DPDenis Packan

Denis Packan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Denis Packan has a total of 94 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Development and experimental validation of a two-axis thrust stand for the characterization of electric thruster thrust vectoring

    by E. Gourcerol, V. Désangles, D. Packan, F. Gaboriau

    A two-axis thrust stand is developed and validated experimentally, enabling direct and simultaneous measurements of two components of the thrust vector of an electric thruster. It is made of two piled-up single-axis stages, each having a hanging deformable parallelogram geometry. A mass deposition calibration method is used to calibrate the thrust stand, including crosstalk between axes. A new methodology is implemented to assess the gap between the theoretical angular resolution and uncertainty and the measured experimental uncertainty. From the measurement of the thrust resolution of each axis, a theoretical angular resolution of 0.1° is estimated for total thrusts above 645 μN and for thrust angles within a 10° half-angle cone. A theoretical uncertainty of 0.2° is estimated prior to thrust vectoring tests, done with a rotating cold gas thruster pointing at known operating angles between −15° and +15° and for total thrusts ranging from 235 to 7711 μN. The difference between the measured thrust angle and the operating angle evolves linearly with the operating angle. Gas tubing deformation, lower platform rotation, or incorrect crosstalk correction are potential origins of this systematic error and are responsible for the current experimental uncertainties of 0.7° at total thrusts below 630 μN and of 1.2° at higher thrusts. With further improvements, the 0.2° theoretical uncertainty could be achieved at a total thrust above 250 μN. Finally, the instrument demonstrates an efficient mitigation of the thermal and magnetic effects of an ECR thruster, paving the way for the characterization of electric thrusters.

  • Open Access

    Comparison of a hybrid model and experimental measurements for a dielectric-coated coaxial ECR thruster

    by Álvaro Sánchez-Villar, Federico Boni, Victor Désangles, Julien Jarrige, Denis Packan, Eduardo Ahedo, Mario Merino

    Electrostatic probe and thrust balance measurements of a coaxial electron-cyclotron-resonance plasma thruster with magnetic nozzle are compared against numerical simulations of the device that solve self-consistently the plasma transport problem with a hybrid particle-in-cell/fluid approach and the microwave electromagnetic fields using mixed finite elements. A simple phenomenological anomalous transport model similar to those used in Hall thruster modeling is applied. Reasonable average relative errors are reported on the ion current density (8.7%) and plasma density (12.8%) profiles along the plume. Good agreement is found in terms of relative errors on thruster performance parameters as the 90%-current divergence angle (0%–3%), utilization efficiency (3%–10%), peak ion energy (9%–15%), and energy efficiency (2%–17%). The comparison suggests that enhanced cross-field diffusion is present in the plasma. Differences in the experimental and numerical behavior of electron temperature point to the areas of the model that could be improved. These include the electron heat flux closure relation, which must correctly account for the axial electron cooling observed.


  • Impact of the Microwave Coupling Structure on an Electron-Cyclotron Resonance Thruster

    by Simon Peterschmitt, Denis Packan

    The electron-cyclotron resonance thruster with magnetic nozzle relies on two successive energy transfer processes: first from electromagnetic energy to electron thermal energy, facilitated by a cou...


  • Open Access

    Characterization of diamagnetism inside an ECR thruster with a diamagnetic loop

    by S. Correyero, M. Merino, Paul-Quentin Elias, J. Jarrige, D. Packan, E. Ahedo

    The plasma-induced magnetic field in an electron cyclotron resonance plasma thruster is measured non-intrusively by means of a diamagnetic loop that encloses the plasma flow. The calibration process is described, and parasitic currents in the thruster walls and plasma oscillations are identified as the dominant sources of uncertainty. The integrated magnetic flux is seen to depend on the applied power and less significantly on the mass flow rate. The effect of the diamagnetic loop radius is also studied by testing two loops of different diameters. To estimate the perpendicular electron pressure in the plasma from the loop measurements, two plasma beam models, 1D and 2D, are used. While both models give similar results for the small loop, they differ significantly for the large loop, showing the relevance of 2D effects when a large diamagnetic loop is used.


  • Direct Thrust Measurement of an Electron Cyclotron Resonance Plasma Thruster

    by Théo Vialis, Julien Jarrige, Ane Aanesland, Denis Packan

    Direct thrust measurements of an electron cyclotron resonance plasma thruster are performed with a thrust balance. The thruster performances are deduced, and the influence of power and mass-flow rate is studied. The measured thrust is around 1 mN for 50 W of microwave power input and 0.1  mg/s of xenon, corresponding to 1000 s of specific impulse and 11% of total efficiency. It is found that the thrust is increased by 25% when the walls of the plasma source are covered with a dielectric layer. Comparisons are made between the direct thrust measurements and the indirect thrust measurements obtained with electrostatic probes in the plasma beam.


  • Numerical modeling of repetitive nanosecond discharge in air

    by S. Rassou, D. Packan, J. Labaune

    A repetitively pulsed nanosecond glow discharge in a flow of atmospheric pressure air at 2000 K is numerically modelled in the framework of plasma assisted combustion. The plasma is modelled in quasi-neutral approximation with fluid transport and diffusion. In our simulations, 16 species and 115 reactions are considered to model the discharge and the post discharge in air flow, and each phase operates at different time scales. The steady-state regime is reached over 200 cycles from the initial composition at thermodynamic equilibrium. The shape and the electron density of the simulated discharge compare well with experimental measurements.


  • 3D ion velocity distribution function measurement in an electric thruster using laser induced fluorescence tomography

    by P. Q. Elias, J. Jarrige, E. Cucchetti, F. Cannat, D. Packan

    Measuring the full ion velocity distribution function (IVDF) by non-intrusive techniques can improve our understanding of the ionization processes and beam dynamics at work in electric thrusters. In this paper, a Laser-Induced Fluorescence (LIF) tomographic reconstruction technique is applied to the measurement of the IVDF in the plume of a miniature Hall effect thruster. A setup is developed to move the laser axis along two rotation axes around the measurement volume. The fluorescence spectra taken from different viewing angles are combined using a tomographic reconstruction algorithm to build the complete 3D (in phase space) time-averaged distribution function. For the first time, this technique is used in the plume of a miniature Hall effect thruster to measure the full distribution function of the xenon ions. Two examples of reconstructions are provided, in front of the thruster nose-cone and in front of the anode channel. The reconstruction reveals the features of the ion beam, in particular on the thruster axis where a toroidal distribution function is observed. These findings are consistent with the thruster shape and operation. This technique, which can be used with other LIF schemes, could be helpful in revealing the details of the ion production regions and the beam dynamics. Using a more powerful laser source, the current implementation of the technique could be improved to reduce the measurement time and also to reconstruct the temporal evolution of the distribution function.


  • Numerical modeling of a glow discharge through a supersonic bow shock in air

    by S. Rassou, D. Packan, P.-Q. Elias, F. Tholin, L. Chemartin, J. Labaune

    The interaction between a glow discharge and the bow shock of a Mach 3 air flow around a truncated conical model with a central spike is modeled, and comparison is made with prior experimental results. The KRONOS workflow for plasma modeling in flow fields, which has recently been developed at ONERA, was used for the modeling. Based on the quasi-neutral approximation, it couples hypersonic and reactive flow fields with electron chemistry, including the effect of non-Maxwellian electron energy distribution function. The model used for the discharge involves 12 species and 82 reactions, including ionization, electronic and vibrational excitation, and attachment. The simulations reproduce the main features of the discharge observed experimentally well, in particular, the very recognizable topology of the discharge. It was found from the simulations that behind the bow shock, in the afterglow, the negative ion flow ensures the electrical conduction and the establishment of the glow discharge. The influence of kinetic rates on the voltage-current characteristics is discussed.


  • Electron dynamics and ion acceleration in expanding-plasma thrusters

    by T Lafleur, F Cannat, J Jarrige, P Q Elias, D Packan

    In most expanding-plasma thrusters, ion acceleration occurs due to the formation of ambipolar-type electric fields; a process that depends strongly on the electron dynamics of the discharge. The electron properties also determine the heat flux leaving the thruster as well as the maximum ion energy, which are important parameters for the evaluation of thruster performance. Here we perform an experimental and theoretical investigation with both magnetized, and unmagnetized, low-pressure thrusters to explicitly determine the relationship between the ion energy, E i , and the electron temperature, T e 0 . With no magnetic field a relatively constant value of is found for xenon, while when a magnetic nozzle is present, is between about 4–5. These values are shown to be a function of both the magnetic field strength, as well as the electron energy distribution function, which changes significantly depending on the mass flow rate (and hence neutral gas pressure) used in the thruster. The relationship between the ion energy and electron temperature allows estimates to be made for polytropic indices of use in a number of fluid models, as well as estimates of the upper limits to the performance of these types of systems, which for xenon and argon result in maximum specific impulses of about 2500 s and 4500 s respectively.