Márcio Santos
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Márcio Santos has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
Jorge André
8 shared publications- Jose Baranda Ribeiro
ADAI, Department of Mechanical Engineering, University of Coimbra, Rua Luís Reis Santos, Pólo II, 3030-788 Coimbra, Portugal
6 shared publications José B. Ribeiro
6 shared publicationsRicardo Mendes
6 shared publications- Ricardo Mendes
Univ Coimbra, ADAI, LEDAP, Department of Mechanical Engineering, Rua Luís Reis Santos, 3030-788, Coimbra, Portugal, Portugal
5 shared publications - André Sousa
ADAI, Department of Mechanical Engineering, Univ Coimbra, Rua Luís Reis Santos, Pólo II, 3030-788 Coimbra, Portugal
1 shared publication
Latest Publications
- Open Access
Performance Improvement and Repowering Strategies for an Existing Sugarcane Cogeneration Plant: Energy, Exergy, Economic and Environmental Assessment
This study evaluates performance-improvement and repowering strategies for an existing sugarcane cogeneration plant in Espírito Santo, Brazil, using field data and thermodynamic simulations performed with Thermoflex and EES software. The current operating condition was adopted as the Base Case and compared with three progressively more intensive scenarios. Increasing steam generation from 75 to 110 t/h raised net electrical power from 10.800 to 18.633 MW, while the simulated condenser steam flow reached 41.3 t/h, slightly exceeding its 40 t/h nominal capacity. Operation at the nominal boiler capacity of 150 t/h increased net electrical power to 32.560 MW and required additional condensation capacity. A repowering configuration at the same steam-generation rate, but with higher steam pressure and temperature and reheating, further increased net electrical power to 38.304 MW and net electrical efficiency from 23.12% to 27.44%. Exergetic efficiency increased from 23.50% to 26.85%, while total combined exergy destruction and losses decreased from 147.698 to 140.554 MW. Specific direct CO2 emissions decreased from 2.962 to 1.468 tCO2/MWh between the Base Case and Scenario 3. The revised incremental economic assessment, based on 3300 operating hours per year, resulted in an NPV of US$6.88 million and a discounted payback of 0.67 years for the transition to Scenario 2, whereas the repowering investment resulted in an NPV of −US$27.44 million. The results distinguish capacity recovery from technological repowering and show that higher thermodynamic performance does not necessarily correspond to greater economic attractiveness.
Open AccessPerformance Improvement and Repowering Strategies for an Existing Sugarcane Cogeneration Plant: Energy, Exergy, Economic and Environmental Assessment
This study evaluates performance-improvement and repowering strategies for an existing sugarcane cogeneration plant in Espírito Santo, Brazil, using field data and thermodynamic simulations performed with Thermoflex and EES software. The current operating condition was adopted as the Base Case and compared with three progressively more intensive scenarios. Increasing steam generation from 75 to 110 t/h raised net electrical power from 10.800 to 18.633 MW, while the simulated condenser steam flow reached 41.3 t/h, slightly exceeding its 40 t/h nominal capacity. Operation at the nominal boiler capacity of 150 t/h increased net electrical power to 32.560 MW and required additional condensation capacity. A repowering configuration at the same steam-generation rate, but with higher steam pressure and temperature and reheating, further increased net electrical power to 38.304 MW and net electrical efficiency from 23.12% to 27.44%. Exergetic efficiency increased from 23.50% to 26.85%, while total combined exergy destruction and losses decreased from 147.698 to 140.554 MW. Specific direct CO2 emissions decreased from 2.962 to 1.468 tCO2/MWh between the Base Case and Scenario 3. The revised incremental economic assessment, based on 3300 operating hours per year, resulted in an NPV of US$6.88 million and a discounted payback of 0.67 years for the transition to Scenario 2, whereas the repowering investment resulted in an NPV of −US$27.44 million. The results distinguish capacity recovery from technological repowering and show that higher thermodynamic performance does not necessarily correspond to greater economic attractiveness.
- Open Access
Thermodynamic Assessment of Heat Pump Configurations for Waste Heat Integrated Carnot Batteries
Carnot batteries based on the coupling of high-temperature heat pumps (HTHPs) and Organic Rankine Cycles (ORCs) emerge as promising solutions for large-scale and long-duration energy storage, enabling sector coupling and the valorization of industrial waste heat. In such systems, the charging subsystem plays a dominant role, as variations in heat pump performance influence the round-trip efficiency more strongly than comparable variations in the ORC. This work presents a thermodynamic assessment of Rankine-based HP–ORC Carnot batteries focusing on the influence of heat pump configuration and working fluid selection. System performance is evaluated using the heat pump coefficient of performance, volumetric heat capacity, ORC efficiency, and Carnot battery round-trip efficiency through a grid-search optimization over a wide range of storage outlet and waste heat source temperatures. The results show that single-stage configurations are optimal at low to moderate temperature lifts, while two-stage and cascade systems become advantageous at higher lifts. Among the investigated fluids, R-601 provides the highest round-trip efficiencies at elevated storage temperatures, whereas R-600 enables more compact systems due to its higher volumetric heat capacity. These findings provide design guidance for selecting heat pump configurations and working fluids in industrial waste-heat-assisted Carnot battery applications.
Open AccessThermodynamic Assessment of Heat Pump Configurations for Waste Heat Integrated Carnot Batteries
Carnot batteries based on the coupling of high-temperature heat pumps (HTHPs) and Organic Rankine Cycles (ORCs) emerge as promising solutions for large-scale and long-duration energy storage, enabling sector coupling and the valorization of industrial waste heat. In such systems, the charging subsystem plays a dominant role, as variations in heat pump performance influence the round-trip efficiency more strongly than comparable variations in the ORC. This work presents a thermodynamic assessment of Rankine-based HP–ORC Carnot batteries focusing on the influence of heat pump configuration and working fluid selection. System performance is evaluated using the heat pump coefficient of performance, volumetric heat capacity, ORC efficiency, and Carnot battery round-trip efficiency through a grid-search optimization over a wide range of storage outlet and waste heat source temperatures. The results show that single-stage configurations are optimal at low to moderate temperature lifts, while two-stage and cascade systems become advantageous at higher lifts. Among the investigated fluids, R-601 provides the highest round-trip efficiencies at elevated storage temperatures, whereas R-600 enables more compact systems due to its higher volumetric heat capacity. These findings provide design guidance for selecting heat pump configurations and working fluids in industrial waste-heat-assisted Carnot battery applications.
- Open Access
- 17 May 2025
- Published by Elsevier in Energy Conversion and Management: X
- Vol. 27
Multi-objective optimization and design of a Carnot Battery for energy storage applications
- 17 May 2025
- Published by Elsevier in Energy Conversion and Management: X
- Vol. 27
Open AccessMulti-objective optimization and design of a Carnot Battery for energy storage applications
- Open Access
Optimization of ORC-Based Micro-CHP Systems: An Experimental and Control-Oriented Study
This study presents an experimental and numerical investigation into the performance and control optimization of an Organic Rankine Cycle (ORC)-based micro-combined heat and power (micro-CHP) system. A steady-state, off-design, charge-sensitive model is developed to design a control strategy for an ORC micro-CHP combi-boiler, aiming to efficiently meet real-time domestic hot water demands (up to 40 °C and 35 kW) while generating up to 2 kW of electricity. The system utilizes a natural gas burner to evaporate the working fluid (R245fa), with combustion heat power, volumetric pump speed, and expander speed as control variables. Experimental and numerical evaluations generate steady-state control maps to identify optimal operating regions. A PID-based dynamic control strategy is then developed to stabilize operation during start-ups and user demand variations. The results confirm that the strategy delivers hot water within 1.5 min in simple boiler mode and 3 min in cogeneration mode while improving electricity generation stability and outperforming manual control. The findings demonstrate that integrating steady-state modeling with optimized control enhances the performance, responsiveness, and efficiency of ORC-based micro-CHP systems, making them a viable alternative for residential energy solutions.
Open AccessOptimization of ORC-Based Micro-CHP Systems: An Experimental and Control-Oriented Study
This study presents an experimental and numerical investigation into the performance and control optimization of an Organic Rankine Cycle (ORC)-based micro-combined heat and power (micro-CHP) system. A steady-state, off-design, charge-sensitive model is developed to design a control strategy for an ORC micro-CHP combi-boiler, aiming to efficiently meet real-time domestic hot water demands (up to 40 °C and 35 kW) while generating up to 2 kW of electricity. The system utilizes a natural gas burner to evaporate the working fluid (R245fa), with combustion heat power, volumetric pump speed, and expander speed as control variables. Experimental and numerical evaluations generate steady-state control maps to identify optimal operating regions. A PID-based dynamic control strategy is then developed to stabilize operation during start-ups and user demand variations. The results confirm that the strategy delivers hot water within 1.5 min in simple boiler mode and 3 min in cogeneration mode while improving electricity generation stability and outperforming manual control. The findings demonstrate that integrating steady-state modeling with optimized control enhances the performance, responsiveness, and efficiency of ORC-based micro-CHP systems, making them a viable alternative for residential energy solutions.
- 24 March 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 271
General framework for hermetic scroll expander modelling derived from commercial compressor
- 24 March 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 271
General framework for hermetic scroll expander modelling derived from commercial compressor
- 25 February 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 269
Thermo-economic optimization of a Carnot Battery under transient conditions
- 25 February 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 269
Thermo-economic optimization of a Carnot Battery under transient conditions
- 1 January 2024
- Published by Editorial Universidad de Sevilla
- p. 391-399
TECHNICAL COMPARISON AND EVALUATION OF A PUMPED THERMAL ENERGY STORAGE WITH TWO DIFFERENT DESIGNS
Increased worldwide demand for energy (especially electricity), rising energy costs, and heightened environmental concerns are factors that continually press for the adoption of technologies to exploit renewable energy sources (RES). In order to adopt these systems, large-scale energy storage systems are needed to ensure the security of supply in energy systems due to the increasing share of renewable energy sources in the energy mix. The paper proposes a new form of energy storage technology that utilizes a combination of a heat pump and an organic Rankine cycle, referred to as Carnot Batteries (CB), which can store thermal energy for several hours to a few days and transform it back to electrical energy. Two different configurations of Carnot Batteries were tested using models created in Matlab programming software, with six working fluids used for technical optimization. The second, more complex configuration increased the roundtrip efficiency mainly due to the better performance of the two-stage heat pump.
- 1 January 2024
- Published by Editorial Universidad de Sevilla
- p. 391-399
TECHNICAL COMPARISON AND EVALUATION OF A PUMPED THERMAL ENERGY STORAGE WITH TWO DIFFERENT DESIGNS
Increased worldwide demand for energy (especially electricity), rising energy costs, and heightened environmental concerns are factors that continually press for the adoption of technologies to exploit renewable energy sources (RES). In order to adopt these systems, large-scale energy storage systems are needed to ensure the security of supply in energy systems due to the increasing share of renewable energy sources in the energy mix. The paper proposes a new form of energy storage technology that utilizes a combination of a heat pump and an organic Rankine cycle, referred to as Carnot Batteries (CB), which can store thermal energy for several hours to a few days and transform it back to electrical energy. Two different configurations of Carnot Batteries were tested using models created in Matlab programming software, with six working fluids used for technical optimization. The second, more complex configuration increased the roundtrip efficiency mainly due to the better performance of the two-stage heat pump.
- 1 January 2023
- Published by Curran Associates, Inc.
Thermo-Economic Optimization of a Carnot Battery Under Transient Conditions
- 1 January 2023
- Published by Curran Associates, Inc.
Thermo-Economic Optimization of a Carnot Battery Under Transient Conditions
- Open Access
- 18 June 2022
- Published by Elsevier in Applied Thermal Engineering
- Vol. 214
Thermal degradation assessment study of a direct vaporization ORC based micro-CHP system under close-to-real operating conditions
- 18 June 2022
- Published by Elsevier in Applied Thermal Engineering
- Vol. 214
Open AccessThermal degradation assessment study of a direct vaporization ORC based micro-CHP system under close-to-real operating conditions