Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


María Jesús Espinosa Trujillo has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Enhancing Vienna Rectifier Performance with a Simplified abc Frame Multi-Loop Control Scheme

    by Homero Miranda-Vidales, Manuel Flota-Bañuelos, Braulio Cruz, Freddy I. Chan-Puc, María Espinosa-Trujillo

    This paper presents a novel multi-loop control strategy for Vienna rectifiers that eliminates coordinate transformations while achieving superior performance under adverse grid conditions. Unlike conventional dq-frame controllers that suffer from computational complexity and degraded performance during unbalanced conditions, the proposed abc-frame scheme achieves a power factor of 98% with total harmonic distortion (THD) below 5% across all operating conditions. The system exhibits a settling time under 120 μs for 90% load transients and ensures robust operation during Type A voltage sags while maintaining a 94% power factor. Furthermore, it guarantees zero steady-state neutral point deviation. The controller employs a dual-loop architecture with high-gain current tracking and PI-based voltage regulation, validated through extensive PSIM/C++ co-simulations at 120 kw. Comparative analysis demonstrates a 35% reduction in computational burden relative to dq-frame alternatives, while fully complying with IEEE-519:2022 standards. These results highlight the proposed method as a practical and robust solution for industrial rectification applications requiring grid-fault tolerance.

  • Open Access

    Experimental Study of an Inverter Control for Reactive Power Compensation in a Grid-Connected Solar Photovoltaic System Using Sliding Mode Control

    by Manuel Flota-Bañuelos, María Espinosa-Trujillo, José Cruz-Chan, Tariq Kamal

    In photovoltaic (PV) systems, inverters have an essential role in providing an energy supply to meet the demand with power quality. Inverters inject energy into the grid considering that a renewable source is available; however, during intermittent periods or in the absence of power generation, the inverter remains inactive, which decreases the performance of the PV system. One way to increase the operation of inverters is to operate them as Volt-Amps Reactive (VAR) compensators to generate reactive power in the absence of renewable sources. The paper presents the development of a control scheme that allows the PV system’s inverter to improve the power factor in the electrical system with or without PV power generation. The proposed control is based on using a sliding mode controller (SMC) current control loop and PI-based voltage control loop. The control scheme is developed in MATLAB/SIMULINK, and for real evaluation, a PV prototype is implemented. The control strategy efficiency is confirmed by the obtained results. The control scheme increases the practical utility of PV systems. Additionally, it improves the power factor in all cases during the injection of active power to the grid operating under intermittent conditions and/or in the absence of power generation.


  • Red de sensores de humedad y temperatura de bajo costo

    by Luis Manuel Mendoza-Pinto, María Jesús Espinosa-Trujillo, Jesús Humberto Peet-Manzón

    This article presents the development of a low cost network of wireless sensors that use an open source hardware platform, consisting of an ESP8266 and a digital temperature-humidity sensor to measure the parameters in an area determined by the range of the sensor. The general development of the system includes the use of open source software to receive information through the network. Tests of sensor effectiveness were performed at three different points in an air-conditioned area. The first sensor was placed outside the area, the second in the middle and the last one at the exit of the air conditioning. The results obtained allowed to know the behavior of temperature and humidity in the area and the effectiveness of the sensor network to measure the variables, the results of the measurements are presented in detail. Because the system is highly scalable, inexpensive and easy to build compared to other systems, it is a good choice for a wide variety of applications.


  • An optimal power sharing and power control strategy of photovoltaic/fuel cell/ultra-capacitor hybrid power system

    by T. Kamal, S. Z. Hassan, M. J. Espinosa-Trujillo, H. Li, M. Flota

    Renewable energy sources experience problems such as deregulation when they are used as stand-alone energy sources. This paper presents an optimal power sharing and power control strategy combining a photovoltaic (PV) array, a fuel cell (FC) stack, an ultra-capacitor (UC) module, and a set of loads. The photovoltaic is the prior energy source while the fuel cell (FC) system is added as a backup source to meet the excess power demand. The ultra-capacitor (UC) is utilized as a buffer storage to compensate the slow dynamic response of the FC during transient and regulate the DC-bus voltage. The power control strategy is designed to work on a two-level arrangement. The top level controls the entire power management, which generates references to low level individual subsystems depending upon solar radiation, temperature, and load conditions. Based on the command signals, each local controller controls the PV, FC, electrolyzer, and UC. The top level also controls the load scheduling during low solar radiation in order to sustain the system operation for 24 h. The performance of the system is tested under real-world record of solar radiation, temperature, and load conditions for Bahria town at Islamabad, Pakistan. The effectiveness of the proposed model in terms of voltage regulation, power transfer, load tracking, and grid stability is verified by Matlab simulation results.


  • A novel stand-alone mobile photovoltaic/wind turbine/ultracapacitor/battery bank hybrid power system

    by M. J. Espinosa-Trujillo, M. Flota-Bañuelos, D. Pacheco-Catalán, M. A. Smit, Y. Verde-Gómez

    This paper presents a new mobile hybrid system using a photovoltaic array, a wind turbine, an ultracapacitor, and a battery bank for grid-independent applications in the city of Cancun, Mexico. A main controller is proposed to manage these different power sources. This controller permits autonomous operation and control over power generation and loading. This proposal used high power and high energy density storage devices, including short- and long-term storage strategies for energy management. An independent load management subsystem was added, given that the mobile application requires the management of critical loads. This subsystem included an ON/OFF pattern for the connection and disconnection of DC and AC power outlets installed inside and outside the mobile unit. In order to verify system performance, each component of the system was modeled and simulated under realistic operating scenarios with a practical load using MATLAB, Simulink, and SimPowerSystems. The results obtained for this simulation showed that, by means of power balancing, this management scheme coordinated the power flow among the different sources and the load. The manager behavior shows that the difference between the power generated and the power demand was 2.08 kW h/day and 4.01 kW h/day in winter and summer, respectively.


  • Batteries-supercapacitors storage systems for a mobile hybrid renewable energy system

    by J. M. Sandoval, M. J. Espinoza Trujillo, M. I. Flota Bunuelos, J. Y. Verde Gomez, D. E. Pacheco-Catalan

    The most popular energy storage system for renewable energy are batteries modules, due to their high energy density and portable applications, nevertheless, they are unable to release all its stored energy and the high initial current demand on electrical machines like engines or compressors, cause stress in batteries and hence to reduce their life cycle. For that reason, supercapacitors are an excellent complement to batteries, because they can supply the power demand at the current peaks, reducing the stress on batteries. In this work, a supercapacitor module characterization at the hybrid system operation conditions was presented and this characterization was compared with the values obtained for mean of simulation of control considering terms such as ESR (equivalent series resistance) and the effect of DC/DC converters, and based on the considered hybrid system and characterization results an interconnection with a battery bank to decrease the stress in the bank is proposed.