Muhammad Mateen Hassan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Muhammad Mateen Hassan has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Adnan Ahmed Khan
Department of Electrical Engineering, Military College of Signals, National University of Sciences and Technology, Rawalpindi, Pakistan
3 shared publicationsFarooq Ahmed Bhatti
Department of Electrical Engineering, Military College of Signals, National University of Sciences and Technology, Rawalpindi, Pakistan
3 shared publicationsImran Rashid
Department of Electrical Engineering, Military College of Signals, National University of Sciences and Technology, Rawalpindi, Pakistan
3 shared publications- Abdul Rauf
Department of Electrical Engineering, National University of Sciences and Technology, H-12, Islamabad 44000, Pakistan
2 shared publications - Zeeshan Zahid
Department of Electrical Engineering National University of Sciences and Technology Islamabad Pakistan
2 shared publications - Maryam Rasool
National University of Sciences and Technology Islamabad Pakistan
1 shared publication
Latest Publications
- 19 October 2020
- Published by Cambridge University Press (CUP) in International Journal of Microwave and Wireless Technologies
- Vol. 13 (8) , 851-858
Dual-band B-shaped antenna array for satellite applications
The paper presents a 1 × 2 B-shaped antenna array for dual-band operation at 4 and 8 GHz. The antenna design consists of a rectangular patch with two annular-strip lines fabricated on the top layer and finite ground plane on the bottom layer. The array is formed by designing an optimum T-shaped microstrip line for impedance matching. The dimensions of the antenna array are 78 × 36 × 1.6 mm3. Full-wave simulations have been conducted and the measured results are in good consent with the simulated results. The measured impedance bandwidth (reference −10 dB) has been observed at 3.84–4.16 and 7.78–8.38 GHz. Measured peak gain and radiation efficiency at 4 and 8 GHz are 8.3, 9.4 dB and 82.5 and 81.2%, respectively.
- 19 October 2020
- Published by Cambridge University Press (CUP) in International Journal of Microwave and Wireless Technologies
- Vol. 13 (8) , 851-858
Dual-band B-shaped antenna array for satellite applications
The paper presents a 1 × 2 B-shaped antenna array for dual-band operation at 4 and 8 GHz. The antenna design consists of a rectangular patch with two annular-strip lines fabricated on the top layer and finite ground plane on the bottom layer. The array is formed by designing an optimum T-shaped microstrip line for impedance matching. The dimensions of the antenna array are 78 × 36 × 1.6 mm3. Full-wave simulations have been conducted and the measured results are in good consent with the simulated results. The measured impedance bandwidth (reference −10 dB) has been observed at 3.84–4.16 and 7.78–8.38 GHz. Measured peak gain and radiation efficiency at 4 and 8 GHz are 8.3, 9.4 dB and 82.5 and 81.2%, respectively.
- 18 May 2020
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 34 (9) , 1210-1224
Two element MIMO antenna with frequency reconfigurable characteristics utilizing RF MEMS for 5G applications
This paper presents a novel two-element multiple input multiple output (MIMO) reconfigurable antenna that can be switched among 600 MHz, 1.8, 2.4, 3.5, and 5.5 GHz bands. The proposed antenna consists of two semi-circular ring-shaped strip-lines and a rectangular slot on the top conducting layer of the substrate and a U-shaped slot, etched on the bottom side of the substrate. Frequency reconfigurable characteristics have been achieved using single pole four throw radio frequency micro-electro-mechanical system switch. The switch has been installed in the ground slot. The dimensions of the proposed MIMO antenna are 32 × 98 × 1 mm3. Measured isolation greater than 15 dB has been achieved in the operating bands. The calculated envelop correlation coefficient is less than 0.04 and the diversity gain in the operating bands is greater than 9.8 dB.
- 18 May 2020
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 34 (9) , 1210-1224
Two element MIMO antenna with frequency reconfigurable characteristics utilizing RF MEMS for 5G applications
This paper presents a novel two-element multiple input multiple output (MIMO) reconfigurable antenna that can be switched among 600 MHz, 1.8, 2.4, 3.5, and 5.5 GHz bands. The proposed antenna consists of two semi-circular ring-shaped strip-lines and a rectangular slot on the top conducting layer of the substrate and a U-shaped slot, etched on the bottom side of the substrate. Frequency reconfigurable characteristics have been achieved using single pole four throw radio frequency micro-electro-mechanical system switch. The switch has been installed in the ground slot. The dimensions of the proposed MIMO antenna are 32 × 98 × 1 mm3. Measured isolation greater than 15 dB has been achieved in the operating bands. The calculated envelop correlation coefficient is less than 0.04 and the diversity gain in the operating bands is greater than 9.8 dB.
- 23 October 2019
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 34 (9) , 1225-1238
A novel UWB MIMO antenna array with band notch characteristics using parasitic decoupler
This paper presents a 4 × 4 multiple-input–multiple-output (MIMO) antenna array for ultra-wide band (UWB) applications with 5.5 GHz wireless local area network (WLAN) band rejection characteristics. The single UWB antenna element consists of modified patch antenna with partial ground plane. WLAN band has been rejected by etching a U-shaped slot in the antenna element. The antenna elements have been arranged in a planar geometry where each element is orthogonal to its adjacent element. A fan-shaped parasitic decoupler, that consists of four strip lines connected with a central square-shaped conductor, is placed among the antenna elements. The dimensions of the antenna array are 67 × 67 × 1.6 mm3. Full wave simulations and experiments have been conducted where measured peak gain and average isolation were 8.1 and −20 dB, respectively. The calculated envelop correction coefficient was less than 0.01.
- 23 October 2019
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 34 (9) , 1225-1238
A novel UWB MIMO antenna array with band notch characteristics using parasitic decoupler
This paper presents a 4 × 4 multiple-input–multiple-output (MIMO) antenna array for ultra-wide band (UWB) applications with 5.5 GHz wireless local area network (WLAN) band rejection characteristics. The single UWB antenna element consists of modified patch antenna with partial ground plane. WLAN band has been rejected by etching a U-shaped slot in the antenna element. The antenna elements have been arranged in a planar geometry where each element is orthogonal to its adjacent element. A fan-shaped parasitic decoupler, that consists of four strip lines connected with a central square-shaped conductor, is placed among the antenna elements. The dimensions of the antenna array are 67 × 67 × 1.6 mm3. Full wave simulations and experiments have been conducted where measured peak gain and average isolation were 8.1 and −20 dB, respectively. The calculated envelop correction coefficient was less than 0.01.