Subhadip Roy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Subhadip Roy has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Chiranjib Mitra
Indian Institute of Science Education and Research Kolkata
5 shared publications - Manish Pal Chowdhury
Department of Physics IIEST Shibpur Howrah West Bengal India
4 shared publications - Rahul Majumder
IIEST Shibpur
4 shared publications - Soumalya Kundu
IIEST Shibpur
4 shared publications Jit Sarkar
Department of Physical Sciences, Indian Institute of Science Education and Research Kolkata, Kolkata, India
3 shared publications- Monalisa Pradhan
IIEST Shibpur
3 shared publications
Latest Publications
- 7 February 2023
- Published by Springer Nature in Journal of Materials Science
- Vol. 58 (7) , 3147-3170
An in situ synthesis of polyaniline/reduced graphene oxide nanocomposite flexible thin film on PET for the room temperature detection of trace level ammonia at ppb level
- 7 February 2023
- Published by Springer Nature in Journal of Materials Science
- Vol. 58 (7) , 3147-3170
An in situ synthesis of polyaniline/reduced graphene oxide nanocomposite flexible thin film on PET for the room temperature detection of trace level ammonia at ppb level
- 5 September 2021
- Published by Springer Nature in Journal of Materials Science
- Vol. 56 (34) , 19128-19143
Effect of grain–grain boundary on ZnO nanorod-based UV photosensor: a complex impedance spectroscopic study
- 5 September 2021
- Published by Springer Nature in Journal of Materials Science
- Vol. 56 (34) , 19128-19143
Effect of grain–grain boundary on ZnO nanorod-based UV photosensor: a complex impedance spectroscopic study
- 5 May 2021
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 54 (28) , 285003
Detection of electron spin resonance down to 10 K using localized spoof surface plasmon
In this study, novel use of the electromagnetic field profile of a localized spoof surface plasmonic mode to detect electron spin resonance (ESR) is being reported. The mode is supported on a resonator with a complementary metallic spiral structure, etched on the ground plane of a microstrip line having a characteristic impedance of 50 Ω. The change in characteristics of the mode of interest with lowering of temperature has been observed and analyzed. ESR spectra of three paramagnetic samples—2,2-diphenyl-1-picrylhydrazyl (DPPH), galvinoxyl, and 2,2,6,6-tetramethylpiperidine-1-oxyl are recorded using this resonator at room temperature. ESR spectra of DPPH are also captured down to 10 K. Potential application of the mode in the detection of microwave induced Rashba field-driven ESR has been discussed.
- 5 May 2021
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 54 (28) , 285003
Detection of electron spin resonance down to 10 K using localized spoof surface plasmon
In this study, novel use of the electromagnetic field profile of a localized spoof surface plasmonic mode to detect electron spin resonance (ESR) is being reported. The mode is supported on a resonator with a complementary metallic spiral structure, etched on the ground plane of a microstrip line having a characteristic impedance of 50 Ω. The change in characteristics of the mode of interest with lowering of temperature has been observed and analyzed. ESR spectra of three paramagnetic samples—2,2-diphenyl-1-picrylhydrazyl (DPPH), galvinoxyl, and 2,2,6,6-tetramethylpiperidine-1-oxyl are recorded using this resonator at room temperature. ESR spectra of DPPH are also captured down to 10 K. Potential application of the mode in the detection of microwave induced Rashba field-driven ESR has been discussed.
- Open Access
- 18 November 2020
- Published by IOP Publishing in IOP SciNotes
- Vol. 1 (3) , 035202
S-band electron spin resonance spectroscopy using a short-circuited coplanar waveguide resonator
In this work, we study the development of a coplanar waveguide (CPW) resonator and its use in an electron spin resonance (ESR) spectrometer. The CPW resonator is designed to operate in S-band (2-4 GHz), with a short circuit configuration leading to miniaturization. It is so constructed such that it has a characteristic impedance of 50 ohms. The resonator supports quasi-TEM mode of propagation owing to its uniplanar nature, demanding detailed electromagnetic simulation. The design parameters and the electromagnetic field distribution are obtained from the simulation. The resonator is fabricated using optical lithography with a rapid prototyping technique. The characteristic response of the resonator is measured by coupling it to a Vector Network Analyzer (VNA). The ESR absorption spectrum of free radical 2,2-diphenyl-1-picrylhydrazyl (DPPH) is captured by using this resonator in reflection geometry. The microwave magnetic field distribution at the sample position is investigated. The ascertained value of Lande g-factor is consistent with that reported in the literature. Spin sensitivity of the order of 1015 spins/gauss is achieved upon using this resonator at room temperature. The quality factor of this resonator is found to be low and this makes it suitable for use in a Pulsed ESR spectrometer.
- 18 November 2020
- Published by IOP Publishing in IOP SciNotes
- Vol. 1 (3) , 035202
Open AccessS-band electron spin resonance spectroscopy using a short-circuited coplanar waveguide resonator
In this work, we study the development of a coplanar waveguide (CPW) resonator and its use in an electron spin resonance (ESR) spectrometer. The CPW resonator is designed to operate in S-band (2-4 GHz), with a short circuit configuration leading to miniaturization. It is so constructed such that it has a characteristic impedance of 50 ohms. The resonator supports quasi-TEM mode of propagation owing to its uniplanar nature, demanding detailed electromagnetic simulation. The design parameters and the electromagnetic field distribution are obtained from the simulation. The resonator is fabricated using optical lithography with a rapid prototyping technique. The characteristic response of the resonator is measured by coupling it to a Vector Network Analyzer (VNA). The ESR absorption spectrum of free radical 2,2-diphenyl-1-picrylhydrazyl (DPPH) is captured by using this resonator in reflection geometry. The microwave magnetic field distribution at the sample position is investigated. The ascertained value of Lande g-factor is consistent with that reported in the literature. Spin sensitivity of the order of 1015 spins/gauss is achieved upon using this resonator at room temperature. The quality factor of this resonator is found to be low and this makes it suitable for use in a Pulsed ESR spectrometer.
- 1 June 2020
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 90 (3) , 31001
Development of planar microstrip resonators for electron spin resonance spectroscopy
This work focuses on the development of planar microwave resonators for use in electron spin resonance spectroscopic studies. Two half-wavelength microstrip resonators of different geometrical shapes, namely straight ribbon and omega, are fabricated on commercially available microwave laminates. Both resonators have a characteristic impedance of 50 Ω. We have performed electromagnetic field simulations for the resonators and have extracted design parameters that were used for fabrication. The effect of the geometry on the quasi-transverse electromagnetic (quasi-TEM) modes of the resonators is noted from simulation results. The fabrication is done using optical lithography in which laser printed photomasks are used. This prototyping technique allows us to fabricate resonators in a few hours with accuracy up to 6 mils. The resonators are characterized using a Vector Network Analyzer. The fabricated resonators are used in a home built low-temperature continuous wave electron spin resonance (CW-ESR) spectrometer which operates in S-band. It captures the absorption spectrum of the free radical DPPH, at both room temperature and 77 K. The measuredg-factor using our resonators is consistent with the values reported in literature. Spin sensitivity of 1015spins/gauss is achieved at 77 K. The designed resonators will be used in setting up a pulsed electron spin resonance spectrometer by suitably modifying the CW-ESR spectrometer.
- 1 June 2020
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 90 (3) , 31001
Development of planar microstrip resonators for electron spin resonance spectroscopy
This work focuses on the development of planar microwave resonators for use in electron spin resonance spectroscopic studies. Two half-wavelength microstrip resonators of different geometrical shapes, namely straight ribbon and omega, are fabricated on commercially available microwave laminates. Both resonators have a characteristic impedance of 50 Ω. We have performed electromagnetic field simulations for the resonators and have extracted design parameters that were used for fabrication. The effect of the geometry on the quasi-transverse electromagnetic (quasi-TEM) modes of the resonators is noted from simulation results. The fabrication is done using optical lithography in which laser printed photomasks are used. This prototyping technique allows us to fabricate resonators in a few hours with accuracy up to 6 mils. The resonators are characterized using a Vector Network Analyzer. The fabricated resonators are used in a home built low-temperature continuous wave electron spin resonance (CW-ESR) spectrometer which operates in S-band. It captures the absorption spectrum of the free radical DPPH, at both room temperature and 77 K. The measuredg-factor using our resonators is consistent with the values reported in literature. Spin sensitivity of 1015spins/gauss is achieved at 77 K. The designed resonators will be used in setting up a pulsed electron spin resonance spectrometer by suitably modifying the CW-ESR spectrometer.
- 13 December 2019
- Published by Springer Nature in Journal of Materials Science
- Vol. 55 (9) , 3884-3901
Relative humidity sensing properties of doped polyaniline-encased multiwall carbon nanotubes: wearable and flexible human respiration monitoring application
- 13 December 2019
- Published by Springer Nature in Journal of Materials Science
- Vol. 55 (9) , 3884-3901
Relative humidity sensing properties of doped polyaniline-encased multiwall carbon nanotubes: wearable and flexible human respiration monitoring application
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1953 (1) , 050040
Evidence of charged puddles and induced dephasing in topological insulator thin films
We investigate the dephasing mechanism in bulk insulating topological insulator thin films. The phase coherence length is extracted from magnetoresistance measurements at different temperatures. There is a crossover of the phase coherence length as a function of temperature signifying the role of more than one dephasing mechanism in the system. The dephasing rates have been studied systematically and explained.
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1953 (1) , 050040
Evidence of charged puddles and induced dephasing in topological insulator thin films
We investigate the dephasing mechanism in bulk insulating topological insulator thin films. The phase coherence length is extracted from magnetoresistance measurements at different temperatures. There is a crossover of the phase coherence length as a function of temperature signifying the role of more than one dephasing mechanism in the system. The dephasing rates have been studied systematically and explained.
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1953 (1) , 120056
Investigating electron spin resonance spectroscopy of a spin-½ compound in a home-built spectrometer
In this work we report electron spin resonance (ESR) measurements performed on NH4CuPO4·H2O, a Heisenberg spin ½ dimer compound. We carried out the experiments both at room temperature and at 78 K, which are well above the antiferromagnetic ordering temperature of the system where the paramagnetic spins have a dominant role in determining its magnetic behavior. We performed the measurements in a home built custom designed continuous wave electron spin resonance (CW-ESR) spectrometer. By analyzing the experimental data, we were able to quantify the Landé g-factor and the ESR line-width of the sample.
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1953 (1) , 120056
Investigating electron spin resonance spectroscopy of a spin-½ compound in a home-built spectrometer
In this work we report electron spin resonance (ESR) measurements performed on NH4CuPO4·H2O, a Heisenberg spin ½ dimer compound. We carried out the experiments both at room temperature and at 78 K, which are well above the antiferromagnetic ordering temperature of the system where the paramagnetic spins have a dominant role in determining its magnetic behavior. We performed the measurements in a home built custom designed continuous wave electron spin resonance (CW-ESR) spectrometer. By analyzing the experimental data, we were able to quantify the Landé g-factor and the ESR line-width of the sample.