Jaehan Lee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jaehan Lee has a total of 68 co-authors. Here are the top co-authors by number of shared publications:
- Jeyong Yoon
School of Chemical and Biological Engineering, College of Engineering, Institute of Chemical Processes, Seoul National University (SNU), 1 Gwanak-ro, Gwanak-gu, Seoul 08826, Republic of Korea
17 shared publications Choonsoo Kim
13 shared publicationsJeyong Yoon
11 shared publicationsSeonghwan Kim
10 shared publicationsJiho Lee
8 shared publicationsSeoni Kim
6 shared publications
Latest Publications
- Open Access
- 25 March 2026
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 31 (5) , 260051
Desalination performance of silver/activated carbon hybrid capacitive deionization under constant-current operation
Capacitive deionization (CDI) is a promising desalination technology but is often limited by the low ion removal capacity of carbon-based electrodes. In this study, a hybrid capacitive deionization (HCDI) system employing an asymmetric silver/activated carbon (Ag/AC) electrode configuration was investigated under constant-current operation and compared with a conventional membrane capacitive deionization (MCDI) system. Desalination performance was evaluated using CDI Ragone plot analysis, while galvanostatic charge–discharge measurements were used to examine the potential evolution of individual electrodes. The results show that the Faradaic Ag/AgCl reaction stabilizes the cell voltage and expands the usable potential window of the activated carbon electrode. As a result, the HCDI system consistently outperformed MCDI, achieving a maximum salt adsorption capacity of 36.5 mg g⁻¹ in a 10 mM NaCl solution, more than twice that of MCDI (17.0 mg g⁻¹), along with a faster ion removal rate. These findings demonstrate that integrating Faradaic electrodes effectively overcomes the intrinsic capacity limitations of conventional CDI systems.
- 25 March 2026
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 31 (5) , 260051
Open AccessDesalination performance of silver/activated carbon hybrid capacitive deionization under constant-current operation
Capacitive deionization (CDI) is a promising desalination technology but is often limited by the low ion removal capacity of carbon-based electrodes. In this study, a hybrid capacitive deionization (HCDI) system employing an asymmetric silver/activated carbon (Ag/AC) electrode configuration was investigated under constant-current operation and compared with a conventional membrane capacitive deionization (MCDI) system. Desalination performance was evaluated using CDI Ragone plot analysis, while galvanostatic charge–discharge measurements were used to examine the potential evolution of individual electrodes. The results show that the Faradaic Ag/AgCl reaction stabilizes the cell voltage and expands the usable potential window of the activated carbon electrode. As a result, the HCDI system consistently outperformed MCDI, achieving a maximum salt adsorption capacity of 36.5 mg g⁻¹ in a 10 mM NaCl solution, more than twice that of MCDI (17.0 mg g⁻¹), along with a faster ion removal rate. These findings demonstrate that integrating Faradaic electrodes effectively overcomes the intrinsic capacity limitations of conventional CDI systems.
- 25 March 2026
- Published by Springer Nature in Carbon Letters
- Vol. 36 (3) , 1197-1207
Hybrid capacitive deionization system for short-chain perfluoroalkyl substances (PFAS) removal using activated carbon composite and Nafion-coated prussian blue electrodes
- 25 March 2026
- Published by Springer Nature in Carbon Letters
- Vol. 36 (3) , 1197-1207
Hybrid capacitive deionization system for short-chain perfluoroalkyl substances (PFAS) removal using activated carbon composite and Nafion-coated prussian blue electrodes
- 3 December 2025
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 14 (1)
Rocking-chair electrochemical lithium recovery system with enhanced cycling stability via state-of-charge (SoC) control
- 3 December 2025
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 14 (1)
Rocking-chair electrochemical lithium recovery system with enhanced cycling stability via state-of-charge (SoC) control
- Open Access
- 9 October 2024
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 30 (3) , 240440
Electrochemical lithium recovery process via state-of-charge control (SoC) for efficient lithium recovery from concentrated seawater
With the increasing demand for lithium driven by its widespread use in various industries, researchers are exploring ways to expand the lithium supply. This study proposes an electrochemical lithium recovery (ELR) system using the state-of-charge (SoC) control for extracting lithium from the actual concentrated seawater from the salt manufacturing process. In cyclic stability tests where the 60% SoC level of the LiMn2O4(LMO) electrode was adjusted, the charge-discharge retention rate showed approximately two times higher performance compared to 100% SoC after 30 cycles. In particular, it was observed that the amount of extracted lithium from source water at 60% SoC is 8 times higher, consuming 89% less energy than at 100% SoC. The study also confirmed the physical stability of the LMO electrodes by X-ray diffraction analysis, showing relatively better results at 60% SoC operation. Based on these results, the SoC control operation in the ELR system has the capacity to enhance both the stability and efficiency of lithium extraction from concentrated seawater.
- 9 October 2024
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 30 (3) , 240440
Open AccessElectrochemical lithium recovery process via state-of-charge control (SoC) for efficient lithium recovery from concentrated seawater
With the increasing demand for lithium driven by its widespread use in various industries, researchers are exploring ways to expand the lithium supply. This study proposes an electrochemical lithium recovery (ELR) system using the state-of-charge (SoC) control for extracting lithium from the actual concentrated seawater from the salt manufacturing process. In cyclic stability tests where the 60% SoC level of the LiMn2O4(LMO) electrode was adjusted, the charge-discharge retention rate showed approximately two times higher performance compared to 100% SoC after 30 cycles. In particular, it was observed that the amount of extracted lithium from source water at 60% SoC is 8 times higher, consuming 89% less energy than at 100% SoC. The study also confirmed the physical stability of the LMO electrodes by X-ray diffraction analysis, showing relatively better results at 60% SoC operation. Based on these results, the SoC control operation in the ELR system has the capacity to enhance both the stability and efficiency of lithium extraction from concentrated seawater.
- Open Access
- 30 March 2024
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 29 (6) , 240099
High capacity rocking-chair capacitive deionization using highly crystalline sodium cobalt hexacyanoferrate (NaCoHCF) electrodes
Prussian blue analogue (PBA) electrodes are widely used cation-selective electrodes for electrochemical desalination technologies due to their high specific capacity rates and fast kinetic properties. Despite the fact that previous studies of PBAs for electrochemical desalination have shown remarkable desalination capacity levels, they remain insufficient if used to desalt highly concentrated salt water such as seawater. Here, we applied highly crystalline sodium cobalt hexacyanoferrate (NaCoHCF) electrodes, a type of PBA that can utilize two redox active sites, to a rocking-chair capacitive deionization (RCDI) process. The specific capacity of the NaCoHCF electrode using two redox active sites was 88 mAh g-1 (active material: 110 mAh g-1), confirmed to be 1.5 times higher than that of PBA electrode that use one redox active site. As a result of desalination tests, this system achieved a high desalination capacity of 123 mg g-1 (active material: 154 mg g-1) with 88% ion removal in a 500 mM NaCl solution. The results of this study present a considerable increase in the desalination capacity through the introduction of NaCoHCF electrodes that utilize two redox active sites in the RCDI system.
- 30 March 2024
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 29 (6) , 240099
Open AccessHigh capacity rocking-chair capacitive deionization using highly crystalline sodium cobalt hexacyanoferrate (NaCoHCF) electrodes
Prussian blue analogue (PBA) electrodes are widely used cation-selective electrodes for electrochemical desalination technologies due to their high specific capacity rates and fast kinetic properties. Despite the fact that previous studies of PBAs for electrochemical desalination have shown remarkable desalination capacity levels, they remain insufficient if used to desalt highly concentrated salt water such as seawater. Here, we applied highly crystalline sodium cobalt hexacyanoferrate (NaCoHCF) electrodes, a type of PBA that can utilize two redox active sites, to a rocking-chair capacitive deionization (RCDI) process. The specific capacity of the NaCoHCF electrode using two redox active sites was 88 mAh g-1 (active material: 110 mAh g-1), confirmed to be 1.5 times higher than that of PBA electrode that use one redox active site. As a result of desalination tests, this system achieved a high desalination capacity of 123 mg g-1 (active material: 154 mg g-1) with 88% ion removal in a 500 mM NaCl solution. The results of this study present a considerable increase in the desalination capacity through the introduction of NaCoHCF electrodes that utilize two redox active sites in the RCDI system.
- 15 December 2023
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 29 (4) , 230677
Increasing the stability of LiMn2O4 electrodes under high-current-density conditions via SoC control in an electrochemical lithium recovery system
For efficient lithium recovery, the electrochemical lithium recovery (ELR) process that uses LiMn2O4 (LMO) electrodes with selectivity for lithium ions, has been introduced. The electrochemical system is environmentally friendly and allows for the recovery of lithium at a high yield, but the issue of manganese dissolution in LMO electrodes, decreasing their stability, remains to be solved. Herein, we suggest a solution to the existing problem through a rapid lithium recovery method that also enhances the stability of LMO electrodes through the state-of-charge (SoC) control approach. The retained discharge capacity of the system with a high current density (0.4 A/g) remains at 99.2% at 60% SoC after 300 cycles. Compared to the results under full charge/discharge operation (44.2% after 300 cycles), the proposed method demonstrates the state-of-charge (SoC) control adjustments at high current density levels to enhance the recovery rate and stability of the electrode. Additionally, high lithium-ion selectivity with a similar recovery rate is maintained at a high current density under 60% SoC operation compared to 100% SoC in lithium recovery tests. These results indicate that the SoC control strategy can increase the efficiency of ELR by improving the stability of the electrode under high-rate operational conditions.
- 15 December 2023
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 29 (4) , 230677
Increasing the stability of LiMn2O4 electrodes under high-current-density conditions via SoC control in an electrochemical lithium recovery system
For efficient lithium recovery, the electrochemical lithium recovery (ELR) process that uses LiMn2O4 (LMO) electrodes with selectivity for lithium ions, has been introduced. The electrochemical system is environmentally friendly and allows for the recovery of lithium at a high yield, but the issue of manganese dissolution in LMO electrodes, decreasing their stability, remains to be solved. Herein, we suggest a solution to the existing problem through a rapid lithium recovery method that also enhances the stability of LMO electrodes through the state-of-charge (SoC) control approach. The retained discharge capacity of the system with a high current density (0.4 A/g) remains at 99.2% at 60% SoC after 300 cycles. Compared to the results under full charge/discharge operation (44.2% after 300 cycles), the proposed method demonstrates the state-of-charge (SoC) control adjustments at high current density levels to enhance the recovery rate and stability of the electrode. Additionally, high lithium-ion selectivity with a similar recovery rate is maintained at a high current density under 60% SoC operation compared to 100% SoC in lithium recovery tests. These results indicate that the SoC control strategy can increase the efficiency of ELR by improving the stability of the electrode under high-rate operational conditions.
- Open Access
- 31 October 2022
- Published by The Korean Society for Bio-Environment Control in Journal of Bio-Environment Control
- Vol. 31 (4) , 432-437
Effect of External Light Environment and Growing Degree Days on Strawberry Production
- 31 October 2022
- Published by The Korean Society for Bio-Environment Control in Journal of Bio-Environment Control
- Vol. 31 (4) , 432-437
Open AccessEffect of External Light Environment and Growing Degree Days on Strawberry Production