June-Heang Choi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
June-Heang Choi has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Ho-Young Cha
4 shared publications- Ho-Young Cha
School of Electronic and Electrical Engineering, Hongik University, Seoul, Republic of Korea
4 shared publications Hyungtak Kim
2 shared publications- Hyungtak Kim
Hongik University
2 shared publications C.-H. Cho
1 shared publicationChang-Yeol Han
1 shared publication
Latest Publications
- Open Access
- 28 May 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (6) , 1422
Room Temperature Operation of UV Photocatalytic Functionalized AlGaN/GaN Heterostructure Hydrogen Sensor
An AlGaN/GaN heterostructure based hydrogen sensor was fabricated using a dual catalyst layer with ZnO-nanoparticles (NPs) atop of Pd catalyst film. The ZnO-NPs were synthesized to have an average diameter of ~10 nm and spin coated on the Pd catalyst layer. Unlike the conventional catalytic reaction, the fabricated sensors exhibited room temperature operation without heating owing to the photocatalytic reaction of the ZnO-NPs with ultraviolet illumination at 280 nm. A sensing response of 25% was achieved for a hydrogen concentration of 4% at room temperature with fast response and recovery times; a response time of 8 s and a recovery time of 11 s.
- 28 May 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (6) , 1422
Open AccessRoom Temperature Operation of UV Photocatalytic Functionalized AlGaN/GaN Heterostructure Hydrogen Sensor
An AlGaN/GaN heterostructure based hydrogen sensor was fabricated using a dual catalyst layer with ZnO-nanoparticles (NPs) atop of Pd catalyst film. The ZnO-NPs were synthesized to have an average diameter of ~10 nm and spin coated on the Pd catalyst layer. Unlike the conventional catalytic reaction, the fabricated sensors exhibited room temperature operation without heating owing to the photocatalytic reaction of the ZnO-NPs with ultraviolet illumination at 280 nm. A sensing response of 25% was achieved for a hydrogen concentration of 4% at room temperature with fast response and recovery times; a response time of 8 s and a recovery time of 11 s.
- 28 February 2021
- Published by The Institute of Electronics Engineers of Korea in JOURNAL OF SEMICONDUCTOR TECHNOLOGY AND SCIENCE
- Vol. 21 (1) , 80-83
Photoresponsivity Enhancement of AlGaN/GaN Heterojunction Phototransistor with ZnO Nanodot Coating Layer
The effects of a ZnO nanodot coating layer on the photoresponsivity characteristics of an AlGaN/GaN heterojunction phototransistor was investigated. The ZnO nanodot layer was introduced on the detection surface of the phototransistor using a simple spin-coating process. The ZnO nanodot layer not only reduced the dark current but also significantly increased the photoresponsivity. At the wavelength of 300 nm, the photoresponsivity increased from 1.02 × 106 to 1.76 × 106 A/W.
- 28 February 2021
- Published by The Institute of Electronics Engineers of Korea in JOURNAL OF SEMICONDUCTOR TECHNOLOGY AND SCIENCE
- Vol. 21 (1) , 80-83
Photoresponsivity Enhancement of AlGaN/GaN Heterojunction Phototransistor with ZnO Nanodot Coating Layer
The effects of a ZnO nanodot coating layer on the photoresponsivity characteristics of an AlGaN/GaN heterojunction phototransistor was investigated. The ZnO nanodot layer was introduced on the detection surface of the phototransistor using a simple spin-coating process. The ZnO nanodot layer not only reduced the dark current but also significantly increased the photoresponsivity. At the wavelength of 300 nm, the photoresponsivity increased from 1.02 × 106 to 1.76 × 106 A/W.
- 15 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 21 (2) , 1244-1249
Recessed AlGaN/GaN Heterojunction-Based Hydrogen Sensor Operated by Reverse Bias Mode
- 15 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 21 (2) , 1244-1249
Recessed AlGaN/GaN Heterojunction-Based Hydrogen Sensor Operated by Reverse Bias Mode
- 1 December 2020
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 325
AlGaN/GaN heterojunction hydrogen sensor using ZnO-nanoparticles/Pd dual catalyst layer
- 1 December 2020
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 325
AlGaN/GaN heterojunction hydrogen sensor using ZnO-nanoparticles/Pd dual catalyst layer
- 31 October 2020
- Published by The Institute of Electronics Engineers of Korea in JOURNAL OF SEMICONDUCTOR TECHNOLOGY AND SCIENCE
- Vol. 20 (5) , 430-435
Improved Stability of AlGaN/GaN Heterojunction Schottky-diode-type Hydrogen Sensor Using Constant Current Source Operation
An AlGaN/GaN heterojunction Schottky-diode-type hydrogen sensor was fabricated with Pd catalyst and exhibited excellent response characteristics. The sensor was operated in two different modes: constant voltage and constant current bias modes. Since the diode current has an exponential relationship with its forward voltage, any small fluctuations or drift in the bias voltage results in large variations in the output current. Using a constant current bias mode of operation thus allowed more stable sensing characteristics for the Schottky-diode-type hydrogen sensor.
- 31 October 2020
- Published by The Institute of Electronics Engineers of Korea in JOURNAL OF SEMICONDUCTOR TECHNOLOGY AND SCIENCE
- Vol. 20 (5) , 430-435
Improved Stability of AlGaN/GaN Heterojunction Schottky-diode-type Hydrogen Sensor Using Constant Current Source Operation
An AlGaN/GaN heterojunction Schottky-diode-type hydrogen sensor was fabricated with Pd catalyst and exhibited excellent response characteristics. The sensor was operated in two different modes: constant voltage and constant current bias modes. Since the diode current has an exponential relationship with its forward voltage, any small fluctuations or drift in the bias voltage results in large variations in the output current. Using a constant current bias mode of operation thus allowed more stable sensing characteristics for the Schottky-diode-type hydrogen sensor.
- 1 July 2020
- Published by American Scientific Publishers in Journal of Nanoscience and Nanotechnology
- Vol. 20 (7) , 4404-4408
High-Sensitivity Hydrogen Sensor Based on AlGaN/GaN Heterojunction Field-Effect Transistor
We have developed a Pd-functionalized hydrogen gas sensor based on a recessed AlGaN/GaN heterostructure field-effect transistor. The AlGaN barrier layer under the Pd catalyst was partially etched to enhance its sensitivity. Both low-power consumption and high sensitivity were achieved by employing a recessed structure. Sensor characterization was carried out at the temperature range from room temperature to 250 °C, among which the best sensing characteristics were observed at 200 °C. A sensitivity of 380% with a response time of 0.25 s was achieved at a bias voltage of 0.3 V at 200 °C under a hydrogen exposure concentration of 4%. The standby power consumption was only 2 μW for the sensing area of 100×28 μm2 due to the low standby current, which was caused by the recessed AlGaN barrier layer.
- 1 July 2020
- Published by American Scientific Publishers in Journal of Nanoscience and Nanotechnology
- Vol. 20 (7) , 4404-4408
High-Sensitivity Hydrogen Sensor Based on AlGaN/GaN Heterojunction Field-Effect Transistor
We have developed a Pd-functionalized hydrogen gas sensor based on a recessed AlGaN/GaN heterostructure field-effect transistor. The AlGaN barrier layer under the Pd catalyst was partially etched to enhance its sensitivity. Both low-power consumption and high sensitivity were achieved by employing a recessed structure. Sensor characterization was carried out at the temperature range from room temperature to 250 °C, among which the best sensing characteristics were observed at 200 °C. A sensitivity of 380% with a response time of 0.25 s was achieved at a bias voltage of 0.3 V at 200 °C under a hydrogen exposure concentration of 4%. The standby power consumption was only 2 μW for the sensing area of 100×28 μm2 due to the low standby current, which was caused by the recessed AlGaN barrier layer.
- 30 April 2020
- Published by The Institute of Electronics Engineers of Korea in JOURNAL OF SEMICONDUCTOR TECHNOLOGY AND SCIENCE
- Vol. 20 (2) , 141-144
Filter-free AlGaN Photodiode with High Quantum Efficiency for Partial Discharge Detection
- 30 April 2020
- Published by The Institute of Electronics Engineers of Korea in JOURNAL OF SEMICONDUCTOR TECHNOLOGY AND SCIENCE
- Vol. 20 (2) , 141-144
Filter-free AlGaN Photodiode with High Quantum Efficiency for Partial Discharge Detection
- Open Access
Investigation of Stability and Power Consumption of an AlGaN/GaN Heterostructure Hydrogen Gas Sensor Using Different Bias Conditions
A Pd-functionalized hydrogen gas sensor was fabricated on an AlGaN/GaN-on-Si heterostructure platform. The AlGaN layer under the Pd catalyst area was partially recessed by plasma etching, which resulted in a low standby current level enhancing the sensor response. Sensor stability and power consumption depending on operation conditions were carefully investigated using two different bias modes: constant voltage bias mode and constant current bias mode. From the stability point of view, high voltage operation is better than low voltage operation for the constant voltage mode of operation, whereas low current operation is preferred over high current operation for the constant current mode of operation. That is, stable operation with lower standby power consumption can be achieved with the constant current bias operation. The fabricated AlGaN/GaN-on-Si hydrogen sensor exhibited excellent sensing characteristics; a response of 120% with a response time of < 0.4 s at a bias current density of 1 mA/mm at 200 °C. The standby power consumption was only 0.54 W/cm2 for a sensing catalyst area of 100 × 24 μm2.
Open AccessInvestigation of Stability and Power Consumption of an AlGaN/GaN Heterostructure Hydrogen Gas Sensor Using Different Bias Conditions
A Pd-functionalized hydrogen gas sensor was fabricated on an AlGaN/GaN-on-Si heterostructure platform. The AlGaN layer under the Pd catalyst area was partially recessed by plasma etching, which resulted in a low standby current level enhancing the sensor response. Sensor stability and power consumption depending on operation conditions were carefully investigated using two different bias modes: constant voltage bias mode and constant current bias mode. From the stability point of view, high voltage operation is better than low voltage operation for the constant voltage mode of operation, whereas low current operation is preferred over high current operation for the constant current mode of operation. That is, stable operation with lower standby power consumption can be achieved with the constant current bias operation. The fabricated AlGaN/GaN-on-Si hydrogen sensor exhibited excellent sensing characteristics; a response of 120% with a response time of < 0.4 s at a bias current density of 1 mA/mm at 200 °C. The standby power consumption was only 0.54 W/cm2 for a sensing catalyst area of 100 × 24 μm2.
- Open Access
- 1 June 2018
- Published by Elsevier in Results in Physics
- Vol. 9, 1170-1171
Design consideration of high voltage Ga2O3 vertical Schottky barrier diode with field plate
- 1 June 2018
- Published by Elsevier in Results in Physics
- Vol. 9, 1170-1171
Open AccessDesign consideration of high voltage Ga2O3 vertical Schottky barrier diode with field plate