SSShailesh Kumar Shukla

Shailesh Kumar Shukla

*This is an algorithmically generated author record based on publicly available information.

Shailesh Kumar Shukla has a total of 3 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Blends of modified epoxy resin and carboxyl‐terminated polybutadiene. I

    by Shailesh Kumar Shukla, Deepak Srivastava

    Six blend samples were prepared by the physical mixing of epoxidized resole (EDR) with different weight ratios of carboxyl‐terminated polybutadiene (CTPB) liquid rubber ranging from 0 to 25 wt % in intervals of 5 wt %. The formation of various reaction products during the curing of unblended EDR and CTPB‐blended EDR were studied with Fourier transform infrared spectroscopy. The curing time at 100°C for the blend sample containing 15 wt % CTPB was the least among all of the blend samples. This blend sample, also, showed the highest initial degradation temperature, as obtained from thermogravimetric analysis thermograms, which indicated that it was the most thermally stable matrix system. The films of coatings based on the blend of EDR with 15 wt % CTPB offered the highest resistance toward different concentrations of acids and alkalis compared to the films having 5, 10, 20, and 25 wt % CTPB in the EDR/CTPB blends. Solvents showed almost the same behavior as acids and alkalis for these films except for hydrocarbon solvents such as mineral turpentine oil, toluene, and xylene. The resistance toward these solvents was poor and slightly inferior to those found with EDR unblended with CTPB. The tensile, flexural, and impact strengths of the molded specimens derived from the EDR/CTPB blends initially increased up to 15 wt % CTPB addition in the blend and then decreased, whereas the elongation at break remained constant for all blend compositions. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 1802–1808, 2006


  • STUDY OF DEGRADATION KINETICS OF BLENDS OF EPOXY AND RESOLE: A STATISTICAL APPROACH

    by Shailesh Kumar Shukla, Pramod Kumar, Deepak Srivastava

    Blends of resole and epoxy were prepared by physical mixing, and cured with 30% polyamide based on blend resin and polyamide. Degradation of each sample was studied by dynamic thermogravimetric analysis in nitrogen atmosphere at a heating rate of 10°C min−1. The degradation of blends of epoxy and resole having 30 wt % polyamide proceeded with 0.50th order. This result was found with the Coats-Redfern equation using best-fit analysis, and further confirmed by linear regression analysis. The validity of data was checked by t test analysis. From this value of reaction order, activation energy (E) and pre-exponential factor (Z) were calculated. The values of activation energy increased, whereas the values of pre-exponential factor decreased as the resole content in the blend decreased from 100 to 0 wt %.