superposition of these mechanisms at an arbitrary { $\textit {V}_{\text{G}}$ , $\textit {V}_{\text{D}}$ } combination often fails to predict the cumulative damage. We experimentally acquired a large data set covering the full bias space of a pMOSFET which allows us to obtain detailed degradation and recovery maps. Our models for describing oxide and interface defects provide physical insights into the underlying mechanisms and a possible interplay between the degradation modes. Additionally, we perform a dedicated experiment to reveal the implications of different stress regimes onto the various types of defects by switching BTI and HCD stress conditions. The results clearly reveal the conceptual limits of the assumption of independent degradation regimes.


  • Influence of high-voltage gate-oxide pulses on the BTI behavior of SiC MOSFETs

    by S. Maas, H. Reisinger, T. Aichinger, G. Rescher

    We study the bias temperature instability (BTI) behavior of 4H-SiC trench MOSFETs after application of very high gate-voltage pulses at high temperatures. These pulses correspond to an electric field sufficiently high to trigger impact ionization and the associated effects in gate oxides. BTI effects measured in the form of threshold voltage or V Th drifts are more severe after these pulses as compared to BTI after voltage pulses that are sufficiently below the impact ionization regime. The effects shown in this paper impose an upper limit on electric fields applied to the gate during, e.g., device screening during front-end processing, but also in the application.


  • Top Cited Papers

    Review on SiC MOSFETs High-Voltage Device Reliability Focusing on Threshold Voltage Instability

    by K. Puschkarsky, T. Grasser, T. Aichinger, W. Gustin, H. Reisinger

    An overview over issues and findings in SiC power MOSFET reliability is given. The focus of this article is on threshold instabilities and the differences to Si power MOSFETs. Measurement techniques for the characterization of the threshold voltage instabilities are compared and discussed. Modeling of the threshold voltage instabilities based on capture-emission-time (CET) maps is a central topic. This modeling approach takes the complete gate bias/temperature history into account. It includes both gate stress polarities and is able to reproduce the short-term threshold variations during application-relevant 50-kHz bipolar ac-stress. In addition, the impact on circuit operation is discussed.