Mónica Millán

Three-dimensional printing (3DP) technology enables an important improvement in the design of new drug delivery systems, such as gastroretentive floating tablets. These systems show a better temporal and spatial control of the drug release and can be customized based on individual therapeutic needs. The aim of this work was to prepare 3DP gastroretentive floating tablets designed to provide a controlled release of the API. Metformin was used as a non-molten model drug and hydroxypropylmethyl cellulose with null or negligible toxicity was the main carrier. High drug loads were assayed. Another objective was to maintain the release kinetics as robust as possible when varying drug doses from one patient to another. Floating tablets using 10–50% w/w drug-loaded filaments were obtained by Fused Deposition Modelling (FDM) 3DP. The sealing layers of our design allowed successful buoyancy of the systems and sustained drug release for more than 8 h. Moreover, the effect of different variables on the drug release behaviour was studied. It should be highlighted that the robustness of the release kinetics was not affected by varying the internal mesh size, and therefore the drug load. This could represent a step forward in the personalization of the treatments, a key advantage of 3DP technology in the pharmaceutical field.

Three-dimensional (3D) printing technology enables the design of new drug delivery systems for personalised medicine. Polymers that can be molten are needed to obtain extruded filaments for Fused Deposition Modelling (FDM), one of the most frequently employed techniques for 3D printing. The aim of this work was to evaluate the extrusion process and the physical appearance of filaments made of a hydrophilic polymer and a non-molten model drug. Metformin was used as model drug and Affinisol™ 15LV as the main carrier. Drug-loaded filaments were obtained by using a single-screw extruder and, subsequently, their printability was tested. Blends containing up to a 60% and 50% drug load with 5% and 7.5% of auxiliary excipients, respectively, were successfully extruded. Between the obtained filaments, those containing up to 50% of the drug were suitable for use in FDM 3D printing. The studied parameters, including residence time, flow speed, brittleness, and fractal dimension, reflect a critical point in the extrusion process at between 30–40% drug load. This finding could be essential for understanding the behaviour of filaments containing a non-molten component.

A biodegradable copolyester, poly(butylene succinate-co-ε-caprolactone) (PBS_CL), was used for first time as an excipient for pharmaceutical dosage forms using direct compression and hot processing techniques (ultrasound-assisted compression (USAC) and hot melt extrusion (HME)). Robust binary systems were achieved with hot processing techniques, allowing a controlled release of the drug. With only 12% v/v of PBS_CL, controlled release forms were obtained using USAC whereas in HME over 34% v/v of excipient is necessary. Amounts over 23% v/v allowed a long-extended release for more than 72 h following diffusional kinetic. Thanks to the high melting point of theophylline and the physicochemical properties of PBS_CL selected and synthesized, the structure of the excipient inside the USAC tablets and HME filaments corresponds to a continuum medium. A percolation threshold around 23% v/v was estimated, which agrees with a continuum percolation model. The polymer shows a high excipient efficiency value using HME and USAC. A nanostructured matrix with wall thicknesses lower than 0.1 µm was obtained. This leads to a very effective coating of the drug particles by the excipient, providing a slow and reproducible release. The present study therefore supports the use of PBS_CL, for the preparation of controlled release dosage forms using hot processing techniques.