Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Alexsandr Tarasov has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Peculiarities of the Calculations of the Gas Turbine Cooling Systems

    by Alexsandr Tarasov, Oksana Lytvynenko, Irina Myhaylova, Vladyslav Ismailov, Svetlana Naumenko

    Системи охолодження газових турбін мають розгалужені мережи різноманітних каналів, гідравлічні та теплообмінні можливості яких визначають необхідну витрату повітря для охолодження деталей турбін і, таким чином, безпосередньо впливають на економічність ГТУ. Елементами систем охолодження, зокрема, є дроселі, діафрагми, ущільнення, отвори, які є регулюючими органами, або елементами, які піддержують тиск в системі. У каналах такого типу, як правило, має місто значне падіння тиску і тому при розрахунках потрібно дуже прискіпливо враховувати зміну щільності повітря уздовж каналу. Тому тут наведено розроблений авторами метод визначення гідравлічного опору в отворах, який дуже добре збігається з експериментальними даними. Показано, як слід враховувати стисливість повітря на коефіцієнт гідравлічного опору каналів охолодження, що дозволяє застосовувати численні експериментальні залежності для коефіцієнтів гідравлічного опору нестисливих рідин. Запропоновано метод розрахунку гідравлічних опорів отворів шляхом дефрагментації їхнього загального гідравлічного опору на окремі компоненти. Створено узагальнену залежність для гідравлічного опору розвантажувальних отворів у дисках, у монтажних зазорах між хвостовиками лопаток та дисками з урахуванням поперечних потоків повітря.

  • Open Access

    Designing the Gas Turbine Cooling System Equipped with Air Coolers

    by Alexander Tarasov, Oksana Lytvynenko, Irina Myhaylova

    MODELING OF GAS TURBINE COOLING SYSTEMS WITH AIR COOLERS

  • Open Access

    Analysis of the Method for Back Pressure Prediction in the Air Supply Path From Compressor in the Gas Turbine Rotor

    by Alexsandr Tarasov, Oksana Lytvynenko, Irina Myhaylova

    Анотація Air supply in the gas turbine rotor depends on value of back pressure that takes place in the compressor rotor cavities. Unfortunately there is a not reliable method for prediction of the back pressure due to sophisticated flow pattern here and different forms of such cavities. Therefore one of the most reliable integral methods for prediction of the swirl factor and back pressure in the cavities was analyzed and the limitations were identified in framework of which it can be used. Suitability of the integral method was evaluated in comparison with the results of CFD analysis of the airflow in a model cavity. Model of cavity was rotated with velocity 377 1/s and was restricted by radii r2 = 0.35 and r1 = 0.15 m, the width of the cavity s varied from 0.06 m to 0.6 m. In the last case, the cavity transformed to the annular channel. Air is fed into the cavity at the outer radius of the axially or radially. It was found that in case of centripetal flow and initial swirl factor equal 1, integral method adequately reflects the flow pattern in the cavity in only a relatively narrow cavity s/r2<0.17 . The flow pattern in case of wider cavities has predominantly vortex nature that tends to equalize the magnitude of swirl factor due to movement of the air mass from the smaller radius to a larger radius. The rotor of the compressors has often wide cavities that makes it necessary to develop a method for calculating the pressure in these cavities to reliably supply the cooling air to the turbine rotor.