SCShih-Wei Cho

Shih-Wei Cho

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Shih-Wei Cho has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effect of waste oyster shell powder as additive on properties and sulfate attack resistance of mortar

    by Yu-Wen Liu, Shih-Wei Cho, Pou-Gang Chiou

    In this study, the waste oyster shell powder was added in mix design to investigate the properties, sulfate attack resistance and sulfide bacterial of concrete. Add 0%, 1%, 3%, 6% and 9% oyster shell powder to the concrete to replace part of the sand. The study conducted flow tests, compressive strength tests, sulfate corrosion resistance and antibacterial tests. From the results, it was found that adding oyster shell powder improved the resistance to sulfate corrosion and antibacterial properties and became more effective as the substitution ratio increased. In addition, the sulfate attack resistance and antibacterial have a linear relationship of mortar with oyster shell powders.


  • Open Access

    Abrasion Behavior of Steel-Fiber-Reinforced Concrete in Hydraulic Structures

    by Yu-Wen Liu, Yu-Yuan Lin, Shih-Wei Cho

    This study investigated two types of abrasion resistance of steel–fiber-reinforced concrete in hydraulic structures, friction abrasion and impact abrasion using the ASTM C1138 underwater test and the water-borne sand test, respectively. Three water-to-cementitious-material ratios (0.50, 0.36, and 0.28), two impact angles (45° and 90°), plain concrete, and steel–fiber-reinforced concrete were employed. Test results showed that the abrasive action and principal resistance varied between the two test methods. The average impact abrasion rates (IARs) of concrete were approximately 8–17 times greater than the average friction abrasion rate (FARs). In general, the impact abrasion loss of the concrete surface impacted at a vertical angle was higher than that of impacted at a 45 degree angle. Moreover, the average FAR and IAR decreased when the concrete was reinforced with steel fibers. The steel fibers acted as shields to prevent the concrete material behind the fibers from abrasion, thus improving abrasion resistance. In both the underwater and waterborne sand flow methods, the resistance to abrasion of concrete without steel fibers increased as the water/cementitious material ratio (w/cm) decreased, and the concrete compressive strength also increased.