Yuanming Song
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yuanming Song has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Baoling Li
Postgraduate Student, Yantai Univ., Yantai, Shandong 264005, China
2 shared publicationsZhijuan Wang
2 shared publications- En-Hua Yang
School of Civil and Environmental Engineering, Nanyang Technological University, 639798, Singapore
1 shared publication - Yiquan Liu
Postgraduate Student, Nanyang Technological Univ., Singapore 639798
1 shared publication Zhitao Chen
Postdoctoral Research Fellow, Nanyang Technological Univ., Singapore 639798
1 shared publication
Latest Publications
- 1 July 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 28 (7)
Gas Generation from Incinerator Bottom Ash: Potential Aerating Agent for Lightweight Concrete Production
Incinerator bottom ash (IBA) has great potential to be utilized for civil engineering applications. This paper is to investigate the characteristic of gas generation from IBA and to study the potential of IBA as an aerating agent. Results show the aeration capacity of IBA used in this study is approximately 1% that of pure aluminum powder by mass. Finer particles, higher alkali molarity, and higher reaction temperature encourage the reaction and more gas is generated per gram of IBA. Type of alkaline solution does not seem to be an important factor for gas generation from IBA. Several exemplary lightweight mortars were produced by incorporating IBA as an aerating agent. It is highly plausible IBA can be used as an aerating agent to replace pure aluminum powder in the production of aerated concrete.
- 1 July 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 28 (7)
Gas Generation from Incinerator Bottom Ash: Potential Aerating Agent for Lightweight Concrete Production
Incinerator bottom ash (IBA) has great potential to be utilized for civil engineering applications. This paper is to investigate the characteristic of gas generation from IBA and to study the potential of IBA as an aerating agent. Results show the aeration capacity of IBA used in this study is approximately 1% that of pure aluminum powder by mass. Finer particles, higher alkali molarity, and higher reaction temperature encourage the reaction and more gas is generated per gram of IBA. Type of alkaline solution does not seem to be an important factor for gas generation from IBA. Several exemplary lightweight mortars were produced by incorporating IBA as an aerating agent. It is highly plausible IBA can be used as an aerating agent to replace pure aluminum powder in the production of aerated concrete.
- Open Access
- 31 May 2016
- Published by Bentham Science Publishers Ltd. in The Open Civil Engineering Journal
- Vol. 10 (1) , 323-333
An Attempt to Reduce Materials Cost of Autoclaved Aerated Concrete Production
Background: Municipal solid waste incineration (MSWI) bottom ash contains a not insignificant amount of metallic aluminum, while circulating fluidized bed combustion (CFBC) fly ash is rich in active SiO 2. Objective: To reduce the materials cost of autoclaved aerated concrete (AAC) production, these two types of solid waste could theoretically be used as the aerating agent and silica source, respectively. Method: In the present work, the metallic aluminum concentration in an MSWI bottom ash sample was determined from hydrogen generation and this ash was used to make AAC in conjunction with CFBC fly ash. The extent of air entrainment in the resulting AAC specimens was varied by changing the bottom ash to fly ash ratio, and the effects of this ratio on the properties of the AAC were investigated. Results: Results showed that the ratio has a negligible effect on both the type and the morphology of the hydrates in the AAC, but is inversely proportional to the compressive strength, density and volume stability. Conclusion: This study proves that AAC having satisfactory properties can be successfully prepared from a combination of MSWI bottom ash and CFBC fly ash.
- 31 May 2016
- Published by Bentham Science Publishers Ltd. in The Open Civil Engineering Journal
- Vol. 10 (1) , 323-333
Open AccessAn Attempt to Reduce Materials Cost of Autoclaved Aerated Concrete Production
Background: Municipal solid waste incineration (MSWI) bottom ash contains a not insignificant amount of metallic aluminum, while circulating fluidized bed combustion (CFBC) fly ash is rich in active SiO 2. Objective: To reduce the materials cost of autoclaved aerated concrete (AAC) production, these two types of solid waste could theoretically be used as the aerating agent and silica source, respectively. Method: In the present work, the metallic aluminum concentration in an MSWI bottom ash sample was determined from hydrogen generation and this ash was used to make AAC in conjunction with CFBC fly ash. The extent of air entrainment in the resulting AAC specimens was varied by changing the bottom ash to fly ash ratio, and the effects of this ratio on the properties of the AAC were investigated. Results: Results showed that the ratio has a negligible effect on both the type and the morphology of the hydrates in the AAC, but is inversely proportional to the compressive strength, density and volume stability. Conclusion: This study proves that AAC having satisfactory properties can be successfully prepared from a combination of MSWI bottom ash and CFBC fly ash.
- Open Access
- 27 January 2016
- Published by Springer Nature in International Journal of Coal Science & Technology
- Vol. 3 (1) , 62-67
Adsorption properties of CFBC ash–cement pastes as compared with PCC fly ash–cement pastes
- 27 January 2016
- Published by Springer Nature in International Journal of Coal Science & Technology
- Vol. 3 (1) , 62-67
Open AccessAdsorption properties of CFBC ash–cement pastes as compared with PCC fly ash–cement pastes