Shiro Kubota
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Shiro Kubota has a total of 118 co-authors. Here are the top co-authors by number of shared publications:
Yuji Ogata
National Institute of Advanced Industrial Science and Technology
24 shared publicationsYuji Wada
National Institute of Advanced Industrial Science and Technology
17 shared publicationsTei Saburi
National Institute of Advanced Industrial Science and Technology
13 shared publicationsKunihito Nagayama
Kyushu University
12 shared publications- Kunihito Nagayama
Kyushu University
8 shared publications Katsumi Katoh
Faculty of engineering, Fukuoka University 8‐19‐1 Nanakuma, Jonan, Fukuoka 814‐0180 (Japan)
6 shared publications
Latest Publications
- 1 May 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (5)
Experimental and numerical studies on potential blast mitigation effect of natural vegetation around high explosive
The potential blast mitigation effect of natural vegetation was studied through small-scale explosions with miniature trees that had iron trunks and branches and porous nylon leaves. The shock wave reflection and transmission behaviors were tested via shock tube experiments, and the interaction behavior between shock waves and the miniature trees was used to determine the proper numerical method for modeling the miniature trees. The possibility of blast mitigation was examined through explosion experiments involving miniature trees placed around an explosive. The parameters of the miniature trees were the tree height, total mass, and plant density. The experiments showed that increasing these values had a substantial impact on blast mitigation efficiency. Numerical simulations were then conducted using a two-phase Eulerian–Eulerian model. The miniature trees were modeled as uniformly distributed blocks of porous nylon with drag force and convective heat transfer models. The obtained blast mitigation effect of the miniature trees agreed with the experimental data. Drag force caused the reflection and transmission of the shock wave, resulting in a nonuniform distribution of the blast mitigation effect behind the porous nylon. Nonetheless, this spatial distribution disappeared after the blast wave sufficiently propagated. The blast mitigation effect was determined by the absorption of the energy released by the explosive. Finally, a parametric study on the plant density, total mass, and location of the porous nylon was conducted to formulate an index that reasonably estimates the blast mitigation effect from the initial configuration of the porous nylon leaves.
- 1 May 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (5)
Experimental and numerical studies on potential blast mitigation effect of natural vegetation around high explosive
The potential blast mitigation effect of natural vegetation was studied through small-scale explosions with miniature trees that had iron trunks and branches and porous nylon leaves. The shock wave reflection and transmission behaviors were tested via shock tube experiments, and the interaction behavior between shock waves and the miniature trees was used to determine the proper numerical method for modeling the miniature trees. The possibility of blast mitigation was examined through explosion experiments involving miniature trees placed around an explosive. The parameters of the miniature trees were the tree height, total mass, and plant density. The experiments showed that increasing these values had a substantial impact on blast mitigation efficiency. Numerical simulations were then conducted using a two-phase Eulerian–Eulerian model. The miniature trees were modeled as uniformly distributed blocks of porous nylon with drag force and convective heat transfer models. The obtained blast mitigation effect of the miniature trees agreed with the experimental data. Drag force caused the reflection and transmission of the shock wave, resulting in a nonuniform distribution of the blast mitigation effect behind the porous nylon. Nonetheless, this spatial distribution disappeared after the blast wave sufficiently propagated. The blast mitigation effect was determined by the absorption of the energy released by the explosive. Finally, a parametric study on the plant density, total mass, and location of the porous nylon was conducted to formulate an index that reasonably estimates the blast mitigation effect from the initial configuration of the porous nylon leaves.
- 1 December 2024
- Published by The Japan Society of High Pressure Science and Technology in The Review of High Pressure Science and Technology
- Vol. 34 (4) , 156-164
Detonation Phenomenon and Applications of Explosion Energy
- 1 December 2024
- Published by The Japan Society of High Pressure Science and Technology in The Review of High Pressure Science and Technology
- Vol. 34 (4) , 156-164
Detonation Phenomenon and Applications of Explosion Energy
- 14 January 2023
- Published by Springer Nature
- p. 7-58
Theory of Shock Wave and Detonation
- 14 January 2023
- Published by Springer Nature
- p. 59-102
Description of Detonation Phenomena
- 14 January 2023
- Published by Springer Nature
- p. 199-285
Ideal and Non-ideal Detonation
- 14 January 2023
- Published by Springer Nature
- p. 149-198
Shock Initiation
- 14 January 2023
- Published by Springer Nature
- p. 1-5
Shock and Detonation Phenomena
- Open Access
- 30 July 2019
- Published by Materials Research Forum, LLC in Materials Research Proceedings
- Vol. 13, 97-102
Tensile Strength Test of Rock at High Strain Rate Using Digital Image Correlation
- 30 July 2019
- Published by Materials Research Forum, LLC in Materials Research Proceedings
- Vol. 13, 97-102
Open AccessTensile Strength Test of Rock at High Strain Rate Using Digital Image Correlation
- 20 February 2017
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10328, 103281N
Dynamic strain distribution of FRP plate under blast loading
The dynamic strain distribution of a fiber re-enforced plastic (FRP) plate under blast loading was investigated using a Digital Image Correlation (DIC) image analysis method. The testing FRP plates were mounted in parallel to each other on a steel frame. 50 g of composition C4 explosive was used as a blast loading source and set in the center of the FRP plates. The dynamic behavior of the FRP plate under blast loading were observed by two high-speed video cameras. The set of two high-speed video image sequences were used to analyze the FRP three-dimensional strain distribution by means of DIC method. A point strain profile extracted from the analyzed strain distribution data was compared with a directly observed strain profile using a strain gauge and it was shown that the strain profile under the blast loading by DIC method is quantitatively accurate.
- 20 February 2017
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10328, 103281N
Dynamic strain distribution of FRP plate under blast loading
The dynamic strain distribution of a fiber re-enforced plastic (FRP) plate under blast loading was investigated using a Digital Image Correlation (DIC) image analysis method. The testing FRP plates were mounted in parallel to each other on a steel frame. 50 g of composition C4 explosive was used as a blast loading source and set in the center of the FRP plates. The dynamic behavior of the FRP plate under blast loading were observed by two high-speed video cameras. The set of two high-speed video image sequences were used to analyze the FRP three-dimensional strain distribution by means of DIC method. A point strain profile extracted from the analyzed strain distribution data was compared with a directly observed strain profile using a strain gauge and it was shown that the strain profile under the blast loading by DIC method is quantitatively accurate.
- 20 February 2017
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10328, 1032814
Self-ignition and flame development of high-pressure hydrogen flow in a rectangular tube by simultaneous shadowgraph and direct photograph
The flame observed during the sudden release of high-pressure hydrogen into a tube filled with air, in the absence of an igniter, has not yet been investigated. In this study, the self-ignition and flame development behavior of high-pressure hydrogen flow in a tube is investigated to obtain fundamental knowledge for safety engineering. Two high-speed cameras are used simultaneously to obtain density gradient data from the shadowgraph image and flame dynamics from the direct image. Self-ignition occurs at the point near the sidewall in the region where cold hydrogen and preheated air are mixed by the precursor shock wave. After ignition, the flame propagates along the wall surface and spreads throughout the mixing region.
- 20 February 2017
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10328, 1032814
Self-ignition and flame development of high-pressure hydrogen flow in a rectangular tube by simultaneous shadowgraph and direct photograph
The flame observed during the sudden release of high-pressure hydrogen into a tube filled with air, in the absence of an igniter, has not yet been investigated. In this study, the self-ignition and flame development behavior of high-pressure hydrogen flow in a tube is investigated to obtain fundamental knowledge for safety engineering. Two high-speed cameras are used simultaneously to obtain density gradient data from the shadowgraph image and flame dynamics from the direct image. Self-ignition occurs at the point near the sidewall in the region where cold hydrogen and preheated air are mixed by the precursor shock wave. After ignition, the flame propagates along the wall surface and spreads throughout the mixing region.