Li-Sha Niu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Li-Sha Niu has a total of 70 co-authors. Here are the top co-authors by number of shared publications:
- Hui-Ji Shi
Department of Engineering Mechanics, Tsinghua University, Beijing 100084, China
31 shared publications Kun Xue
Beijing Institute of Technology 1 State Key Laboratory of Explosion Science and Technology Beijing 100081, China
5 shared publications- Shao-Shi Rui
State Key Laboratory of Nonlinear Mechanics, Institute of Mechanics, Chinese Academy of Sciences, Beijing 100190, China
5 shared publications Enqiang Lin
3 shared publicationsEnze Jin
AML, Department of Engineering Mechanics, Tsinghua University , Beijing 100084, China
3 shared publications- Xiaoxiong Song
AML, School of Aerospace Engineering Tsinghua University Beijing 100084 China
3 shared publications
Latest Publications
- Open Access
Estimation Method of Relative Slip in Fretting Fatigue Contact by Digital Image Correlation
An experimental method that can quantify relative slip was developed using digital image correlation (DIC) in order to evaluate the sliding portion. The bridge-type test setup was designed to establish the fretting contact condition. The relative displacements between the contact surfaces were determined by DIC methods. Based on the evolution and distribution of relative slip, the transitions from gross slip to partial slip on the contact surface were found throughout all tests. This result indicated that the fretting scar was closely correlated to relative slip. The variation of relative slip corresponding to the stick-slip state was consistent with the tangential force coefficient. Besides, the load amplitude was an important factor for fretting fatigue damage, which can affect the stick-slip state.
Open AccessEstimation Method of Relative Slip in Fretting Fatigue Contact by Digital Image Correlation
An experimental method that can quantify relative slip was developed using digital image correlation (DIC) in order to evaluate the sliding portion. The bridge-type test setup was designed to establish the fretting contact condition. The relative displacements between the contact surfaces were determined by DIC methods. Based on the evolution and distribution of relative slip, the transitions from gross slip to partial slip on the contact surface were found throughout all tests. This result indicated that the fretting scar was closely correlated to relative slip. The variation of relative slip corresponding to the stick-slip state was consistent with the tangential force coefficient. Besides, the load amplitude was an important factor for fretting fatigue damage, which can affect the stick-slip state.
- 10 September 2019
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 33 (11) , 10457-10475
Adsorption of Methane, Nitrogen, and Carbon Dioxide in Atomic-Scale Fractal Nanopores by Monte Carlo Simulation I: Single-Component Adsorption
- 10 September 2019
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 33 (11) , 10457-10475
Adsorption of Methane, Nitrogen, and Carbon Dioxide in Atomic-Scale Fractal Nanopores by Monte Carlo Simulation I: Single-Component Adsorption
- 1 February 2019
- Published by Elsevier in Tribology International
- Vol. 130, 9-18
Effects of secondary orientation and temperature on the fretting fatigue behaviors of Ni-based single crystal superalloys
- 1 February 2019
- Published by Elsevier in Tribology International
- Vol. 130, 9-18
Effects of secondary orientation and temperature on the fretting fatigue behaviors of Ni-based single crystal superalloys
- 23 October 2018
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 42 (3) , 597-611
Plastic mismatch effect on plasticity induced crack closure: Fatigue crack propagation perpendicularly across a plastically mismatched interface
In the present work, comprehensive investigation of both theoretical analysis and numerical simulation was carried out to investigate the plastic mismatch effect on plasticity induced crack closure (PICC) behavior and effective fatigue crack tip driving force. During the process of crack tip approaching interface, crack tip load and crack tip load ratio will change, resulting in the change of PICC degree. When the crack propagates towards higher strength side,Kop/Kmaxincreases; when the crack propagates towards lower strength side,Kop/Kmaxdecreases firstly and then increases. The two mechanisms of “interface plastic mismatch effect on nominal fatigue crack tip driving force” and “interface plastic mismatch effect on PICC degree” were compared. The second mechanism must be considered when building crack tip driving force model for describing fatigue crack crossing plastically mismatched interface, because it is more physically factual and maybe more important than the first mechanism.
- 23 October 2018
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 42 (3) , 597-611
Plastic mismatch effect on plasticity induced crack closure: Fatigue crack propagation perpendicularly across a plastically mismatched interface
In the present work, comprehensive investigation of both theoretical analysis and numerical simulation was carried out to investigate the plastic mismatch effect on plasticity induced crack closure (PICC) behavior and effective fatigue crack tip driving force. During the process of crack tip approaching interface, crack tip load and crack tip load ratio will change, resulting in the change of PICC degree. When the crack propagates towards higher strength side,Kop/Kmaxincreases; when the crack propagates towards lower strength side,Kop/Kmaxdecreases firstly and then increases. The two mechanisms of “interface plastic mismatch effect on nominal fatigue crack tip driving force” and “interface plastic mismatch effect on PICC degree” were compared. The second mechanism must be considered when building crack tip driving force model for describing fatigue crack crossing plastically mismatched interface, because it is more physically factual and maybe more important than the first mechanism.
- 11 September 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 124 (10) , 105105
Effect of uniaxial stress on the threshold displacement energy of silicon carbide
Silicon Carbide (SiC) is a very promising nuclear material. Understanding the effect of stress field on the irradiation damage behavior of SiC is crucial for the actual service. Numerous experiment and simulation studies have revealed the fundamental irradiation damage mechanism in non-stress SiC. We can learn from the previous simulation studies that though several limits and inaccuracies in calculating the threshold displacement energy(Ed) have been reported, molecular dynamics (MD) methods are still considered valid in general. In this work, we calculate the Eds of both the elements in SiC along 5 primary crystallographic directions under 13 kinds of uniaxial stress fields using the MD method. The Eds obtained under the non-stress condition are consistent with previous research works. The rules of Eds changing with the deformation are discussed in detail, and the corresponding displacement process and displacement configurations are also analyzed. In general, Eds decrease with the increase in deformation whether it is stretching or compressing. Under relatively high stress field, the reduction of Ed is significant, and the anisotropy of Ed also greatly reduces. A transition of preferred displacement configuration from octahedral interstitial to tetrahedral interstitial is reported and discussed.
- 11 September 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 124 (10) , 105105
Effect of uniaxial stress on the threshold displacement energy of silicon carbide
Silicon Carbide (SiC) is a very promising nuclear material. Understanding the effect of stress field on the irradiation damage behavior of SiC is crucial for the actual service. Numerous experiment and simulation studies have revealed the fundamental irradiation damage mechanism in non-stress SiC. We can learn from the previous simulation studies that though several limits and inaccuracies in calculating the threshold displacement energy(Ed) have been reported, molecular dynamics (MD) methods are still considered valid in general. In this work, we calculate the Eds of both the elements in SiC along 5 primary crystallographic directions under 13 kinds of uniaxial stress fields using the MD method. The Eds obtained under the non-stress condition are consistent with previous research works. The rules of Eds changing with the deformation are discussed in detail, and the corresponding displacement process and displacement configurations are also analyzed. In general, Eds decrease with the increase in deformation whether it is stretching or compressing. Under relatively high stress field, the reduction of Ed is significant, and the anisotropy of Ed also greatly reduces. A transition of preferred displacement configuration from octahedral interstitial to tetrahedral interstitial is reported and discussed.
- 1 August 2018
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 733, 329-337
EBSD analysis of creep deformation induced grain lattice distortion: A new method for creep damage evaluation of austenitic stainless steels
- 1 August 2018
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 733, 329-337
EBSD analysis of creep deformation induced grain lattice distortion: A new method for creep damage evaluation of austenitic stainless steels
- 1 December 2017
- Published by Elsevier in Journal of Materials Science & Technology
- Vol. 33 (12) , 1582-1595
Fracture mode identification of low alloy steels and cast irons by electron back-scattered diffraction misorientation analysis
- 1 December 2017
- Published by Elsevier in Journal of Materials Science & Technology
- Vol. 33 (12) , 1582-1595
Fracture mode identification of low alloy steels and cast irons by electron back-scattered diffraction misorientation analysis
- 13 March 2013
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 113 (10) , 104309
Effects of irradiation on the mechanical behavior of twined SiC nanowires
Irradiation is known to bring new features in one-dimensional nano materials. In this study, we used molecular dynamics simulations to investigate the irradiation effects on twined SiC nanowires. Defects tend to accumulate from outside toward inside of the twined SiC nanowires with increasing irradiation dose, leading to a transition from brittle to ductile failure under tensile load. Atomic chains are formed in the ductile failure process. The first-principles calculations show that most of the atomic chains are metallic.
- 13 March 2013
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 113 (10) , 104309
Effects of irradiation on the mechanical behavior of twined SiC nanowires
Irradiation is known to bring new features in one-dimensional nano materials. In this study, we used molecular dynamics simulations to investigate the irradiation effects on twined SiC nanowires. Defects tend to accumulate from outside toward inside of the twined SiC nanowires with increasing irradiation dose, leading to a transition from brittle to ductile failure under tensile load. Atomic chains are formed in the ductile failure process. The first-principles calculations show that most of the atomic chains are metallic.