Li Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Li Li has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Donald J. Weidner
Stony Brook University
4 shared publications- John P. Brodholt
Department of Earth Sciences University College London London UK
3 shared publications Cesar R. S. Da Silva
2 shared publications- Dario Alfè
University College London
2 shared publications - Donald J. Weidner
Mineral Physics Institute, Stony Brook University, Stony Brook, New York 11794, USA
2 shared publications Donald Weidner
Mineral Physics Institute, Department of Geosciences, State University of New York at Stony Brook, Stony Brook, New York, 11794-2100, U.S.A.
2 shared publications
Latest Publications
- 31 March 2012
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 194-195, 98-106
Anelasticity and transient creep in NaMgF3 perovskite at high pressure
- 31 March 2012
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 194-195, 98-106
Anelasticity and transient creep in NaMgF3 perovskite at high pressure
- 30 June 2011
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 186 (3-4) , 199-203
Bulk attenuation in the earth's mantle due to phase transitions
- 30 June 2011
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 186 (3-4) , 199-203
Bulk attenuation in the earth's mantle due to phase transitions
- 4 April 2011
- Published by Springer Nature in Journal of Earth Science
- Vol. 22 (2) , 169-175
Ab initio molecular dynamic simulation on the elasticity of Mg3Al2Si3O12 pyrope
- 4 April 2011
- Published by Springer Nature in Journal of Earth Science
- Vol. 22 (2) , 169-175
Ab initio molecular dynamic simulation on the elasticity of Mg3Al2Si3O12 pyrope
- 1 December 2009
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 177 (3-4) , 103-115
Structure and elasticity of hydrous ringwoodite: A first principle investigation
- 1 December 2009
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 177 (3-4) , 103-115
Structure and elasticity of hydrous ringwoodite: A first principle investigation
- 30 November 2008
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 170 (3) , 176-180
Elastic softening of peridotite due to the presence of melt phases at high pressure
- 30 November 2008
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 170 (3) , 176-180
Elastic softening of peridotite due to the presence of melt phases at high pressure
- 11 September 2008
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 174 (1-4) , 174-180
An exploratory study of the viscoelasticity of phase-transforming material
- 11 September 2008
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 174 (1-4) , 174-180
An exploratory study of the viscoelasticity of phase-transforming material
- 1 August 2008
- Published by Springer Nature in Nature
- Vol. 454 (7207) , 984-986
Effect of phase transitions on compressional-wave velocities in the Earth’s mantle
The velocities of seismic waves in the Earth are governed by the response of the constituent mineral assemblage to perturbations in pressure and stress. The effective bulk modulus is significantly lowered if the pressure of the seismic wave drives a volume-reducing phase transformation. A comparison between the amount of time required by phase transitions to reach equilibrium and the sampling period thus becomes crucial in defining the softening and attenuation of compressional waves within such a two-phase zone. These phenomena are difficult to assess experimentally, however, because data at conditions appropriate to the Earth's deep interior are required. Here we present synchrotron-based experimental data that demonstrate softening of the bulk modulus within the two-phase loop of olivine-ringwoodite on a timescale of 100 s. If the amplitude of the pressure perturbation and the grain size are scaled to those expected in the Earth, the compressional-wave velocities within the discontinuities at 410, 520 and, possibly, 660 km are likely to be significantly lower than otherwise expected. The generalization of these observations to aluminium-controlled phase transitions raises the possibility of large velocity perturbations throughout the upper 1,000 km of the mantle.
- 1 August 2008
- Published by Springer Nature in Nature
- Vol. 454 (7207) , 984-986
Effect of phase transitions on compressional-wave velocities in the Earth’s mantle
The velocities of seismic waves in the Earth are governed by the response of the constituent mineral assemblage to perturbations in pressure and stress. The effective bulk modulus is significantly lowered if the pressure of the seismic wave drives a volume-reducing phase transformation. A comparison between the amount of time required by phase transitions to reach equilibrium and the sampling period thus becomes crucial in defining the softening and attenuation of compressional waves within such a two-phase zone. These phenomena are difficult to assess experimentally, however, because data at conditions appropriate to the Earth's deep interior are required. Here we present synchrotron-based experimental data that demonstrate softening of the bulk modulus within the two-phase loop of olivine-ringwoodite on a timescale of 100 s. If the amplitude of the pressure perturbation and the grain size are scaled to those expected in the Earth, the compressional-wave velocities within the discontinuities at 410, 520 and, possibly, 660 km are likely to be significantly lower than otherwise expected. The generalization of these observations to aluminium-controlled phase transitions raises the possibility of large velocity perturbations throughout the upper 1,000 km of the mantle.
- 17 April 2008
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research
- Vol. 113 (B4)
Correction to “Vibrational and thermodynamic properties of forsterite at mantle conditions”
- 17 April 2008
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research
- Vol. 113 (B4)
Correction to “Vibrational and thermodynamic properties of forsterite at mantle conditions”
- 9 May 2007
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research
- Vol. 112 (B5)
Vibrational and thermodynamic properties of forsterite at mantle conditions
We present a first‐principle study of the vibrational and thermodynamic properties of Mg2SiO4 forsterite up to 20 GPa. The calculated local density approximation (LDA) frequencies and their pressure dependence are in good agreement with the available Raman and infrared spectroscopy data. We also predict the pressure dependence of the modes which are yet to be measured. Thermodynamic properties are obtained using the quasi‐harmonic approximation (QHA) to the free energy in conjunction with these results. The calculated pressure‐volume‐temperature (P‐V‐T) relations and thermodynamic properties agree well with the reported experimental data within the regime of validity of the QHA. The only discrepancies with experimental data that point to intrinsic anharmonic effects are the mode Gruneisen parameters of two Raman and one infrared modes. However, their effect on thermodynamic properties appears to be negligible.
- 9 May 2007
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research
- Vol. 112 (B5)
Vibrational and thermodynamic properties of forsterite at mantle conditions
We present a first‐principle study of the vibrational and thermodynamic properties of Mg2SiO4 forsterite up to 20 GPa. The calculated local density approximation (LDA) frequencies and their pressure dependence are in good agreement with the available Raman and infrared spectroscopy data. We also predict the pressure dependence of the modes which are yet to be measured. Thermodynamic properties are obtained using the quasi‐harmonic approximation (QHA) to the free energy in conjunction with these results. The calculated pressure‐volume‐temperature (P‐V‐T) relations and thermodynamic properties agree well with the reported experimental data within the regime of validity of the QHA. The only discrepancies with experimental data that point to intrinsic anharmonic effects are the mode Gruneisen parameters of two Raman and one infrared modes. However, their effect on thermodynamic properties appears to be negligible.
- 1 April 2006
- Published by Mineralogical Society of America in American Mineralogist: Journal of Earth and Planetary Materials
- Vol. 91 (4) , 517-525
Plastic flow of pyrope at mantle pressure and temperature
Despite the abundance of garnet in deforming regions of the Earth, such as subduction zones, its rheological properties are not well defined by laboratory measurements. Here we report measurements of steady-state plastic properties of pyrope in its stability field (temperature up to 1573 K, pressure up to 6.8 GPa, strain rate ~10−5 s−1) using a Deformation-DIA apparatus (D-DIA) coupled with synchrotron radiation. Synthetic pyrope (Py100) and natural pyrope (Py70Alm16Gr14) are both studied in a dry environment. Transmission electron microscopy (TEM) investigation of the run products indicates that dislocation glide, assisted by climb within grains and dynamic recrystallization for grain-boundary strain accommodation, is the dominant deformation process in pyrope. Both synthetic-and natural-pyropes’ stress and strain-rate data, as measured in situ by X-ray diffraction and imaging, are best fitted with the single flow law: where ε̇ is the strain rate, σ= |σ1 – σ3| is the differential stress, R is the gas constant and T the absolute temperature. Synthetic forsterite and synthetic pyrope were stacked along the uniaxial compression direction in the same cell assembly during deformation to compare their strength at mantle condition. Forsterite is observed to be stronger than pyrope, deforming at a rate about 10% slower than the pyrope at 5.2 GPa and 1573 K. San Carlos olivine and natural pyrope were compared in a similar fashion at 6.8 GPa and 1473 K. In this case, San Carlos olivine deformed 2~3 times faster than natural pyrope. The experimental data suggest that pyrope is stronger (by more than a factor of 4) than the dominant mineral (olivine) in the upper mantle when temperatures exceed 1273 K.
- 1 April 2006
- Published by Mineralogical Society of America in American Mineralogist: Journal of Earth and Planetary Materials
- Vol. 91 (4) , 517-525
Plastic flow of pyrope at mantle pressure and temperature
Despite the abundance of garnet in deforming regions of the Earth, such as subduction zones, its rheological properties are not well defined by laboratory measurements. Here we report measurements of steady-state plastic properties of pyrope in its stability field (temperature up to 1573 K, pressure up to 6.8 GPa, strain rate ~10−5 s−1) using a Deformation-DIA apparatus (D-DIA) coupled with synchrotron radiation. Synthetic pyrope (Py100) and natural pyrope (Py70Alm16Gr14) are both studied in a dry environment. Transmission electron microscopy (TEM) investigation of the run products indicates that dislocation glide, assisted by climb within grains and dynamic recrystallization for grain-boundary strain accommodation, is the dominant deformation process in pyrope. Both synthetic-and natural-pyropes’ stress and strain-rate data, as measured in situ by X-ray diffraction and imaging, are best fitted with the single flow law: where ε̇ is the strain rate, σ= |σ1 – σ3| is the differential stress, R is the gas constant and T the absolute temperature. Synthetic forsterite and synthetic pyrope were stacked along the uniaxial compression direction in the same cell assembly during deformation to compare their strength at mantle condition. Forsterite is observed to be stronger than pyrope, deforming at a rate about 10% slower than the pyrope at 5.2 GPa and 1573 K. San Carlos olivine and natural pyrope were compared in a similar fashion at 6.8 GPa and 1473 K. In this case, San Carlos olivine deformed 2~3 times faster than natural pyrope. The experimental data suggest that pyrope is stronger (by more than a factor of 4) than the dominant mineral (olivine) in the upper mantle when temperatures exceed 1273 K.