Alex Friedman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Alex Friedman has a total of 105 co-authors. Here are the top co-authors by number of shared publications:
- David P. Grote
Lawrence Livermore National Laboratory
10 shared publications - Jean- Luc Vay
Lawrence Berkeley National Laboratory
6 shared publications - John J. Barnard
Lawrence Livermore National Laboratory 1 , Livermore, California 94550, USA
5 shared publications - Igor. D. Kaganovich
Princeton Plasma Physics Laboratory
4 shared publications - Simon S. Yu
Department of Engineering Science and Ocean Engineering, National Taiwan University, Taipei, Taiwan
4 shared publications - Debra A. Callahan
Focused Energy Inc. 3 , 201 Spear Street, San Francisco, California 94105
3 shared publications
Latest Publications
- 16 June 2022
- Published by Elsevier in Gastroenterology
- Vol. 162 (7)
Su1566: TRENDS AND OUTCOMES DURING DELIVERY HOSPITALIZATION AMONG PATIENTS WITH IBD: A NATIONWIDE ANALYSIS
- 16 June 2022
- Published by Elsevier in Gastroenterology
- Vol. 162 (7)
Su1566: TRENDS AND OUTCOMES DURING DELIVERY HOSPITALIZATION AMONG PATIENTS WITH IBD: A NATIONWIDE ANALYSIS
- 1 December 2021
- Published by AIP Publishing in Physics of Plasmas
- Vol. 28 (12) , 123104
Reduced bandwidth Compton photons from a laser-plasma accelerator using tailored plasma channels
It has been demonstrated experimentally that laser plasma accelerators can produce multi-100 MeV electron bunches with a few percent energy spread, and from these electrons, multi-MeV quasi-monoenergetic photons have been demonstrated based on Compton up-scattering from a counter-propagating laser. This offers the potential of a high-quality, narrow-bandwidth, compact, photon source with broad application. The bandwidth of the resulting photons depends directly on the distribution of the electron bunch and is limited, in particular, by the bunch divergence (i.e., the spread in transverse velocity angle). At the same time, the ability to decelerate electrons after scattering is important to source deployment. We describe a series of plasma structures that expand and then collimate the electron bunch, reducing its divergence and thus reducing the bandwidth of the scattered photons while enabling both high performance scattering and deceleration. These plasma structures are demonstrated in simulations of the accelerator system, showing the potential to reach few-percent photon spread which is important for applications using nuclear resonance fluorescence.
- 1 December 2021
- Published by AIP Publishing in Physics of Plasmas
- Vol. 28 (12) , 123104
Reduced bandwidth Compton photons from a laser-plasma accelerator using tailored plasma channels
It has been demonstrated experimentally that laser plasma accelerators can produce multi-100 MeV electron bunches with a few percent energy spread, and from these electrons, multi-MeV quasi-monoenergetic photons have been demonstrated based on Compton up-scattering from a counter-propagating laser. This offers the potential of a high-quality, narrow-bandwidth, compact, photon source with broad application. The bandwidth of the resulting photons depends directly on the distribution of the electron bunch and is limited, in particular, by the bunch divergence (i.e., the spread in transverse velocity angle). At the same time, the ability to decelerate electrons after scattering is important to source deployment. We describe a series of plasma structures that expand and then collimate the electron bunch, reducing its divergence and thus reducing the bandwidth of the scattered photons while enabling both high performance scattering and deceleration. These plasma structures are demonstrated in simulations of the accelerator system, showing the potential to reach few-percent photon spread which is important for applications using nuclear resonance fluorescence.
- 1 October 2018
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 89 (10) , 103302
Design and implementation of a Thomson parabola for fluence dependent energy-loss measurements at the Neutralized Drift Compression eXperiment
The interaction of ion beams with matter includes the investigation of the basic principles of ion stopping in heated materials. An unsolved question is the effect of different, especially higher, ion beam fluences on ion stopping in solid targets. This is relevant in applications such as in fusion sciences. To address this question, a Thomson parabola was built for the Neutralized Drift Compression eXperiment (NDCX-II) for ion energy-loss measurements at different ion beam fluences. The linear induction accelerator NDCX-II delivers 2 ns short, intense ion pulses, up to several tens of nC/pulse, or 1010-1011 ions, with a peak kinetic energy of ∼1.1 MeV and a minimal spot size of 2 mm FWHM. For this particular accelerator, the energy determination with conventional beam diagnostics, for example, time of flight measurements, is imprecise due to the non-trivial longitudinal phase space of the beam. In contrast, a Thomson parabola is well suited to reliably determine the beam energy distribution. The Thomson parabola differentiates charged particles by energy and charge-to-mass ratio, through deflection of charged particles by electric and magnetic fields. During first proof-of-principle experiments, we achieved to reproduce the average initial helium beam energy as predicted by computer simulations with a deviation of only 1.4%. Successful energy-loss measurements with 1 μm thick silicon nitride foils show the suitability of the accelerator for such experiments. The initial ion energy was determined during a primary measurement without a target, while a second measurement, incorporating the target, was used to determine the transmitted energy. The energy-loss was then determined as the difference between the two energies.
- 1 October 2018
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 89 (10) , 103302
Design and implementation of a Thomson parabola for fluence dependent energy-loss measurements at the Neutralized Drift Compression eXperiment
The interaction of ion beams with matter includes the investigation of the basic principles of ion stopping in heated materials. An unsolved question is the effect of different, especially higher, ion beam fluences on ion stopping in solid targets. This is relevant in applications such as in fusion sciences. To address this question, a Thomson parabola was built for the Neutralized Drift Compression eXperiment (NDCX-II) for ion energy-loss measurements at different ion beam fluences. The linear induction accelerator NDCX-II delivers 2 ns short, intense ion pulses, up to several tens of nC/pulse, or 1010-1011 ions, with a peak kinetic energy of ∼1.1 MeV and a minimal spot size of 2 mm FWHM. For this particular accelerator, the energy determination with conventional beam diagnostics, for example, time of flight measurements, is imprecise due to the non-trivial longitudinal phase space of the beam. In contrast, a Thomson parabola is well suited to reliably determine the beam energy distribution. The Thomson parabola differentiates charged particles by energy and charge-to-mass ratio, through deflection of charged particles by electric and magnetic fields. During first proof-of-principle experiments, we achieved to reproduce the average initial helium beam energy as predicted by computer simulations with a deviation of only 1.4%. Successful energy-loss measurements with 1 μm thick silicon nitride foils show the suitability of the accelerator for such experiments. The initial ion energy was determined during a primary measurement without a target, while a second measurement, incorporating the target, was used to determine the transmitted energy. The energy-loss was then determined as the difference between the two energies.
- 1 June 2012
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 678, 39-47
Effects of errors in velocity tilt on maximum longitudinal compression during neutralized drift compression of intense beam pulses: II. Analysis of experimental data of the Neutralized Drift Compression eXperiment-I (NDCX-I)
- 1 June 2012
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 678, 39-47
Effects of errors in velocity tilt on maximum longitudinal compression during neutralized drift compression of intense beam pulses: II. Analysis of experimental data of the Neutralized Drift Compression eXperiment-I (NDCX-I)
- Open Access
- 1 August 2010
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 244 (2) , 022052
Warp simulations for capture and control of laser-accelerated proton beams
- 1 August 2010
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 244 (2) , 022052
Open AccessWarp simulations for capture and control of laser-accelerated proton beams
- 1 July 2007
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 577 (1-2) , 197-202
Beam experiments on the Pulse Line Ion Accelerator
- 1 July 2007
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 577 (1-2) , 197-202
Beam experiments on the Pulse Line Ion Accelerator
- Open Access
- 16 June 2006
- Published by EDP Sciences in Journal de Physique IV
- Vol. 133, 731-741
US heavy ion beam research for high energy density physics applications and fusion
- 16 June 2006
- Published by EDP Sciences in Journal de Physique IV
- Vol. 133, 731-741
Open AccessUS heavy ion beam research for high energy density physics applications and fusion
- Open Access
- 12 June 2006
- Published by American Physical Society (APS) in Physical Review Special Topics - Accelerators and Beams
- Vol. 9 (6) , 063201
Beam energy scaling of ion-induced electron yield fromimpact on stainless steelElectron clouds limit the performance of many major accelerators and storage rings. Significant quantities of electrons result when halo ions are lost to beam tubes, generating gas which can be ionized and ion-induced electrons that can multiply and accumulate, causing degradation or loss of the ion beam. In order to understand the physical mechanisms of ion-induced electron production, experiments studied the impact of 50 to 400 keV ions on stainless steel surfaces near grazing incidence, using the 500 kV ion source test stand (STS-500) at LLNL. The experimental electron yield scales with the electronic component () of the stopping power and its angular dependence does not follow . A theoretical model is developed, using TRIM code to evaluate at several depths in the target, to estimate the electron yield, which is compared with the experimental results. The experiment extends the range of energy from previous works and the model reproduces the angular dependence and magnitude of the electron yield.- 12 June 2006
- Published by American Physical Society (APS) in Physical Review Special Topics - Accelerators and Beams
- Vol. 9 (6) , 063201
Open AccessBeam energy scaling of ion-induced electron yield fromimpact on stainless steelElectron clouds limit the performance of many major accelerators and storage rings. Significant quantities of electrons result when halo ions are lost to beam tubes, generating gas which can be ionized and ion-induced electrons that can multiply and accumulate, causing degradation or loss of the ion beam. In order to understand the physical mechanisms of ion-induced electron production, experiments studied the impact of 50 to 400 keV ions on stainless steel surfaces near grazing incidence, using the 500 kV ion source test stand (STS-500) at LLNL. The experimental electron yield scales with the electronic component () of the stopping power and its angular dependence does not follow . A theoretical model is developed, using TRIM code to evaluate at several depths in the target, to estimate the electron yield, which is compared with the experimental results. The experiment extends the range of energy from previous works and the model reproduces the angular dependence and magnitude of the electron yield. - Open Access
- 15 February 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19444680,p. 1479-1481
Initial Self-Consistent 3D Electron-Cloud Simulations of the LHC Beam with the Codewarp+Posinst
We present initial results for the self-consistent beam-cloud dynamics simulations for a sample LHC beam, using a newly developed set of modeling capability based on a merge [1] of the three-dimensional parallel Particle-In-Cell (PIC) accelerator code WARP [2] and the electron-cloud code POSINST [3]. Although the storage ring model we use as a test bed to contain the beam is much simpler and shorter than the LHC, its lattice elements are realistically modeled, as is the beam and the electron cloud dynamics. The simulated mechanisms for generation and absorption of the electrons at the walls are based on previously validated models available in POSINST [3, 4].
- 15 February 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19444680,p. 1479-1481
Open AccessInitial Self-Consistent 3D Electron-Cloud Simulations of the LHC Beam with the Codewarp+Posinst
We present initial results for the self-consistent beam-cloud dynamics simulations for a sample LHC beam, using a newly developed set of modeling capability based on a merge [1] of the three-dimensional parallel Particle-In-Cell (PIC) accelerator code WARP [2] and the electron-cloud code POSINST [3]. Although the storage ring model we use as a test bed to contain the beam is much simpler and shorter than the LHC, its lattice elements are realistically modeled, as is the beam and the electron cloud dynamics. The simulated mechanisms for generation and absorption of the electrons at the walls are based on previously validated models available in POSINST [3, 4].